Given a three-stage system with an input power Pin = -26 dBm and power gain of the three stages of AP1 = 23 dB, AP2 = 1.995 , AP3 = 16 dB, determine, the total gain in dB __________ , the output power (Pout ) in dB __________ and find the output voltage in dBmV ____________ if RL = 2 kΩ.

Given a three-stage system with an input power Pin = -26 dBm and power gain of the three stages of AP1 = 23 dB, AP2 = 1.995 , AP3 = 16 dB, determine, the total gain in dB , the output power (Pout ) in dB and find the output voltage in dBmV ____ if RL = 2 kΩ.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter13: Transmission Lines: Transient Operation

Section: Chapter Questions

Problem ECSQ

See similar textbooks

Related questions

Q: 102 1mH 1mF

Q: At what potential should the cyclical sweep begin? O open circuit potential O anodic peak potential ...

A: The current response of a redox active solution to a linearly cycled potential sweep between two or ...

Q: 1) What is meant by measurement? 2) What are the basic requirements of measurement? 3) State the two...

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you ar...

Q: RE a coring distance was sent down the spring. a. On the diagram, indicate which cup(s) were hit by ...

A: (a) In the tutorial of superposition and reflection of pulse, there is a pulse reflected from the fr...

Q: 50 2 ww R1 A V = 10 V=

A: Given that circuit

Q: R1 20 R3 R2 100 V 80 240Vpk 60HZ C2 = 20μF L3 6H

Q: Two shunt generators A and B operate in parallel and their load characteristic s may be taken as s...

A: It is given that: EgA=240 VVA=220 VIA=200 AEgB=245 VVB=220 VIB=150 ACommon load supply=300 A

Q: In the circuit shown, find V2, I3, I2, l1, and V1 . R2 1 kN R, R3 3 kN 5 mA ↑ V, V2 RA 4.5 kN 6 kN

A: This question belongs to circuit theory . It is based on the concept of kirchhoff's current law . It...

Q: A 6 pole, 3 phase, 50 Hz alternator has 12 slots per pole and 4 conductors per slot. The winding is ...

A: This question belongs to electrical machine . It is based on induced e.m.f. per phase in a three ph...

Q: A circuit has an impedance Z = 2 - j5. What is the power factor?

Q: For the LC oscillator shown in Figure 1: a) Identify the type of LC oscillator b) What is the freque...

Q: washing machine is, in effect, an RL circuit. If the machine takes 311 W and 4.5A from 115-V source ...

Q: AC or DC coupled Type of waveform Chopped or alternate mode.

A: Answer- 4 Since both waveform of signal-1 and signal-2 are periodic therefore the average value of ...

Q: intrinsic carriers

A: Doping in semiconductor- When impurity us added to a intrinsic semiconductor intentionally for enhan...

Q: In the electronic circuit given below: O+9V O +9V 1, = 0.8 mA oVs +VGs VSD 1 V, ID3R, = 4 kSN If IDS...

A: We need to find out source to drain voltage for given circuit

Q: The rms value of a half wave rectifier sine wave is 200A. The rms value for full wave rectification ...

Q: A 60 cycle current has a maximum value of 6.5A. What will be the instantaneous value of current at (...

A: Note: As per the policy we can solve only one question at once please reupload the remaining one as ...

Q: 1. A flat, square surface area with side of 4m is in the xz-plane at y=0, Find the magnitude of the ...

A: This question belongs to electro magnetic field theory . It is based on the calculation of magnetic ...

Q: Duse theor imo voltage across terminals A and B and the load current in the circuit 6 V 12 V

A: Given circuit

Q: Example Determine Vo, I,, Ipi, and Ip2 for the parallel diode configuration. 0.33 k2 R 10 V DSi D; S...

Q: 20 R, G- 10 A R30 R, 50

Q: Sensor Circuit Light Source Control Alarm Photodiode Circuit Circuit 9. Which may not be used as an ...

A: Given, Alarm circuit is LED source ---> Photo Diode ----> Control Circuit ----> Alarm circ...

Q: Q3/ Using nodal analysis, find the branch currents in circuit below. V3 12 8. A B R1 R3 R5 10 +. V1 ...

A: By Nodal Analysis,KCL at node A,VA-1212+VA6+VA+10-VB4=0⇒0.5VA-0.25VB=-1.5 ....... 1By KCL at node B,...

Q: identical, 3-phase, Y-connected alternators A and B share equally a load of 10MW at 33kV at 0.8pf la...

Q: Given a transistor amplifier of gain ß = 100 with emitter bias, determine the values of Rb and Re ...

A: Given a transistor amplifier of gain ß = 100 with emitter bias, we need to determine the values of...

Q: 100 V Ideal diodes 2.2 k2 -100 V

Q: An impedance coil is connected in series with a capacitor across a 220 V, 60 Hz ac supply. The circu...

A: In this question, An impedance coil is connected in series with a capacitor across a 220 V, 60 Hz ac...

Q: 100-mH inductor is connected in parallel to the series connection of a variable resistor R and a 20-...

Q: Find the two elements in a series circuit (i.e., R and L, or R

Q: 7. Which device may suit the block for the photodiode? Sensor Circuit Light Source Control Circuit A...

Q: 1- Identify the DC motor that can be used in Electric Traction vehicles. Also, explain the requireme...

A: Ans:- In case of traction DC Series motor is a preferable choice. DC series motor will be analysed f...

Q: A cube is defined by 1 âz + e»²e²ây + 3e*e2²âz D =

A: The gauss law for calcuating the flux is given as: ψ=Q=∯D.ds→=∭ρvdv In the given formula ψ=flux pass...

Q: 50 Hz, 2 pole, 3Φ star-connected turbo alternator has 54 slots with 4 conductors per slot. The pitch...

A: The solution can be achieved as follows.

Q: Enumerate five step-by-step procedures of Superposition theorem method in application to ac electri...

Q: Voltage to Current Converter with Floating Load (In phase) Design a Voltage to Current Converter...

A: Given: For a Voltage to Current Converter with Floating Load, assume that a 10 V input voltage with ...

Q: Introduction of the kind of application used by Voltage Controlled Boiling to surfactants.

A: Bubble formation governs the process of boiling, which has been used to power enterprises since the ...

Q: In an Amplitude Modulator where the carrier and modulating signals are both sine waves, the frequenc...

A: In this question, We need to determine the equation of the modulating signal, bandwidth the signal?...

Q: Explain what RLC circuits do and how they work including transformers, where applicable.

A: It is asked to explain what RLC circuits do and how RLC circuits can work including transformers als...

Q: 2Ω 4Ω 3Ω 10V 5Ω 62 Vo 20V

A: The given circuit diagram is shown below:

Q: Find rn] for each DTFT given below: (a) Xa(w) = e-juš +e-ju9 (b) Xa(w) = e-ju25, wEl-T,7) (c) Xa(w) ...

Q: Given v1 = 20 sin (ωt + 60˚)V and v2 = 60 cos (ωt - 10˚)V, determine the phase angle between the two...

Q: 13.31 There is no energy stored in the capacitors in the PSPICE circuit in Fig. P13.31 at the time t...

Q: When an impedance coil is connected to a 100 V, 60-Hz, ac supply, the circuit current is 1.325 A. Wh...

A: In this question, We need to determine the inductance and resistance of the coil. If current is gi...

Q: Solve for ID (mA) in a JFET given the following: IDSS=11.8mA VGS=-1.55V VGSoff=-4.9V

Q: Find the equivalent inductive reactance if the frequency is 65 Hz

A: This question belongs to circuit theory . It is about calculation of equivalent inductive reactance ...

Q: Find the transfer function of the following differential equation: d?y 1. dt2 dy dx +11+ 24y(t) = 5+...

A: In this question, We need to determine the transfer function? If differential equation is given. ...

Q: A series circuit contains an inductance of 0.1062 mH, a capacitance of 106 pF and a resistance. At r...

Q: An LTI system can be described by the equation (D² + 6D+5)y(t) =(D+1)x(t). (a) Find the characterist...

A: Here we have given the LTI system(D2+6D+5)y(t)=(D+1)x(t)(a). the characteristics equation of the sys...

Q: For the voltage-divider configuration of the figure below: Show the details of your work. ...

A: The given circuit is shown below:

Q: . The front end of a television receiver, having a bandwidth of 7 MHz and operating at a temperature...

A: As per the guidelines of bartleyby I have to answer only first question.Here it is only 4th question...

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

Given a three-stage system with an input power Pin = -26 dBm and power gain of the three stages of AP1 = 23 dB, AP2 = 1.995 , AP3 = 16 dB,
determine, the total gain in dB __________ ,
the output power (Pout ) in dB __________ and
find the output voltage in dBmV ____________ if RL = 2 kΩ.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

For the system shown in Figure 2, find the equivalentsingle transfer function by using(a)Mason`s rule and(b)Reduction of block diagram method.
Q:- which characteristic of an analog signal are changed to represent the lowpass analog signal in each of the following digital-to-analog conversation? a)ASK b)FSK c)PSK d)QMA.
Figure 1 shows the equivalent circuit of a voltage amplifier with a source and aload connected to its input and output, respectively. Suppose that the sourceinternal resistance is Rs = 5 kΩ, the amplifier input resistance is RIN = 95 kΩ, theamplifier gain is A = 100, the amplifier output resistance is ROUT = 150 Ω and theload resistance is RL = 5 kΩ. For a sinusoidal input with amplitude VS = 5 mV, whatis the amplitude of the voltage VL across the load resistor RL? What would thevoltage across the load be without the amplifier?
Will upvote for quality result!
Ignoring the “zero” in the numerator, and based only on the denominator of the closed-looptransfer-function, determine the range of constants Kp and Ki such that the rise-time of theclosed-loop system is equal (or less than) ?r =0.18 s and so that the relative damping factor ζ isequal to (or greater than) 0.8. Use the textbook approximation for the rise-time.
For V = ± 6Volt and C1 = 0.001 µF in the Phase Locked Loop (PLL) circuit given belowa) Find the free running frequency (f0)?b) Find the deadlock range? Calculate the lowest and high frequency for locking?c) Find the capture range?
Determine the output voltage value of a transistor amplifier circuit by frequency for 1.923 V to input voltage. Instead of. Calculate the gain in dB for the frequency given in the table. Maximum write down the frequency (s) where the gain is halved in terms of power (3dB). Frequency curve draw as
Solve for voltage gain
The forward transfer function G(s) with a H(s) feedback configuration of an uncompensated Basic Satellite Launching System is as shown in figures 1 and 2. A- Write a m-script and generate the time and frequency response of the system shown in Figure 1. (a = 4, b = 2, c=2, d = 1and e=10, and f=4). B- Compute the percent overshoot, peak time and settling time, using second order approximation through pole zero cancellation and unity feedback configuration shown in figure 2.
In a summing inverting amplifier,Rf is 100k ohms, V1 is a sinusoid with 2V amplitude and frequency of 1Hz ,R1 is 10k ohms, V2 is a sinusoid with 3V amplitude and frequency of 1Hz, and R2 is 10k ohms. Vs+ = 18 V and Vs- = ground. What is the output voltage? Please draw the waveform as well.
Q1) What is the output power in dBm ? Diagram is-
For this question, I just need to understand if the analogy is a Multiplexer, Demultiplexer, Encoder, Decoder or Adders. If you could please explain, thank you! Identify the correct combinational circuit in the following analogy. Consider a four-room high-school with a microphone in the principal's office and speakers in each room. By configuring two switches, the principal can specify which room will herher voice.