From point A to point B of the system shown in the figure, oil flows (specific gravity of 8.64 kN/m3). A) Calculate the volumetric flow of the oil. ( WORK LIKE NEW PLEASE

Q: Applications and significance of flow over weirs in fluid mechanics. Give at least one real life…

A: In civil engineering, free and forced vortices have various uses. Forced vortices are formed by…

Q: wo alternatives are being considered: Initial Cost Uniform Annual Benefit Useful Life A $500 $140 8…

A:

Q: What are some common construction materials used in civil engineering projects?

A:

Q: 010* 60 30ft Øin answer given 435K LRFD 288.3KASD Determine LRFD design strength Qc Pn and ASD…

A: Column section W 10 x 60 Section properties: Ag = 17.6 in2 rx = 4.39 in ry = 2.57 in Length, L = 30…

Q: A wide river with a water surface elevation 1/8000 of depth of flow D. If the depth of flow in the…

A: Discharge ratio- Q1/Q2=2.58 Surface slope decrease by 40%, Elevation=1/8000. % change in discharge=?

Q: Calculate the end areas for depths of fill from 0 to 20 ft using increments of 2 ft for level…

A:

Q: 1. A 5-m beam simply supported at the ends carries a concentrated load of 90 kN at midspan. Select…

A: Length of beam = 5 m Concentrated load at mid span = 90 kN Allowable stress = 50 MPa Lightest 'S'…

Q: A small urban watershed located in north of Iraq has four rainfall gauges as located in the figure…

A: The given data is shown below:

Q: Appendix 1 shows a structural drawing of the first floor of a random building. The labels "C"…

A: Section 200 UB 29.8 The concentrated point load acting on the beam is 12 kN

Q: define in your own words each of the "5 D's of Development": Density, diversity, design, destination…

A: Planning and policy that incorporates the 5 D's of development can promote health and well-being…

Q: Problem 1: Determine the reactions and all bar forces for the truss shown below. E=29000ksi and…

A: The given question can be solved with the help of equilibrium equations which are: ΣFx= 0 ΣFy= 0ΣMx=…

Q: ernier (attached to a horizontal circle) to read 25 degrees 12'. The horizontal circle is divided…

A: Given:- horizontal circle=30' 30 divisions To find:- direct circular vernier design

Q: The body on the 30° incline is acted upon by a force P inclined at 20° with the horizontal. If P is…

A:

Q: A RAFT OF SIZE 4 M-SQUARE CARRIES A LOAD OF 400 KN/M2. DETERMINE THE VERTICAL STRESS INCREMENT AT A…

A: Given: The size of the square raft is 4 m. The load is 400 kN/m2. The depth is 5 m.

Q: Determine the location of the centroid and he moment of inertia about the neutral ■xis of the…

A:

Q: At the point of operation with maximum efficiency, a turbine indicated unit power of 12 units and…

A: A turbine indicated, Unit speed, Nu=98Unit power, Pu=12Design head, H=8.5 m

Q: SITUATION The homogeneous bar ABCD shown is supported by a cable that. runs from A to B around the…

A:

Q: A sample of clayey silt is mixed at about its liquid limit of 40. It is placed carefully in a small…

A: Here we have to determine the shrinkage limit and dry density

Q: Determine the LRFD design tensile strength and the ASD allowable tensile strength for the…

A: Fy = 36 ksi  Fu = 58 ksi  3/4 inch diameter A325 grade bolt Calculations shown in steps below

Q: In Problems 3.13 and 3.14, compute the corrected horizontal distance (assume normal tension was used…

A:

Q: A C9 x 20 with 2 lines of 7/8-in diameter bolts in the web as shown in the figure. Fy = 36 ksi and…

A: Given data: Properties of C9x20 section -  Ag = 5.8 in2d = 9 intw=0.448 inbf = 2.65 intf =0.413 intw…

Q: nowmobile has a weight of 260 lb, centered at G₁. the rider has a weight of 180 lb, centered at G₂.…

A: Mass of snowmobile=260lb Mass of rider =180lb h=2ft

Q: Draw a shear force diagram and bending moment diagram for a cantilever beam experiencing sine…

A: Given: Required : Shear force and bending moment diagram

Q: The truss ABC is constructed of three titanium (E Ti ​ =17.4×10 3 ksi) members. A horizontal force…

A: E=17.4×103 ksiCross sectional area of AB=0.1 in2                                          BC=0.0025…

Q: The truss shown is supported by a roller at A and a pin at H. Calculate the reactions at these…

A:

Q: 0x - 16Мра бу = - 48М ра, т гу - 48 Mpa I 16 Mpa 60 Mpa - 60 Мра

A: State of stress of given as shown- σx=16 MPa,σy=-48 MPa,τxy=60 MPa. To Find- The values of…

Q: For the frame loaded as shown, draw the complete and correct FBDs of the following: whole frame,…

A:

Q: Q.3/ A three-span continuous beam ABCD is simply supported at A and D and loaded as shown in Fig. if…

A:

Q: compression loads in the first interior column of the structure shown are: 95 kN (dead load), 50 ve…

A: Given:- dead load=95kN live load=50kN wind load=75kN k=0.65 To find:- remaining allowance

Q: 2. Complete the consolidation table below. H₂= 25 mm A = 50 cm² Volume 125 cm³ W₁ = 190.4g…

A: H0=25 mmVolume= 125 cm3G=2.68γw=1 g/cm3A=50 cm2ws=190.4 gwf=25.04%senstivity of dial gauge =0.01 mm

Q: 3. 20 kips 12 ft 5 kips/ft 18 ft 16 kips 12 ft

A: A loaded beam is given and it has been asked to determine support reactions and draw shear force and…

Q: The diameter of a horizontal tube is 4 in., in which tetrabromoethane (SG = 3.0) is flowing at the…

A:

Q: Design the section below as a doubly reinforced beam for resisting the ultimate positive moment of…

A: We are given  Ultimate Positive Moment Mu = 425 KN-m We know that Nominal Moment capacity is given…

Q: 5) Compute the deflection at the center due to the 36 kN load induced at midspan of 4m simply…

A: Conjugate Beam Method is defined as the imaginary beam having the same dimension as the original…

Q: The levee is to be built along the side of a river to protect a nearby town from flooding.…

A: FoS = (resisting forces / driving forces) The resisting forces are the shear strength of the soil…

Q: Consider a cubical water tank with a side length of 4 m. The tank is half filled with water, and is…

A: Side of cube = 4 m   Acceleration = 7 m/s2

Q: The floor system of a residential building consists of 125mm thick reinforced concrete slab (unit…

A: Thickness of slab (t) = 125 mm  unit weight of concrete (¥) = 23.6 kn/m3  span of each beam = 8 m…

Q: Figure 1 shows a simply supported beam with a concentrated force P applied at the mid-span, B. Given…

A:

Q: b) With the vertical spring, determine the overall stiffness of the system with both the force and…

A:

Q: xfiltration trench is to retain the latory water-quality depth is 2.5 fer is 10 m/d and the trench…

A: Given:- 0.5 ha catchment  water quality depth =2.5cm wide=1m deep=1.5m porosity=0.4 To find:-…

Q: A rectangular beam has a width of 300 mm and effective depth of 600 mm. The beam is reinforced with…

A: Width of the beam (b)= 300mm effective depth of beam (d)= 600mm tension reinforcement area (Ast) =…

Q: Q.2 What is the maximum torque transmitted by a hollow shaft of outer diameter and inner diameter of…

A: A hollow shaft as shown- Outer diameter=2d, Inner diameter=d. To Find- The value of maximum torque…

Q: 5. /6 Using the figure below, answer the following: a. What is the type of weld to be made? b. What…

A:

Q: he support bracket for a water pipe that brings water from the city water system into the basement…

A: The pressure force is defined as the force that is exerted by the pressure on any area that is equal…

Q: A high income community produces a peak daily flow of wastewater of 450 m³/s into pipe Y. You are…

A:

Q: What is the end area for the depth of 20 ft? Express your answer in feet squared as an integer. End…

A:

Q: A rigid reinforced concrete foundation is subjected to a column load of 87,000 lbs. The foundation…

A:

Q: A reinforced concrete beam has a width of 300 mm and a total depth of 500 mm. It is reinforced with…

A: width b = 300 mm Total depth = 500 mm Effective depth d = 419 mm f'c =27.6 Mpa fy = 414.7 Mpa…

Q: For the rigid frame shown in figures, determine: a) the nodal displacements and rotations of the…

A: Given, To find,a)  Nodal displacements and rotations of the nodes  b) Reaction  at supports.c)…

Q: P8.10. (a) Compute the horizontal displacement of joint B produced by the 240-kN load in Figure…

A:

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.