From the given data of a differential leveling as shown in the tabulation:BacksightForesightElevationStation(m)(m)(m)BM124.64209.6515.805.0622.255.02BM136.025.8538.964.9448.063.229.453.7112.322.02BM141.98a) Find the difference in elevation of station 5 and station 2,b) Find the difference in elevation of station 6 and station 3.c) Find the elevation of BM14.96

Height of instrument = elevation (B.M) + B.S Elevation = H.I - F.S

From the given data of a differential leveling as shown in the tabulation: Backsight (m) Foresight (m) Elevation Station (m) BM12 4.64 209.65 1 5.80 5.06 2.25 5.02 BM13 6.02 5.85 3 8.96 4.94 4 8.06 3.22 9.45 3.71 6. 12.32 2.02 BM14 1.98 a) Find the difference in elevation of station 5 and station 2. b) Find the difference in elevation of station 6 and station 3

From the given data of a differential leveling as shown in the tabulation: Backsight (m) Foresight (m) Elevation Station (m) BM12 4.64 209.65 1 5.80 5.06 2.25 5.02 BM13 6.02 5.85 3 8.96 4.94 4 8.06 3.22 9.45 3.71 6. 12.32 2.02 BM14 1.98 a) Find the difference in elevation of station 5 and station 2. b) Find the difference in elevation of station 6 and station 3

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A differential leveling circuit began on BM Hydrant (orthometric height 5869.31 ftft) and closed on BM Rock (orthometric height 5880.03 ftft). The plus sight and minus sight distances were kept approximately equal. Readings (in feet) given in the order taken are 5.48 (+S) on BM Hydrant, 5.59 (−S) and 10.83 (+S) on TP1, 9.26 (−S) and 13.41 (+S) on BM 1, 8.91 (−S) and 7.57 (+S) on BM 2, 5.14 (−S) and 9.01 (+S) on TP2, and 6.63 (−S) on BM Rock. Prepare, check, and adjust the notes. Determine the Plus and Minus adjustments. Express your answers in feet to two decimal places separated by a comma. Determine the page check. Express your answer in feet to two decimal places. Determine the misclosure and the correction. Express your answers in feet to two decimal places separated by a comma.
To test its line of sight adjustment, a level is set up near C (elev. 193.436 m) and then near D. Rod readings listed in the order taken are C = 1.315 m, D = 0.848 m, D = 1.296 m, and C = 1.767 m. Compute the elevation of D, and the reading required on C to adjust the instrument.
use of stadia reduction tables. From an instrument station a backsight was made on a turning point and the following data were obtained: Upper stadia hair reading = 1.745m Rod reading = 1.495m Lower stadia hair reading = 1.245m Stadia constant = 0.381m Stadia interval factor = 95.5m Observed vertical angle = -15 30’ Height of instrument above occupied station = 1.495m Elevation of turning point = 463.24m Determine the elevation of the instrument station using values taken from stadia reduction tables.
A line level was run from BM1 to BM2, 8 km apart. The average backsight and foresight distances were 100m. At every turning point, the rod settles by 3cm. Determine the total error in the recorded elevation of BM2. a. 1.17 m b. 1.25 m c. 1.40 m d. 1.57 m
Reciprocal leveling gives the following readings in meters from a setup near A: on A, 1.365; on B, 4.928, 4.924, and 4.926. At the setup near B: on B, 4.251; on A,1.687, 1.688, and 1.688. The elevation of A is 564.872 m. Determine the disclosure and elevation of B.
Surveying Question: A differential leveling circuit starts at benchmark Concrete Benchmark (Elevation=232.051m) goes out to an unknown benchmark and then continues to a known control point (Elevation=227.975m). Two turning points are used with the measurements included in the attached table. Determine the elevation of the unknown benchmark Determine the order and class of the survey. For First order Class 1: Allowable Error= +/- 4(K)1/2 Range of Constant= m less than/equal to 4 For First Order Class 2: Allowable error= +/- 5(K)1/2 Range of constant= m greater than/equal to 4, and m less than equal to 5 (between 4 and 5) For Second Order Class 1: Allowable error = +/- 6(K)1/2 Range of Constant = m greater than/equal to 5, and m less than equal to 6 (between 5 and 6) For Second Order Class 2: Allowable error = +/- 8(K)1/2 Range of Constant = m greater than/equal to 6, and m less than equal to 8 (between 6 and 8) For Third Order, Any Class: Allowable Error = +/-12(K)1/2 Range…
In a leveling work, sum of the Back Sight (B.S.) and Fore Sight (F.S.) have been found to be 3.085 m and 5.645 m respectively. If the Reduced Level (R.L.) of the starting station is 100.000 m, the R.L. (in m) of the last station is
A Reciprocal leveling is observed across a wide river and the reciprocal level readings were takenbetween points A and B as follows. With instrument set up near A, the rod readings on A are 2.283 mand 2.285 m. The reciprocal level readings on the opposite side of the river at point B are 3.618, 3.619,3.621 and 3.622 m. With the instrument set up near B the rod readings on B are 4.478m and 4.476 m,and the rod readings on the on the opposite side of the river at point A, the rod readings are 3.143,3.140, 3.146 and 3.144.a.Compute the difference in elevation between A and B with the instrument set up near A.b.What is the true difference in elevation between A and B?c.If the elevation A is 300 m, what is the elevation of B?
A, B and C are three known control stations and P is the position of a sounding vessel which is to be located. If AC = 6925.50m and AB = 6708.40m, angle BAC = 112°45'25", angle BPA = 25°32'40", angle APC = 45°35'50", determine the distance AP if A is nearer to P than B and C.
The following data were obtained by stadia observation: vertical angle, + 12deg 51 min; upper and lower stadia hair reading, 4.311 and 3.730 m, respectively. the rod reading was taken at 3.785m above the stadia point A and the height of instrument set up at point B is 1.620m. If the stadia interval factor is 99.5 and the stadia constant is 0.381m, what is the vertical distance? a.54.098 b.94.780 c.12.620 d.26.364
A backsight reading of 2.73m is taken on point A and subsequently a foresight reading of 1.35m is taken on pointB from a level station established midway between the two points. what is the difference in elevation between two pointsA and B is?
A differential leveling loop began and closed on BM Tree (elevation 323.48 ft). The plus sight and minus sight distances were kept approximately equal. Readings (in feet) listed in the order taken are 3.18 1 +S2 on BM Tree, 4.76 1 -S2, and 2.44 1 +S2 on TP1, 3.05 1 -S2 and 6.63 1 +S2 on BM X, 3.64 1 -S2 and 2.35 1 +S2 on TP2, and 3.07 1 -S2 on BM Tree. Prepare, check, and adjust the notes.