From a chemical point of view, what the results of the flow in each pipe mean. Could you explain me?, please Also, could you explain the figure to me? The results are:  Q2=43/85Q1 Q3=42/85Q1 Q4=22/85Q1 Q5=20/85Q1 Q6=12/85Q1 Q7=8/85Q1

Q: What is the pH of an aqueous solution consisting of 0.070 M formic acid (HCOOH) and 0.070 M sodium f...

A: Formic acid is a weak acid with dissociation constant Ka = 1.8 X 10-4  And since we have weak acid H...

Q: The answer should be W~=1900j/mol I have posted this question but can you explain how to get that va...

A: Given information:   Since nothing is mentioned about the behavior of methane gas, assume it to be a...

Q: A quiescent body of water has a depth of 600 mm. The DO level at the bottom after 16 days is 3.5 mg/...

A: The DO of the water body is to be determined.

Q: Calculate the heat change associated with cooling a 350.0 g aluminum bar from 70.0°Č to 25.0°Č. Is t...

A: The heat change associated with the of cooling of an aluminium bar is to be calculated along with th...

Q: Determine the length and diameter of a horizontal reflux drum for the conditions shown in Figure .

A: The length and diameter of a horizontal reflux drum for the conditions shown in Figure is to be dete...

Q: A single-effect evaporator is being used to concentrate 10,000 kg/h of tomato juice from 5% total so...

A: Consider single effect evaporated used to concentrate the tomato juice. Initial concentration= 0.05 ...

Q: Given the reaction C,H16+11 O2→7 CO2+8 H20 determine the extent of reaction if 100 g mol of O2 enter...

A:

Q: During the crystallisation of aluminium hydroxide in an alumina production plant, the feed solution ...

A: Given data: The crystallization of aluminum hydroxide is achieved in aluminum production plant. Conc...

Q: To analyze the alcohol content of a certain wine, a chemist needs 1.00L of an aqueous 0.200M K2Cr2O7...

A: Molarity is a measure/unit used to represent the concentration of a solute in a solution. It has the...

Q: It takes 20 seconds to fill a two-liter bottle with water from your kitchen faucet. What is the mass...

A: Given : The volume of the water bottle is 2 L  And the time required to fill the water is 20 s  

Q: An adiabatic steam turbine in an electric power plant is designed to accept steam at 5000 kPa and 60...

A: The inlet pressure of the steam to the adiabatic electric turbine is, P1 = 5000 kPa The inlet temper...

Q: Coconut milk was extracted from fresh coconut flesh. The rheological behavior ofcoconut milk contain...

A: Part (a)   The given fluid is coconut milk which is a non-Newtonian fluid. It follows the power-law ...

Q: Use material balance based on species method to calculate the products from reactor, where the two f...

A:

Q: In adsorption processes, what distinguishes purification from bulk separation?

A: The difference between the purification and bulk separation is to be mentioned.

Q: State the approximation of Fick's equation

A: Fick’s law is used to find the molar flux with respect to the observer moving with the molar average...

Q: What is the approximation of Fick’s equation (Hint: the first three terms)

A: The first law of Fick’s gives the relationship between the diffusive flux and the concentration grad...

Q: ​A stream with a flow of 1.7 m3/s and BOD 3.4 mg/l is saturated with DO (9.27 mg/l at 20oC). It rece...

A: Let ‘S’ represent the stream, ‘E’ be the effluent, and ‘M’ be the mixed stream.   The flow rate of t...

Q: A bottle of wine contains 12.5% ethanol by volume. The density of ethanol (C2H5OH) is 0.789 g/mL.  C...

A:

Q: Please complete part B).

A: a)   Expression given for excess Gibbs energy for a binary mixture is:   For a binary mixture, mole...

Q: 1

A: The auto-ignition temperature is given as:   Initial temperature and pressure of the air are:   Al...

Q: Data of Othmer and Agarwal for the batch extraction of oil from soybeans by oil-free n-hexane at 80o...

A: Assume that the effective diffusivity of oil in soybeans is constant.   A table of data for oil cont...

Q: Air at 25o C and 50 % relative humidity flows over water surface measuring 12m × 6m at velocity of 2...

A: Given information:   Let water be ‘A', and air be ‘B’.   Air temperature, T = 25°C Relative humidity...

Q: Use material balance based on species method to calculate the products from reactor, where the twofo...

A: The two reactions taking place are, 1) 2 C10H22 → 2 C10H10 + 12 H2  2) 2 C10H22 + 2 H2 → 4 C5H12  Th...

Q: a)Oxygen is compressed from an initial condition of 1 bar and 250C to a final state of 5 bar and 250...

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If y...

Q: A pharmaceutical manufacturer forms tablets by compressing a granular material that contains the act...

A: The Normal distribution curve equation can be written using mean and standard deviation as 

Q: Why do some evaporators operate under vacuum? How is the vacuum produced?

A: The reason for operation of some evaporators under vacuum is to be mentioned along with the method f...

Q: How do pressure-swing and thermal-swing adsorption differ? What are inert-purge swing and displaceme...

A: The difference between pressure swing adsorption and thermal swing adsorption is to be mentioned. Th...

Q: 6.16. Using a colo below 01 mo

A: Given data: Concentration of A in the feed = 0.6 mol/L Volume of each MFR = 400 cm3 Steady – state f...

Q: 3. a.) How does the presence of crosslinks affect molecular mobility, Tg and mechanical strength in ...

A:

Q: Derive expressions for the surface-mean and mass-mean diameter from a particle-size analysis based o...

A: Assume that all the particles are of the same shape.   Let the number of particles for the given siz...

Q: Discuss the factors that influence drying rates of food in a dryer.

A: Drying is a process in which the excess moisture present in the substance is being removed. Hence dr...

Q: In the empty graph below, draw a phase diagram for a binary-eutectic alloy with the following charac...

A: Since the plot is temperature v/s composition of B Hence the melting point of A will be on left y ax...

Q: What are Marangoni effects?

A: The definition of the Marangoni effect is to be mentioned.

Q: Three fixed-bed adsorbers containing 10,000 lb of granules ofactivated carbon (ρb=30 lb/ft3) each ar...

A:

Q: (c) Teacher explained the process of heat capacity, work done and first law of thermodynamics and as...

A:

Q: Material Balances question

A: Note: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question...

Q: 30.10 Silicon tetrachloride, SiCl4, is an important chemical used in the manufacture of microelectro...

A: Given data: Temperature = 298 K Pressure = 1 atm Diameter of Cl2 gas bubble = 2 mm or 0.002 m Densit...

Q: Explain the methodology for obtaining the vapor liquid equilibrium diagram for non-ideal systems.

A: Vapor-liquid equilibrium can divert from ideality in many conditions which include, molecular intera...

Q: 2- Explain greenhouse and global warming, write their effect, solution to lower their level?

A: The explanation of greenhouse effect and global warming is to be mentioned along with their effect a...

Q: Use material balance based on species method to calculate the products from reactor, where the two f...

A:

Q: Before being recirculated to a dryer, air at 96oF, 1 atm, and 70% relative humidity is to be dehumid...

A:

Q: A continuous vacuum evaporating crystallizer of the DTB type is used to produce 2,000 lb/hr of Al2(S...

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If y...

Q: Which gas phase process does entropy increase? a. Constant pressure Constant Pressure b. Constant vo...

A:        Assume Ideal gases

Q: Feed to a cooling crystallizer is 2,000 kg/h of 30 wt% Na2SO4 in water at 40oC. This solution is to ...

A: Given data:   Flow rate of feed = 2,000 kg/h Composition of Na2SO4 in the feed = 30 wt% Temperature ...

Q: A distillation column is used to separate 500 kg /h of a mixture containing 50 wt% benzene (C6H6) in...

A:

Q: Under what conditions is extraction preferred to distillation?

A: The conditions are to be mentioned where extraction process of separation is preferred over the dist...

Q: A meat processing factory’s raw effluent has a five day BOD at 20oC of 1760 mg/l. If the k value is ...

A:

Q: One-kg blocks of wet Borax laundry soap with an initial H2O content of 20.2 wt% on a dry basis are d...

A: The amount of moisture evaporated from each block is to be determined.

Q: Sircar and Myers measured liquid-phase adsorption at 30C for a binary mixture of cyclohexane (1) and...

A: (a)   The given data of q1e versus x1 is given for the liquid-phase adsorption of a binary mixture o...

Q: Air is heated in a heat exchanger by hot water. The water enters theheat exchanger at 45 oC and expe...

A: Air is the cold (c) stream that is being heated and water is the hot (h) stream used to heat the col...