For RZ code, if PB = 1E-4 and NO =1 E-12, then the bit energy is equal to-------- : a. 13.7 pico joule b. 6.7 pico joule c. none of the mentioned d. 8.5 nano joule     This multiple choice question from DIGITAL COMMUNICATIONS course. just write for me the final answer.

Q: Q4: Draw the constellation diagram of 2*4 QAM signal then show the output amplitudes and phases of…

A:

Q: Q7/A low pass signal of 3 kHz bandwidth and amplitude over -5 Volts to +5 Volts range is sampled at…

A: Low Pass Filter: A low-pass filter (LPF) is a circuit that only allows signals below its cutoff…

Q: Q3) A- Find the 4-bit PCM signal for the message wave and sampling signal shown below: Amplitude A…

A: Given  Message signal of amplitude 11 V Sampling signal  Find  PCM output for the message signal and…

Q: For the above given signal each bit is separated by a vertical line. If duration of a bit is given…

A:

Q: Suppose, 5 signals are coming through 5 sources and will be multiplexed by time division…

A: Given, 5 signals are coming through 5 sources and will be multiplexed by time division multiplexing…

Q: For NRZ code, if Eb = 9.07 pico Joule and NO =1E-12, then the bit error rate is equal to a)1E-5…

A:

Q: (i) Below (figure 1) is an example of a VHDL code for a multiplexer. "00000010000001"WHEN…

A: A VHDL code for the multiplexer is given in the question.   Consider the code line, SIGNAL input :…

Q: Consider a (10,6) single error correcting code for which code polynomial is x8 + x6 + x5 + x³ + x…

A: The polynomial is given as:

Q: c) Find the parity check matrix for the code (5, 2) given {00000, 10100, 01111, 11011}. Find the…

A: m1 m2 P1 P2 P3 0 0 0 0 0 0 1 1 1 1 1 0 1 0 0 1 1 0 1 1

Q: The function of RBI bit in the BCD - to -7-Segment Decoder is Display number 8 Block the zero number…

A: We need to select the function of RBI

Q: Consider a transmitter using 2-PAM, with available power PTx = 1 W. The noise density is NO = 100 ×…

A:

Q: For the source coding Explain the difference between variable length and fixed length source coding?

A:

Q: Consider a CDMA system where transmitter A has the code 101010 and transmitter B has the code…

A: The given CDMA system transmitter A code is  101010. The given CDMA system receiver B code is 111001…

Q: B- Give a brief answer for the following questions 1. A temperature measurement within a range of…

A:

Q: Assume a digital communication system with the following specifications: the channel Pe=0.05, and…

A: Solution : Given ; Bit error probablility Pbe=0.05 Block code can connect maximum upto 3 bitsso,…

Q: 3. A communication system transmits an analog waveform via a Yagi antenna of length 3m. The analog…

A: According to guidelines we need to solve only first three sub-parts. According to the question we…

Q: a) i) Determine the number of bits per level required when using FSK with 4 different frequencies…

A: According to the question,  i) Determine the number of bits per level required when using FSK with 4…

Q: 1 1 0 0 0 1 0 1 лишь ASK --> PSK NRZ (M) --> -

A:

Q: Q4/The minimum decoders using to design 6- to-64 decoder are

A: The explanation is as follows.

Q: Using Verilog continuous assignment statements or VHDL signal assignment statements, write a…

A: The verilog assignment statement for the given circuit can be obtained by converting the gates into…

Q: For the above given signal each bit is separated by a vertical line. If duration of a bit is given…

A:

Q: In your own words, explain the importance of line coder in digital communication. In…

A: Line coding  Line coding also known as digital baseband modulation or digital baseband transmission…

Q: The Question is in JPEG

A: Given: A DC circuit consisting of independent and dependent current sources. According to question:…

Q: F(A, B, C, D) = Σm(2,7,8,9,13,14) implement the following function F by using one 8-to-1…

A:

Q: Q1 .An M-ary PSK, ISI-free system is to operate with 2k PSK symbols over a 120 [kHz] channel. The…

A: As per the rules we can answer only one question, please post the remaining questions as the…

Q: Identify and draw the odd and even parts of the signal given below. ?(?) = ?(? + 2) − 2?(? − 1) +…

A: Identify the given signal draw the odd and even parts of the signal given ?

Q: Bit sequence: 100101 Draw the voltage level signal for the bit sequence using Unipolar-RZ,…

A: The voltage level signal for the bit sequence using unipolar-RZ is given by:

Q: For the above given signal each bit is separated by a vertical line. If total time is given as 12…

A: Bit duration=12ms

Q: sent using Single-bit AM Single-bit FM Single-bit PM

A:

Q: Calculate the number of bits per signal element and the channel SHIRAS that will permit a bit rate…

A:

Q: Gs. For apavicu lar mp, the manufuc tur specifics that the width ola cer tain control signal…

A: a). The value of clock frequency is: The value of the clock period is:

Q: 5. What will be the final output of the following figure? where Ac amplitude of carrier signal, wc =…

A:

Q: Draw the waveforms for the following data stream corresponding to NRZ-I, RZ, Manchester and…

A: We need to draw the waveforms for the following data stream corresponding NRZ, RZ, Manchester and…

Q: Calculate the bit rate of the base channel of T1 carrier system

A: In the T1 carrier system, 24 individual users are given a single frequency channel and the channel…

Q: Q31)The bit rate for American PCM-24 system is a. 2.048 Mb/s b. 1.544 Mb/s c. 8 kb/s d. 64 kb/s

A: The explanation is as follows.

Q: Examine the following digital stream, where (+) means a positive pulse, ) means a negative pulse and…

A:

Q: Communication Three different information signals each bandlimited to 6kHz, 11kHa, and 3kHz.…

A:

Q: 1. For a digital signal (101100111001100010) use DPSK to transmit and receive this signal including…

A: Note: We are authorized to answer one question at a time since you have not mentioned which question…

Q: a) Answer the following questions in more than two lines. i) What type of signals do a WDM use?…

A: FDM, TDM, and WDM are types of analog and digital multiplexers.

Q: The time difference between the input signal crossing a 0.5VDD and the output signal crossing its…

A: It is explain by figure.which is given below in figure time difference between input and output,…

Q: How do you realize a higher magnitude comparator using lower bit comparator?

A: The digital circuits can be combinational as well as sequential circuits. The combinational circuits…

Q: Q3. b) Suppose you want to transmit the 10-bit message [101101101] by Pulse code Modulation (PCM).…

A: Part (iv) -  Delay modulation - In communication, delay modulation is also known as millier's…

Q: Q.1: What is Quadrature Amplitude Shift Keying (QAM)? Explain with geometrically for symbol…

A: This scheme is called as M-ary QAM (where M= Number of symbols/messages and n=log2M is the number of…

Q: Ius 2ps 3 us 4s Sps 6ps 8us a) 3µs,1us b) 5us, 1µs c) 5us, 4us d) 2µs,1µs e) 8us,1us

A: The serial transfer time for transfer 8 bit will be 8 micro sec.(since in series transfer one bit is…

Q: Four computers are sending the digital data over a multiplexed line as shown in the Figure below.…

A:

Q: alternativeapproach that is similar to ADSL; uses coaxial, fiber-optic or twistedpair cable for…

A: In this question we will write about VDSL...

Q: Given the definition of the following data segment, where A and B are ASCII numbers. .DATAA DB ’ 2 8…

A: Concept: BCD: binary coded decimal is a number system in which one decimal numeral is represented by…

Q: Consider a packet switched network, where one packet of size 10000 bits is send from Host A to…

A: The data rate of each link is 2kbps means 2kb data is sent through it within a second, using the…

Q: 1) Which multiplexing technique shifts each signal to a different carrier frequency? a) FDM b) TDM…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…