For a twisted pair cable the attenuation measured is 5 dB and the Attenuation to cross talk ration is 10 dB then the near end cross talk of the cable is

Q: Q4/ To transmit a bit sequence 10011011, draw the resulting waveform using Unipolar RZ Unipolar NRZ…

A:

Q: draw all the diagram of line coding using 110011001000 1) Unipolar 2) Polar (NRZ, RZ and…

A:

Q: The excess-3 code for 486 is given by

A: Excess three code of 486. Add 3 in the BCD code.

Q: rding to:

A:

Q: The modulated carrier voltage of a carrier signal is 45 Vmax and 20 Vmin. Determine the modulation…

A:

Q: The modulator is the main part of the receiver in a basic transmission system. True False

A: Given statement:  The modulator is the main part of the receiver in a Basic transmission system Is…

Q: How many select lines would be required for an 8-line-to-1-line multiplexer? O a. 1 O b. 8 О с. 2 O…

A: The number of select lines required for the N:1 Multiplexer is given by  Log2 (N). N is the the…

Q: Modern high-speed circuit breakers have tripping times between three and eight minutes. Select one:…

A: Modern high speed circuit breakers have tripping time between three and eight minutes is False…

Q: Choose the correct Answer: The difference in the propagation delay between the fastest and slowest…

A: Inorder to choose the correct option we need to know the definitions of all the options  Answer is…

Q: lo avold corruption during transmission, the code-word snould be Select one: O a. None of the…

A: The code-words should be far apart from one and another as possible  So even when the vectors…

Q: The modulation technique tha uses the minimum channel bandwidth and transmitted power is:

A: The explanation is as follows.

Q: For an AM DSBFC transmitter produces an output as in Figure Q1(d) with resistance load, RL of 102…

A: Given: The amplitude modulated signal (AM DSBFC) is, Modulation coefficient, m1=0.5m2=0.8 Load,…

Q: Polimide coating is used in which of the following cable? a. Twisted Pair Cable b. Straight Pair…

A: Polimide coating gives a excellent balance of electrical, chemical and physical properties. It is…

Q: mplement the sum of minterm: F(x,y,z) = Σm(1,2,6,7) with a single 1 bit 8-to-1 multiplexer.   clear…

A: To solve above problem, one should have idea about working operation of MUX circuit. MUX is a…

Q: d capacity if the cable is replaced by a coaxial cable with bandwidth (B=500kHz). Assume no and…

A:

Q: The problem in TDM is the busy slots. Select one: O True O False

A: In TDM system, different different time slot is given to the different different consumer with hugh…

Q: A 1000-W carrier is amplitude-modulated and has a side-band power of 300 W. The depth of modulation…

A:

Q: Determine the percent modulation for an unmodulated carrier of 80 Vp-p if the maximum and minimum…

A: When Vmin is there will be 100% modulation

Q: Pair of the quantiter of at load-bus and Q1 what are Slack bus jA toad 2low studies?

A: In this question we will write about quantities specified on load bus and slack bus...

Q: Determine the lower cutoff frequency of this network.

A: Small-signal modeling of the amplifier will be Cutoff frequency due to…

Q: The expression of C1 for Schering bridge is given by

A:

Q: SUBWF , INCFSZ, BCF, CALL, MOVLW, RETFIE

A: PIC is RISC microcontroller which has 35 instructions that perform many operatikns like data…

Q: Which of the following multiple access techniques are used by second generation cellular systems? a)…

A: The solution is provided in the following section:

Q: AM double-sideband full carrier is also known as: Select your answer. НЗЕ R3E ЈЗЕ A3E

A: AM double sideband full carrier is also known as

Q: Problemse Find the transter function for C/Ris) Tor the fallowing Contral systets by using black Cha…

A: The given block diagram can be reduced by considering the parallel connected and series connected…

Q: In the FM system, the audio frequency is 1 KHz and the audio voltage is 2v. The frequency deviation…

A:

Q: For a category-5e twisted pair the far end cross talk is if the cross-talk near the receiver 10 dB…

A: Far-end crosstalk (FEXT) is measured at the far end of the channel. It is detected to the opposite…

Q: In a broadcasting studio, a 1000kHz carrier is modulated by an audio signal of frequency…

A: Given: An audio signal of frequency range100-5000Hz. fc=1000 kHzfmmin=100 Hz=0.1 kHzfmmax=5000 Hz=5…

Q: Using previous syndrome table, find the corrected word for the received word [R]=[1010011].

A: First, the receiver will find [S] from the reminder of R(X)/g(X) 1 1 0…

Q: 19.CALL [BX] is : a. Near call b. Far call c. Indirect call

A: CALL [BX] is a Indirect call, because it is using register as an argument or an indirect call uses…

Q: For a category-5e twisted pair the far end cross talk is if the cross-talk near the receiver 10 dB…

A: Far-end crosstalk (FEXT) is measured at the far end of the channel. It is detected to the opposite…

Q: Construct 16-to-1 line multiplexer using 4-to-1 line multiplexer.

A: A 4-to-1 multiplexer has four input lines and one output line. The output line is connected to one…

Q: Define wy higher on-ofp 1- off ralio. on- Sevies JEFT has ratio compared to shunt as JEFT?

A:

Q: In the FM system, the audio frequency is 1 KHz and the audio voltage is 2v. The frequency deviation…

A:

Q: are connect

A: The inverter is a logic gate which invert the input to the output. When the input 0 is given to the…

Q: Identify the mistake in the following program lines and correct it. A= (1+ZY/2) C= Y(1+(ZY0.25))

A:

Q: How far is it from A (100, 30°, 60°) to B (40, 75°, 125°)?

A:

Q: For a category-5e twisted pair the far end cross talk is if the cross-talk near the receiver 10 dB…

A: Far-end crosstalk (FEXT) is  measured at the far end of the channel. It is detected to the opposite…

Q: Explain bridge T-attenuator andalso designit with anatenuation if 20dB. and terminatedinaloadof5002.

A: Given,  Bridge T-attenuator has, Attenuation =20log10K = 20dB Load impedance (ZL) = 500 ohm.

Q: ? ( time constant) We = ? ( cut-off angular fragnency ) T = ? ( Trans for funetion ET) V; (N) Volw)

A: From the asked questions, we are answering the first two questions(b and c), please repost your…

Q: For the OLTF G(s), neatly sketch the root locus to scale using the drawing guides.

A:

Q: Impedance plane is important in ECT, by using diagram briefly explain impedance plane.

A:

Q: How many select lines would be required for an 8-line-to-1-line multiplexer? a. 1 O b. 2 O. 8 O d. 3

A: Multiplexer is also called as MUX. These are used to select one input at a time from many input…

Q: 3.14 Given the data stream 1110010100, sketch the transmitted sequence of pulses for each of the…

A: The sketch of the transmitted sequence of pulses for the line codes are:

Q: In DSB-SC-AM modulation the information carried by carrier is zero more than information carried by…

A: So We have to solve DSB SC AM and third harmonic question.

Q: CB radios were developed using the full-carrier DSB AM. It operates using 40 channels, each 10KHz…

A:

Q: The accuracy gives similar indication to the precision. True O False

A: accuracy is the closeness of the instrument reading with the actual value  and precision is the…

Q: To provide two or more voice circuits with the same carrier, it is necessary o use the…

A: Simple problem on communication. Look below the explaination..

Q: The minority of carrier concertation is highly a function of

A: consider the given question;

Code Conversion

The method or technique used to convert code from one format to another is termed code conversion. Code conversions are most commonly used in computers, digital electronics, microprocessors, etc.