For the consecutive first-order reaction without reverse reactions, assume that k₁ = 0.01000s-¹ and k₂ = 0.1000 s ¹. If [A]o = 0.100 mo L-¹, find the value of each concentration at t = 10.00 s and at t = 100.0 s.

Q: e 4.5:An oil containing 2.55 mole per cent of a hydrocarbon is stripped by running the oil down…

A: L = oil moles = 100 kmol G = steam moles = 4 kmol x1 = 0.0255 , x2 = .0005 y = 33x yo=0

Q: يا أصدقائي، كل يوم أكتشف أن الفراغ يزيدنا خيبات، والانشغال يزيدنا إنجازاً. كلما زادت الضغوط…

A: this is an urdu literature that needs to be translated

Q: Consider a mixture of 2 moles of 1-propanol and 8 moles of water at 1 atm (760 mmHg) (a) What would…

A:

Q: Water -Bo C CC14 D 2B.9 Analysis of a capillary flow meter. Determine the rate of flow (in lb/hr)…

A: Diameter of the capillary = 0.01 in Density of the manometric fluid, CCl4 = 1.594 g/cm3

Q: Air oxygen (A) dissolves in a shallow stagnant pond and is consumed by microorganisms. The rate of…

A: a. To derive a relation for the steady-state oxygen concentration distribution in the pond b. Obtain…

Q: A batch reactor is charged with 11.1 kmol of sulfur dioxide and 6.3 kmol oxygen, which react…

A: Mole of SO2 =11 kmol Mole of O2 = 6.3 kmol Reaction  SO2 +1/2 O2 = SO3

Q: 4. The figure below shows a Px diagram for a binary system (component 1 and component 2) at 480 K.…

A: Px diagram of a binary mixture is given. Px diagram represents the distribution of components in…

Q: What is the equilibrium constant expression for the following reaction? SO₂(aq) + 4H+ (aq) →Cu(s) +…

A: Given reaction SO2  +4H+  →Cu +2H2O  +SO42-

Q: 10 kg of Phenanthrene is to be burnt with supplied air which is 30% less than the requirement. Find…

A: given = 10 kg of Phenanthrene air is 30% less than the requirement.  To find = air which is 30% less…

Q: In a laboratory drying test with a solid material the following relation for the falling rate period…

A: Relation of moisture content with time in falling rate period is, dXdt = -0.8 X - 0.05…

Q: Draw the equlibulim curive when X > and y = 33x ? 1-32x 0.05*102 2 0.1 16² 0.2 16² 0.4 x 16² 1 x 10²…

A: Y = 33X1-32X

Q: Use the enthalpy changes given in the data below to calculate the enthalpy change for this reaction:…

A: there is chemical reaction given and their enthalpy of formation is given at 298 k We have to find…

Q: A heat exchanger

A: for a heat exchanger, Flue gas flowrate = 750 kmol/hr hot flue gas in: T1=400 C = P1=1atm flue gas…

Q: Hydrogen gas is diffusing through an unglazed neoprene rubber with a wall thickness of 50 mm at 30°C…

A:

Q: Required information NOTE: This is a multi-part question. Once an answer is submitted, you will be…

A: Gaseous propane is burnt with excess air.

Q: A cylindrical gas tank with a total volume of 0.1 m³ is initially filled with oxygen to a pressure…

A:

Q: The following are all principles used to control particulate matter, except a.  electrostatic…

A: To identify which of the given four principles is NOT used to control particulate matter

Q: Air with a volumetric flow rate of 6 m³/min, enters to a room having 180 m³ volume and leaves the…

A:

Q: 02: A sphere of diameter 10 mm, is initially in equilibrium at 672 K in a furnace. It is suddenly…

A: Diameter of sphere = 10 mm Temperature of sphere = 672 K Temperature of air = 292 K Convective heat…

Q: A) In an attempt to make the membrane process more time efficient, you want to operate the same…

A: A)At a higher flowrate we need the membrane process more time efficient Find-Set of experiments to…

Q: hould be the overall composition of the mixture? ) Suppose you have 2.0 moles of component 1 and 2.0…

A:

Q: A chemistry graduate student is studying the rate of this reaction: NH,OH(aq) →+NH, (aq)+H,O(aq) She…

A: An aqueous reaction is given as, NH4OH → NH3 + H2O The concentration of reactant NH4OH is measured…

Q: Consider a heterogeneous gas-phase catalytic reaction: AB(g)→A(g)+B(g) (Catalyst) The surface…

A: Catalytic heterogeneous gas phase reaction is given, AB(g) + S ↔ka-1ka Ab*S…

Q: Calculate the steady-state substrate and biomass concentrations in a continuous fermenter that has…

A: Given,  Flow rate, F = 8 L/h volume , V= 25L limiting substrate concentration, S0 = 2000 mg/L Ks =…

Q: Your company was appointed as a consultant to purify chloroform (up to 99 mole%) from solution…

A: Distillation is a separation process in which the light key components are separated from the heavy…

Q: One hundred g-moles per hour of liquid n-hexane at 25°C and 7 bar is vaporized and heated to 300°C…

A:

Q: 1. The solubility product, Ksp, is not strongly influenced by pressure. 2. The solubility product,…

A: Since you have posted multiple questions, we will provide the solutiononly to the first five…

Q: Prepare a graph of the plotted points for the given drying data. All moisture are in erms of free…

A:

Q: Question 5. The basic chemical reaction involved in a typical wet process for SO₂ removal (emission…

A: SO2 is removed by the wet process by reacting with (NH4)2SO3.

Q: 16.18 For the gas-phase reaction 2NO₂ + F₂ → 2NO₂F, the rate constant k is 38 dm³ mol-¹ s¹ at 27°C.…

A:

Q: 12.1- 1. Equilibrium Isotherm for Glucose Adsorption. Equilibrium isotherm data for adsorption of…

A: Glucose adsorption from an aqueous solution to activated alumina is given as   Find Which isotherm…

Q: 1. Write down the reaction rate laws for each of the reactions given below: 1/5A + 2B + C + 3D A+…

A:

Q: Please answer for the following questions The following figure is the Lead-Tin Phase Diagram of…

A: Composition of the mixture is, Sn = 40 wt % Pb = 60 wt% Temperature = 150 0C

Q: For a unit cube containing a dispersion of 2nd phase particles with radius r the number of particles…

A: Number of particles as the function of radius and f.

Q: Estimate the activation energy and pre-exponential factor for a first-order decomposition reaction…

A:

Q: The following acid-base reaction occurs spontaneously in the gas phase at 25.0 °C: NH3(g) + HCl(g) =…

A: Given reaction is acid-base reaction which occurs spontaneously. We have to predict the entropy…

Q: of

A:

Q: A solder batch is made by melting together 71 g of a 40:60 Pb-Sn alloy with 56 g of a 60:40 Pb-Sn…

A: Total mass of Pb = 71*0.4 + 50*0.6 = 58.4 g Total mass of Sn = 71*0.6 + 50*0.4 = 62.6 g Wt% of Sn =…

Q: (b) 5.00 mol of an ideal gas expands adiabatically against a constant external pressure of 1.00 bar.…

A: Given: n = 5 mol of an ideal gas, Pext = 1 bar = 105 Pa Pi = 5 bar = 5×105 Pa and Ti = 298 K The…

Q: If a chemical reaction has a negative AH and a positive AS, then A) it will be spontaneous at all…

A: given that  ∆H<0∆S>0

Q: 26.20 The data provided in Figure 26.7 are based on the diffusion of O₂ into SiO₂ formed from the…

A:

Q: A distillation column is being used to separate a mixture of benzene, toluene, and cumene. The feed…

A: The composition of feed is The mole fraction of benzene, z1 = 0.4 The mole fraction of toluene, z2 =…

Q: What is the water What is the water % volume when VH20-15.8 cm³/mol? Ans.: 6% In molar fraction when…

A: Given = VH2O = 15.8 cm3/mol To find = water % Volume For this, we have to draw a vertical line from…

Q: Calculate the heat required to raise the temperature of a 4.535 kg (10 lb) roast containing 15%…

A: Mass of roast, M = 4.535 kg Composition of protein in roast = 15% Composition of fat in roast = 20%…

Q: The molar enthalpy (kJ/mol) of a binary liquid mixture at T and P is given by H=150x1+65x2+…

A: The given expression for the molar enthalpy of a binary liquid mixture (1 and 2) at constant…

Q: A distillation column is to be used for separating n-butane and n-pentane where the feed (F) mole…

A:

Q: Phase Transformations Assignment 7 2. Apply Gibbs phase rule at points A, B, and C given in the…

A: Phase diagram represents the distribution of component in different phase with different conditions…

Q: Pure hydrogen gas at 2.0 atm abs pressure and 27 °C is flowing past a vulcanized neoprene rubber…

A: Thickness of rubber slab = 5 mm Pressure of hydrogen gas=  2 atm , or 202.65 kPa Temperature = 27o…

Q: y 200 12 Case 1 90 1:4 90 12 f₁²t T Units in mm Units in mm Case 2 Figure 3 200 X X

A:

Q: Consider a single "cell" model. The cell contains a liquid with known initial concentration of a…

A: