Answered: For the circuit shown find the…

Engineering

Electrical Engineering

For the circuit shown find the impedance phase angle Z (in degrees) i= 0.02 sin(157t+40) 17 2517 Asin(157+ 501 Z

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.11MCQ: The power factor for an inductive circuit (R-L load), in which the current lags the voltage, is said...

See similar textbooks

Related questions

Q: Question 2 A supply voltage V (t) = 24 sin(4000nt) [V] is applied across a R-L-C circuit shown…

A: it is asked to draw phasor diagram for the supply voltage, the voltage across R, the voltage across…

Q: What logic functions is performed in a NOR gate? Explain?

A: The given transistor-based circuit will perform NOR logic. Based on the input to the transistor the…

Q: A loop is a closed current path in a circuit. 2) A node is a junction of two or more current paths.…

Q: The waveforms of two supply voltage signals V₁1 and V2 are shown below. V₂ ^^^ a) Does V₂ lead or…

Q: Assuming the dioder to be ideal is the for the output to be clipped, the impot volta figure Vp must…

A: It is given that:

Q: L... loss, in terms 1.7. For a two winding transformer, derive an expression for the total ohmic…

A: Solution: For a two winding transformer,derive an expression for total ohmic loss in terms of…

Q: 9:00 M 2 A capacitor and a resistor are connected in parallel to a 120-V, 60-Hz line. The resistor…

A: Answer: Given that The resistance R=40 ohm The capacitance C=132.6 μF

Q: A 3-phase, 50Hz overhead transmission line 100km long has resistance/km/phase 0.1 2, inductive…

A: It is given that: f=50 Hzl=100 kmR=0.1×100=10 ΩXL=0.2×100=20 ΩY=0.04×10-4×100=4×10-4 SVR=663=38105…

Q: Lecture 5 P5.1. For the full-wave rectifier with active load Vrms=120 V, frequency f-60 Hz, load…

A: It is Given that: The frequency f=60 Hz The resistance R=5 Ω Vrms=120 Vω=2πfω=2×3.14×60ω=377 radsec

Q: 2. Consider the interconnection shown in Fig. 2. a) What value of a is required to make this a valid…

Q: The aggregated supply and demand for a particular hour of a day-ahead market of a two-sided auction…

A: Given: Supply: Cs=10+0.2V+0.3V2 Demand: Cd=100-0.3V-0.02V2

Q: A power amplifier delivers 50 W output at 50% efficiency. The ambient temperature is 25°C. If the…

A: Given: A power amplifier delivers 50 Watts power at 50% efficiency. The ambient temperature is 25o…

Q: 51. W In the circuit of Figure P21.51, determine (a) the cur- rent in each resistor and (b) the…

A: In this question We need to determine the current in the each resistance and voltage across the 200…

Q: Convert the following boolean expressions to their standard expanded form. Show all steps and…

A: In the given questions we need to find the standard expanded form of the given Boolean expression.

Q: Consider a negative unity feedback control system KG (s) = - K(s + 1) s² +4 Apply the seven steps…

Q: From schematic # 1 please provide the following calculated values: Rt: it: Pt: 11: 12: 13: 14:

A: The required parameters can be calculated by using the resistance reduction techniques and current…

Q: Find the equation of the time waveform v₁ (t). v₁ (t) 3 V -2 s v₁ (t) 10 s A 6 V t

A: In this question we need to find the expression for the given waveform.

Q: a. Determine the peak output voltage for the bridge rectifier in the Figure. b. What minimum PIV…

A: Given: A full wave bridge rectifier circuit, To find: a) Peak output voltage. b) Minimum peak…

Q: If Vin=5V what is the value of Vout Number

A: The given circuit diagram is a voltage-follower circuit. The circuit produces the output the same as…

Q: R₂ = 1.2 kn D₁ Si, rg 2 02, TR = 220 kn R₁ D₂ Given: R₁ = 2 k SAIN E D₁ R₂2 R3 = 6.8 k E 10 V D₂:…

Q: 33nF 27 k www +1₁ 10 k www 10 k Vo Opamp is 741 with Vcc = 15V and VEE = -15V What is the frequency…

A: Answer : given that a astable multivibrator circuit with VCC = 15 V and VEE = -15 V resistance R2 =…

Q: 15. In measurement of impulse voltage by using a resistance divider, its low voltage side is…

A: Given, Input impedance, Zin = 1 MΩ, and, Characteristic impedance, Zo=75Ω

Q: Find the unknown quantities for the circuit below using the information provided. E + RT 2 A 6Ω 12…

Q: An LC circuit has an inductance of L mH and a capacitance of (5.87740x10^-3) mF. At one instant the…

A: Given, Capacitance C = 5.87740 × 10-3 mF Charge Q = 8.636× 10-3 mC Voltage…

Q: E = 100 V, R₂ = 19 kN, RB = 82 k, Capacitor = 77 μF. The capacitor starts fully discharged. The…

A: The required parameters can be obtained by analysing the circuit at t before 0 and after zero.…

Q: 3. Calculate the A B C D constants for a 275 kV overhead line of length 83 km. The parameters per…

A: Solution of question number 3

Q: Basics & Theorems The simplified form of the Boolean expression Y = (ABC + D) (ĀD+ BC) can be…

A: Given: Boolean expression, Y=A.B.C+DA.D+B.C

Q: Q2\ A continuous-time linear control system is described below, where u, x. and y are the input, the…

Q: Find the periodic time for the following wave forms, (a) 60Hz ( b) 1000Hz

Q: (2) Derive the Laplace transform for the following time functions: (a) tu(t) (b) t'u(t) (c) e…

A: Given, a) tu(t) b) t3u(t) c) e-atcosωtut

Q: In the circuit shown below, the voltage VR equals to 30 V. The value of current i is V i 3Ω elle m…

A: Given- Voltage- VR=30 V To Find- The value of current.

Q: 4. An ac amplifier has a mid-band voltage gain of 250 and the cutoff frequencies are f₁ = 30Hz.…

A: In this question We need to determine the gain at the cut off frequencies. Also find the upper cut…

Q: Plot an Excel surface model of a Gaussian light intensity distribution at z = 539 mm, whereby the…

A: To plot an Excel surface model of a Gaussian light intensity distribution at z = 539 mm, whereby the…

Q: 2 V For the circuit given above, 202 ΤΩ ww 302 352 ww 2 A ww 202 a. Calculate the node voltages. b.…

Q: Calculate the duty cycle and output voltage for i. Buck converter ii. Boost converter iii.…

A: Given : Vdc=12 Vf=3 kHzTON=0.2 ms

Q: Vi (+) - LI elle L2 5 domain? - transfer function? R₂ R - Vo(+)

Q: 5) An antenna radiates an electric far-field given by ет jkr E(r)= -sin(0) 4лr Express this field in…

A: Given data The expression for the electric in the spherical coordinates system is given by;…

Q: The tight upper bound for the worst case to selection sort a sequence is O(log2 n). True False

A: In this question we need to verify the given statement is true or false

Q: solve for the computed values only, please show complete solution.

A: Applying nodal analysis to the above given circuit calculate the node voltages By using those…

Q: given the following system of equations -9x-5y+z=14 4x-3z=27 7x-y+z=2 forming the augmented matrix…

A: Given that System of linear equations as follows. -9x-5y+z=14 4x-3z=27 7x-y+z=2

Q: Topic Maximum Power: Ro is the RL here. The variable resistor RL is adjusted until maximum power…

Q: What resistance, RL will provide the highest power in the circuit? What is the resultant power and…

Q: What are some cool/interesting applications of Fourier Series or Fourier Analysis that are not…

A: To explain: Applications of Fourier Series or Fourier Analysis that are not mentioned a lot.

Q: How many time constants does it take to deliver 89 % of the found energy?

Q: 90 degrees 2 A capacitor and a resistor are connected in parallel to a 120-V, 60-Hz line. The…

Q: Based on the given figure, a) what is the peak input voltage (V1) b) what is the peak output…

Q: www 6Ω ww 592 2 A 5 V 15 92 ww 8 V +|₁F 10 Ω ww 10 V 452 452 www Determine the power supplied by…

A: Given Data: A DC resistive circuit with, Branch currents and Node voltages which are assumed as…

Q: Give the other types of low-pass filters. Draw the circuit and frequency response of each.

Q: Find the zero-input response for the following linear difference equation: y[n + 2] + 3y[n + 1] +…

A: I have written this solution as handwritten solution. Hope you find the perfect solution.

Q: A graded indexed optical fiber has a parabolic refractive index profile (a = 2). If the fiber has a…

A: According to the question, a graded indexed optical fiber has a parabolic refractive index profile…

Question

.....

For the circuit shown find the impedance phase
angle Z (in degrees)
i = 0.02 sin(157t +40)
V=2547.4 sin(157t-50)
Z

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The power factor for an inductive circuit (R-L load), in which the current lags the voltage, is said to be (a) Lagging (b) Leading (c) Zero
Given V T = 100V∠0 , Z 1 = 1000 + j1500 Ω, Z 2 = 3700 + j0 Ω, and Z 3 = 2000 – j1000 Ω, allconnected in series. Finda. the total impedanceb. the total currentc. phase angle of the circuit
Impedances Z1 = 5.83 at angle of -59 deg. and Z2 = 8.94 at an angle of 63.43 deg. are in series and carry an effective current of 5A. Determine the Power and power factor of the circuit indicating if it is leading or lagging.
-A impedance of Z = 15∠ 35° ohms is connected across a source with a voltage of 207.846 sin (157.08t) volts. For the circuit, what is the frequency in hz?
A three-phase 50 Hz double circuit as shown below, assumed that the line is completely trasposed. The diameter of each conductor is 2.76 cm. Find the capacitance to neutral in uF/km b O O O O - -- 6m 6m 6m bm bm
Circuit elements with an inductance of 200 mH, a capacity of 50 μF and a resistance of 10 Ω connected in parallel. if we apply average value of 198 V sinusoidal AC voltage to the system . Find the line current, impedance and phase angle of the circuit. (Take Frequency in 60 Hz)
a) total impedance [ZT] in polar form, b) current [ I ] in phasor form, c) resistor voltage [VR] in phasor form, d) power factor [p.f.] indicating whether leading or lagging
For the circuit below in phasor form with R1 = 13Ω, X1 =-7, A=8 and B=39, calculate the average power dissipated in the circuit in Watts.
Van = 4160 cos (t - 49°), Vbn = 4160 cos (t - 289°), Vcn = 4160 cos (t + 191°)" A POSITIVE PHASE SEQUENCE B NEGATIVE PHASE SEQUENCE
For the given circuit below a. Calculate E, IR, and IL, in phasor form.b. Calculate the total power factor (leading or lagging) and the average power delivered to the circuit.c. Draw the admittance diagram and draw the phasor diagram of the currents Is, IR, and IL, and the voltage E.
Calculate for the: a.) Impedance b.) Current in Z3 and Z5
estimate the value of equivalent impedance