Answered: For the circuit in FIGURE 2, determine…

For the circuit in FIGURE 2, determine the current in the 1-2 resistor.(2.8 A) the 3-2 resistor. (1.2 A) the 4-2 resistor.(0.90 A) ii. ... 11.

Inquiry into Physics

8th Edition

ISBN:9781337515863

Author:Ostdiek

Publisher:Ostdiek

Chapter7: Electricity

Section: Chapter Questions

Problem 9P: A 120-V circuit in a house is equipped with a 20-A fuse that will b1ow if the current exceeds 20 A....

See similar textbooks

Related questions

Q: How do figure what the equivalent resistance is for two resistors in parallel, as to the attached…

Q: 3. A triangular array of resistors is shown in the figure on the right. What current will this array…

Q: Question 1. Consider the circuit given below. 1) What is the equivalent resistance for the voltage…

Q: Base your answers to questions t- on the diagram below in which the source of voltage is 26 Volts.…

Q: In the circuit below, if the battery in the circuit below is 2V, resistor R1=114Ω, and resistor…

Q: What is the power in a circuit if a 30-V battery is connected to a 10-Ω resistor? Find the power…

A: Given data: Voltage of the battery, V=30 V Resistance, R=10 Ω

Q: In the circuit in Figure, find v, i, and the power absorbed by the 4 2 20 V 102 resistor.

A: Given data: The voltage of the battery is, V= 20 V The resistance value of the resistors are R1= 5 Ω…

Q: 3. A triangular array of resistors is shown in the figure on the right. What current will this array…

Q: The figure shows the resistor wired in a different way -- a combination of series and parallel.…

A: Given: R1=1 ΩR2=6 ΩR3=13 Ω

Q: In the circuit shown in the figure (Figure 1), the current in the 20.0-V battery is 5.00 A in the…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: 17. Examine the following circuit diagram showing four resistors connected to a battery. R₁=100 www…

Q: 3.00 k2 R3 E3 70.0 V 60.0 V | 80.0 V R2 4.00 k2 2.00 kQ

A: The circuit diagram is shown below, In the loop abcf, apply Kirchhoff laws. Substitute the known…

Q: ure 2 shows the schematic of a Wheatstone bridge circuit. What are the conditions in order for the…

A: Wheatstone bridge, also known as the resistance bridge, calculates the unknown resistance by…

Q: 2. In this circuit, the voltage drop across the upper resistor is 4.5 V. What is the battery…

A: Resisance 1: R1 = 30 Potential drop across R1 is V1 = 4.5 V Resisance 2: R2 = 50 is

Q: 1. What is the total current in the circuit below? What is the total power dissipated by the…

A: We need to calculate total current and total power dissipation in the circuit shown.

Q: 3. For both circuits: Determine the potential difference on and the current through each resistor.…

Q: In the circuit below, if the battery in the circuit below is 3V, resistor R1=154ΩΩ, and resistor…

A: Battery Voltage, E= 3 Volts To find- The total/net current in the circuit.

Q: A parallel-series combination of resistor is shown in the diagram below. If R1=5 KO, R2= 13 KQ,…

Q: Describe the difference between resistors wired in series vs. resistors wired in parallel. Which…

Q: In the circuit below, if R1=100 ohms and R2=200 ohms and the total resistance is 54.5 ohms, what is…

A: Given- R1 = 100 ohms R2 = 200 ohms Total resistance, Req = 54.5 ohms…

Q: What is the current through a resistor (12.08 Ω) if the voltage across the resistor is 15.88 V?

Q: A toaster operating on 120 v uses a current of 9.3 A. What is the toaster power consumption? How…

A: Given dataOperating Voltage V=120 VCurrent I=9.3 Aa) Power consumption P P=VI watt…

Q: The diagram below depicts a couple of circuits containing a voltage source (battery pack), a…

A: We know that the ohm's law states that Voltage is directly proportional to current. It's…

Q: FIGURE 3 shows a circuit with a battery having an emf of 12 V and an internal resistance of 0.2 2…

Q: For the below circuit, find the current i through the 18 ohms resistor. 4 2 120 V i,E18Ω is, 59Ω y…

Q: A parallel-series combination of resistor is shown in the diagram below. If R1= 90, R2= 10 Q, R3=15…

A: Given: R1=9 ΩR2=10 ΩR3=15 Ω

Q: For the circuit shown in the figure, compute the potential difference and current for each resistor.…

A: V = 12 V To find = Current and potential difference across each resistor

Q: In the circuit below, if resistor R1=25.42N, and resistor R2=60.37N, what is the equivalent…

Q: Figure 4 shows the arrangement of 3 resistors, which are connected to 3 sources: 70 V, 60 V and 80…

A: Let current i1 is flowing in the clockwise direction in the left-side loop and current i2 is flowing…

Q: Given the circuit in figure shown below. 1. What is the total resistance of the circuit?\ 2. If E…

Q: 3. A triangular array of resistors is shown in the figure on the right. What current will this array…

A: Given: Three resistences are connected as shown in figure, ab = 15 ohm bc = 10 ohm ac = 20 ohm…

Q: R1 R2 Hil- 12 V

A: When resistors are connected along the same conductive path, the current flow through the resistor…

Q: 4.0 µF 3.0 µF 6.0 µF

A: Given 3 capacitor in a circuit. We have to find equivalent capacitance of the circuit.

Q: Question 3. Consider the combination of the resistors as in Figure 1. Find (a) the equivalent…

Q: What is the equivalent resistance if you connect three 10.0 Ω resistors in series? 2. What is the…

Q: In the circuit below, if resistor R1=19.4ΩΩ, and resistor R2=77.32ΩΩ, what is the equivalent…

A: Resistance 1, Resistance 2, Since the resistances are in parallel, their equivalent resistance is…

Q: The diagram below shows two resistors connected to a 20.-volt battery. 5.0 Ω 15.0 2 ww 20. V If the…

A: 54. The voltage drop across each resistors in series connection can be calculated using the ohms…

Q: 0.12 A R1 R3 50 20 V R2 100 R4 120

Q: Four resistors of 1000 ohms each are arranged in a square. What is the resistance across either…

Q: Let Us Apply 1. A triangular array of resistors is shown in Figure 11. What current will this array…

Q: . Based on questions 2, 3, and 4, what happens to the current in a circuit as the resistance…

Q: 1. What happened to the voltage across the resistance box as the current through it was increased?…

A: Part (1): Introduction: Write the relation between potential difference and current. According to…

Q: 2. In the circuit diagram shown on the right, find the currents through each of ww the three…

Q: 2. Create an illustration of a parallel circuit that connects a battery and five resistors in five…

Q: Suppose that the current I (amperes) in an electrical circuit is related to the voltage V (volts)…

A: The relation is given by the Ohm's law V = I r where, V is the voltage, I is the current and R is…

Question

20
30
12V
4
50
ww
10
FIGURE 2
12. For the circuit in FIGURE 2, determine the current in
the 1-2 resistor.(2.8 A)
the 3-2 resistor. (1.2 A)
the 4-2 resistor.(0.90 A)
i.
11.
...
iii.
ww
B.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

. All of the electrical outlets in a room are connected in a single parallel circuit (Figure 7.38). The circuit is equipped with a 20-A fuse, and the voltage is 120 V. (a) What is the maximum total power that can be supplied by the outlets without blowing the fuse? (b) How many 1,200-W appliances can be plugged into the sockets without blowing the fuse?
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . A power supply is connected to two bare wires that are inserted into a glass of saltwater. The resistance of the water decreases as the voltage is increased. Sketch a graph of the voltage versus the current in the water showing this type of behavior.
Integrated Concepts A light-rail commuter train draws 630 A of 650-V DC electricity when accelerating, (a) What is its power consumption rate in kilowatts? (b) How long does it take to reach 20.0 m/s stalling from rest if its loaded mass is 5.30 1()4 kg, assuming 95.0% efficiency and constant power? (c) Find its average acceleration. (d) Discuss how the acceleration you found for the light-rail train compares to what might be typical for an automobile.
A student in a physics lab mistakenly wired a light bulb, battery, and switch as shown in Figure 21.44. Explain why the bulb is on when the switch is open, and off when the switch is closed. (Do not try this-it is hard on the battery!)
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . Make a sketch of an electric circuit that contains a switch and two lightbulbs connected in such a way that if either bulb burns out the other still functions, but if the switch is turned off, both bulbs go out.
(a) Haw much power is dissipated in a short circuit of 240-V AC through a resistance of 0.250 ? (b) What current flows?
Nichrome wire is used in some radiative heaters. (a) Find the resistance needed if the average power output is to be 1.00 kW utilizing 120-V AC. (b) What length of Nichrome wire, having a cross-sectional area of 5.00mm2, is needed if the operating temperature is 500°C ? (c) What power will it draw when first switched on?
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . Six resistors, all having the same temperatures and compositions, are each attached to a battery with voltage V to form a simple circuit. The resistors have different lengths, l, but the same diameters. Rank the circuits according to the current that flows through the resistor from smallest to greatest. If two (or more) circuits have the same current flowing, give them the same ranking. Explain the rationale you used to establish your rankings. Circuit 1: l = 2 cm; V = 3 V Circuit 2: l = 2 cm; V = 6 V Circuit 3: l = 1 cm; V = 3 V Circuit 4: l = 1 cm; V = 6 V Circuit 5: l = 3cm; V = 2 V Circuit 6: l = 3cm; V = 6 V
A 120-V circuit in a house is equipped with a 20-A fuse that will b1ow if the current exceeds 20 A. What is the smallest resistance that can be plugged into the circuit without causing the fuse to blow?
Integrated Concepts Cold vaporizers pass a current through water, evaporating it with only a small increase in temperature. One such home device is rated at 3.50 A and utilizes 120 V AC with 95.0% efficiency. (a) What is the vaporization rate in grams per minute? (b) How much water must you put into the vaporizer for 8.00 h of overnight operation? (See Figure 20.42.)*******
Integrated Concepts (a) An aluminum power transmission line has a resistance of 0.0580/km. What is its mass per kilometer? (b) What is the mass per kilometer of a copper line having the same resistance? A lower resistance would shorten the heating time. Discuss the practical limits to speeding the heating by lowering the resistance.
Integrated Concepts (a) An immersion heater utilizing 120 V can raise the temperature of a 1.00 102 -g aluminum cup containing 350 g of water from 20.0°C to 95.0°C in 2.00 min. Find its resistance, assuming it is constant during the process. (b) A lower resistance would shorten the heating time. Discuss the practical limits to speeding the heating by lowering the resistance.