From a table inside a room with current temperature of 31 degrees Celsius, a left over Fried Chicken is removed and placed inside a refrigerator set to a temperature of 7 degrees Celsius. After 6 minutes the temperature of the chicken is 22 degrees Celsius. What is the temperature of the chicken 27 minutes after it was placed in the refrigerator? (use 2 decimal digit. unit is not needed)

From a table inside a room with current temperature of 31 degrees Celsius, a left over Fried Chicken is removed and placed inside a refrigerator set to a temperature of 7 degrees Celsius. After 6 minutes the temperature of the chicken is 22 degrees Celsius. What is the temperature of the chicken 27 minutes after it was placed in the refrigerator? (use 2 decimal digit. unit is not needed)

Algebra: Structure And Method, Book 1

(REV)00th Edition

ISBN:9780395977224

Author:Richard G. Brown, Mary P. Dolciani, Robert H. Sorgenfrey, William L. Cole

Publisher:Richard G. Brown, Mary P. Dolciani, Robert H. Sorgenfrey, William L. Cole

Chapter7: Applying Fractions

Section7.3: Equations With Fractional Coefficient

Problem 7E

See similar textbooks

Similar questions

6 is 82% of what number? If necessary, round the answer to 2 decimal places.
What is 7.25% of 43.80? Round your answer to 2 decimal places.
Name the decimal: 13.461.
The concentration of carbon dioxide in the atmosphere is 3.9104 . Convert this number to decimal form.
Write these numbers as words using the alternative method for reading decimal fractions. 42. 0.208
In the 2010 winter Olympics, two skiers took the silver and bronze medals in the Men's Super-G ski event. The silver medalist's time was 1 minute 30,62 seconds and bronze medalist’s time was 1 minute 30.65 seconds. Whose time was faster? Find the difference in their times and then write the name of that decimal.
A plate 57.20 millimeters thick is to be machined to a thickness of 44.10 millimeters. The plate is to be rough cut with the last cut a finish cut 0.30 millimeter deep. If each rough cut is 3.20 millimeters deep, how many rough cuts are required?
The length, L, of the standard 82° included angle drill can be calculated using the formula L=0.575 , where Ø represents the diameter of the drill. Determine the length of a drill point with a diameter of 12.5 mm. Round your answer to 1 decimal place.