Compute the average power and the RMS for the signal x(t) = sin(t)

Q: Three identical resistors of 2 ohms are connected in wye. Find the ohmic value of the equivalent…

A: Using relation between resistance in star and delta connection find the value of resistance in delta…

Q: A current of 3.6 A transfers a charge of 375 mC. How long would this take?

A: We need to find out the time for given current and charge .

Q: The resistance of armature winding depends on length of conductor cross-sectional area of the…

A: Concept- The resistance of the armature winding is the value of the ohmic resistance of the copper…

Q: An 8 pole shunt generator has a lap connected armature with 640 conductors. The flux per pole is 50…

A: In this question,  We need to determine the speed in rpm of the generator.  We know Induced emf in…

Q: Wave energy is extracted in Buoy devices by: Using a rotary generator Using its floating part which…

A: Intoduction -  Wave Energy is a non-polluting and renewable form of energy that is produced by the…

Q: Q2/ A / Given the waveform ofx/(t) shown in Figure 2, generate and plot the waveform of: - x2(1) =…

A: In this question we need to plot the given signal.

Q: Calculate the resistance of a load that takes 1,600 watts from a 220 volts source.

A:

Q: DC series motor has an armature resistance of 0.060 and a series field resistance of 0.080. The…

A:

Q: mesh analysis

A:

Q: Make a ladder diagram for the ff. Interlocking Circuit (2 – way Interlock) Automatic Priority…

A: According to the question, we need to make a ladder diagram for the flip flop, Interlocking Circuit…

Q: Find the power factor and apparent power

A: It is given that: vt=160cos377t+100 V V=160∠100 V  Z=60+j40 Ω

Q: 3. The synchronous speed for 3-phase 6-pole induction motor is 1200 rpm. If the number of poles is…

A: Given, A three phase induction motor has, Initial number of poles, P1=6. Synchronous speed, Ns=1200…

Q: Question 1 ( (a) Find the transfer function, G(s)= for the network shown in Figure 1. Solve the…

A: As per Bartleby guideline we need to answer the first question. Kindly repost the rest questions…

Q: S' R' A. From an Active Low SR Latch, Draw the normal and complemented output

A:

Q: A 50 KVA transformer has a core loss of 500W and full-load copper loss of 900 W. The load at which…

A:

Q: In a 3-phase power measurement using two wattmeter method, if one wattmeter reads 2.5 times the…

A: Given,In a 3-phase power measurement using two wattmeter method ,if one wattmeter reads 2.5 times…

Q: For the aluminum pipe shown in figure below (G=27GPa).Determine (a) The torque To causing an angle…

A:

Q: Determine ID1= 15 V C 10 ΚΩ D D₁ KH D₂ ID2= E 5kQ www F 10 V ; VD1= VD2=

A: In this question,  We need to determine the current in diodes and voltage across it.  Assume diodes…

Q: The nature of the characteristic impedance of the line is: a. inductive b. could be any one of these…

A:

Q: State Kirchhoff’s Current Law.

A:

Q: The total resistance of two resistors connected in series is 50 ohms. When connected in parallel,…

A:

Q: Determine ID1= ; ID2= ; VD1= ; VD2=

A:

Q: Diode acts as a short circuit when reverse biased. O True O False

A:

Q: 5. Solve Ix and all the mesh currents using mesh analysis. lov (+) 15V (+ 22 N 1₁ 62 13 72 102 :15 8…

A:

Q: In a 3-phase power measurement using two wattmeter method, if one wattmeter reads 2.5 times the…

A: Given: In a 3-phase power measurement using two wattmeter method, One wattmeter reads 2.5 times the…

Q: What is the equivalent resistance (in 0) seen at the terminal of the 7.5V voltage source? (up to 2…

A: According to KCL, the sum of current entering a node is equal to sum of current leaving the node

Q: In dc machines, armature windings are placed on the rotor because of the necessity for…

A:

Q: 8 The current flowing through a 47092 resistance is 4 A. Determine the energy dissipated in a time…

A: We need to find out the energy for given current and resistance in joule and kwh .

Q: On full load a 300V series motor takes 90A and runs at 900 rpm, the armature resistance is 0.10 and…

A:

Q: A load of 1000 kW at 0-8 p.f. lagging is received at the end of a 3-phase line 20 km long. The…

A:

Q: Problem 20. The current I flowing in a resistor R is measured by a 0-10A ammeter which gives an…

A: Given: Ammeter Measurement range : 0-10A Voltmeter Measurement range : 0-50V Ammeter Reading =…

Q: Question A 50 KVA transformer has a core loss of 500W and full-load copper loss of 900 W. The load…

A: Given- Full load = 50kVA Core loss, Pi=500W , Full load copper loss = 900W . To find- Load at which…

Q: On full load a 300V series motor takes 90A and runs at 900 rpm, the armature resistance is 0.10 and…

A:

Q: An intrinsic germanium has a resistivity of 0.4711 m at room temperature. Find the intrinsic carrier…

A: Given: Resistivity, ρ=0.4711μh=0.19 m2V-sμe=0.39 m2V-s

Q: A coil of inductance 318.3 mH and negligible resistance is connected in series with a 200 resistor…

A: Inductance of coil L = 318.3 mH Resistance R = 200 Ω Voltage V = 240 V Frequency f = 50 Hz

Q: Example 12.36. A capacitor of capacitance 10 µF has a loss angle of 10° at 50 Hz. Find (i) power…

A: Given: Capacitance, C=10 μF. Loss angle, δ=10°. Frequency, f = 50 Hz.

Q: Copper brushes in D.C. machine are used where low voltage and high currents are involved where high…

A: This is a problem of dc machines. The solution is given in the next step

Q: Use mesh analysis to find I₁, I₂ and 13. 1' 15 V +1 I, + Vo§222 4529 12 SA 13 1002 2V0

A: By using of mesh analysis we will find out the mesh current for given circuit

Q: Which of the below statements is NOT True regarding Tidal Power? The primary source for Tidal Power…

A: Given: Tidal Energy

Q: A DC generator has eight poles, wound as lap then rewound as a wave, calculate the electrical motive…

A:

Q: Verify that the closed-loop transfer function T(s) = C(s)/R(s) in terms of parameters a and pressed…

A: Given that: The block diagram is shown below. A continuous time, linear, time-invariant feedback…

Q: A SW1 B SWZ 2 5 6 8 9 12 10 13 or A 0 0 1 1 11 C Logic function: Boolean equation for output, C =…

A: We need to simplify the given logic circuit , we need to fill the truth table .

Q: A DC generator has eight poles, wound as lap then rewound as a wave, calculate the electrical motive…

A: Number of Poles P = 8 Armature Slots Z = 240 Magnetic flux ϕ = 0.04 Wb RPM N = 1200

Q: Find the octal equivalent to 359.325d

A: This is basic problem of conversion in digital electronics.

Q: Determine if the given control system is linear:

A: It is given that: y(t)=[xt+4]2

Q: The primary resistance of a transformer is 0.10 When and its leakage reactance is 0.80 the applied…

A:

Q: 1. Determine Vx. LOV (+ 202 M 202 2VX +- + 52 Ux

A: Given, The circuit is,

Q: + Vs 1A Figure 8.3 10 Q2 6 V 222 See Figure 8.3. What is the value of the voltage Vs?

A: Given circuit,

Q: A dc shunt generator has a critical field resistance of 400 at 1200 rpm. Now if the speed of the…

A:

Q: Choose the correct answer/s. a) Which of the given losses is directly proportional to the square of…

A:

Fourier Series

Most of the incidents studied in the field of Engineering and Science as a function of time. For example, current and voltage are in the alternating current circuit. These occasional activities can be analyzed in the activity components (fundamental frequency and harmonics) through a process called Fourier analysis.