i need the answer quickly Given FM andd PM modulators with the following parametos.FM medulatorPM meduladorke: 1.5 knz/vkP = o75 vod/vfc Su0 KH2fe: 500 kHzUm : 2sin(27 2kt)Um - 25in (2r zkt)Determine the modulatian in detes and sketch the opspectrums for be th modalatorg.Ochange the modulating signal amplitude Ror both moehulatorsto 4 Vp andrepent step @O change the modilating signal frequency for ba thmedulators ato I kz and repent step .

According to the question, for the given data of FM modulator and PM modulator, we need to find the…

Given FM and PM modulators with the following parameters. FM modulator PM modulator kg = 1.5 KM₂/V KP: 0.75 vad/v fe= 500 KHZ fc = 500 KHz Um = 2 sin(2x 2kt) Um = 25in (2K₂kt) O Determine the modulation indexes and sketch the op spectrums for both modulators. I change the modulating signal amplitude for both modulators to 4 Vp and repeat step@

Given FM and PM modulators with the following parameters. FM modulator PM modulator kg = 1.5 KM₂/V KP: 0.75 vad/v fe= 500 KHZ fc = 500 KHz Um = 2 sin(2x 2kt) Um = 25in (2K₂kt) O Determine the modulation indexes and sketch the op spectrums for both modulators. I change the modulating signal amplitude for both modulators to 4 Vp and repeat step@

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

then second questrion po eh eto 2. Determine the over-all transmittance of the signal flow graph shown below.
d) Determine the value of the gain Acl and voltage Vout?e) Determine the ACL and Vout of the circuit if it has a combination of Ri and Rf as followsi. Rf= 12kΩ and Ri= 750Ωii. Rf= 27kΩ and Ri= 1.5kΩiii. Rf= 100kΩ and Ri= 20kΩ
Sketch the waveforms of the inductor current, the current through the filter capacitor branch, and current through the load resistance. Describe the nature of the current through the equivalent series resistance (ESR) of the capacitor. What is the effect on the shape of the current when the value of the ESR is increased? Explain how the switching frequency component is eliminated by the output filter network. The efficiency of the buck converter decreases with an increase in the load current. Justify What is the effect of increasing switching frequency on the current ripple of the converter?
Q2 (A) A frequency modulator is supplied with a carrier at frequency fc = 5 MHz and an audio tone signal of Am = 1 volt amplitude and frequency fm = 1 kHz. It produces a frequency deviation f of 10 kHz as the output of the frequency modulator. (3)(i) The FM waveform described above is passed through a frequency multiplier with a total multiplication factor of 18, that is, fout = 18*fc. After passing through the frequency multiplier, what is the frequency deviation f at the output?(ii) The output of the multiplier in part (a) is next input to a mixer stage with the LO oscillator frequency set at fLO = 55 MHz. Find the sum-frequency output fo of the mixer’s IF port and also find the magnitude of the frequency deviation f.
What can you say about AM DSB-FC, AM DSB-SC, and AM SSB? What do they have in common and their difference?
For V = ± 6Volt and C1 = 0.001 µF in the Phase Locked Loop (PLL) circuit given belowa) Find the free running frequency (f0)?b) Find the deadlock range? Calculate the lowest and high frequency for locking?c) Find the capture range?
What is the high-frequency gain and cutoff frequency for this circuit if R1 = 20kΩ, Rin=100kΩ, and C=100nF?
a. At what frequency is the gain equal to 0 dB? (in Mrad/sec)b. At what range of frequencies is the phase equal to 90∘? (in form: Mrad/sec ≤ ω ≤ Mrad/sec)
The circuit show in figure has fr=200MHz, Cbc=1pf, Cbe=50pf, 1rbb=0 and rbe=1kohm. Derive an expression for Av=Vo/Vs at high frequency and find the value of effective fH
The figure shows multiple modulation schemes for the signal that is given by the dashed line sinusoidal function, the X-axis is the time axis is seconds and the Y-axis is the amplitude. Answer the following: What is the quantization noise in a modulator that uses a 4-bits register for the analog to digital conversion of the given sinusoidal signal? Please give deatiled solution for good understanding
For the filter in the Figure shown: (a) What is the critical frequency? (b) Looking at the critical frequency formula, how would you increase the critical frequency value? (c) What is the voltage gain? (d) Looking at the voltage gain formula, how would you increase the gain?
For the circuit show in figure. Derive an expression for Av=Vo/Vs at high frequency and wh for the input and output circuit.