For this reaction, 19.4 g sulfur dioxide reacts with 10.1 g water. sulfur dioxide (g) + water (I)sulfurous acid (H₂SO3) (9) What is the maximum mass of sulfurous acid (H₂SO3) that can be formed? What is the FORMULA for the limiting reagent? What the maine after the reaction is complete? 9

Q: Should raw honey be exempted from front-of-pack labelling? Why or Why not? What do you think Health…

A: Introduction Health Canada has recently exempted raw honey from the proposed new mandatory rules for…

Q: Using recycled aluminium instead of aluminium from virgin stock saves approximately how much…

A: In general, recycling any material is better and environment friendly than creating new material.…

Q: Calculate the standard enthalpy of formation of NOCI (g)

A:

Q: Question The solubility of Oxygen gas (O2(g)) in water in units of (g O₂/100 g H₂O) is described by…

A: Given that The solubility of O2 in water as a function of temperature is given by the following…

Q: A reversible compression of 1 mol of an ideal gas in piston/cylinder device results in a pressure…

A: Given, The moles of ideal gas, n = 1 mol The initial pressure, P1 = 15 bar = 0.2 bar The final…

Q: A species (A) in a gaseous mixture diffuses through a 3mm thick film and reaches a catalyst surface…

A: Given data: Thickness of film = 3 mm Partial pressure of A in the bulk gas = 8.5 kN/m2 Diffusivity…

Q: 1. Consider the case of flow and heat transfer over a single sphere The Ranz-Marshall correlation is…

A:

Q: Butyric acid is being cooled from 82oC to 60 oC by heat exchange with water entering a shell and…

A: Given Data  Acid is being cooled from  820C to 600C using water that is being heated from 36oC to…

Q: Evaporation

A:

Q: Calculate the molar Entropy change AS in the of oxygen gas when its pressure is increased…

A: Given that P1 =50 KPaP2 =140 KPaisothemally T =300 k

Q: A continuous single-effect evaporator concentrates 9072 kg/h of a 1.0 wt% salt solution entering at…

A: Introduction:- The heat exchanger for boiling the solution and the specific features for separating…

Q: Hot water (cph = 4188 J/kg*K) with mass flow rate of 2.5 kg/s at 100 deg C enters a thin- walled…

A:

Q: A shell-and-tube exchanger is used to cool an aqueous stream from 95 to 30°C using cooling water at…

A: It is given that aqueous stream is to be cooled by cooling water in heat exhanger. Inlet temperature…

Q: 2.A rigid tank of volume 0.5 m³ is connected to a piston-cylinder assembly by a valve as shown…

A: A piston-cylinder assembly is given.

Q: Determine the equilibrium conversion for the isomerization reaction of methylcyclopentane (CH3C-H9)…

A:

Q: Calculate the standard reaction entropy at 298K for the following balanced reaction equation: 2A + B…

A:

Q: Calculate the reaction enthalpy for the reaction below: 2 C(s) + D (g) 2 A (s) +2B (s) given the…

A:

Q: 2. What is the change in volume for a change from 200 °F and 1 bar to 0 °C and 10 atm?

A: given = T1 = 200 F = 366.48 K (1 F = 255.92 K) P1 = 1 bar = 100000 Pa T2 = 0oc = 273 K P2 = 10 atm =…

Q: Long term Trichloroethylene (TCE) exposure has been linked to harmful health effects in humans. A…

A: Given data: Volumetric flow rate = 43.5 m3/min Residence time = 90.8 min Initial concentration of…

Q: Acetone is used as solvent in a certain process. Recovery of acetone is done by evaporation into a…

A: Given that- Acetone is the solvent whose recovery is done by evaporation of stream of N2.…

Q: QUESTION 4 One mole of an ideal gas undergoes isothermal reversible compression to 20% of its…

A:

Q: 5.16. In the tank in Fig. 5.24 water is under a layer of compressed air, which is at a pressure of…

A: Velocity of water at the exit is to be calculated.

Q: 4-21 Carbon dioxide contained in a piston-cylinder device is compressed from 0.3 to 0.1 m³. During…

A: Given  Pressure volume relation  P = a V-2 a = 8 kpa m6 Initial volume V1 = 0.3 m3 Final volume V2 =…

Q: #2 From the data given in the following table, construct a complete temperature-composition diagram…

A: Data and graph drawn in excel and shown below

Q: Calculate the Entropy of Ammonia in kJ/(kmol K) at T=130 oC and P=1 bar. The reference state is…

A:

Q: A first order reaction is carry out in certain reactor with initial concentratio 2 mol/ m3 If final…

A: Given  Initial concentration CAo = 2 mol/ m3 Final concentration CA =1 Rate constant K = 2 sec-1

Q: Calculate the change in the molar Gibbs energy of oxygen gas when its pressure is increased…

A: Given that isothermally P1  =50 KPaP1  =100 KPaT =500 K

Q: 2. (30 points) An aqueous solution of Na2CO3 contains 12% carbonate and small amounts of soluble…

A:

Q: 5-161 An ideal gas expands in an adiabatic turbine from 1200 K, 600 kPa to 700 K. Determine the…

A: Given  Cv = 0.83 KJ/kg R = 0.3 KJ/kg K CP  - Cv = R Cp = 1.13

Q: In a thermal oxidizer as in Figure 1, the pollutant [Volatile organic compound (VOC), CO, odor] is…

A: Here volatile organic compound is oxidised through high-temperature combustion. Given thermal…

Q: Calculate the equilibrium constant for the following reaction using the data at 298°K H₂O(g) +…

A:

Q: 100mole mixture of benzene and toluene with 45 percent benzene feed to distillation column after…

A: A mixture of benzene and toluene is separated into distillate and bottom product.

Q: In a certain gas manufacturing plants, they presented a horizontal tube in which a gas assumed to be…

A: Given data: Initial temperature of N2 = 761.67 0R Initial velocity = 5.6 mph Final velocity = 180…

Q: 5. A steady-flow water power plant has the following inlet and outlet conditions: Inlet 0 75 400…

A:

Q: 5.30. The venturi meter in Fig. 5.30 has air flowing through it. The manometer, as shown, contains…

A: It is given that air is flowing in the venturi meter. Given data are as follows: Inlet area of…

Q: 26. [Vaporization/Condensation] Acetone is used as solvent in a certain process. Recovery of acetone…

A: N2 , acetone 1000F (750 mm Hg)  ----(dryer)---->  N2 , acetone 850 F(740 mm Hg)  partial pressure…

Q: The specific gravity of white petrolatum is 0.850. Find the weight of this substance needed to fill…

A: Given, The specific gravity of white petrolatum, SG = 0.850 The volume of jar, V = 2 fluid ounce…

Q: If the overall heat transfer coefficient in question 3 above is 27 W/m²-K find the heat loss per…

A: Given data are as follows: Overall heat transfer coefficient h = 27 W/m2-K Temperature of hot oil =…

Q: Ethanol will be separated from the ethanol-water mixture at atmospheric pressure by simple…

A: Given Data F= 1 KmolXF=0.20Xw=0.01 To Find  aThe remaining amount in the boiler (b)Percent of…

Q: for your viscosity equation, can u show me how u derived that? the only equatios i know are these.…

A: Data is given as:- Q=π4D2V1-∆Pρ=Q∆xμρ128π D04 Derive the equation, μ=ρg(∆z)π D4128Q∆x

Q: QUESTION 9 Calculate the change in the molar Gibbs energy of Argon gas when its pressure is…

A:

Q: 2. Balloons now are used to moved huge trees from their cutting place on mountain slope to…

A: Given, The temperature of balloon, T = 290 K The pressure of the balloon, P = 0.940 atm The mole% of…

Q: It is proposed to pump 20,000 kg/h of toluene at 114°C and 1.1 atm abs pressure. From the reboiler…

A:

Q: 2Zn(s) + O2(g) → 2ZnO(s) + 701kJ 1. Solve for the standard enthalpy of formation of ZnO(s) at 298K?…

A: Write the reaction as follows: 2Zns + O2g → 2ZnOs Two moles of Zn reacts with 1 mole of  O2 and…

Q: Task 3.2. Calculate the standard enthalpy of reaction of some thermochemical equations governed by…

A:

Q: 3.2. Liquid A decomposes by first-order kinetics, and in a batch reactor 50% of A is converted in a…

A: Given  Let initial concentration CAo

Q: Each flask, labeled "S", "T" and "U", contains a certain mixture of A, B and C of different…

A: Given data: Amount of solution formed = 1 kg Composition of desired composition is, A = 0.3 B = 0.3…

Q: Consider a 1000 L perfectly mixed bioreactor where the nutrient stream with a density of 1000g/L…

A:

Q: 1. If a parcel of air at 15 °C has a specific humidity of 4.6 g/kg, what is the relative humidity of…

A: Note: Since you have asked multiple question, we will solve the first question for you. If you want…

Q: 1 x 10 mole of a substance decomposed when it was irradiated with a light of wavelength 4800 Å. If…

A: