For the circuit below, find the power factor combination (hint: find the total complex power S=S1+ S2), and then find the value of the capacitance that will give a power factor of 0.95when connected to the load. Assume that VRMS = 120 V, 60 Hz. Load 1 20kW pf = 0.7 lagging Load 2 50 kW 120 pf=0.9 lagging

For the circuit below, find the power factor combination (hint: find the total complex power S=S1+ S2), and then find the value of the capacitance that will give a power factor of 0.95when connected to the load. Assume that VRMS = 120 V, 60 Hz. Load 1 20kW pf = 0.7 lagging Load 2 50 kW 120 pf=0.9 lagging

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Similar questions

Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor, and a 4 capacitor. (a) Draw the circuit diagram. (b) Compute the series impedance. (C) Determine the current I delivered by the source. Is the current lagging or leading the source voltage? What is the power factor of this circuit?
Consider the current i(t)= 30sin(100t+90o) mA. is applied the circuit given below. a) Find and draw phasor equivalent of the circuit b) Find Iload and Vload phasors and and draw them on the real-imaginary axis. Find iload(t) and vload(t) via inverse phasor, comment phase angles c)Find active, reactive and complex power (P,Q,S) absorbed by the load. please fast
The load ZL in the circuit of Figure consistsof a 25-Ω resistor in series with a 0.1-H inductor.Assuming f = 60 Hz, calculate the following.a. The apparent power supplied by the source.b. The apparent power delivered to the load.c. The power factor of the load.
Impedances Z2 and Z3 in parallel are in series with impedance Z1 across a 100 V, 50 Hz acsupply. Z1 =6.25 + j 1.25 ohm; Z2 = 5 + j0 ohm and Z3 = 5 – jXc ohm. Determine the value ofcapacitance of Xc such that the total current of the circuit will be in phase with the totalvoltage. When is then the circuit current and power.
The load ZL in the circuit of Figure consistsof a 25-Ω resistor in series with a 0.1-mF capacitor anda 70.35-mH inductor. Assuming f = 60 Hz, calculatethe following.a. The apparent power delivered to the load.b. The real power supplied by the source.c. The power factor of the load.
Show that at a given frequency ω, the circuits will have the same impedance between the terminals a,b ifR2=1+ω2R12C12ω2R1C12,C2=C11+ω2R12C12.(Hint: The two circuits will have the same impedance if they havethe same admittance.)2. Find the values of resistance and capacitance that when connectedin parallel will give the same impedance at 50 krad/s as that of a1 kΩ resistor connected in series with a capacitance of 40 nF
A 25- W resistor and a 40-µF capacitor are connected in parallel across a 120-V, 50-Hz source. Determine the magnitude of the following: (a) admittance; (b) current through resistor and capacitor; (c) the total current; (d) true power and capacitive reactive power; (e) apparent power, power factor, and power factor.
A 120-V rms 60-Hz source supplies two loads connected in parallel, as shown in the figure. a) Find the power factor of the parallel combination. b) Calculate the value of the capacitance connected in parallel that will raise the power factor to unity.
in the figure below, find a) The p.d across j5 ohmn inductance b)The p.d across -j10 ohmn capacitance c) the current in 20 ohmn resitance d) the current in (12+j160 ohmn impedance e) the complex power for (12+j16) ohmn impedance
Using the node-voltage method, determine the magnitude of the phasor voltage V1; that is, find |V1| in Volts (peak). The values of the phasor voltage sources in the above diagram are VA = 3 and VB = 3 Volts. The resistor values are R1 = 4 Ω and R2 = 8 Ω, and X1 = 12 for the capacitor giving an impedance of -j12 Ω. Express your answer using 3 significant figures.
Find the complex power for the following: Vrms= 200 ∠ 30∘ V, Z= 40+ j60 Ω in addition form
For the following voltage and current phasors, calculate the complex power, apparent power, real power, and reactive power. Specify whether the pf is leading or lagging. a. ? = 220∠30° ? ???, ? = 0.5∠60° ? ??? b. ? = 160∠45° ? ???, ? = 8.5∠90°? ???