For the circuit shown find the impedance phase angle Z (in degrees) i = 0.02 sin(157t +40) V=2547.4 sin(157t-50) Z

Q: Determine the phase difference between the two waves v_1 (t)=10 sin( 377t-30) V v_2 (t)=10 sin(…

A: Given data, Voltages are given as,  v1t=10sin377t-300 V.,v2t=10sin377t+900 V.

Q: 4. A full-wave bridge controlled rectifier has an AC input of 120V rms at 60Hz and 2012 load…

A: Given:  Full-wave bridge controlled rectifier having,Vsrms=120 V,f=60 Hz,R=20 Ω,α=40°

Q: C [H.W3]: For the circuit shown below; find vo? R₁ = 1KR²₂ R₂ = 2K₁r R₂ = 3 Kr R₁=9kr Ans: Vo= 6v₁…

A:

Q: Seccion 1 Seccion 2 6.9 kV/115 kV 115 kV/13.8 kV Seccion 3

A: Given data Base complex power; Sb=100 MVA Voltage ratio of Section 1; 6.9 kV/115 kV Voltage ratio of…

Q: Question 1: Reduce the block diagram shown below to a single transfer function, T(s) = C(s)/R(s).…

A:

Q: 6 A TISIM V₁40 0 11 Use the node-voltage method to find v₁ and v2 the circuit in Fig. P4.11. Figure…

A:

Q: Capacitor bank energisation causes current and voltage transient operating states. Thus, the maximum…

A: Given Line to line voltage = VLine =6.6 kV System frequency =fs =50 Hz capacitor kVA rating is =kVA…

Q: If Fig 1 is to be converted to a T network, find Lb (in H). L₁-3.17H, L₂=6.1H, M=0.49H. (Give answer…

A:

Q: For the Low Pass Filter in figure 1, develop a differential equation for the voltage, Vout, based on…

A: Given the Low pass filter,

Q: While constructing a Bridge rectifier, the designer mistakenly has swapped the terminals of D3 as…

A: “Since you have posted multiple sub parts,we will provide the solution only to the first three sub…

Q: Solve for the mesh current 11, then give its magnitude (in Amperes). Use V-28V. (Give answer in 3…

A:

Q: The identical current is I = 5mA, internal resistance Rs = 250k. If the load resistance is RL = 10k,…

A: Given that  Current I1 = 5 mA Internal Resistance Rs = 250 kohm Load resistor RL = 10 k ohm

Q: V₁ 502 www 10 Q2 R al₁ + (Unit is not required. If your calculation yields a whole number, do not…

A: We have to find out the h parameters for given circuit .

Q: X(t) = AS (2Tyt +Q) : Asalw²+0) Ladibide be lause of the good by Inlogadany. Soul wale اعلی core…

A: Please refer the attached images for the complete answer

Q: Electric vehicle charging: Developing efficient and convenient charging infrastructure for electric…

A: Electric vehicle charging:

Q: v(t) = 32 i (t) = 10 sin (377€ -3²) A =320 cor (377 +30°) V NOTE: D a) Find the load impedance b)…

A:

Q: 2 Cπ 2π α 2 SVm² sin wt² dwt

A:

Q: (a) Using Boolean identities, simplify the following expression as much as possible. F = ((BC) +…

A: The Boolean expression can be simplified by using the Boolean identity and demorgans law. The logic…

Q: TOPIC: COMBINATIONAL CIRCUIT What is a half-adder? Write its truth table. Design a half-adder using…

A: Since you have posted the multiple questions so we are supposed to answer 3 questions only. In the…

Q: Two coupled coils have self-inductances of 500 mH and 750 mH, respectively. If the coefficient of…

A:

Q: 1. For the circuits shown below, if A=∞, Calculate a) The overall input resistance, Rin b) The…

A: An Electrical circuit and A=∞,  To find: a) The overall input resistance, Rinb) The output…

Q: Find the mesh currents 1₁, 12, and 13. 2va 10 V ( Given Variables R1 2 ohm R2 2 ohm R3:1 ohm R₁ ww…

A:

Q: Problem 1 ; (t) = 5 sin (40€ +15°) v (t) = 50 cos (yot) i) Find load Impedance ii) Find the complex…

A: (1). given that       circuit has voltage source   v(t ) =50cos(40t) = Vmcos(ωt)        current…

Q: CONVERT TO SFG

A:

Q: 3. Given the frequency response below, determine the output response y(t) resulting from input x (t)…

A: Fourier transform:-

Q: Q1/ Answer by True or False and correct the false sentence: 1- The microcontroller is an embedded…

A: Note: As per Bartleby guidelines we are supposed to provide solution for first sub three questions…

Q: (c) For the RLC circuit: 1. What frequency (in Hz) will make the inductive impedance cancel the…

A: Expressions of Inductive and Capacive reactances are given below.

Q: (a) A load receives 400 V through a transmission line. The line current is 20A. The power factor is…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: 2.16 Determine V, in the circuit of Fig. 2.80. 9V ( Figure 2.80 For Prob. 2.16. 692 www Vo 292 ww +1…

A:

Q: 40 Ω Ci Μ 10Ω + 50 Ω www 20 Ω 60 V Figure 6.1 RC Circuit + 2 / V + C

A: The solution is given below.

Q: Vs1 R₁ ia R3 ww ic R₂ You are correct. Your receipt no. is 157-2141 ? Submit Answer Incorrect. Tries…

A: Given data Vs1=127 VVs2=68 VR1=6 ΩR2=50 ΩR3=15 ΩR4=23 ΩR5=12 Ω We have to determine the value of the…

Q: Find the Fourier transform of the function f(t) = (1, -b < t <b (0, otherwise

A: In this question We need to determine the Fourier transform of the given signal.  We know Fourier…

Q: • Draw the circuit diagram to implement the expression x= (A+B+CB + CD)

A: It is given that: x=A+B+CB¯+CD

Q: For the op amp circuilt in the given figure, suppose vs 10u0 V. Find 0 for t> 0. = 10 kQ www 10 kQ…

A: We need to find out the voltage across capacitor for given circuit .

Q: Enter in the Voltage response as a numerical answer in a+bj format if R1=1122, R2=802, X1=9N, X2=4N,…

A:

Q: What is the RMS value of the following signal? v(t) = 10 cos(400t + 45°) V 7.07 V 4.24 V 10 V 5V

A: Given data, Signal is given as, vt=10cos400t+45° V.

Q: Q3. Find the current across the inductor from -∞ <t<∞o? 15V t = 0 poto m 75Ω www 250 2H

A:

Q: 4. Using a Karnaugh map, simplify the function F (A, B, C, D) = Σ (0, 2, 3, 6, 7, 8, 10, 11, 12,…

A:

Q: For the circuit shown determine Vx V2 5V- R4 1k 11 0.02 A Vy

A: We need to find out the voltage across the resistor .

Q: 150 , Z02 50 , and For the transmission line system in Figure 2, and for the values of Z01 1 =…

A: Transmission Line:Z01=150ΩZ02=50Ωl=0.357 λ1To find SWR=?

Q: 1. A sequential circuit is defined by the following characteristic equations: Q1+ = x’Q1 + xy Q0+…

A: Since you have posted multiple questions, we will provide the solution only to the first question as…

Q: a stepper motor  travel 90º in 0.2s and operate at a pulse frequency of 3000 pps. What is the…

A: Given, Stepper motor is traveling 90° in 0.2 seconds. Pulse frequency= 3000 pps We need to find the…

Q: Q3. A large industrial plant receives 3-phase electric power from the local utility. The following…

A: Note: Only active power will be available in purely R Load Only Reactive power will be available in…

Q: Two 60Hz alternators are driven by shunt motors. The shunt motors have speed-load droop…

A: Please refer the attached images for the complete answer

Q: A power system has 200 buses including 40 generator buses. For the load flow analysis using…

A: Given data, Total number of busbar n = 200. Number of generators = 40.

Q: Find the voltage Vy. What is the power delivered or absorbed by the dependent source? 29ip 500Ω Ν…

A:

Q: A three phase half-wave-controlled rectifier has voltage source equal to 230V supplies a load of 5kW…

A: Given: In this question, the given details are, A three phase half-wave-controlled rectifier has…

Q: Consider the continuous-time signals depicted below. Evaluate the convolution integral: m(t) = f(t)…

A:

Q: The dimensional equivalence of the quantity "momentum OMIT! Ob-ML²T2 OCMLT the fundamental…

A: Momentum is given by formula, Momentum = Mass×Velocity.

Q: The step response of a time LTI system continuous is given by (1-e-t )u(t). For some unknown input…

A: In this question We need to determine the input if output is given.  We are solving this problem…