For the two-port network shown in Figure (1) below, obtain the Y-Parameters and state whether the network is symmetrical, reciprocal or not? 1₁ -j5 S m 28{ js S HH

Q: How many 40 W cool white fluorescent lamps would be required to have an initial lamp output of 9,600…

A: Given:Power. P=40WOutput=9600 lumens

Q: B- Compare between circuit switching, message switching, data gram packet switching and virtual…

A: Switching : Switching techniques involves a specific message which is to be transferred from initial…

Q: d the Current Io. In figure (2). IMA 2mA Ika m Ika Iy 2KA m In 12 lkn Is 13 lkn 6mA

A:

Q: Find the discrete transfer function of the filter below when R = 250k and C = 80mF.

A: Given: R=250kΩ and C=80 mF

Q: 47. In NPN BJT, .......current is lowest current.

A:

Q: 2. For the Network given on Figure 45, determine VG, VGS, ID, VDS, IE, IB, VD, and Vc. VG 91 ΚΩ 18…

A: Given: Consider the following network: To find: VG, VGSQ, IDQ, IE, IB, VD, VC

Q: Determine the value current supply (IT) in figure (1). Fig.1 lon lons 55 zlor Slov IT 24V VT

A:

Q: R(S) 2s³+4s²+s+5 C(s) 3s4+7s3+2s²+3s+8' Given the transfer function G (s) write the corresponding…

A:

Q: 5.6 The generalized circuit constants of a transmission line are A = 0.93 + j0.016 B = 20 + 140 The…

A: Given data : Parameters values of given transmission line is shown below,…

Q: (/Find the current through the 10 ohms resistor by Maxwell theorem? t 30.03 100 150 60 V

A: In this question,  We need to determine the current in the 10 ohm resistance as shown the circuit.…

Q: A 3-Phase 10Kva, 400 V, 50Hz star connected alternator supplies a rated load at 0.8 power factor…

A:

Q: 1. x[n] contains 128-point samples obtained through sampling continuous-time signal x (t) with…

A: Continuous time signal is define the real line time. It is also called a analog signal. that is…

Q: a) Briefly explain about True, Reactive, and Apparent Power.

A: (a) To explain about True power, reactive power and Apparent power

Q: 6-How much charge passes through a cross section of a conductor in 60 seconds if a current value is…

A: Given: Current, it=5t mA Time, t=60 s

Q: Consider an a.c circuit supplied by 220V at 50Hz. The circuit consists of only two inductors, L1 and…

A: Capacitive reactance inversely propotional to frequency  Inductive reactance directly proportional…

Q: ARC. Circuit has the Following trans For Function & YUS) RUS) # 2. 105+4 For step input retis 20,…

A:

Q: of all free spaces in the parking system, then tell the user where to park. If all free spaces are…

A:

Q: A 132 kV line, three phase system delivers 70.7 MVA of a balanced delta load of power factor 70.7%.…

A: The ratio of the working power is called a power factor. It is measured in a kilowatts and kilovolt…

Q: hot matter! [Q2] The probability distribution for the discrete random variable in the table below.…

A:

Q: 29. A series R-C circuit takes a current whose equation is i = 0.85 sin (754t + */4) when connected…

A: 29. (a) The current and the voltage of the circuit are known, and the impedance of the circuit is…

Q: Q1: For the Instrumentaion amplifier shown below, drive the equation of v, and i,. R₂ ww CHI A₁ A₂ R…

A: 1)  To derive the equation of output voltage and current for instrumentation amplifier

Q: 2. A balanced 3-phase a-b-c system with line-to-line voltage Vab = 20820⁰ V supplies to a balanced A…

A:

Q: Problem 26 O 27. (11) Consider three capacitors, of capacitance 3100 pF, 5800 pF, and 0.0100 F. What…

A: This question belongs to circuit theory . It is based on the concept of equivalent capacitance .…

Q: Determine the value current supply (IT) in figure (1). Fig.1 lon lons 55 zlor Slov IT 24V VT

A:

Q: Q2. Figure QI The aircraft concept uses quickly turning jet nozzles to steer the airplane. The…

A: 2) To determine the system stability using Routh's stability criterion

Q: Apply Norton theorem to calculate the current in 6 2 resistance for the circuit in figure 3 2000 + 5…

A: In this questions we need to calculate the current through 6ohm resistance by Norton theorem.…

Q: Q₁) find from fig-1 below in state space in phase-variable form, Draw the signal flow gra $²+2 +6…

A:

Q: Q1 Plot the amplitude spectrum and the phase spectrum for the signa X(t)= 2+ 3 sin (200m t) + 4…

A:

Q: Calculate the maximum range of a radar system which operates at 3 cm with a peak pulse  power of 600…

A: Given :minimum detectable signal power Smin = 10-13 WEffective cross section area of antennaAe = 5…

Q: In the RC circuit below, Vs=12, R =43k2, and the capacitor =71 µF. if, initially, the switch is at…

A:

Q: 2. Dip-coating process is one of the methods for electrode surface modification.

A: Answer : True The above statement is correct.

Q: Find the Current Io. In figure (2). 4mA 2mA Ika mmm 2 KA w In lkn Is I3 Elka 16MA

A:

Q: Which differential equation models a series circuit with impressed voltage and no resistance? O Q"…

A: We need to select correct equation for series LC circuit

Q: Consider the following IC-555 in monostable configuration having output pulse duration 0.825 m sec.…

A: Given a IC-555 in monostable configuration, Output pulse duration, T = 0.825 ms R=7.5 kΩ

Q: (a) Figure 1(a) is a sinusoidal oscillator. Given that the feedback factor is: R³ B= 1 5R R³+j²C²²C²…

A: Since you have posted the question with multiple subparts, we will solve the first three subparts…

Q: What is the velocity of an electromagnetic wave in free space?

A: In this case, the velocity of an electromagnetic wave in free space is to be determined.

Q: If the magnitude of a transfer function is given to be 2000 in linear scale, |H| = 2000 , what would…

A: Given: Magnitude of transfer function on linear scale, H=2000

Q: Q4/Compare between Microprocessor and Microcontroller for the following: 1. Internal Architucture 2.…

A: 1. Internal Architecture: Microprocessor consists of only CPU whereas Microcontroller consists of…

Q: Q2/ For the circuit shown, find Vo(t) and lo(t)

A:

Q: Assume a DC motor has 100% efficiency and running at speed of 1000 rpm, what is the toque if E,…

A: Given, A DC motor has η=100%N=1000 rpmE=6 VIa=150 mA

Q: A non-linear pressure sensor has an input range of 0 to 10 bar and an output range of 0 to  5 V. The…

A: Input Range           0 to 10 bar Output Range        0 to 5 volt Output voltage @ 4 bar- 2.20 volt…

Q: مصدر تیار ma ۸۸ 12kn 10k2 RE = Sk2

A:

Q: A copper conductor has a resistance of 15 ohms at 20 degrees celcius. Determine the resistance at 80…

A: A copper conductor has a resistance of 15 Ω at 20°C.here we have to determine the resistance at 80°C…

Q: 3. What is the output voltage in the circuit of Fig. 14.44? 2012 V₁= 1.5 VW 250 k V₂

A: Given data : The given circuit of inverting amplifier is,

Q: b) Determine the true power and reactive power of the circuit shown. VI rms 2V f=2 kHz с 0.01 μF

A: b)  To find the true power and reactive power of the circuit

Q: Consider a square wave astable multivibrator circuit shown in the figure below. 20μF A 20ΚΩ ww Then,…

A: Given, Astable multivibrator circuit Resistance, R=20 kΩ Capacitance, C=20 μF

Q: Determine the value current supply (IT) in figure (1). lon lons 55 n ২lor Slove IT 24V VT

A: The circuit is given

Q: Briefly explain the working of following power plants a) Thermal Power plant b) Hydel power plant

A: Given: a) Thermal Power plant b) Hydel power plant

Q: a receiver has a noise power bandwidth of 10khz. A resistor that matches the receiver input…

A: Noise bandwidth is a ideal filter which pass through the same noise or power as the real filter. In…

Q: 2.22 For the circuit in Fig. 2.86, find i and iz. 20 mA 6ΚΩ Figure 2.86 For Prob. 2.22. 2 4 ΚΩ

A:

Transmission Line Parameters

The performance of a power system is mostly determined by the producing stations and transmission lines in the system which can be studied with the help of transmission line parameters.