For uncontrolled half wave rectifier, R=80ohm, L=0.15H, f=50Hz and Vm=311V. Calculate the average current (A).
Q: A center tapped rectifier is supplied using 220 V,60 Hz supply, then using ideal mode, the peak…
A: Third option is correct. The explanation is provided below.
Q: A three phase full wave rectifier is shown below along with peak phase voltage Vm-169.7V. The load…
A:
Q: A full-wave rectifier operating from a 60HZ supply develops a peak rectifier voltage of 23V.…
A: Ripple factor is given by where, and, f=60 C=223uF Idc = 76mA
Q: A single phase full bridge diode rectifier incorporates a capacitive output filter with C = 330µF,…
A:
Q: A conductor carries a current that is equivalent to a 2.5 amp continuous current in one direction…
A: The half-wave rectifier is superimposed in the opposite direction with the DC- source of 2.5 A The…
Q: For the full wave rectifier circuit shown in Figure 1, calculate: 1) The maximum current through the…
A:
Q: Complete design an electronic circuit to produce bridge full wave rectifier with decrement…
A: Given Vin = 50 sin(wt) We have to design an best electronic circuit to produce bridge full wave…
Q: Q2 A full-wave controlled supplying 3k load that operate at 9 V. The input rms voltage is 110 V and…
A: For full-wave controlled rectifier Vdc=Vmπ(1+cosα) Vrms=Vm 12-α2π+sin2α4π
Q: A three-phase controlled rectifier is supplied from a 400V, 50HZ line and supplying an RLE load with…
A: Vsupplied Linemax = 400 Vf = 50 HzR = 6ΩL = 25.5 mHE = 200 Vα = 45°firing angle
Q: A 24-V secondary of a transformer is connected to a half-wave rectifier and a 50 ohms load device.…
A: In this question, A 24-V secondary of a transformer is connected to a half-wave rectifier and a 50…
Q: A C-filtered center-tapped rectifier circuit is used to rectify sinusoid of 110 Vrms, 60HZ. The…
A: Given:V=110 Vrmsf=60HzMinimum output voltage=35Volttransformer ratio= 2:1load resistance, RL=1.8kΩ
Q: What will be the out put of the H.W.R+PMMC meters, if an average responding a.c meter of half-wave…
A: Measuring Instruments: Generally we use two types of measuring instrument in electrical system.…
Q: In a single phase half-wave controlled rectifier has 400 sinwt as the input voltage and R as the…
A:
Q: Resolve the following half-wave, full-wave and bridge rectifier by finding the dc output voltage if…
A: In the question, Resolve the following half-wave, full-wave and bridge rectifier finding the dc…
Q: A 3 phase half wave controlled rectifier has a 3 phase line to line supply voltage of 420 V rms at…
A: Given, Vrmsline=420 Vα=70∘ Vrmsphase=Vrmsline2=4202V
Q: For Ideal controlled rectifier which one of the following statement is correct? O a. RF and TUF…
A:
Q: Calculate the average value of the output current of the thyristor rectifier below with the…
A: Calculate the average value of the output current of the thyristor rectifier below with the…
Q: 3) Power of a 100W, 110 V lamp is to be varied by controlling the firing angle of an SCR in a…
A: Given: Vrms=110 V, P=100 W, firing angle α=60° Required: RMS voltage and current measured in the…
Q: For Ideal controlled rectifier which one of the following statement is correct? O a. RF and THD…
A: For ideal controlled rectifier which one of the following statement is correct? a.RF and THD values…
Q: A Three Phase Uncontrolled Bridge Rectifier is operated from a three phase star connected 210V, 60Hz…
A:
Q: if a half wave rectifier is supplied using 240 V (rms), 50 Hz supply, then using constant voltage…
A: Primary winding voltage V =240 V RMS F = 50 Hz . Vavg = ?. Average output voltage in case of…
Q: 1.A half wave rectifier is supplied with 230V,50Hz ac supply to a load of 12Kohms. Secondary…
A: Solution As per our policy, I am solving only three parts Given data,…
Q: A 3 phase fully controlled rectifier has a 3 phase line to line supply voltage of 410 V rms at 50 Hz…
A:
Q: 30°, the average value of output current in A single-phase full-wave transistor rectifier feeds…
A: We need to find a average output current in the given 1 phase full wave rectifier having RLE load
Q: feeds power to motor load. The source A single-phase full-wave transistor rectifier feeds power to…
A: In this question we need to find a average value of output voltage of rectifier.
Q: For a single phase half wave rectifier feeding 10 ohms load with input supply voltage of (use your…
A: Since you have posted the questions with multiple subpart so we are supposed to answer 3 subpart.
Q: In a half wave rectifier, the sine wave input is 300sin300t. The average value of output voltage is?…
A: The solution can be achieved as follows.
Q: A 3 phase fully controlled rectifier has a 3 phase line to line supply voltage of 420 V rms at 50 Hz…
A: The solution can be achieved as follows.
Q: A single-phase full bridge uncontrolled rectifier is supplied by 220 V (rms) line voltage . The load…
A: In this question we need to find a average output voltage of single phase full wave rectifier.
Q: A 3 phase half wave controlled rectifier has a 3 phase line to line supply voltage of 416 V rms at…
A: Given data: Line voltage , VL=416 VLoad resistance, RL=13 OhmLoad inductance, LL=2…
Q: A three-phase controlled rectifier is supplied from a 400V, 50HZ line and supplying an RLE load with…
A:
Q: A 3 phase fully controlled rectifier has a 3 phase line to line supply voltage of 420 V rms at 50 Hz…
A:
Q: In a phase controlled full wave rectifier, the source voltage is 50 VRMS sinusoidal, the source…
A:
Q: For Ideal controlled rectifier which one of the following statement is correct? O a. RF and THD…
A: ripple factor = rms voltage2-average voltage2average voltage THD = Is2-Is12Is1 form factor = rms…
Q: The primary to secondary turns ratio of a transformer used in a Half wave rectifier is 20:1. The…
A:
Q: A single phase fully controlled rectifier is operated from a 230 volts, 50 Hz supply. The load is R…
A:
Q: Determine the output voltage for a bridge rectifier utilizing a transformer with a 110 Vrms primary…
A: In this question, Determine the output voltage for a bridge rectifier? a transformer with a 110…
Q: A 110V single-phase motor has a power requirement of 360 W and is to be varied by controlling the…
A:
Q: design a uncontrolled three phase rectifier
A: Uncontrolled three-phase rectifier: Rectifier is used to convert the AC signal into DC signal. When…
Q: Calculate the peak voltage across each half of a center-tapped transformer used in a full wave…
A: Peak voltage (Vm): Peak voltage is the maximum value of the voltage attained by the waveform. Full…
Q: 2. If the maximum reverse voltage that can be applied across the silicon diode of a half-wave…
A:
Q: Figure B1 shows a 3 phase half wave rectifier. If the firing angle, a is to set at z/6, analyze the…
A: A circuit of three phase half wave controlled rectifier is shown in the question. We need to analyze…
Q: In half wave rectifier with filter, if the capacitance is increased, the ripple factor increases.…
A: In this question we need to verify the given statement is true or false
Q: A three-phase controlled rectifier is supplied from a 400V, 50HZ line and supplying an RLE load with…
A:
Q: _1. A conductor carries a current that is equivalent to a 2.5 amp continuous current one direction…
A: The current in the conductor Idc=I1=2.5 A Full-wave rectifier Vavg=2VmπIavg=2Imaxπ opposite…
Q: 2. A Half-Wave rectifier with a capacitor filter (capacitance is 4700 uF) supplies to a load an…
A: The given information about a half-wave rectifier with a capacitor filter: Average load voltage is…
Q: A conductor carries a current that is equivalent to a 2.5 amp continuous current in one direction…
A: Given, that the conductor carries a Dc-current of 2.5 A in one direction & a super-imposed…
Q: A three phase full wave rectifier is shown below along with the peak input phase voltage Vm=169.7V.…
A:
Q: Which of the following statements about bridge tip rectifiers is false? A) If the 1-phase type has…
A: A single-phase bridge-type uncontrolled rectifier consists of four diodes D1, D2, D3, and D4 (as…
Q: A Half-Wave rectifier with a capacitor filter (capacitance is 4700 µF ) supplies to a load an…
A:
Step by step
Solved in 2 steps
- For uncontrolled half wave rectifier, R=80ohm, L=0.15H,f=50Hz and Vm=311V.Find the point when the current reaches to zero in radian.Calculate the ripple voltage of a full-wave rectifier with a 150 µF filter capacitor connected to a load drawing 55 mA.Calculate the ripple voltage for a full-wave rectifier @120 Hz with a 45.03 uF filter capacitor connected to a load drawing 326.20 mA current.
- The half wave rectifier is supplied with 240V, 50Hz signal. Assume the number of turns in the primary to secondary ratio is 7:2. Calculate the average dc current through the load resistor 4KΩ.The half wave rectifier is supplied with 240V, 50Hz signal. Assume the number of turns in the primary to secondary ratio is 7:2. Calculate the Maximum Current ImWhat will be the out put of the following meters, if an average responding a.c meter of halfwave rectifier read (4.71v), and true form factor of input waveform is (1.414).
- In a single phase half-wave controlled rectifier has 400 sinwt as the input voltage and R as the load.For the firing angle of 60 degrees for the SCR,the average output voltage is a. 300/pi b. 200/pi c. 240/pi d. 400/piIf the ripple factor of a rectifier is 30% for an average voltage of 2V, its ripple rms voltage (VrRMS) will be 0.6mV 0.6 V 9.67 mV 0.7 VThe half wave rectifier is supplied with 110V, 70Hz signal. Assume the number of turns in the primary to secondary ratio is 7:2. i) Calculate the average dc current through the load resistor 5KΩ. ii) Calculate the value of input ac power, output dc power.
- calculate the ripple voltage of a full wave rectifier with a 100-mF filter capacitor connected to a load drawing 50mA if the peak rectified voltage for a simple filter circuit is 30 V Ans. 27.90 V4a) This question is about half wave rectifier Half wave rectifier with a reservoir capacitor -> connected -> AC mains supply (220Vrms, 50Hz) by 20:1 transformer. What is the value of capacitor for the ripple voltage of X% of the peak input voltage? The load's maximum current is 170mA. Show the full working!Is it true true that Schottky’s Diode acts as the battery when properly biased or not?