assuming Ideal gus benavior, culcul ate the heut that Must bě trunsferved in eucin of the following cases. 1. a streum of hirrogen flowing fanebeA at a rare of 100 mol/min is neared from 20°l to lo0°C . 2. hitrogen contained in a 5-liter flusK at an Intial PresS Vye ot 3 bar IS COoled from 90°C to 30°C

Q: Give four challenges and suggest solutions for those challenges in biogenic formation

A: The challenges associated with biogenic formation along with the solutions are to be mentioned.

Q: 4.44 Calculate the volume occupied by 50 kg of propane at 35 bar and 50°C, using the following: (a) ...

A: Note: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question...

Q: Consider a steel pipeline (AISI 1010) that is 1 m in diameter and has a wall thickness of 40 mm. The...

A:  =7823 kg/m3  c = 434 J/kg.K (the above values are relevant for the average temperature of (-20+60)/...

Q: The system equations for two liquid surge tanks inseries are A₁dh′₁/dt=q′i−1/R₁h′₁,q′₁=1/R₁h′₁ A₂dh′...

A: The system equations are A1dh1'dt=q1'-1R1h1'        ........(1)A2dh2'dt=1R1h1'-1R2h2'        ..........

Q: im confused on how to do this problem can you do a step by step for me? A 47.0 mL of aliquot of a 0....

A: Given data: Volume of stock solution, V1=47.0mL Molarity of stock solution, S1=0.500M Molarity of di...

Q: If a liquid solution of HCl in water, containing 1 me absorbs an additional 1 mol of HCl(g) at a con...

A: Amount of HCl in solution = 1 mol Amount of water in solution = 4.5 mol Additional HCL = 1 mol Tempe...

Q: A mixture of n-hexane vapor and air leaves a solvent recovery unit and flows through a 70 cm diamete...

A:

Q: Explain in a table what are the differences between enantiomers and diastereomers.

A: Enantiomers Diastereomers 1) They are mirror images of each other. 1) They are not mirror images o...

Q: Use the data below from a Dumas experiment using CCl4 to determine the atmospheric pressure (in torr...

A: Given: Mass of flask (mf) = 386.316 g Mass of flask + condensed vapor (mf+mv)=388.872 g Volume of fl...

Q: 1. Write the reaction of lithium with cold water.2. Write the reaction of magnesium with steam.3. Wr...

A:

Q: When 0.625 grams of ethanol (62H5OH) undergoes combustion in a bomb calorimeter attaining a temperat...

A: Ans; Given  mole of ethanol =0.625 gTemprature difference =2.8∘CHeat capacity of calorimeter = 5.17 ...

Q: An old process for the production of hydrochloric acid requires heating a mixture of NaHSO4 and NaCl...

A: Mass of NaCl fed to the oven, mNaCl(fed) = 5844 lb/day Conversion is 95% The reaction occurring in t...

Q: Aqueous A reacts to form R ( A R ) and in the first minute in a batch reactor its concentration drop...

A: Given:-Order of reaction =2 Initial concentration Ci=2.03 mol/litFinal  concentration Cf=1.97 mol/li...

Q: Give four challenges and suggest solutions for those challenges in Butterfly valve

A: Our objective is to write the challenges and the solutions for those challenges in butterfly valve.

Q: (2) Fresh apple juice contains 70% water flowing at a mass flow rate of 120 kg/h. The fresh juice is...

A:

Q: One compartment in a gasoline tank truck has a volume of 11,860 liters. How much gasoline liquid (...

A: (1) Given that volume = 11860 L, P= 1 atm, T = 25⁰C = 298.15 K Value of gas constant R = 0.0821 atm....

Q: P6C.3 Although the hydrogen electrode may be conceptually the simplest electrode and is the basis fo...

A:

Q: Consider a system like the one shown in the figure. Tank A has a volume of 100 L and contains satura...

A: Given: Volume in tank A (VA)=100 L Temperature in tank (TA)= 250 °C The piston needs 300 kPa to lif...

Q: An aqueous solution is 15%wt salt. What mass of solute is used in this solution if the volume of the...

A: ( According to guidelines of Bartleby, we can only solve the first question, the remaining question ...

Q: Chemical Engineering Question

A: Hello !! Thanks for asking the question. You have asked 2 different full questions. The first full q...

Q: Please do 5 a

A: Given data: Volume of a mobile home= 100 m3 Ventilation rate = 0.38 ach (air changes per hour) Conce...

Q: Petroleum oil of 0.9 specific gravity and 13 centipoise viscosity flows isothermally through a horiz...

A: Given: The reading on the manometer is 3 ft.  that means h=3 ft And acceleration due to gravity g=32...

Q: In a pharmaceutical plant, a copper pipe (kc=400 W/mK) with inner diameter of 20 mm and wall thickne...

A:

Q: If the pressure inside a pressure cooker is 200 kPa, what is the boiling point of water insideit? Th...

A: Given: T1=373K Pressure of water at T2 (P2)=200 kPa latent heat of vaporisation of water(L) =2257 kJ...

Q: Can you apply Equation (2) at non-phase change temperatures? Why?

A: No, we cannot apply equation 2 at non-phase change temperature.

Q: Ethanol was burned with air and the combustion produced CO2, CO, and H2O. The feed contains 5.6% eth...

A: Write the reaction as follows: C2H5OH + 2O2 = 2CO + 3H2O        ......(1)C2H5OH + 3O2 = 2CO2 + 3H2O ...

Q: For the following reaction, 6.03 grams of potassium hydrogen sulfate are mixed with excess potassium...

A:

Q: The normal melting point of benzene, C6H6, is 5.5°C. For the process of melting, what is the sign of...

A: Since you have posted a question with multiple sub-parts, we will solve the first three subparts for...

Q: 3.) Convert the information given in the table below from the U.S. customary units to SI units. U.S....

A:

Q: A mixture containing 65.0 mole % acetone (A) and the balance acetic acid (AA) is separated in a cont...

A:

Q: A flow of 100 lb-mols/hr of a vapor containing 0.40 mole fraction NH3 and 0.6 mole fraction of H2O i...

A: Given:- Feed F=100lb mole/hrXF,A  = 0.4 mole  @ moles of ammonia in feedXF,W= 0.6 mole   @ moles of ...

Q: 4.20 Using the data in the following table, predict the relative degree of atomic solid solubility o...

A: The factors on which the atomic solid solubility of an element in another element are: Atomic size:...

Q: 8. Sodium chloride is added in cooking to enhance the flavor of food. When 10.00 g of NaCl are disso...

A: Given data: Mass of Nacl = 10g Initial water temperature = 25°C Volume = 200mL density = 1gm/mL    

Q: There is a nickel coating process. The area of materials 2.5 dm2, is coating by current flow is 75 m...

A: Area=2.5 dm2=250 cm2efficiency, η=.95time for current flow =75 min =75*60s=4500Current, I=1.2AmpAtom...

Q: 1.35 kg is suspended by a A sphere with diameter D = 0.12 m and mass m = jet of air as shown below. ...

A: Given data: Diameter of the sphere = 0.12 m Mass of the sphere = 1.35 kg Drag coefficient fro the sp...

Q: Calculate the value of ∆H°rxn for the reaction: N2H4(l) + O2(g) → N2(g) + 2 H2O (l) Using the follow...

A: Write the reactions as follows: N2O (g) + 3 H2 (g) → N2H4(l) + H2O (l); ∆Hrxno= -317.0 kJ Multiply w...

Q: Fill in with the suitable word:pH of 7 = _________________________solution.pH greater than 7 =______...

A: the pH of 7= neutral solution. pH greater than 7 = basic solution. pH less than 7 = acidic solution....

Distillation

Distillation is a process/technique to separate more volatile components from less volatile components using the principle of relative volatility. In chemical engineering, distillation is one of the most common and important topics that is involved in almost every industry and process.