Gaseous methane  CH4  reacts with gaseous oxygen gas  O2  to produce gaseous carbon dioxide  CO2  and gaseous water  H2O . If  1.01g  of carbon dioxide is produced from the reaction of  1.6g  of methane and  2.2g  of oxygen gas, calculate the percent yield of carbon dioxide.  Be sure your answer has the correct number of significant digits in it. In %

Q: An equimolar mixture of substances A, B and C is fed to a reactor to produce product D by the reacti...

A: Given data: Conversion in the reactor = 50 % Feed is equimolar.

Q: The endothermic liquid-phase elementary reaction A+B→2C proceeds, substantially, to completion in a ...

A: Write the reaction as follows: A +B → 2C   Write the energy balance equation for the non-isothermal ...

Q: Explain the formation of group orbitals in a square planar field. Draw the group orbitals that form.

A:

Q: Question: 1.5 mol of methane gas, which behaves ideally, with a pressure of 10 bar and a temperature...

A: Given that, Number of Moles of Methane gas = 1.5 mol Initial Pressure P1 = 10 bar Initial Temperatur...

Q: Consider the thermal decomposition of a 41.6 g calcium carbonate (CaCO3, molar mass 100.1 g/mol) sam...

A:

Q: Which element mainly imparts the stain resistant property of iron-carbon alloys? Chromium Silver O G...

A: Answer: Chromium

Q: A fluid is flowing downward (via gravity) through a cylindrical packed bed. The void fraction of thi...

A: Given data: Void fraction of the bed (ε) = 0.42 Diameter of the packing material = 0.006 m Depth of ...

Q: Students want to decrease the pressure of a gas in a 1.2L container from 6.7 atm to 3.8 atm Accordin...

A: Boyle's law is an experimental gas law that describes how the pressure of a gas tends to increase as...

Q: Estimate the critical point of Kr, reason? Evaluate the phase rule at the point indicated?explain an...

A: It is required to calculate the critical point of Krypton and the phase rule at the point indicated....

Q: Give four challenges and suggest solutions for those challenges in formation wettability

A: The challenges and the solutions in formation wettability are to be described.

Q: Consider the following balanced equation, an important reaction in the industrial manufactur of phos...

A:

Q: A sample of a halogen gas has a mass of 0.538 g and exerts a pressure of 600.0 torr at 14.0 oC in a ...

A: Given that, Mass of Halogen gas= 0.538 g, Volume  = 100.0 mL =0.1 L, Temperature = 14.0⁰C =287.15 K ...

Q: im confused on how to do this problem can you do a step by step for me? A 47.0 mL of aliquot of a 0....

A: Given data: Volume of stock solution, V1=47.0mL Molarity of stock solution, S1=0.500M Molarity of di...

Q: assuming Ideal gus benavior, culcul ate the heut that Must bě trunsferved in eucin of the following ...

A: 1.) Given: flowrate of nitrogen stream (n) = 100 mol/min                                            ...

Q: The molality of a solution of water and calcium chloride is 3 moles per kilogram. Water acts as the ...

A:

Q: An aqueous solution is found to have an H+ concentration of 7.8x10^-2 M. What is the concentration o...

A: H+ concentration in solution = 7.8 ×10-2 M  

Q: At a reservoir in the neighbourhood of Delhi the following climatic data were observed Estimate the ...

A: Meyer's formula is  EL=Kmew-ea1+u916        ........(1)Where,Km= constant with a value of 0.36  for ...

Q: An equimolar mixture of NH3 and 02 is fed into the oxidation reactor. The feed stream is 100 mol /h....

A: Hello, you have posted multiple subparts to the question, we are solving the first 3 parts for you. ...

Q: If the measured input to a PI controller is a step change(Yₘ(s)=2/s) and the controller output chang...

A: The controller output of the integral control is pt=p+Kcet+1?1∫0tet* dt* Here, ?1=integral timeet=...

Q: What is the boiling point of the azeotrope? If a liquid with Xamm=0.2 is heated, at what temperature...

A: Azeotrope behave as pure liquid as the azeotrope boils at a fixed value of temperature. The composit...

Q: Problem 5. (2) Consider zirconia nanoparticle with spherical shape and radius r=4 nm. Under careful ...

A: Given:- Density(ρ)=5600 Kg/m3Radius( r)=4 nm =4*10-9 m                             =4×10-9mAverag am...

Q: Consider the Scherer coal fired power plant in the state of Georgia. It was built in the 1980’s. It ...

A: Given: Electricity produced from coal fired power plant = 3500 MW Efficiency of power plant converti...

Q: a) 1 mol of liquid ethanol is at 25 ºC, and has been adiabatically compressed from 1 atm to 20 atm. ...

A:                  

Q: Show that μ= (RT2 /PCP)*((∂Z/∂T)P) Where Z is the compressibility factor,the Joule Thomson coefficie...

A: Write the expression for Joule Thomson coefficient as follows: μ = ∂T∂PH       .......(1)           ...

Q: 300 /h of a0% mal Cate-80%en-LyHo mixture at 0 and LLatm and S00lh of a 45% mal (sHR-55% n-llHo.mixt...

A: Given the system consists of two inlets and one outlet. Inlet(1): Flow rate of gas, F1 = 300 L/h mol...

Q: For an equimolar feed, cyclohexane and benzene products of 98 and 99 mol%, respectively, can be prod...

A: Given information: Feed to the 2nd stage of the process, F = 9905 kg/h Mass fraction of benzene (B) ...

Q: Determine the mass, in kg, of 0.1 m3 of Refrigerant 134a at 4 bar, 100⁰C.

A:

Q: Chemical Engineering Question

A: organic matter has better waterholding capacity and also provide nutrient to soil so organic matter ...

Q: Does this reaction satisfy the law of conservation of matter? Use details to support your work. 2 H2...

A: Given: 2H2O2→H2+O2

Q: Cumene (C6H5C3H7) is produced by reacting benzene with propylene [A H; = -39,520 Btu] (See footnote ...

A: The basis of the given process is taken as 1200 lbm/h of the cumene (C) produced. Convert it into mo...

Q: What is the mass of 7.80  1018 carbon atoms? A. 1.30  10-5 g B. 6.43  103 g C. 7.80 ...

A: We are asked to calculate the mass of 7.8×1018 carbons.

Q: Consider a steel pipeline (AISI 1010) that is 1 m in diameter and has a wall thickness of 40 mm. The...

A: Given:- Inner diameter DI=1 mOutter diameter DO=1+0.040 m=1.040 mFluid temperature Tf=60C∘inner sure...

Q: Please solve as soon as possible.

A:

Q: In a manufacturing facility, 2-in brass balls (k = 64.1 Btu/h·ft·oF, ρ = 532 lbm/ft3, Cp = 0.092 Btu...

A: Given info diameter of brass balls,d=2 inch k=64.1Btu/h.ftoF Cp=0.092 Btu/lboF ρ = 532 lbm/ft3 Initi...

Q: The vapor pressures of heptane (substance 1) and octane (substance 2) are as follows: Temp(°C) va...

A: Given that, Temperature T = 110oC Vapor pressure of heptane at 110oC p1vap = 1047 mm Hg Vapor pressu...

Q: How many mL of solution will result when 15.0 g of H2SO4 (Molar mass 98 g/mole) is dissolved to make...

A:

Q: Calculate the %w/v of a solution made by dissolving 22.0 g CH3OH (methanol) in C2H5OH (ethanol) to m...

A:

Q: Two air stripping units are being installed at industrial sites. One will be used to strip Toluene f...

A: Given: Two air stripping units (A & B) installed in industrial sites for two different purpose F...

Q: Consider the Scherer coal fired power plant in the state of Georgia. It was built in the 1980’s. It ...

A: Given: Scherer coal fired power plant has a capacity to produce 3500 MW of electricity in US The pla...

Q: simplify the following block diagram showing the steps of the process to get to the final result.

A: according to sign given in diagram we will use like that only for - we will subtract, for + we will ...