For the circuit shown in Fig. 2.2 calculate (a) the circuit resistance, (b) the circuit current, (c) the p.d. developed across each resistor, and (d) the power dissipated by the complete circuit. R, R2 330 2 1.5 k2 470 2 1. V, V2 V3 24 V Fin 22

For the circuit shown in Fig. 2.2 calculate (a) the circuit resistance, (b) the circuit current, (c) the p.d. developed across each resistor, and (d) the power dissipated by the complete circuit. R, R2 330 2 1.5 k2 470 2 1. V, V2 V3 24 V Fin 22

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter9: Current And Resistance

Section: Chapter Questions

Problem 55P: A 20.00-V battery is used to supply current to a 10-k resistor. Assume the voltage drop across any...

See similar textbooks

Related questions

Q: 10.0 0 2.5 V Figure shows a circuit whichlconsists of a battery connected in series with a 10.0 (2…

A: In the given question We have given a circuit in which voltage is 2.5volt and internal resistance is…

Q: What is the output voltage in the circuit below if Vin =2.0 V (DC)? Your answer should be in Volts…

Q: A heater has a resistance of 400Q when the potential difference across it is 12V. If this same…

Q: In the network shown, Find the voltage V and the current Is, for lo = %3D 5 A. 6 V Is Select one: a.…

A: We will be applying Kirchoff's laws. Also ,in the left loop the direction of current I1 is wrong,…

Q: What is the CEFF of the following circuit if C1 is 10µC, C2 is 2.5µC, and C3 is 0.30µC?

Q: If two resistors with resistances R, and R, are connected in parallel, as shown in the figure, then…

Q: Calculate the power dissipated in the metal wire when the current Which graph was obtained at the…

Q: Find the voltage of the battery in the circuit above if R1 = 4 ohms, R2 = 4 ohms R3 = 4 ohms and the…

A: (b) 17 V

Q: Answer the following Problems: 1. An 800 mA current is passing through a resistor. The voltage…

Q: Find the resistance of an iron rod 2 cm in diameter and weighing 3 kg. Find the readings of the…

A: 5) Resistivity (ρ) of Iron=9.70×10-8Ω-m The density of Iron =7.86g/cm3 Mass of…

Q: 3. In Fig. 3, the resistances are R1 = 20.0 W and R2 = 40.0 W, and the ideal batteries have emfs…

Q: 1. For the circuit below ,find the total resistance RT R, 102 R2 40Ω

A: If two resistances R1 and R2 are in parallel combination then total resistance of the combination…

Q: An electric device draws 7.10 A at 240 V. If the voltage drops by 10 % , what will be the current,…

Q: Calculate the output voltage of the circuit of Figure 1, if Vi = -2.0 V and V2 = 0.8 V. 330 kn 33 kn…

Q: R1 R2 R3 R4 ere would be a decrease in the current through the circuit if the third resistor is…

Q: An initially uncharged 5.26x10^-4 capacitor is connected to a 6.65x10^5 Ohm resistor in series. A…

A: Given C = 5.26*10-4F Resistance R = 6.65*105ohm voltage V = 10.6 volt we have to find out time…

Q: A current of I = 3.7 A passes through the circuit shown, where R = 78 Ω. (a) In terms of R, I, and…

Q: For the circuit below, calculate the potential difference VA - VB and Vc - VD. Notice that the…

Q: The combined electrical resistance R of two resistors R, and R. connected in parallel, is given by…

Q: The temperature coefficient of resistivity a is based on a reference temperature T, of 20.0°C and…

A: Given that, ρ = ρo (1+α T -To ) →1 'ρo' resistivity at T = 20°c…

Q: A 12.0 (V) battery is connected to a resistor network as shown below in fig (i). What's the…

Q: 3.6 O 106 J, what does it cost to operate a window- type air conditioning for one hour if the unit…

Q: Digital thermometers often make use of thermistors, a type ofresistor with resistance that varies…

A: Given,

Q: I = ? Iz = ? 1. = ? 0.2 Q 0.2 Q 0.2 Q la = ? I = ? I; = ? 0.2 0 0.1 2 0.1 2 0.2 Q I = ? I; = ? 0.3 0…

Q: If two resistors with resistances R, and R, are connected in parallel, as in the figure below, then…

Q: The current in the circuit below is 1.5 A, and the bulb has a resistance of 6.0 . Compare the…

A: Given data: Current (I) = 1.5 A Resistance of bulb (R1) = 6.0 Ω Required: Current through battery,…

Q: The charge on a capacitor in a circuit is modeled as Q(t) = Qmax cos (ωt + ϕ). What is the current…

A: It is known that current is defined as rate of flow of charge through a circuit . So, when a charged…

Q: 40µF 30µF 20µF 30uF 7.5 V •What is the equivalent capacitance? • What is the charge of the circuit?…

A: 40 µF and 20 µF capacitors are in parallel therefore there equivalent capacitance can be calculated…

Q: In the circuit below, if the battery in the circuit below is 3V, resistor R1=277N, and resistor…

Q: For the circuit shown in Figure P2.24, determinewhich components are supplying power and which…

A: When an amount of positive current enters to the terminal having a positive charge of the battery…

Q: The formula for the power output P of a battery is P- VI - RI“, where V is the electromotive force…

A: (1) Given : P = VI -RI2 R = 0.5 ohm V = 10 volts At maximum value of power…

Q: In the circuit shown, R,=R2=R, and ɛ, =. The power dissipated in R, is 40 W. Does battery ɛ, supply…

A: For the given circuit we need to find the power absorbed or supplied by the battery ε2.

Q: A piece of material with a square cross-section measuring 1 mm on each side has a length of 1 m.…

Q: The three bulbs below have the resistances RA 16 Q, Rg = 17 Q, and Rc 18 Q. If the emf of the…

A: Given data The resistance value is RA = 16 Ω The resistance value is RB = 17 Ω The resistance value…

Q: For the circuit shown in Fig. 2.45, find: (a) vị and v2, (b) the power dissipated in the 3-kN and…

Q: For the circuit portion shown in Figure 5, the emf's and internal resistances of the two batteries…

Q: Answer the following Problems: 1. An 800 mA current is passing through a resistor. The voltage…

A: The resistance of a household water heater is 25 ohm. Current is 4.40A.

Q: A 15 V battery is connected in parallel to 3 resistors, resistor A has 8 ohms, resistor B of 5 ohms…

A: Battery is of 15 V Equivalent Resistance in parallel 1/Req = 1/R1 +1/R2 +1/R3

Q: A 160-µF capacitor charged to 450 V is discharged through a 31.2-k 2 resistor. (a) Find the time…

Q: What is the maximum voltage that can be applied to a 10-k Ω resistor rated at 1/4W ?

A: Given data The resistance is given as R = 10 kΩ. The Power is given as P=14 W=0.25 W. The…

Q: Find (a) the equivalent resistance of the circuit in Fig- ure (b) the potential difference across…

Question

ssignment6.pptx (65.9 KB)
supply.
For the circuit shown in Fig. 2.2 calculate (a) the circuit resistance, (b) the circuit current, (c) the p.d.
developed across each resistor, and (d) the power dissipated by the complete circuit.
R,
R2
Ra
330 2 I
1.5 k2
470 2
V2
V3
Fin 22
bome
ort sc
delete
nun
loc
+ backspace
8
6
4.
R
ento
K
pause
M
B

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . Explain what current, resistance, and voltage are.
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . A solid metal cylinder has a certain resistance. It is then heated and carefully stretched to form a longer, thinner cylinder. After it cools, will its resistance be the same as, greater than, or less than what it was before? Explain our choice.
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . A 20-A fuse in a household electric circuit burns out. What catastrophe could occur if it is replaced by a 30-A fuse?
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . A power supply is connected to two bare wires that are inserted into a glass of saltwater. The resistance of the water decreases as the voltage is increased. Sketch a graph of the voltage versus the current in the water showing this type of behavior.
Two 3.0 μF capacitors are in series with a resistor of 150 Ω, a battery of15.0 V, and an open switch. What is the time constant of the circuit? Whatis the equation for the current as a function of time?
By measuring the currents and times and then draw the current vs time graph using the measurementat the lab for ε =8 V, R=1M Ω and C=60μF. What is the current at t=50 s? values obtained after the experiment:I0=8μAApproximate time until current becomes zero= 180 s
What is the sensitivity of the galvanometer (that is, what current gives a full-scale deflection) inside a voltmeter that has a 1.00-M Ω resistance on its 30.0-V scale?
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . There are two basic methods for connecting more than one electrical device in a circuit. Name, describe, and give the advantages of each.
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . Saltwater contains an equal number of positive and negative ions. When saltwater is flowing through a pipe, does it constitute an electric current?
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . If AC in a circuit can be thought of as a wave, which kind is it, longitudinal or transverse?
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . Alternating current with a frequency of 1 million Hz flows in a wire. What in particular could be detected traveling outward from the wire?
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . Make a sketch of an electric circuit that contains a switch and two lightbulbs connected in such a way that if either bulb burns out the other still functions, but if the switch is turned off, both bulbs go out.