For the op-amp shown in the following figure, if R1 = 100 2 and Rf = 1 k2, the overall voltage gain is equal to -------- V₁ O a. -10 O b.-1 O c. 11 O d. 9 Rf

Q: Find the average value of the voltage in the figure 5 V hn ov+ O 1.59 V O 63.7 V O6.37 V O 10.5 V

A: In this question,  We need to choose the correct option determine the average value of output…

Q: 3. A dual-tone multi-frequency (DTMF) system is used to produce signals that represent the dialed…

A: Dual tone multi-frequency (DTMF) is the sounds or tones generated by a telephone when the numbers…

Q: The kVA and kW inputs of 3-phase star connected system are 52 and 25 respectively. The KVAR input is

A: Given: In a 3-phase star connected system, The apparent power, S=52 kVA. The real power, P=25 kW.

Q: 4...

A: Given: Consider the following Simulink diagram: To find: Determine the equation implemented by the…

Q: 13.For an active low RS FLIP FLOP with a HIGH normal output, the value of its S and R inputs,…

A: The Flip-Flop is a device that stores a bit of information. The Flip-Flop changes its state during…

Q: ST 1A Figure 8.3 10 Q2 6 V 222 See Figure 8.3. What is the value of the voltage Vs?

A: Given

Q: circuit comprises a 50 resistor, a 5 mH inductor and a 0.04µF capacitor. Determine, in the s-domain…

A:

Q: 1. When the inputs to an exclusive-OR circuit are alike, the output is binary 2. An exclusive-NOR…

A: Note: We are authorized to answer the first three sub-parts at a time, so we are answering the first…

Q: 4. If the total current is equal to 10A, find the total voltage. VT 102 M 52 n 150 2022 4022

A: We need to find out the total Voltage , we will find out total resistance by using of parallel…

Q: The angle between vector A (2i+3j+k) and ? vector B (i-2j+2k) is 1100 1000 100 2100

A:

Q: 3. Determine 1₁ and 12 using current division. 12 2010 ent from our this 152 2002

A: Given:    Required:  I1 and I2

Q: Series Circuit Measured (Provide all necessary pictures/screenshots from the software.) 1. Connect…

A: DC Power Supply (Vs) = 15 V R1 = 10 ohms R2 = 50 ohms R3 = 75 ohms All the resistors are connected…

Q: A motor in a building for driving pumps is rated at 250 KVA with a power factor of 0.8. If energy is…

A:

Q: A semiconductor with a concentration of electrons 3 x 10¹9/m³ At a temperature of 300 K if arsenic…

A:

Q: 4. An electric dipole is located at the origin and points along the z-axis. The dipole is centered…

A:

Q: For this system The heater is off when Comparator Reference value T Та Error signal (Td-Ta) • TaTd…

A:

Q: Question- Find the maximum power delivered by 1500 kW, 3-phase, star-connected, 4 kV, 48 pole, 50 Hz…

A:

Q: SV (+ un R₁= 10K B = hfe = 50 R3-30KL un VBE = 0.6V b)Find Vce R₂=2012 Rs=6002 VCE V₁ R6 =1001…

A:

Q: n a household during a particular week three 2 kW fires are used on average 25 h each and eight 100W…

A: Given,Fires-Number of fires =3Energy = 2 kWTime =25 hBulbs-Number of bulbs=8Energy=100 WTime=35 h

Q: Compute the average power and the RMS for the signal x(t) = sin(t)

A: In this question we need to find a average power and the RMS value of the signal x(t).

Q: what is the output after 738 pulses?

A: An asynchronous circuit is a sequential digital logic circuit that synchronizes its components…

Q: A single phase 11 kV line with a length of 15 km is to transmit 500 kVA. The inductive reactance of…

A:

Q: 2. Determine the total resistance using delta to wye transformation. Also, find the total current.…

A:

Q: Does the following discrete system have the parameter of memory, y[n] = x[n-1] + x[n] ? O Maybe O…

A: Q.1) Memory system:-  A system is said to be memory system if its output is depends on past or…

Q: SUL A SW2 B 1 2 7486N 3 C Logic function: L1 Record the state in the appropriate space in the Table.…

A:

Q: 5. Determine the total resistance if each Ris 30. RT M

A:

Q: 5A V3 O a. 5v1 Ob. 201 www O c. 5v₁ - 492 202 w www Pi V2 2v3 = -2 5v₂ + 2V3 ww = V2 - 2v3 = 4 Od.…

A:

Q: Example 12.36. A capacitor of capacitance 10 µF has a loss angle of 10° at 50 Hz. Find (i) power…

A: Given: C = 10 μff = 50 Hzδ = 10∘ Find: Power Factor Angle φcPower Factor cosφc

Q: VI. MAXIMUM POWER TRANSFER 10. A. Find R for the maximum power transfer. B. Find the maximum power…

A:

Q: At what frequency will a 0.016 henry inductor have an inductive reactance of 80 ohms?

A:

Q: A coil of inductance 50 mH and resistance 5 ohm is connected to a 110V, d.c. supply. Determine the…

A: In this question,  We need to determine final value of current, current after 4ms and 6ms. We know,…

Q: A 15 nC point charge is at the origin in free space. Calculate V1 if point P1 is located .at P1 (-2,…

A: Here the given option is not matching as per the solution. The detailed solution is given in the…

Q: 4. Determine the node voltages, V₁ and V₂, using nodal analysis. IOA (1) GA 102 M 4822 2 $24₁ (1)…

A:

Q: At a frequency of 1.5 kHz, the open circuit impedance of the length of the transmission line is…

A:

Q: 2. Determine lx. 10A (↑ It iz $2.0 → Ix |↑ Ix $82 lla 452

A: We need to find out current for given circuit , we apply nodal analysis to find out node voltage…

Q: solution: VI 412 super mode. 2√2 www 30v V2 V3- V1 = 22 15 A V3 30 8.2 How did it become like that??…

A:

Q: = 2. An aging battery generating 200e-5t volts is connected in series with a 20 ohm resistor, and a…

A: The required parameters can be calculated by using the series RC circuit analysis and by using the…

Q: A coil takes a current of 2A from a 12V d.c. supply. When connected to a 240V, 50 Hz supply the…

A: Given,Current, IDC=2 AVoltage, VDC=12 VandVoltage, VAC=240 VFrequency, f=50 HzCurrent, IAC=20 A

Q: In decreasing order of experience, the four categories of electrical workers recognized by the…

A: An ACT to protect people and property, establish an electrical administrative board, to license and…

Q: mesh analysis

A:

Q: 1. At 250 K, the activation energy for a gas-phase reaction was determined to be 6.500 kJ mol ¹.…

A: Solution !! The expression in terms of moles for the distribution of molecular energies, nE =…

Q: 1. Sketch the unit step response of the system shown below: + VIE; = 1V + Determine the following:…

A:

Q: 1. A single phase overhead transmission line delivers 4000 kW at 11 kV at 0-8 p.f. lagging. If…

A:

Q: Output data ratio of a 8-bit PCM-TDM system sampling 24 voice channels, comparing these using u-law…

A: A TDM PCM communication system consists of a number of user terminals, a switching network, and a…

Q: Prove the simultaneous relationship mathematically between the steps of the solution in detail:…

A: We need to prove given electron and hole concentration formula .we will use electron and hole…

Q: pov हु 4J lokr ster potr

A: We have to find out the power dissipation by each resistor.

Q: A semiconductor with a concentration of electrons 3 x 10¹9/m³ At a temperature of 300 K if arsenic…

A:

Q: 9. The time constant of the circuit shown in the figure below is A. 25 sec. B. 0 sec. C. .025 sec.…

A: Given data, Circuit diagram is given as,

Q: For the circuit shown in Figure. Determine whether the transistor is in saturation or not. Assume…

A:

Q: If the no load secondary voltage of a 1-phase transformer is 235 V and full load secondary voltage…

A: Given: VSno-load=235 V and VSfull-load=223 V. Required: Percentage regulation of the transformer.

Operational Amplifier

An operational amplifier also called op amp is an integrated circuit or analog circuit that takes input as a differential voltage and produces output as a single-ended voltage. It is an IC that can amplify weak electric signals.An op amp has one output pin and two input pins. The basic role of an opamp is to amplify the voltage difference between the two input voltages. It is also used in filtering or to perform mathematical operations or in signal conditioning.