Answered: Given a four pole IM connected to a…

Given a four pole IM connected to a 50-cycle 3 phase circuit. Calculate the airgap diameter (rotor diameter), given that the peripheral velocity at synchronous speed is 3500 fpm

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter6: Power Flows

Section: Chapter Questions

Problem 6.48P

See similar textbooks

Related questions

Q: b) The speed of a separately excited motor is controlled by a single-phase semiconverter in Figure 1...

A: Given: The speed of a separately excited motor is controlled by a single-phase semi converter in the...

Q: The single-phase half-controlled rectifier shown in Fig.3.11 operating at a triggering angle of 60° ...

A: The solution is given below

Q: 3) For the Half-Wave Rectifier circuit shown below, determine: the Transformer Turns ratio, n [ IEEE...

Q: 22. Let z(t) and y(t) with Fourier transforma X) and Y) respective below then Y (w) is a. ) x- C. X:...

Q: Calculate the line and phase current drawn by the load

Q: Given the circuit fed by 3 phases 380V phase to phase voltage, with 50HZ. a) Draw the power triangle...

A: In this question, 2 parallel loads are given. Draw the power triangle. We know Power P= S cos(V^I) R...

Q: 2. The LTI system with h(t) = 8(t – 1) + e*u(-t-- 1) is %3D a. causal and nonstable b causal and sta...

Q: With R, set at 15 ohms and R2 set at 30 ohms, close the circuit and take readings of I,, 2, and la. ...

A: Given circuit consist of two resistors R1 and R2 are connected in parallel across source voltage. R1...

Q: why is the current in the multimeter and power supply the same in tinkercad? but when the positiv...

A: Multimeter uses a D'arsonval movement that has a resistance of 200ohm and a full-scale current of 50...

Q: Given a star connected system with power factor of 80 percent, true power of 2,500 kW and phase volt...

Q: A cylinder whose radius is 2cm and altitude of 100cm is uniformly wound with 2500 turns of wires in ...

A: The solution is given below

Q: Question 4. The signal r(t) = A+ B sin(C't + D) can be expressed in exponential form as r(t) = Σ whe...

A: The given question can be solved by using proper method of Fourier series expansion as the signal gi...

Q: 20. Which of the following cannot be the Fourier series expansi a periodic signa a. all of these can...

A: Fourier series is only for periodic signals

Q: Determine the trigonometric Fourier series to represent the periodic voltage function v() shown in F...

A: "According to the Company's policy, we will solve the first subpart of the question". Given the sign...

Q: The resonance frequency wo of the circuit shown below is.. rad/s 10 mH lle 0.5 mF 102 V cos ot O 320...

Q: A 400-amp circuit breaker protects a feeder that's installed in a nonmetallic raceway that requires ...

A: Circuit Breaker- It is used as switch which works as a safety device for the circuit and circuit ele...

Q: 16. Evaluate y(t) = sin(t) * rect at t = 0 %3D 2 a. y(0) = sin(7)dr %3D b. none of these c. y(0) = 1...

A: The given question can be solved by using the integral Definition of convolution. The solution can b...

Q: FIGURE R4 20 R5 V1 102 3PH C1 120V 60HZ 1mF L2 10mH Figure 3.1

Q: Find the magnitude of voltage gain corresponding to a decibel voltage gain of 55 dB.

Q: 3. Calculate the capacitance of a 3-phase transmission line equilaterally spaced at 6m if conductor ...

Q: ww 2 ΚΩ Vo 15 KO 10 mA Consider the following circuit and find the output voltage D zenon -150 V -30...

A: Brief description : Operational amplifier is active device which have the capability to deliver powe...

Q: Spectrum of z(t) 15 -9 w rad/s 15 wo = 3 b. wo = 6 2 We2 TE C. none of these d. wo = 1 e. wn = 1/3

Q: 4. CMOS Logic Gate The PUN of a CMOS Logic Gate is shown below Vdd B-d 02 c 'Q3 B-das A-예- Q6 Q4 Q7 ...

Q: The EMF induced in the secondary winding of a 50 Hz single-phase transformer having 500 turns on its...

Q: X = 6 N Xc = 10 N ll + UL %3D R = 20 t UC + UR e = 70.7 sin 377t ZT

Q: 12. If u[n] is the discrete-time unit step function. Then u[-n - 1] + u[n- 1] is equal to (a) u[n] +...

Q: Q3: In the circuit shown below determine Thevenin's equivalent circuit and find the maximum power of...

Q: 15. Consider the signal r(t) = 3 cos(2nt-/4). Determine the fundamental period of the signal y(t) 4r...

A: In this question, Choose the correct option What is fundamental time period We know time period T= ...

Q: 17. A fanction is given by a(t) sint + cos 2t. Which of the following is true a 2(t) has frequency c...

Q: 4) Write a truth table for the function performed by the CMOS transistor. The truth table should hav...

Q: Phase a of a 3-phase system is given by, ean = 155.56cos(377t)V. There is a balance load comprised o...

Q: 1. Obtain the truth table of the following functions, and express each function in sum-of-min- terms...

Q: The overall voltage gain in multistage amplifier system is the: * 5 zefno none of them is correct Ex...

A: The solution is given below

Q: Question 11: Evaluate the following integral y(t) | 5t2u(t – 3)6(2t – 4)dt A: 20 B: 10 C: 0 D: 40 E:...

Q: 2. Show how the output conductance of a transistor affects the voltage transfer characteristics (but...

A: Transfer characteristic of a cross coupled inverter represent the the relation between the input and...

Q: 40 50 A V OE OC 41.17 09 09 S000- time Fig. 4 6) The waveform of iz can be expressed as: (1) 50cos(1...

A: It is cosine function with delayed

Q: jw X(W) = jw 9. If X(w) = then #(t) is 2 tjw %3D 2+jw a. none of these 2F b. 2e-(t8(1) d 2e-245(t) (...

Q: V* = 10V Rg = 5kN Ro = 20k2 Cc - R. Ro = 3.19kN Ro = 19.72 1 k2 R 93.72 R. 13.90 v- = -8V The transi...

Q: termine if the given statement is a proper way to handle electricity or not and explain why ( or why...

A: A. Inserting a conducting material in socket : It is known that in conductor a very high current flo...

Q: find the voltage V in 62 15V 102 50 20 V

A: In this answer we will find the value of V as explained below. We will use the concept of delta-star...

Q: Consider the circuit diagram below, where the load is indicated by the dashed box. Compute the appar...

A: Given circuit,

Q: 100 A 220 V 50 Hz 0.138 H f(x) = 0 90 ohm Solver Configuration Electrical Reference

Q: The following data were obtained on a 20 kVA, 50 Hz, 2000/200 V Transformer: SCT: 60 V, 10 A, 30o W....

Q: Energy conservation in electrical drive is achieved by reduction of losses in its various parts. Exp...

A: Power factor play important role in the electrical system because good power factor means energy smo...

Q: d) Find the complex power supplied by the source after adding the capacitor bank. e) Explain why hig...

A: In this question of last part 2. We need to determine the total. Complex power In the load after cap...

Q: 100 A 220 V 50 Hz 0.138 H f(x) = 0 90 ohm Solver Configuration Electrical Reference

Q: 7. The Fourier series of an even and half-wave periodic function, contains only a. none of these odd...

A: In this question we will write about Fourier series of even half wave periodic function....

Q: 1. Simplify the function below together with its don't care condition to r-SOP using Karnaugh map. F...

A: In this question, We need to simply the given minimum expression with don't care conditions into SO...

Q: 13. A signal z(t) has the following energy spectral density The total ener of the signal is a. 1/4m ...

Q: 15.Calculate the DAC output of 010000 by R-2R ladder network method, and circuit analysis. Assume th...

A: In this question, We need to determine the DAC output of 010000 by R-2R ladder network method. I...

Question

Given a four pole IM connected to a 50-cycle 3 phase circuit. Calculate the airgap diameter (rotor diameter), given that the peripheral velocity at synchronous speed is 3500 fpm. (ILLUSTRATIONS such as diagrams and graphs are Required).

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Given a six pole IM connected to a 60-cycle 3 phase circuit. Calculate the airgap diameter ( rotor diameter), given that the peripheral velocity at synchronous speed is 4090 fpm.
a) 3-phase star-connected synchronous generator supplies a current of 10A having phase angle of 20° lagging 400V (phase voltage). Given the direct and quadrature axis reactances as 10ohms and 6.5ohms respectively and neglecting armature resistance, Find: 1. The load angle 2 The direct and quadrature components of armature currents 3. Voltage regulation
The fuel-cost curves for two generators are given as follows: C1(P1)=600+18P1+0.04(P1)2C2(P2)=700+20P2+0.03(P2)2 Assuming the system is lossless, calculate the optimal dispatch values of P1 and P2 for a total load of 1000 MW, the incremental operating cost, and the total operating cost.
For Problem 3.18, the motor operates at full load, at 0.8 power factor leading, and at a terminal voltage of 10.45 kV. Determine (a) the voltage at bus 1, which is the generator bus, and (b) the generator and motor internal EMFs.
A 3 phase, star connected synchronous generator supplies current of 10A having phase angle of 20º lagging at 400V. Find the load angle and the components of armature current Id and Iq if Xd = 10 ohm and Xq = 6.5 ohm Assume armature resistances to be negligible
A synchronous generator is connected to an infinite bus by a transmission line as shown in the figure. The field current IF = 900A when the unloaded generator is synchronized to the infinite bus. a.) P_M is increased to 0.5pu while I_F is held constant at 900A. Find the complex power S_Inf supplied to the infinite bus in per unit. b.) Determine S_Inf in per unit if IF increases to 1600A and PM is held fixed at 0.5pu.
A 230V, 50Hz, four-pole, three-phase, star connected synchronousmotor has a synchronous resistance and reactance of 0.1 and 1.5 inohms per phase, respectively. If the synchronous motor operateslightly with a load angle of 5 degrees and a back electromotive force(emf) of 120V per phase, determine:(i)The effective armature voltage per phase(il) The armature current per phase(ill) The power factor of the motor
(a) A short shunt cumulative compound dc generator supplies 6kW at 235V. The Shunt field resistance, Series field resistance and Armature resistances are 8012, 0.192 and 0.22 respectively. Calculate the induced emf and load resistance.
Explain the concept of economic dispatch in power systems. How does it optimize the generation of power in a multi-generator system?
1- Static synchronous compensator (STATCOM) for powe factor improvement. 2- What is penalty factor? Derive the expression for the penalty factor in economic load dispatch.
Derive emf equation of the synchronous generator.
Draw the per-phase equivalent circuit of a three-phase synchronous machine considering the presence of armature reaction. Explain the relationship of the induced electromotive forces (EMFs) and the armature reactance.