Fossil fuel power plant generates power to 5 residential household community with the following data: HS # 1 = 202 KW HS # 2 = 0.22 MW HS # 3 = 172 KW HS # 4 = 0.185 MW HS # 5 = 218 KW Diversity Factor = 80% Compute the maximum demand of the power plant in KW? A 3,218.15 KW B 2,012.50 KW 1,246.25 KW (D) 1,016.25

Fossil fuel power plant generates power to 5 residential household community with the following data: HS # 1 = 202 KW HS # 2 = 0.22 MW HS # 3 = 172 KW HS # 4 = 0.185 MW HS # 5 = 218 KW Diversity Factor = 80% Compute the maximum demand of the power plant in KW? A 3,218.15 KW B 2,012.50 KW 1,246.25 KW (D) 1,016.25

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A rankine turbo-generator unit receives 27,000kg/hr. of steam at 1.20 MPa and superheated by 122 degrees. condensate leaves at 22 degree celsius, for brake steam rate WB= 4.74 kg/kwhr, mechanical efficiency of 90% and generator efficiency = 94%. Determine the A) ideal work B) Work net C) Ec, cycle thermal efficiency D) W indicated E) indicatedsteam rate F) Indicated engine efficiency G)turbo generator output in KW(Wk)
Thermodynamics (Carnot Cycle) An Ocean Thermal Energy Conversion (OTEC) power plant produces 25000 kW of ouput using warm surface water temperature of 29°C and a cold deep-water temperature of 12°C. Assume it is a carnot cycle and density of cold water to be 1000 kg/m3. Calculate the heat rejected in kW. Options: a. 920000 b. 720000 c. 120000 d. 420000 e. 820000 f. 320000 g. 520000 h. 220000 i. 620000
On my online homework, it says the answer for part b, 993.2 kW and part c, 360.06 are incorrect. I also need help with part d. The figure below provides steady-state operating data for a cogeneration cycle that generates electricity and provides heat for campus buildings. Steam at 1.5 MPa, 280°C, enters a two-stage turbine with a mass flow rate of m1 = 2 kg/s. A fraction of the total flow, y = 0.15, is extracted between the two stages at 0.2 MPa to provide for building heating, and the remainder expands through the second stage to the condenser pressure of 0.1 bar. Condensate returns from the campus buildings at 0.1 MPa, 60°C and passes through a trap into the condenser, where it is reunited with the main feedwater flow. Saturated liquid leaves the condenser at 0.1 bar.
Thermodynamics (Carnot Cycle) An Ocean Thermal Energy Conversion (OTEC) power plant produces 25000 kW of ouput using warm surface water temperature of 29°C and a cold deep-water temperature of 12°C. Assume it is a carnot cycle and density of cold water to be 1000 kg/m3.If the temperature of the sink is maintained and the efficiency is doubled, what is the new temperature of the hot source? Options: a. 38.16% b. 48.16% c. 58.00% d. 32.09% e. None of the above
Provide a complete and logical solution for the problem. If linear interpolation is required in the problem, tabulated values is considered as a solution. Also, provide T-S or P-V diagrams for each problem. For a Rankine Cycle, steam at 5.25 MPa, 435°C expands to 0.036 MPa. For 10 kg/s of steam, determine: a. Heat added b. Heat rejected c. Work of turbine d. Thermal Efficiency
In a constant pressure open cycle gas turbine air enters at 1 bar and 20°C and leaves the compressor at 5 bar. Using the following data: Temperature of gases entering the turbine = 680°C, pressure loss in the combustion chamber = 0.1 bar; Compressor Efficiency = 85%, Turbine Efficiency = 80%, Combustion Efficiency = 85%, k = 1.4 and Cp = 1.024 kJ/kg∙K for the air and gas.Find the quantity of air circulation, in kg/sec, if the plant develops 1,065 kW.Find the heat supplied, in kJ per kg of air circulationFind the percent thermal efficiency of the cycle, neglecting the mass of fuel.
The properties of this Organic Rankine Cycle are as follows: • Turbine feed: P = 24.49 bar, T = 272.19C• Turbine exhaust: P = 2 bar, T = 203C. Assume ideal gas at P = 2 bar. • The pump efficiency is 65%.• Benzene is used as the working fluid Calculate the turbine shaft work Ws,turbine (in J/mol).
A factory uses superheated steam (P = 15 bar, T = 250 oC) for heating purposes of 20,000 tons/month. Steam is made in a boiler-furnace using 2 (two) types of fuel, namely coal fuel (LHV = 5500 kcal/kg) and heavy fuel oil (137129 Btu/ft3, density = 0.98 m3/kg) Question: a. How much coal fuel is needed to produce steam with the above specifications if the overall efficiency of the system (boiler-furnace = 75%)! b. How much heavy fuel oil is needed to produce steam with the above specifications (boiler-furnace = 75%)! answer every month... Help pleasee.. fast please
Steam at 100 bar, 625 C is received by a rankine engine and exhaust at 2 bar. (a) For an ideal engine, find work, steam rate, thermal efficiency and. (b) for actual engine, brake engine efficiency is 85% and generator efficiency is 94%. The driven generator produces 30 MW. Find combined work, combined thermal efficiency, actual exhaust enthalpy, mass flow rate of steam.
Thermodynamics (Carnot Cycle) An OTEC power plant has an efficiency of 2.5%. The difference in temperature of teh warm surface water (hot source) and cold deep-water (sink) is 7.5℃. Assuming powerplant is operating in a Carnot Cycle, find the temperature of the sink in ℃. Options: a. 11.5 b. 12.5 c. 13.5 d. 14.5 e. 15.5 f. 16.5 g. 17.5 h. 18.5 i. 19.5 j. None of the above
Write legibly, provide manual step by step solution, and diagram for below given problem. A superheat steam Rankine cycle has turbine inlet conditions of 17.5 Mpa and 530 C expands in a turbine to 0.007Mpa. The turbine and pumps polytropic efficiencies are 0.9 and 0.7 respectively, pressure losses between pump and turbine are 1.5MPa. What should be the pump work in KJ/kg? A. 17.3 C. 37.3 B. 27.3 D. 43.4
Completely answer. Write legibly. 1. What are the problems with Offshore Power Plant, explain each.2. Which of the following statements is/are valid for Solving the Energy Crises in the country of the Philippines? a. Stop production of petroleum and coal.b. Find a good substitute for Oil and Gas.c. Give some importance and increase the usage of non-conventional energy resources.Explain your answer.