For the networks shown in Figures (Q1), the switch has been at position "A" for a long time. At t2o, it has been moved to position "B". Calculate the amount of energy stored in the capacitor at t=0 and at t=10000sec.

For the networks shown in Figures (Q1), the switch has been at position "A" for a long time. At t2o, it has been moved to position "B". Calculate the amount of energy stored in the capacitor at t=0 and at t=10000sec.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Figure 1 of 1 Part B We know that the current in the circuit is growing. It will approach a steady…

Q: The switch in the circuit hasbeen in position a for a long time. At t=0, it moves instantaneously…

A: The circuit diagram is shown below: When the switch is at position a, the capacitor can be replaced…

Q: Assume the switch is closed and enough time has elapsed for the circuit to be in "steady-state,"and…

A: In circuit under steady state condition after the switch is closed, the capacitor will act as open…

Q: Q2/ For the network shown in figure (Q2), the switch has been open for a long time before closing at…

A: Given data: L=20 mH

Q: QI/ For the network shown in figure (Q1), the switch has been in position "a" for a long time. At…

A: In steady state, the inductor behaves as short circuit and the capacitor behaves as open circuit.…

Q: QI) The circuit given is at steady state when the switch opens at time t = 0. Determine i(t) for t 2…

Q: A 130-µF capacitance is initially charged to 1160 V . At t = 0, it is connected to a 1-k2…

A: Energy stored in capacitor=12×CV2. We will write expression for for general Expression for voltage…

Q: In the circuit shown in Figure, the switch is activated at t = 0 s for position 2 of position 1,…

A: Case 1: When switch is connected to position 1 Although it is given that switch is connected to…

Q: The capacitor in figure begins to charge after the switch closes at t = 0 [s]. a) What is AVc a very…

A: Once the switch is closed, the capacitor starts charging and the charging of a capacitor takes place…

Q: An electrical circuit consisting of an inductor, L, and a capacitor, C, in series is shown in Figure…

Q: Q2/ For the network shown in figure (Q2), the switch has been open for a long time before closing at…

Q: CONSIDERING THE CIRCUIT OF FIGURE 2. THE INPUT FUNCTION OF V(T) IS THE VOLTAGE PULSE SHOWN IN FIGURE…

A: Capacitor When a voltage is suddenly applied across a capacitor it will take some time to charge the…

Q: R1 R2 3. Given that the battery has a potential of 12 V, resistors R1 = 1N and R2 = 3N, and…

Q: Q1/ For the networks shown in Figures (Q1), the switch has been at position "A" for a long time. At…

Q: The switch in the circuit shown has been in position a for a long time. At t=0, the switch is moved…

A: This problem is associated with a double switching case. CASE-1: Drawing the circuit diagram for…

Q: In the circuit shown in the figure, after the switch is open for a long time, it is closed at t = 0.…

A: after the switch is open for a long time t<0 closed at t = 0. Voltage expression Vc(t) for t…

Q: 1 The switch in the circuit shown in Figure Q1 has be At t = 0, the switch is closed. Based on the…

A: Given

Q: Q1/ For the network shown in figure (Q1), the switch has been in position "a" for a long time. At…

A: In this network shown as per given question, Initial switch at position a for long time. At the…

Q: Q1/ For the network shown in figure (Qi), the switch has been in position "a" for a long time. At…

Q: Q2/ For the network shown in figure (Q2), the switch has been open for a long time before closing at…

Q: 01/ For the networks shown in Figures (Q1), the switch has been at position "A" for a long time. At…

Q: In the figure, C= 0.4 µF, E = 20 V, R1 = 10 k2, and R2 = 15 k2. Initially, the switch S is closed a…

A: At steady state capacitor acts as open circuited , now using voltage division rule calculate voltage…

Q: Consider the circuit shown in the figure, with ε=36.0V,R0=50.0Ω,R=150Ω andL=4.00H. (a) Switch S1 is…

Q: A circuit consists of switches that open or close at t=0, resistances, dc sources, and a single…

A: According to the given problem we will consider a series RL circuit which can be realized as…

Q: Assuming the circuit has reached a DC steady-state condition prior to t=0, determine v(t) for t20. -…

A: Drawing the circuit for the t<0:

Q: The switch in the circuit shown in Figure Q1(c) has been in position a for a long time. At t-0, the…

Q: a) Write the mathematical expressions for vc, VR1, and ic after the switch is thrown into position…

A: Since the question has multiple sub parts , we are answering only the first two parts of the…

Q: For the network shown in figure Q1 below, the switch is closed on to position 1 when t = 0 and then…

A: The circuit shown in the figure is the RC circuit which is DC biased. As the switch move to…

Q: Let be the first-order electric circuit shown in the figure below. It is known that the switch T…

A: The circuit is as shown below,

Q: The circuit shown in the figure consists of ideal batteries ɛ, =20V and E2 =20V, resistors R =6002,…

A: Given circuit, Now, E1+E2-qc+qc-iR=040-2q10mF-dqdt×600=0 By solving above equation, q=q01-e-tς…

Q: 4. Based on the figure above, sketch graphs as a function of time t > 0, when the inductance of the…

A: To solve above question, one should understand the behavior of Inductor and capacitor in DC circuit.…

Q: (b) For the circuit shown in Figure Q2(b), (i) calculate the initial energy stored in the inductor…

Q: In the circuit shown in the figure, after the switch is open for a long time, it is closed at t = 0.…

A: First switch is open t=0s switch on then find Vc(t)

Q: Q1/ For the network shown in figure (Q1), the switch has been in position "a" for a long time. At…

A: To find current through the inductor , first we need to know that , under steady state condition ,…

Q: (b) For the circuit shown in Figure Q2(b), (i) calculate the initial energy stored in the inductor…

A: We need to find current through inductor in given circuit.

Q: Get a state space model for the following electrical system. Make sure to clearly define the states…

Q: For the network shown in figure (Q2), the switch has been open for a long time before closing at…

A: Transient is the time taken for an electrical circuit to settle down to it's steady state from a…

Q: In the circuit shown in the figure, switch S1 is closed and switch S2 is left open. After a long…

A: The storage elements such as capacitors & inductors have the property to store energy across…

Q: In the circuit shown in the figure, switch S is closed at t = 0. a) What is the current in the…

A: Inductor: It is a passive two-terminal electrical component and measured in Henry (H). When…

Q: A circuit with a battery, 2 resistors, a capacitor, and a switch is built as shown in the figure.…

Q: Q1/ For the network shown in figure (Q1), the switch has been in position "a" for a long time. At…

A: For the network, the switch at position a. For. Long time. At time t= 0, the switch moves position…

Q: (iv) Write an expression for i, (t) for t20. (V) What is the total energy stored in the circuit at…

Q: * Question Completion Status: QUESTION 5 t= 0 R1 Vc(t) R3 V1 R2 V2 For the above circuit, the switch…

A: given data:

Q: 1. The switch in the circuit in Figure 1 has been in position a for long time. At t=0, the switch…

A: Given circuit-

Q: b SHOW un c What value does the levěl III lIMU d. The level in the right compartment has risen 6cm…

Q: In the circuit shown in the figure, S, remains closed for a long time and S2 remains open. Now S2 is…

Q: The switch in the circuit shown in Figure Q2 opens at t = 0, find the capacitance value, Cand the…

A: The solution is given below

Q: In the figure below, after sitting for a long time in position a, the switch in the circuit was…

A: The Transient Equation of a series RL circuit is given as: i(t)=ist(t)+itr(t)⇒i(t)=I(∞)+I(0)-I(∞)…

Question

For the networks shown in Figures (Q1), the switch has been at position "A" for a long time. At
t20, it has been moved to position "B". Calculate the amount of energy stored in the capacitor at
t=0 and at t=10000sec.
100 2
1502
A B
ww
t= 0 sec./
30 KQ
60 ΚΩ
50mA(
,500 2
750 Ω)
: 600Ω
IK OA
10/3 F
Ž120 KA
40 ΚΩ
250 2
300 2
Figure (Q1)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 9 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Analysis of Multiple Order System and Steady State Error

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A RL network supplied with 10V battery Find the mathematical expressions for the transient behaviour of vl, iL, VR2 and VR2 when the switched is moved to position 2. Sketch the curves of vL, iL and VR2. Then find How much time must pass before it can be assumed, for all practical purposes, that iL =0A and vL = 0 Volt? PLEASE STEP-BY-STEP STEPI NEED THEM TO STUDY.
Select the forward path gain (M ktop) for the system for the SFG diagram given below
A RL network supplied with 10V battery (a)Find the mathematical expressions for the transient behaviour of vL, iL , vR2 and vR2 when the switched is moved to position 2. Sketch the curves of vL, iL and vR2.A how much time must pass before it can be assumed, for all practical purposes, that iL=0A and vL = 0 Volt?
A 1 H choke has a resistance of 50 Ω. This choke is supplied with an a.c. voltage given by e= 141 sin 314 t. Find the expression for the transient component of the current flowing throughthe choke after the voltage is suddenly switched on.
Let Vs=530tᶾ v, leg t >0 and iL (0) = 1 A, in the circuit shown, at t=0.2s, determine the values of the energy stored in the capacitor and the coil. The circuit is in the attached image.
The structural engineering design section within the engineering department of a regional electrical utility corporation has developed several standard designs for a group of similar transmission line towers. The detailed design for each tower is based on one of the standard designs. A transmission line project involving 50 towers has been approved. The estimated number of engineering hours needed to accomplish the first detailed tower design is 126. Assuming a 95% learning curve, a. What is your estimate of the number of engineering hours needed to design the eighth tower and to design the last tower in the project? b. What is your estimate of the cumulative average hours required for the first five designs?
Please answer this NEATLY, COMPLETELY, and CORRECTLY for an UPVOTE. Consider an RLC circuit with ?=10 ohms (Ω), ?=2 henries (H), and ?=5 ? 10−3 farad (F). At time ?=0 seconds (sec), when both I(0) and ?(0) are zero, the voltage applied is E(?)=100 volts (V), Find the current I(?) in the circuit. Given:R=10 ohmsC=10-3 FL=2 HE=100 VI(0)=q(0)=0
Kindly determine the Norton equivalent of this figure as seen by RL. Please do provide an explanation. Thank you.
A RC network supplied with 40V battery is shown in the following figure: a)Find the mathematical expressions for the transient behaviour of vc, ic and vR when the switched is moved to position 1. Plot the curve of vc, ic and vR. And how much time must pass before it can be assumed, for all practical purposes, that ic = 0A and vc = E Volts? Please step-by-step
For a Second Order Damped system, the damping rate is ζ=0.58 and its natural frequency is ωn=55rad/sise; How many seconds is the peak time in the unit-digit response applied to the system?
The speed with which nerve impulsestravel is determined in large part by the characteristic time constant t = RC of the circuit formed by the resistivity of the axonand the capacitance of its wall. The resistance of a 1.00-mm-longsegment of an axon is 25.5 MΩ. (a) For nerve axons with no protective myelin sheath, the wall capacitance is about 3.14 * 10-10 Ffor each segment of length L = 1.00 mm. Find the speed ofthe nerve impulses given by v = L>t. (b) Many axons are surrounded by a myelin sheath that decreases the wall capacitanceto 1.57 * 10−12 F. What is the speed of nerve impulses along suchmyelinated axons?
Determine the simplest equation based on the image Note : Option D. other option false