Answered: if a half wave rectifier is supplied…

if a half wave rectifier is supplied using 240 V (rms), 50 Hz supply, then using constant voltage drop model, the average output voltage is equal to 108.04 V 107.8 V 152.79 V 76.17 V

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter12: Electronic Control Devices

Section: Chapter Questions

Problem 3RQ: Diodes and rectifiers allow current to _________. flow in one direction only flow in both...

See similar textbooks

Related questions

Q: A three-phase, half-wave uncontrolled rectifier is fed from an ideal three-phase voltage source of…

A: " Since you have posted a question with multiple subparts, we will solve the first three subparts…

Q: A center tapped rectifier is supplied using 220 V,60 Hz supply, then using ideal mode, the peak…

A: Third option is correct. The explanation is provided below.

Q: single phase half wave controlled rectifier circuit has a transformer secondary voltage 230V, 50 Hz…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: A half-wave rectifier is to provide an averagevoltage of 50 V at its output.a. Draw a schematic…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: For the half-wave rectifier, the source is a sinusoid of 120 V rms at a frequency of 60 Hz. The load…

Q: When the rms output voltage of a full-wave bridge rectifier is 31.8 V, the peak inverse voltage…

Q: Q11. The rectification efficiency of single phase half wave rectifier is greater than center tapped…

A: Rectification efficiency of single phase half wave and centre tap wave?

Q: The following waveforms are measured on the input and output of a rectifier while driving a…

Q: A 3 phase half wave controlled rectifier has a 3 phase line to line supply voltage of 430V rms at 50…

Q: The following waveforms are measured on the input and output of a rectifier while driving a…

Q: a half wave rectifier is supplied using 240 V (rms), 50 Hz supply, then using constant voltage drop…

Q: In a centre-tapped full wave rectifier having a load resistance of 750 2 diode forward bias…

Q: (a) A centre tapped rectifier has the following parameters: Nsec = 0.2, Vp(pri) = 240 V, ƒ = 120 Hz…

Q: Consider the half wave rectifier is supplied with 115V, 80HZ signal. Assume the number of turns in…

Q: A Three Phase Uncontrolled Bridge Rectifier is operated from a three phase star connected 210V, 60Hz…

Q: A 3 phase fully controlled rectifier has a 3 phase line to line supply voltage of 410 V rms at 50 Hz…

Q: A single-phase bridge reetifier has a load of 10 Ohm and Zmll. The input AC of 220V (rms) @ 100Hz…

A: Input Voltage= Vi Vi=Vmsin(ωt)........(where Vm is the peak value of the input or ac source voltage,…

Q: A full wave rectifier circuit is fed from center tap transformer. The RMS voltage from the end of…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: A 3 phase fully controlled rectifier has a 3 phase line to line supply voltage of 410 V rms at 50 Hz…

Q: For a single phase half wave rectifier feeding 10 ohms load with input supply voltage of (use your…

A: Since you have posted the questions with multiple subpart so we are supposed to answer 3 subpart.

Q: For a full-wave controlled rectifier, find out the RMS output voltage

A: Given data Vm = 220

Q: A 3 phase half wave controlled rectifier has a 3 phase line to line supply voltage of 420 V rms at…

A: In this question we need to find a average output voltage

Q: A 3 phase fully controlled rectifier has a 3 phase line to line supply voltage of 420 V rms at 50 Hz…

A: The solution can be achieved as follows.

Q: A 3 phase fully controlled rectifier has a 3 phase line to line supply voltage of 420 V rms at 50 Hz…

Q: A three-phase controlled rectifier is supplied from a 400V, 50HZ line and supplying an RLE load with…

Q: In an AC to DC rectifier circuit, the output DC signal of the rectified wave was measured to be Vpc=…

A: AC to DC rectifier- A rectifier circuit convert AC into DC form with the help of four diode system…

Q: A voltage, 100sin314t volts, is maintained across a circuit consisting of a half-wave rectifier in…

A: The circuit consisting of the voltage source connected with the R load through the half-wave…

Q: Consider the full- wave bridge rectifier circuit. The input signal is 120 V (rms) at 60 Hz. The…

A: peak value Vsmax Vsmax=V0max+2Vγ Vγ is the diode cut-in voltage. V0max is the desired peak value of…

Q: Both ripple factor and harmonic factor should be unity for ideal controlled rectifier. Select one:…

A: ripple factor and harmonic factor Ripple factor =√(FF2-1) should be unity for ideal controlled…

Q: The single-phase half-wave rectifier is supplied directly from a 120-V (rms), 60-Hz source through a…

Q: A 3 phase fully controlled rectifier has a 3 phase line to line supply voltage of 420 V rms at 50 Hz…

Q: (a). In the given waveform shown. Find the ripple factor ℽ , if V1 = 8 and V2 = 12. (b) Draw…

A: In the waveform Find the ripple factor ℽ , if V1 = 8 and V2 = 12. Draw the circuit diagram for Full…

Q: In a phase controlled full wave rectifier, the source voltage is 50 VRMS sinusoidal, the source…

Q: For a full wave controlled rectifier with pure resistive load (R=1002),the supply voltage is…

A: Given: A full wave controlled rectifier with, Pure resistive load, R=10 Ω Supply voltage, Vs=50 sin…

Q: For the half wave rectifier shown, determine input power factor & ripple factor for a firing angle a…

A: Solution: For α=90°Input pf=π-α+sin2α2π=π-π2+0π=12 lagging Average value of output voltage for…

Q: Calculate the peak voltage across each half of a center-tapped transformer used in a full wave…

A: Peak voltage (Vm): Peak voltage is the maximum value of the voltage attained by the waveform. Full…

Q: hen a 60-Hz sinusoidal voltage is applied to the input of a full-wave rectifier, what is the output…

A: To solve above problem, one should know what rectifier circuit is and how it works. To charge a…

Q: What is the peak load voltage out of a bridge rectifier for a secondary voltage of 15 V rms? (Use…

Q: Figure B1 shows a 3 phase half wave rectifier. If the firing angle, a is to set at z/6, analyze the…

A: A circuit of three phase half wave controlled rectifier is shown in the question. We need to analyze…

Q: Consider the full-wave bridge rectifier circuit. The input signal is 120 V (rms) at 60 Hz. The load…

A: Given:-Vrms=120vF=60HzRL=250ohmVp(out)=9volt

Q: The RMS output voltage of a Full-Wave Bridge Rectifier is 20 volts, Calculate the average current…

A: Given Data: Vrms = 20 RL = 4.6 kohm

Q: A 3 phase half wave controlled rectifier has a 3 phase line to line supply voltage of 410 V rms at…

A: A 3 phase half wave controlled rectifier has a 3 phase line to line supply voltage of 410 V rms at…

Q: 2. A Half-Wave rectifier with a capacitor filter (capacitance is 4700 uF) supplies to a load an…

A: The given information about a half-wave rectifier with a capacitor filter: Average load voltage is…

Q: A sinusoidal signal V(t) = 100 Sin (314t) is given to the input of a fill wave bridge rectifier with…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost the other…

Q: Determine the value required for each given condition if an AC voltage with an amplitude of 10 V at…

A: An AC voltage simply can be defined as: Where, Vm = amplitude or peak value of the voltage T…

Q: Which of the following statements about bridge tip rectifiers is false? A) If the 1-phase type has…

A: A single-phase bridge-type uncontrolled rectifier consists of four diodes D1, D2, D3, and D4 (as…

Q: A Half-Wave rectifier with a capacitor filter (capacitance is 4700 µF ) supplies to a load an…

Q: Both ripple factor and harmonic factor should be unity for ideal controlled rectifier. Select one: O…

A: In case of rectifier, output should be pure dc ideally.

Q: A three-phase half wave rectifier is operated from a 3-phase, 230 V, 50 Hz supply with load…

A: Given: A three-phase half-wave rectifier is operated from a 3-phase, 230 V, 50 Hz supply with load…

Q: b) The maximum mean output voltage of a three-phase controlled full-wave rectifier is 540.2 V whilst…

A: Given Parameters of a full wave rectifier we need to find the ripple factor of full wave and half…

Question

if a half wave rectifier is supplied using 240 V (rms), 50 Hz supply, then using constant voltage drop model, the average output voltage is equal to

		108.04 V
		107.8 V
		152.79 V
		76.17 V

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Three Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Diodes and rectifiers allow current to _________. flow in one direction only flow in both directions divide paths of flow none of the above
What is the difference between a diode and rectifier?
How is a solid-state diode tested? Explain.
What is CEMF?
If a half wave rectifier is supplied using 240 V (rms), 50 Hz supply, then using constant voltage drop model, the average output voltage is equal to
What will be the out put of the following meters, if an average responding a.c meter of halfwave rectifier read (4.71v), and true form factor of input waveform is (1.414).
If a resistive load is supplied from a single phase half wave rectifier , if a supply voltage is (230v) calculate Vout at firing angle (a =120o) and draw the input and output waveform .
In a phase controlled full wave rectifier, the source voltage is 50 VRMS sinusoidal, the source frequency is 60 Hz and the load is 20 ohms. Since the delay angle in the circuit is 20 °, which of the following is the value of the RMS load voltage? a) 99.54 V b) 49.77 V c) 70.38 V d) 35.19 V e) 23.46 V
If a half-wave rectifier is used with 117-V rms ac (house mains), the average dc output voltage is about:
A three phase fullwave controlled rectifier has an input voltage which is 480vrmsat 60hz. the load modelled as a series resistance and inductance with R=10ohm and l=50mH. determine the delay angle to produce an average of 50ain the load.
Show your solution If a half-wave rectifier is used with 117-V rms ac (house mains), the average dc output voltage is about:
A 50 ohms load resistance is connected across a half wave rectifier. The input supply voltage is 230V (rms) at 50 Hz. Determine the DC output (average) voltage (4 significant figures)