For the truss shown, determine thestress in members AC and BD. The cross sectional area of each member is 900 mm²

Q: What is the capacitive reactance Xc of a 50.0 µF capacitor placed in an ac circuit driven at a frequ...

A:

Q: Using the figure, indicate in the points the energy conversion of the car.

A: As we know that when something is at a height then it contains potential energy and when it comes do...

Q: A.) A 7,300-kg truck runs into the rear of a 1,000-kg car that was stationary. The truck and car are...

A: A)       Given that                       The mass of the truck is (M) = 7300Kg                     ...

Q: icroscope objective with a magnification of 16 is used in a microscope with a magnification of 46. F...

A: GivenA microscope objective with a magnification, mo=16A microscope with a magnification, m=46The oc...

Q: The lens in the figure below is made of glass of index 1.50 and have surfaces with radii of curvatur...

A:

Q: A heat engine is involved with exchange of heat of 1915 J, - 40 J, +125 J and Q J, during one cycle ...

A: Efficiency of a heat engine is defined as the ratio of output work to input heat .

Q: In the circuit below, the ammeter has an internal resistance of 200.00 oh ms. The voltmeter has a se...

A:

Q: A 4.88 x 10-6 C charge moves 265 m/s perpendicular (at 90°) to a magnetic field of 0.0579 T. What is...

A:

Q: Question 1. A 34.5 m length of copper wire at 20.0°C has a radius of 0.25 mm. If a potential differe...

A:

Q: A transverse wave on a string is described by the wave function y=0.12...

A:

Q: A 3.1 kg block, initially in motion, is pushed along a horizontal floor by a force F of magnitude 20...

A:

Q: The diameter of a gas molecule is 2:4 x 1-10 m. Calculate the mean free path at NTP. Given Boltzmann...

A:

Q: Consider a series RLC circuit where R = 651 Q and C = 5.25 µF. However, the inductance L of the indu...

A: According to question we need to find Value of unknown L .

Q: In a certain region of space, the electric potential is given by V = 3 / (5 – x 2). Find the electri...

A:

Q: Determine the charge in each capacitor and the voltage across each capacitor in Circuit B. Given: V3...

A: The charge stored in a capacitor connected to a voltage source is given by Q = CV, where C = the cap...

Q: Taking the wavelength of first Balmer line in hydrogen spectrum (n = 3 to n = 2) as 660 nm, the wave...

A:

Q: At t=0 sa particle is located at 5 m north of the origin, has a velocity of 2.25 m/s south, and is m...

A:

Q: A flat cookie sheet has a length of 35 cm, a width of 22 cm, and a mass of 467 g with the axis of ro...

A: Moment of inertia of any sheet through centre I = (1/12) M(a^2 + b^2)  Where a is length  b us width...

Q: potential

A:

Q: Find the most probable dustance of a 2s electron from the nucleus in a hydrogenic atom

A:

Q: Find the refractive index of the glass in the figure below.  (Take ? = 26°, y = 6.8 cm, and x = 4.7...

A:

Q: Three resistors, RA=4 k N, RB=1.0 N, and Rc=2 N are connected to a battery providing potential diffe...

A:

Q: A conducting rod spans a gap of length L = 0.065 m and acts as the fourth side of a rectangular cond...

A:

Q: A. What would be the extension that the spring undergoes when adding the mass, if we have a spring w...

A:

Q: A wire stretched between two rigid supports vibrates in its fundamental mode with a frequeney of 45 ...

A:

Q: A thin ring of mass 2.3 kg and radius 0.66 m is rolling without slipping along a horizontal surface ...

A:

Q: Consta Part A A0.060-kg tennis ball, moving with a speed of 5.62 m/s, has a head-on collision with a...

A:

Q: star with mass m, period Ti = 30 days, and radius ri = 1E4 km collapses into a neutron star (Links t...

A: Given that                    The initial radius of the stat ri = 1.0×104Km and             Time per...

Q: From the window of a building, a ball is tossed from a height yo above the ground with an initial ve...

A:

Q: Assume that you are riding a bicycle. An applied force of 701 N downward is applied as you push on t...

A: MA = Fo/Fi

Q: The diameter of a gas molecule is 2.4 x 10-10 m. Calculate the mean free path at NTP. Given Boltzman...

A:

Q: What is the force per meter on a lightning bolt at the equator that carries 20,000 a perpendicular t...

A:

Q: Find the image distance and linear magnification for a small object on the optical axis, 20.8 cm fro...

A: Given, Object distance from the lens, u = 20.8 cm focal length of the lens, f = -9.3 cm

Q: uring a transcranial magnetic stimulation (TMS) treatment, a magnetic field, typically of magnitude ...

A:

Q: You would like to create a reflection grating like the one Incident light shown, with an incident an...

A: component of optical Equipment contain of a surface ruled with close, equidistant, and Horizontal li...

Q: A pendulum is pulled to one side until its mass is 15 cm above the reference point. After achieving ...

A:

Q: In an experiment similar to Perrin's, you counted the concentration of suspenc particles in a liquid...

A: We know that we have given that  When observing the suspension at a depth of 9 mm from the bottom of...

Q: A point charge with charge Q1=-4.3 µC is held stationary at the origin. A second point charge wi cha...

A: Work done = change in electric potential energy

Q: Of the graphs below, which accurately shows the relationship of terminal speed of a sedimenting part...

A: When an object falls through a fluid, it attains a constant velocity through its subsequent motion. ...

Q: A microscope objective with a magnification of 15 is used in a microscope with a magnification of 51...

A: Given value--- magnification of objective = 15 . magnification of microscope = 51 . near point = 23...

Q: 6. From the window of a building, a ball is tossed from a height 6 above the ground with an initial ...

A: As per our guidelines we will solve first three subparts for you. To get remaining subparts solved p...

Q: Directions: Describe the relationship between resistance, cross-sectional area and length of the wir...

A:

Q: A copper wire is r = 0.0250 cm in radius and 3.00 m in length, has resistivity ρ = 1.72x10^–8 Ωm, an...

A:

Q: Review Part A The current through inductance L is given by I = In e-t/T. Find an expression for the ...

A:

Q: Calculate the rate of heat conduction through house walls that are 13.0 cm thick and that have an av...

A:

Q: Question 15 The half-life of Unobtanium-118 is 3 days. How many days pass for 800 grams of this elem...

A:

Q: 4. From a speed of 75 kph, a car decelerates at the rate of 500 m/min? along a straight path. a. How...

A: Initial velocity of car u=75 kph=20.83 m/s, deceleration rate of car a=-500 m/min2=-0.138 m/s2 and t...

Q: 3 A 60N bowling ball is lifted 1.5m off of the ground, and held at rest. a. Determine the bowling ba...

A: Given  Weight of ball, W = 60 N  Lifted to height, H = 1.5m and held at rest.

Q: Find the far point of an eye for which a prescribed lens has an optical power of -0.58 d. (b) Find...

A:

Q: A 1.6-μF capacitor is connected in series with a 15.0-kΩ resistor. It is charged by a 5.0 V battery....

A: Given value--- capacitance = 16 micro F resistance = 15 k ohm. We have to find--- time constant?

Mechanical Properties of Solids

There are three types of matter- solid, liquid and gas. Out of them, solids have a rigid shaped and size. The intermolecular forces of attractions in solids are greatest. Mechanical properties are the physical properties of a material which it shows, when it is provided with certain amount of force or load. These properties are to be kept in mind for various purposes. When a force is applied to an object, the object may or may not get deformed depending upon its elastic property. But every time the object develops a restoring force against the force applied. This is commonly known as stress. If the object changes its dimensions due to the force applied it develops strain ( which is the ratio of change in dimension to the original dimension).