For the given circuit, find voltage V using Superposition theorem. 85 15V4 12 reell +f 1022 2052 20v/30 10 AL26 +iv- wwww 522 lon los ↑ 8A L60

Q: ) Find Find the power factor of a circuit that absorbs 1.5 kW for a 120 V input voltage and a 16 A…

A: Note: We are authorized to answer one question at a time, since you have not mentioned which…

Q: In the system shown in Figure P5, an incident wave of voltage V+ strikes the discontinuity from…

A:

Q: How can you tell that a hologram is a true three dimensional image and that those in 3-D movies are…

A: A hologram is a true three-dimensional image because when the image is viewed from different angles…

Q: 14.3.6 - What field is sent in period 8 of an I2C message? ACK The read/write bit The STOP condition…

A:

Q: If the absorption coefficient of silicon is 0.05 pm-1 at 860 nm, find the penetration depth at which…

A: Given, The absorption coefficient of silicon, α=0.05 μm-1 At wavelength, λ=860 nm And,…

Q: B) Show that the system shown in Figure (3) is equivalent to

A:

Q: Which of the following is an effective tool to determine directly the conductor surface equation?…

A:

Q: 1. Solve the circuits below. Vs b) Vs www R1 ww R2 ww R2 Load R₁ R₂ Total Load R₁ R₂ R3 Total…

A:

Q: In the following circuit, what is the equivalent resistance seen by terminals a and b? Select one:…

A: Given circuit,

Q: In a specific multiplexer, 4 select lines are present. Estimate the number of inputs present in the…

A:

Q: A current of 8.2 A is maintained in a single circular loop having a circumference of 80 cm. An…

A: Given data, Number of loop N =1  Current flowing I=8.2 A Circumference 2πr=80 cm Magnetic field B=2…

Q: (b). With an appropriate diagram, describe the operation of a current to voltage converter.

A: Note: We are authorized to answer one question at a time, since you have not mentioned which…

Q: Calculate the equivalent resistance of the following circuit: 12 v 10 www R1 10 R2 10 R3

A: Given circuit:

Q: In the figure, these three resistors are connected to a voltage R, source so that R2 = 5.5 N and R3…

A: The required parameters can be calculated by using resistor reduction techniques and by using the…

Q: What is the z-transform of: 3nu(n)

A:

Q: ) Obtain the truth table of the following functions, and express each function in sum-of-minterms…

A:

Q: If the baud rate for a 64-QAM signal is 1000 bauds/sec, what is the bit rate? Select one: O a. 4000…

A: If the baud rate for a 64-QAM signal is 1000 bauds/sec, what is the bit rate?

Q: A dc shunt motor runs at 900 rpm from a 460 V supply when taking an armature current of 25 A.…

A:

Q: In the circuit below, what is the value of the current 13? A 25 Ω F 0.52 A O 0.19 A O 0.71 A O 0.25…

A:

Q: A trigger pulse is applied to the sweep generator every 10 ms. Compute the amplitude of the voltage…

A: A trigger pulse is applied to the sweep generator, Given data Time (t) = 10 ms = 10 * 10-3 sec…

Q: What is the self-inductance of a circuit in which there is induced emf of 100 volts when the current…

A:

Q: Determine lE, BDc and pc for a transistor where lg = 30 µA and Ic = 1.5 mA.

A: Given: A transistor with, Base current, IB=30 μA Collector current, IC=1.5 mA

Q: Design a basic wide-band, RC band stop filter with a lower cut-off frequency of 300Hz and a higher…

A: Given here a RC band stop filter with lower cut-off frequency of 300 Hz and a higher cut-off…

Q: b) Two voltage waveforms are given in Fig. 1. Sum these two voltages using Op-Amp Summing Amplifier…

A:

Q: 7. Given the am signal below, determine the original signal, vs that was amplitude modulated using…

A:

Q: Design an 8-4-2-1 BCD code converter to drive a seven-segment indicator. The four inputs to the…

A:

Q: Q-3A: A line shaped into an arc of radius R = 2 cm and two straight infinitely-long segments carries…

A: Given data, The curve part radius R=2 cm   =2×10-2 m The current flowing through all the segments,…

Q: (1) Determine the output voltage of the DAC (digital-to-analog converter) if the input is…

A:

Q: What is true about the current through each resistor in the circuit below?  If the resistances are…

A:

Q: Q 1  You are hired as Maintenance Engineer for Pakistan Accumulator Ltd., the company that…

A: The Given company is hired as Maintenance Engineer for Pakistan Accumulator Ltd., the company that…

Q: Calculate the reactive power absorbed by the load shown below when its impedance is 34+j46 and Ix =…

A:

Q: For the series R-L-C circuit of Figure Q4: (i) Calculate the total impedance Zr for the frequencies…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Find the line and phase voltage if Vcn= 30<50 V. Assuming ACB sequence

A:

Q: In the circuit below, what is the reading of the voltmeter (round off to the nearest whole number)?…

A: To find voltage across 15 ohm resistor

Q: Formulate Ybus matrix for the power network given in figur The relevant pu line admittances are…

A: We have been asked to formulate Ybus matrix of the power network shown in figure. The network has…

Q: A non-sinusoidal voltage consists of a fundamental and a third harmonic. If the effective value of…

A:

Q: A 1.31-coulomb and 1.01-kilogram particle is going to be launched at an initial velocity 4.39 meters…

A:

Q: a. Show that for the PMOS transistor to operate in saturation, the following condition must be…

A:

Q: Problem 2) Determine the output time function. y(t), from the convolution integral y(t) =…

A: According to Laplace transforms

Q: NMOS transistor are given below. What are the values of Kn and VTN for this transistor? Is this an…

A:

Q: A sensor requires 30 s to indicate 90% of the response to a step input. If the sensor is a first…

A: Given: c(t)=90%=0.9  t=30s

Q: Two bidirectionally infinite line charges exist in vacuum. One has a charge density of -5 nC/m at x…

A: Given data: First charge density  λ=-5 nC/m  =-5×10-9  C/m Located point x = 0 , y = -6 Second…

Q: e following problem must be solved analytically, without the use of mathematical formulas or…

A: Given data, Cross sectional area A=5 cm2 =5×10-4 m2 Flux density B=108 T RMS voltage V = 120 V…

Q: In the circuit below, what is the value of 11? A 30.0 V F O 1.77 A O 0.23 A O 1.00 A O 1.54 A ↑ 6.0…

A:

Q: Determine the ideal voltage gain for the circuit shown in the following diagram.

A: The circuit is as shown in figure, In circuit there 2 Operational Amplifier and both are connected…

Q: In a certain transistor, the emitter current is 1.5 times larger as the collector current. If the…

A: Given, In a certain transistor, emitter current is 1.5 times of the collector current. IE=1.5IC…

Q: Consider a conductor of length 95 millimeters and inner and outer diameters 7.06 millimeters and…

A: Given data, Length of conductor l=95 mm = 0.095 m Inner diameter r1=7.06 mm = 7.06×10-3 m Outer…

Q: Find the magnitude and phase of the bandpass filter circuit below by using MANUAL CALCULATION. Then,…

A: The given circuit is shown below. We need to find the magnitude and phase of the band-pass filter…

Q: (1) Determine the output voltage of the DAC (digital-to-analog converter) if the input is…

A:

Q: 2. The variable resistor R in the circuit is adjusted until it absorbs the maximum average power.…

A: In order to find the value of R and maximum average power Find the Thevenin's equivalent voltage…