Answered: Given the following Resistances and…

Given the following Resistances and Voltage source parallel to each other: R1 = 92 ohms R2 = 5 ohms R3 = 56 ohms Vs = 73 Volts What is the Power of R1 in watts?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter11: Conduction In Liquids And Gases

Section: Chapter Questions

Problem 8RQ

See similar textbooks

Related questions

Q: II. Express the notations below in rectangular and polar form 7. ej0.92 jn 8. е 6 j4T 9. е з

Q: 12. Determine the work needed to move a 13.3 mC charge from 1.2 mm to 0.41 cm. 20 pr for th

Q: 2. Apply Ohm's law to the following problems: a. A current of 0.0021 A flows to a resistor having a ...

A: By ohms law , Voltage across the resistor = current ×resistance.

Q: For the combination resistor shown below, calculate the equivalent resistance for the entire circuit...

A: Given, R1=23.7 ΩR2=34.1 ΩR3=74 ΩR4=45 Ω

Q: Activity 3: Electric Motor Vs. Generator Objective: Compare the electric motor and generator You wil...

A: Given: Details of electric motor and electric generator. To find: Venn diagram for electric motor an...

Q: A magnetic circuit has a 20 V battery connected to an 80 2 coil of 800 turns with an iron bar of 2 m...

Q: Find the width of the depletion layer in a germanium junction diode which has the following specific...

Q: 100 kN 15 V = 10 V 56 kN RL (©) figure also for Norton's theorem

Q: Calculate the total capacitance in the series circuit

A: In this question series circuit of capacitances is given....We have to find out total capacitance......

Q: Q4/ Use Source Conversion technique to find the load current IL in the circuit below. IL R1 R2 R3 V1...

A: The given circuit is shown below: The 12 volts voltage source with the series resistance of 6 Ohms...

Q: Problem 5. while that of the other is -0.43m/s. If the collision is perfectly elastic, what is the f...

Q: Given the circuit below. i, (t) = v210 cos(377t). Give your answer in four decimal places if it is n...

A: Belief description: For an AC circuit we have 3 types of powers such as real power, reactive and com...

Q: Use spherical coordinates to find the volume of a hemispherical shell of inner radius 2.00 m and out...

A: Brief description: In electromagnetic theory we have three type of coordinate systems such as Car...

Q: Which of the following statement is fake? Current is proportional to voltage Resistan ce is inversel...

A: 1. Which of the following statement is false. A. Current is proportional to voltage B. Resistance i...

Q: A coil connected in series with a resistance are supplied from a 240 volts 60 Hz source draw 1.0 amp...

A: Here, we have given a circuit where, the resistor and the inductor are connected in series. The sup...

Q: What is the value of Vgs, when Id is.10 ?constant reference voltage Vdd =12V @

A: For a circuit, The reference voltage is 12V. and The drain current is constant.

Q: How does the voltage across R1 compare with that through R2? What is the connection between the tota...

A: The given circuit is a parallel-connected resistor with the voltage source. In parallel connection t...

Q: Fine the transfer function Vetsy V(s) of the system:

A: Transfer Function The relation between the Laplace transform of the output and the input when all i...

Q: What is the resulting PDN equation of Y = A'B' + A'C'

Q: What is the magnetic field intensity in a material whose relative permeability is 1 when the flux de...

A: Given a material having, Relative permeability, μr=1 Flux density, B=0.005 T

Q: if a transformer has a primary rated voltage of 480V and requires 40V to produce the rated current i...

Q: Consider the circuit shown in below Figure, Find values of the resistances R1 and R2 that cause the ...

Q: Explain why Silicon and Germanium are the most common semiconductor materials used in Electronics De...

Q: The input current to a 220v, compound motor at no load is 6 A. The shunt field circuit resistance is...

Q: 1.) For the circuit shown below, determine (a) the total circuit capacitance (b) the total energy in...

Q: in 6 4 2 IL R1 R2 R3 V1 12 R4 12 6 11 RL 6

A: SOLUTION- for the source transformation,

Q: A person draws 3 balls in succession from a box containing 5 red balls, 6 yellow balls and 7 green b...

A: The solution is given below

Q: Determine the values of the node voltages, v1, V2 and v3 in the circuit shown. 15 V 50 Ω 10Ω 20Ω 25 ...

A: In this question, 3 independent voltage source is given. Find the Voltage at the 3 nodes as shown ...

Q: 2. Use the circuit in Figure P4.2 to solve for the numerical values of the quahtities requested. a) ...

A: We have given the following problem

Q: 2. A magnetic circuit has a 20 V battery connected to an 80 Q coil of 800 turns with an iron bar of ...

Q: On a deck of cards, 2 cards are draw at random. What is the probability of getting an A and a king? ...

A: The solution is given below

Q: A receiver consists of an antenna with a noise temperature equal to 120 K that feeds an attenuator w...

Q: Determine the output (M) for the J-K flip-flop and the inputs shown in Figure 3. [Tentukan output (M...

Q: What is the speed of a 100 Kw, 230 Volts , 3 phase , 4 pole , 60 Hz , alternator 1800 RPM 1700 RPM 1...

A: Consider the formula for the speed is, N=120fp Here, f is the frequency and p is pole.

Q: Sketch the output waveform. Show your complete analysis. 1. Vigat R E CITY RSI" IN 2.

Q: 4. Use the circuit shown in Figure P4.4 to find the indicated quantities. a) Find the power delivere...

Q: 7. Refer to the graphics appendix. What is the total resistance of the circuit? 1500 Ohms 400 Ohms 3...

Q: Calculate the area of the surface using the differential surface a r = 10, a/4 < o < 2a/3, 0 < ¢ < 2...

Q: What is the difference between time and frequency domain?

Q: Find the cross-sectional area of a round conductor in square mils if the conductor's diameter is 11/...

A: Given Diameter of round conductor is d = 11/16. Fnd area of round conductor in square mils.

Q: State the frequency of the 7th harmonic of a 2KHZ sine wave? O i) 14Khz O ii) 9KHZ O ) 5KHZ O iv) 2K...

A: Given: A sine wave with Fundamental frequency, f=2 kHz Harmonic is 7th.

Q: In an ideal pn junction with an ideality factor of 1 at T = 300 K, the magnitude of the reverse-bias...

A: Consider the formula for the diode current is, I=I0eVηVT-1 Consider the given ideal factor is 1 then...

Q: Q9. Determine the voltmeter reading in Figure 2, if the 4.7 k (R3) resistor is open. What is the rea...

A: We will replace the voltmeters with the symbols for voltmeter. So, the simplified circuit will look ...

Q: What is the Voltage per Phase? O 4340 Volts O 4430 Volts O 4530 Volts O 4360 Volts

Q: Problem 2: Thermal Units with Linear Cost functions (Linear Programming) Given two ONLINE thermal un...

A: The thermal units are given below,For Unit1-F1=500+5P1 300MW≤P1≤200MWFor Unit2-F2=300+3P1 20MW≤P...

Q: 1. A 1Ø, 2 wire distribution line, 1280m long has an impedance per conductor per km of 1+j2.52. The ...

Q: IT = P1 = R1 = P2 = R2 = P3 = VI = PT =

A: NOTE: As per Bartleby guidelines for multiple questions , I supposed to do only first one... Thanku ...

Q: A CE amplifier uses a BJT with ß = 100 biased at IC = 0.5 mA and has a collector resistance RC = 15 ...

Q: 2) Simplify the following functions using ONLY Boolean Algebra a) F = Ā.B +Ā.B.Č + (A + Č) b) F = (B...

A: 2. a) Given: F=A¯·B¯+A¯·B·C¯+A+C¯¯

Q: In the series combination of a 300 ohm resistor, 0.25 H inductor, and a 1 microfarad capacitor, find...

Question

100%

Given the following Resistances and Voltage source parallel to each other:

R1 = 92 ohms

R2 = 5 ohms

R3 = 56 ohms

Vs = 73 Volts

What is the Power of R1 in watts?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Using nodal analysis, what is the power absorbed by the 2-ohms resistor?
The allowable ampacity of a 4 AWG THHN from Table 310.15(B)(16) is 95 amperes. What is this conductors ampacity if connected to a terminal listed for use with 60C wire? ______
1) - Is a resistor an ohmic or a non-ohmic conductor? Explain in detail. 2) - Why would you plot a graph of I versus V and not V versus I. So in this case, I is the Y axis and V is the X axis
Choose the correct answer In the USA, the heating element inside a hairdryer is marked as follows: (120V, 2400W). What is the resistance of the filament in the lamp? (HINT: Use Ohm's Law and power "law" equations). A. 10 ohm B. 4800 ohm C. 2 ohm D. 6 ohm
4. A 1-ampere fuse has a resistance of 0.2 ohm. It will melt or blow when the instantaneous current through it is large enough to create power loss of 5 watts. What is the value of the “melting” current? answer asap provide soln
why use V1 = 4V but not E1=2V or the other voltages?
What dimensions are used when measuring the area of building?See PEC 2.20.12?
A cable one mile long and 0.50 inches in diameter is composed of a steel core 0.25 inches in diameter and the outside shell is aluminum. The resistance of the cable is _____ is Ps and Pa 57.4 and 17.5-ohm Cmil/ft, respectively Choices: a.) 0.447 ohm c.) 0.625 ohm b.) 0.893 ohm d.) 5.3 ohms
If a nonlinear resistor has a voltage-current relation of V = 2 I3 + 7, what power does it absorb when energized by 67 V? The final unit must be in watts, W. Round your answer to 2 decimal places. **Show your correct and complete solution. Thank you!**
Find the power ( in watts) being absorbed by element X if it is a :a). 100 Ω resistorb). 40 volts independent voltage source + reference on topc). 2 ampere independent current source, arrow directed upward
Calculate the resistance of a load that takes 1,600 watts from a 220 volts source.
Pick which is the correct answer from the given choices 11. The normal current through a load resistor is 2 amperes and the normal voltage dropacross it is 120 volts. What is the half power point of the load power?a. 169.68 wattsb. 240 wattsc. 120 wattsd. 84.84 watts 12. When current flows through a resistance:a. Heat is produced.b. Power is dissipated.c. Neither (a) nor (b).d. Both (a) and (b).