For the network shown in Figure 1 10V a) Determine the total resistance, RT. b) Find Is, IR2 and IR4. c) Find voltage VRS and VR7. R2 E ww 2k R1 www 1k R9 ww 1.5k www R3 8.2k www R5 www 6.8k R4 4.7k www R6 3.9k R7 5.1k www R8 9.1k

Q: The PIC 16F84A microcontroller has analog I/O pins. a. False. b. True.

A:

Q: A bandpass filter has a center, or resonant, frequency of 50 krad/s and a quality factor of 4. The…

A:

Q: Consider the system as shown in the figure below, is you know that the damping factor is 0.5 R(s)…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: A light-seeking control system, used to track the sun, is shown in Figure P1.5. The output shaft,…

A: Given a light-seeking control system. which is used to track the sun. To draw the closed-loop system…

Q: A 200-V, 100 A armature full-load line current, 1000 RPM, shunt DC motor is considered in this…

A:

Q: Find this results using Multisim/Pspice Software,

A:

Q: A transformer has a turn ratio of 15:1. If the primary voltage is 7.2KV line-to-line, the primary…

A: Torque induced in an rotating machine is depends on Rotor magnetic field density  Stator magnetic…

Q: www =10V 500A m 3 w 2 7,8{ 5 F IL (+)

A:

Q: Question 19 The primary function of equipment grounding is to protect individuals interacting with…

A: Choose the correct answer:

Q: A) find the current through each parallel branch in Figure below: A 17:5AL30- HE 0000 60

A: it is asked to find the current in each branch of given circuit

Q: Explain the on-load operation of a single phase iron core transformer. Draw the corresponding phasor…

A: To understand the concept of on-load operation of transformer we will understand the flux-current…

Q: Find the state-space representation of the network shown in Figure (b)if the output is VL(t)

A:

Q: Q³: For the convolutional encoder shown below, draw the sate diagram and the table, if you know that…

A: Given: A convolution encoder,  Code rate = 1/2, To find: Draw state table and state diagram.

Q: The drawing shows two situations in which charges are placed on the x and y axes. They are all…

A: Given the two situation of charge configeration  distance between the charge and origin is 5.40 cm

Q: Problem 7- circuit Using the principle of superposition, express vo in terms of v/ and v2 for the…

A: In this question We need to determine the voltage Vo using the super position theorem.  We are…

Q: A three-phase line feeding a balanced-Y load has one of its phases (Phase b) open. The load neutral…

A: Types of Fault  LG Fault  LL Fault  LLG Fault  LLL Fault  LLLG Fault

Q: Illustrate with some example what is allasing The continuous time signal x (t) = cos (1000x azt) is…

A: Introduction - Aliasing is a significant phenomena that has a significant impact on the field of…

Q: For amplifier in Figure 1 ID=0₁3 mA, ^₁ =^₂=0.15 V-1 and CL = 94 pF.F T the gm₁ = 6ms, gm₂=1ms

A:

Q: An eight-pole, 24 KW, 100 V, DC machine has a duplex LAP-wound armature which has 64 coils with 10…

A:

Q: in the inverse fft  we multiply after the first stage only right? but in the fft we multiply in…

A: To draw: Butterfly structures of FFT and IFFT of 8-point.

Q: connected balance load of 0.667+ j0.111  ohms, the secondary voltage (line to neutral) would be:…

A:

Q: A 4.4kΩ resistor has 12V impressed across its terminals. Find the current through the resistor and…

A: Given: Resistor, R = 4.4kΩ and Voltage, V= 12V. Needs to calculate the current, I, and Power…

Q: Find the current through the 300 ohm resistor 300 Ω 10 mA 500 Ω M W i + 600 Ω M 120i₁ 100 Ω

A:

Q: What is v3 in the following circuit 12 V της ν www 20 Ω 10 Ω 6V +) 40 Ω 309

A:

Q: Compare the nested and the NPC topologies in terms of the blocking voltage for the switches employed…

A: We need to compare NPC and Nested topology .

Q: ➡ Find the current through the 300 ohm resistor 300 Ω 10 mA 500 Ω W + 600 Ω ww w 120/₁ 100 S2

A: In this question We need to calculate the current in the 300 ohm resistance.  We are solving this…

Q: A 480V, 60 Hz, 6-pole, three-phase, delta-connected induction motor has the following parameters:…

A: Introduction Thevenin's Theorem: It states that any linear electrical network can be reduced to an…

Q: In the circuit given below, R=4 22. Find V₁, V2, and v3. 5 A VI R 8 Ω W 292 ww 22 3 A 292 The value…

A:

Q: Convert the following binary numbers to decimal numbers: a. 1010 b. 1000000 c. 11001100

A:

Q: Where do gates and circuits differ?

A: Example of basic logic gate AND Gate OR Gate NOT Gate NAND Gate NOR Gate

Q: Q-6 b, Consider a negative unity feedback system with forward path transfer function K G(s) = where…

A: Given- A negative unity feedback system with forward path transfer function. Gs=Ks+as-bs+c, To Find-…

Q: Calculate the Thevenin equivalent for the given circuit.

A: The given circuit is shown below. We need to calculate the Thevenin equivalent for the given…

Q: Problem 5: Complex numbers z₁ and z2 are given by Z₁ = 52-60° Z₂ = 4445° a. Determine the product…

A:

Q: Three-bus power system with generation at bus#1. The loads at buses 2and 3 are as marked on the…

A: Introduction Gauss-Seidel Method: One of the simplest iterative methods is the Gauss-Seidel (G-S)…

Q: A 185-V, 100 A armature full-load line current, 1500 RPM, shunt DC motor is considered in this…

A: It is given that: V=185 VIA=100 AN2=1500 RPMRA=0.25 ΩRf=20 ΩNf=2000 turnsRadj=165  Ω and 440 Ω

Q: Three identical Y-connected loads, each having a resistance of 20 2 in parallel with an inductor,…

A: Given,Resistance, R=20 Voltage, V=400 VFrequency, f=50 HzAbsorbed power, P=8 kWPower factor,…

Q: Find the Fourier series of the function shown in Figure below. Where f(x) = x+n if -n<x<П and f(x) =…

A:

Q: R₁ W C₁ Ao - Vout The circuit shown above is used to amplify a sinusoidal input by a factor of 5. If…

A:

Q: Determine the center frequency and bandwidth of the bandpass filters in Fig. 14.88. 19 ww HH 1 H (a)…

A: Given: In this question, the given details are, To determine the center frequency and bandwidth of…

Q: Problem 7: find the phasors of the following time function a. v(t) = 9 cos (wt -) (V) b. v(t) = 12…

A:

Q: The transfer function of a plant is given in the image. Design a leading compensator per root locus…

A: Answer:   To design a forward compensator for the given plant using root locus method in MATLAB, you…

Q: A 200-V, DC motor is connected as a cumulatively-compounded DC motor. Its characteristics are given…

A:

Q: Find the average power absorbed by the resistor R R = 10 S MY 50/0°V (rms) O a. 75 W O b. none of…

A:

Q: The maximum transferred average power to a load without restrictions calculated in terms of the RMS…

A:

Q: What allows controlling the gain in an ECG machine? O a Driven-right-leg circuit O b. Oc O d.…

A: d.micro controller  One of the common approaches  for the  automatic gain control (AGC) of the ECG…

Q: Determine the two currents in and 1₂.

A:

Q: B- A Unit ramp is applied to the system shown in the figure below: Find the steady state error of…

A: Introduction: Steady-state…

Q: 220 V SO WZ 120√ 60w W 0.5 R. Vi Find R and VR

A:

Q: B-6-5. Plot the root loci for a closed-loop control system with G(s) K(s +0.2) 3²(5 +3.6) H(s) - 1

A: Given that , G(s)=K(s+0.2)/s2(s+3.6), H(s)=1   We have to plot root-loci.   To plot the root-loci,…

Q: A four-pole, 24 KW, 120 V, DC machine has a Duplex LAP-wound armature which has 80 coils with 10…

A:

Current Division Method

The generalized current divider formula is given by the following relation below,