f(x) = (x² + 5)(x² + 16)O it has 4 imaginary rootsO it has two imaginary rootsO it has two real roots and two imaginary rootsO it has 4 real roots

Answered: Image /qna-images/answer/fb06ec25-059e-4b88-acd3-fc72132457b8.jpg

Answered: f(x) = (x2 + 5)(x² + 16) O it has 4…

f(x) = (x2 + 5)(x² + 16) O it has 4 imaginary roots O it has two imaginary roots it has two real roots and two imaginary roots it has 4 real roots

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.2P: Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your...

See similar textbooks

Related questions

Q: An ideal transformer has 500 turns on the primary and 300 turns on the secondary. The source produce...

Q: Sketch v, for the network of Fig. 2.175 and determine the de voltage available. Ideal 170 V 2.2 k2 d...

A: DC voltage: Dc voltage is also known as the average output voltage of the circuit and its unit is th...

Q: Calculate the length of the following antennas, and state their radiation resistance at 28 MHz. Do n...

A: a) The length of the dipole antenna is given as: l=λ2λ=Wavelength Plugging the known values in the ...

Q: The figure open? to a battery. What is the total current drawn from the battery when the switch is T...

A: In this question, We need to determine the total current in the given circuit. We know current I =...

Q: RI Rq A R2 a.. Form the norton circuit b. calculate In C. Calculote RN Note : N is norton

Q: Calculate V 2 and the average power delivered t

Q: Question 4: The Transformer A current transformer is used to provide a range of values of 5A, 1A and...

A: Current transformer is an measuring instrument which measure the currents in winding. In CT, high si...

Q: Discuss the effect of placing a bleeding resistor R1 in series with the Zener diode that is connecte...

A: Bleeder resistors are resistors with very high resistances in few mega ohms, usually used in paralle...

Q: 5. The non-linear modulation signal is expressed as: s(t) = Acos (wot + 200 cos(@mt)). (1) If s(t) i...

A: We need to find message signal for given FM and PM signal .

Q: The metering of a 3 phase inductive load indicated the following values: 4000 kW, 34.5 kV, 80% power...

A: Option : b ( Answer ) = 5000 (kVA)

Q: QUESTION 28 A three-phase balanced delta connected power system has a line current of 50 amps. What ...

A: Given a three phase balance delta connected power system having, Line current, IL=50 A

Q: For an ideal Si-SiO2 MOS capacitor with d = 5 nm, NA = 1017 cm–3, find the applied voltag

Q: Design a circuit that will satisfy the input/output relation below using the following components: i...

Q: 1- What causes a three-phase motor to run backwards? 2- How we can reverse the direction of the indu...

A: Whenever the phase sequence of the motor is reversed it makes the motor to move backwards

Q: 3. Give the SI unit of the following Potential Work Potential Energy Electric Current Electric Charg...

A: 1.Electric Potential is defined as Potential energy per unit charge of a test particle. SI Unit : V ...

Q: ww 20 =:45 Problem 5. Determine the value of Vo www Vo$50

Q: 1KÖ D1 D2 νουτ Wp.p 9V 4.5V

Q: Q10/ A 3-phase, 6-pole induction motor is connected to a 60 Hz supply. The voltage induced in the ro...

Q: An ideal transformer is connected to a 110V(rms), 60HZ source. Line impedance on the primary is 4+5i...

Q: Name the type of memory with the following characteristic: this memory is non- volatile, read/write,...

Q: Derive [h] parameters in terms of [T]. a: b: Derive [z] parameters in terms of [y].

Q: 2. Build CMOS circuit using Bubble Pushing & Structure method: a) F = (a + b)(c + d) b) F = ab + cd ...

A: We need to design the given Boolean function by using CMOS gate .

Q: In the circuit shown in the figure, S, remains closed for a long time and S2 remains open. Now S2 is...

Q: Determine Vout for fig. 1 VEE -5V D1 R1 1.5kQ silicon diode Vout D2 R2 1.5k0 Germanium Diode

A: We need to find out output voltage for given circuit

Q: Design a dc motor reverse and forward circuit using a single switch. Main components: DC Power Suppl...

A: DC motor- A DC motor is the simplest form of electric motors that is used to convert electrical ener...

Q: →(s) X3 X2 1 X1 Us) 3 3 Find state space equations with input U(s) and output Y(s)

A: In this question, The control system is given. Find the state space equations with inputs U(s) and...

Q: values for the same component. This causes different signed power therefore we cannot state whether ...

A: Simple solution regarding this chaos: If the current is discharging from any device that means if th...

Q: Question 4 a) Simplify the circuit in Figure Q3 into a circuit (with clear labels) with only two ele...

Q: In the given circuit, Vx = 6.5 V and Rx = 50. R 0.1V 3.32 V2 Referring to the given circuit, determi...

Q: The circuit below is used to filter specific frequencies of a speech signal

Q: 2-2 6-2 to Isv 3 t. 17.5 Turn on the circuit and find t = 1, t = 2, t = 3, t = 4, t = 5

Q: 3. Consider a three-wire Y-Y circuit. The voltages of the source are Van V3 o Vrms, Vin V3 <- 208 12...

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you ar...

Q: 5. Which components' powers are positive? Whať's the meaning of positive power?

A: For The load components like light load(resistor),motor(inductive load) etc the power is positive W...

Q: 54. Calculate V2 and the average power delivered to the 8 2 resistor of Fig. 13.72 if V, = 10/15° V,...

Q: Determine the current 13, in Amperes, if E R1 R2 R3 R4 R5 24 V 0.3 0 24 Q 0.3 0 15 Q 16 0 I3 'R, R2 ...

Q: Discuss the following a. Digital to Analog and Analog to Digital Converter b. Phase Locked Loop

A: a) Digital to Analog Converter(DAC): A DAC is a device that transforms digital input signal to an an...

Q: A. Consider the Common-Source (CS) amplifier shown below. Vo He Cc Rsig CG RL Cs Sketch/draw and pro...

Q: A 150 KW, 3000V, 50HZ, 6-pole star-connected induction motor has a star-connected slip ring rotor wi...

Q: 10 R 2V -10+ 3V

A: We need to find out output voltage for given circuit

Q: Find the Fourier series for the periodic extension of the signal -.5 <ts.5 (the periodic extension m...

Q: Determine the bandwidth and baud for an FSK signal with mark frequency of 32 kHz, a space frequency ...

A: Given, For an FSK signal, Mark frequency (f1) = 32 kHz Space frequency (f2) = 24 kHz Bit rate (Rb) =...

Q: 4. O Find RT X I Sor cet shown? 2KA fov T

A: In this question, A circuit is given. Find the total equivalent resistance and total current in th...

Q: I. Determine Vx and Vo of the circuit below. 10uF 6V Ge 10K Si ohm 4.3K Vx • ohm Vo Vi = 30 Vp-p Vx ...

Q: The system y(t) = [ 2(t+1)-5] [x1(t) + x2(t-1)] is: Select one: a. Nonlinear and causal O b. linear ...

A: The solution is given below

Q: Copute for the i2t if the surge current passing through a device is i(t) = 41.32sin(11.2t) for 31ms.

Q: Calculate the average total propagation delay of the circuit below. From external input source 1st l...

Q: With the help of a simple example, we wil explore how we can use the PN generator in the transmitter...

A: PN generator (Pseudo Noise generator): These are generally used to create a noise that is roughly "w...

Q: 4.For the following pair of voltage and current, indicate whether the element involved is a capacito...

Q: Question 2 Refer to the circuit in Figure Q2: R,=62 10V C=5F R,=42 R,=20 Figure Q2 a) When the switc...

A: As per our company guidelines we are supposed to answer. We need to find out voltage across the capa...

Q: Question 3 Refer to the circuit in Figure Q3: C=265.25 uF R = 52 L=39.79mH v = 85 sin (377t+10) V Fi...

A: Since you have asked multiple questions in a single request, we will be answering only the first thr...

Question

100%

f(x) = (x² + 5)(x² + 16)
O it has 4 imaginary roots
O it has two imaginary roots
O it has two real roots and two imaginary roots
O it has 4 real roots

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Simplification of Boolean Functions Using Karnaugh Map

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

If i = 4 sin(2*pi*f*t - 30°) and v = 7sin(2*pi*f*t-50degrees) which one of these statements is true? i leads v by 20° i leads v by 80° i lags v by 20° i lags v by 80°
The voltage across a 100 mH coil is v = 100 sin 50t. Which of these expressions describesthe current? 2) _____A) 20 sin 50tB) 20 sin(50t - 90°)C) 2000 sin(50t - 90°)D) 20 sin(50t + 90°)
A series circuit of two pure elements has an applied voltage of 200sin(100t+30)V. Determine the resulting steady-state current of the two elements are:a) R = 300 L =2.5 Hb) R = 400, Xc= 150 c) R = 250, C = 100u d) R = 120, Xl=300
Use CTFT table and properties to find the numerical value of x(t) at t=0.75 if x(t)= 3 sinc (2t) * sinc (4t) : Select one: a. 0.75 sinc (1.5) b. None of the given options c. 3 sinc (1.5) + 3 sinc (3) d. 3 sinc (1.5) sinc (3) e. 3/8 rect (1.5) rect (3)
The circuit shown is at steady state before the switch closes at t = 0. The switch remains close for 0.5 second and then opens. Determine v(t) for t ≥ 0. Answer: 12V, t ≥ 0; (4 + 8e−3t) V, 0 ≤ t ≤ 0.5s; (12 − 6.215e−(t-0.5)) V, t ≥ 0.5s;
A series RLC circuit with L=160 mH, C= 100 micro F and R=40 ohm is connected to a sinusoidal voltage v(t) = 40sinWt, with W= 200 rad/sec. find,(1) What is impedance of the circuit (2) Let the current at any instant in the circuit be I(t) = I0 sin(Фt-F). find I0(3) What is the phase Ф I need all parts complete solve don't copy from any answer else I will give downvote
1- What is the mutual admittance, Y34, of the electric circuit shown in Figure ? Select one: a. 2+j3 b. 0 c. -2+j3 d. -2-j3 2- The admittance of the impedance -j0.5 is given by: Select one: a. 2j b. 4j c. -4j d. -2j Please help me as fast as possible please. PLEASE ANSWER ALL THE QUESTIONS COMPLETE STEP BY STEP PLEASE. THANKS.
A. Find z11. Express your answer with the appropriate units. B. Find z21. Express your answer with the appropriate units. C. Find z12. Express your answer with the appropriate units. D. Find z22. Express your answer with the appropriate units.
8. 7.8 In the circuit , the voltage and current expressions are v=400e−5tV, t≥0+;i=10e−5tA, t≥0.2. b) τ (in milliseconds).
A 50-µF and 100-µF capacitors are connected in series and across a 100 sin (wt + 30o) voltage. Write the equation of the current.a. 1.26 sin (wt + 120o) c. 5.65 sin (wt + 120o)b. 1.26 sin (wt + 90o) d. 5.65 sin (wt + 90o)s
The givens are I1 = 0.219A, R1 = 66 ohms, R2 = 38 ohms, C = 0.1 farads. What is Vc across the capacitor at time t = 4.58 seconds?
Reduce 5 sin(ωt)+5 cos(ωt+30°)+5 cos(ωt+150°) to the form Vm cos(ωt+θ)..