For the circuit shown in figure, potential difference of 12 V is applied across AB C 20 E 30 20 20 Lwww wwwwww 32 D 20 F 12 12 V Current drawn through cell is A. O M-Vl=3 V more than 1 correct. i will give full rating.

Q: The current flowing in resistor R in the circuit shown in figure is l, + I A R 12 E1 Select one: O…

A:

Q: +10V lo 4.3k2 В - 100 H OVo | 0. I µF li B Vio- 0.1 µF Zi E Zo 390k2 +10V

A: we need to find out a) IC, IB currents and re value.b) hfe and hie values.c) Zi, Zo, Av and Ai.d)…

Q: . Determine the equation of current for the circuit shown below with L = 2H, R = 60 and a battery…

A: In this question,  We need to determine the current equation in. The inductor and capacitor?  We…

Q: Construct the circuit below on breadboard. 2K Ohm RS 3KOhm R1 R3 V1 1.5K Ohm 3.3KChm 10V R2 R4 1.5K…

A: To find current in all the branches we will first determine the current supplied by battery. For…

Q: 2. (30 points) For the circuit below, do the following. a) Find the voltage vx. b) Find the voltage…

A: This problem is from basic of circuit.  Solution is given below

Q: 1. Determine V1 in the circuit shown below. Vx + 10 kN 5 kN Vx 25 V V1 4

A: Given circuit,

Q: For the circuit shown in the figure shown below, find the node voitages: 100 www 2V 2A 20 7A ww ww

A: applying  KCL super node  and KVL in middle loop gives two equations, solving equations will give…

Q: 1) For a circuit shown in Figure, (a) find the currents I, I, and Iz. (b) find the potential…

A: In the circuit 2 independent voltage sources are consist.  Find the current in the each branch.…

Q: 60MH : For the mutuar electric circuit shown in figure beside if Vs-10cos100t Volts, write the set…

A:

Q: Through the mathematical method determine: 1. ID 2. VS and VDS 3. VG and VGS 4. VP 18 V Ip 2 k2 750…

A: We need to find out voltage and current for given circuit.

Q: For the given circuit , VDD = 15.8 V and VGG= 4V Calculate the value of VDs. VDD 2 kn D IDss= 10 mA…

A: Find the value of VDS  ?  VDD=15.8V VGG= 4V

Q: 17. What is the potential of the node 'A' in the following circuit? 20 ww 152 IDEAL I I in

A: Modifying the given amplifier for finding the voltage at point A we get  In the given diagram, the…

Q: (d) 1.50 A Figure 3: Circuit for 50V: E402 3A Problems 6 and 7 Given the circuit of Figure 3, answer…

A: Find voltage V1 and current is for the given figure 3 circuit using nodal analysis.

Q: Determine the currents and voltages across all the resistances indicated in the circuit shown in…

A: Given:

Q: For the circuit shown in the given figure the current I is given by mit 2Ω ww 6 A 3Ω 3 V ww

A: According to the question we have to find the value of the current I.

Q: H.W. 2.13: Find i, v, and the power dissipated in the 6- Oresistor in Figure below. Solution:i= 6 A,…

A:

Q: In the circuit shown in Figure, V = 1.61 kV, R1 = 2.44 kΩ, R2 = 4.58 kΩ, R3 = 5.00 kΩ and R4 = 2.33…

A:

Q: Q2) Non – sinusoidal voltage applied on 102 resistance with consumed power 521.25 watts and the…

A: We need to find out current and effective voltage for given power .

Q: 3.4 Find the currents and voltages in the circuit shown in the following figure: 20오 오 40 ww SV JV V…

A:

Q: Given that V = 24 Volts, Find E in the circuit below. R= 62 R, = 42 R=162 R, = 12 24 V R; =42 %3D40…

A: A resistive network with known resistance values is given. The voltage across one of the resistors…

Q: R ll + + 12 cos 3t V Vo 4 sin 2t A 10 V If we would like to use Superposition to solve for vo in the…

A: In this question we need to find a voltage Vo considering only the contribution of Dc voltage…

Q: 1. Using KCL, write the write the expression ²3↑ V3 a V4 + Vs Is Vs+ V1_ is 16 d 2. Using KVL. Write…

A:

Q: (c) Find the total power consumed in the circuit of Figure QI(c) by using mesh/loop analysis. 230 V…

A: This question belongs to circuit theory . It is based on power calculation in the circuit . It is…

Q: Note: The indicated total potential difference in in the circuit as shown in the figure below is 45.…

A: Resistance is the obstruction offered to the path of current. The element or the electrical…

Q: und the equivalent resistor at the terminal of the voltage source then find the power delivered by…

A:

Q: For the circuit shown in Figure Q1 (c), find the unknown quantities (Voltage E, Currents I l2, I3…

A:

Q: Q.2/A/ Determine all currents and voltages in the circuit shown in Figure 2. Q.2/B/ For the circuit…

A: In the circuit, series parallel resistance combination consist.  Find the current in the circuit.…

Q: etermine the voltage Vo in the circuit in Figure below. I 3 k2 VA 2000 I %3D 12 V+V 5 k2 V.

A: The given circuit has only one independent loop. The current and voltages in it can be estimated by…

Q: 9) Using mesh analysis, determine the current through R1 for the circuit shown in Figure Ry = 10 R2…

A:

Q: (A): Two resistances (R and 252) are connected in series with each other, and then they connected to…

A: Given two resistances R and 2ohm having a potential difference of 12V The current flowing is 2A. To…

Q: For the circuit in Figure 3: a) Find Ipo, VGsq and Vp. b) Plot the Q point. 9 22 V 2.2 ΚΩ Ipo VGSTH)…

A: Given circuit is MOSFET,  VGS(Th) = 3V   Find the drain current, Vgsq and Vd.  Plot the Q point

Q: The currents ia and i in the circuit shown in figure on below are 4 A and -2 A, respectively. Find…

A:

Q: For the circuit below find V S MIN when Given: R1 = 1000 & RLOAD 4700 Vs R1 RLOAD Vz Vg Assume:…

A: R1=100 ohm Rl=470 ohm Vz=4.7 V Pd=500mW

Q: In the circuit of Figure, (a) Use nodal analysis to determine v1 and v2. (b) Calculate the power…

A: Given,

Q: Q.2 (a) (i) If the power supply voltage to the Wheatstone bridge in Figure Q.2a(i) increased, what…

A:

Q: Determine the currents and voltages across all the resistances indicated in the circuit shown in…

A: Since there are 2 different problems, as per the guidelines, the first problem will be solved.

Q: For the network on figure 3, determine; a. VG b. IpQ c. Vp and Vs d. VDSQ o 20 V 2.2 k2 910 k2 Ioss…

A: According to the question we have to find the value of VG, IDQ, VD, VS and VDSQ.

Q: The current flowing in resistor R in the circuit shown in figure is l, + I A 12 E2 E1 D Select one:…

A: Current using KCL

Q: H.W. 2.7: current supplied by battery in the circuit shown in Figure by using Kirchhoff's' laws.…

A: Kirchhoffs Voltage Law or KVL, states that “in any closed loop network, the total voltage around the…

Q: For the circuit shown in Figure 1 with VS = 1.7 V, determine: a. IDQ b. VGSQ c. IDSS d. VD e. VDS 18…

A: The Field Effect Transistor (JFET) is a unipolar device and a three-terminal voltage-controlled…

Q: 4. Determine the total circuit resistance, total current through R1, in the circuit below: E = 12V…

A: The given circuit is, Where E=12 V, R1=1000 Ω and R2=200 Ω.

Q: 2. Analyse the circuit given in figure 2. Denote every assumption and theorem you use. (B=100) +15 V…

A: BJT Circuit Ic  Operating region?

Q: rallel Circuits: the Unknown Resistor value R1 and Currents 1, 12 & 13 on the circuit below. 1.0 kN…

A: In this question we will find unknown resistnace and currents...

Q: 752 70.2 300 a d• 502 1252 40.2 902 Figure 2.2

A:

Q: 1) For a circuit shown in Figure, (a) find the currents I, I,, and lz. (b) find the potential…

A: We will assume voltage at node b as V and voltage at node a is zero as it is grounded. We will apply…

Q: For the following circuit, Vsrc=1.5 V and Rload=225 Q. What is the power sourced by the DC voltage…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: For the configuration shown in Figure Q1: (a) Determine the total resistance, RT. (b) Find the…

A:

Q: Calculate the load resistance (R ) if the maximum power supplied to the load resistor (Pmax)=200…

A:

Q: Q3.1. An electrical network is shown in the figure 1 w 10V RLOAD Figure 1 Determine: Norton's…

A:

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.