Answered: Given the ilb stration on the right,…

Name: 1. Given the ill»stration on the right, compute the work done by thef
Uploaded: 2024-03-20T06:57:25.000Z
Channel: Bartleby
Description: 1. Given the ill»stration on the right, compute the work done by thefollowing:a. Tension (.b. Frictional force650 ft1.0 kN

Science

Physics

Given the ilb stration on the right, compute the work done by the following: a. Tension (. b. Frictional force

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter7: Work And Kinetic Energy

Section: Chapter Questions

Problem 76P: Calculate the power output needed for a 950-kg car to climb a 2.00 slope at a constant 30.0 m/s...

See similar textbooks

Related questions

Q: The compound bow in the previous problem requires 152 J of work to draw the string back tox = 0.540…

Q: 2R A R 3R ME a) How much work is required to move a mass m from position A (tuo Eauth radii from the…

A: Given data: Position of the point A from the centre of the earth is, 2R Position of the point B from…

Q: A locomotive of mass m starts moving so that its velocity varies according to the law v = aV s,…

Q: Compute the work required to stretch a spring from 9 to 10 cm past equilibrium, assuming that the…

A: Given data: X1 = 9 cm = 0.09 m X2 = 10 cm = 0.10 m Spring constant (k) = 160 kg/s2 Required: The…

Q: Determine the total work

A: Given data: The force supplied by a motor is: F The distance of the load moved is: d The total…

Q: Calculate the work done by the force during the first

A: Apply work energy theorem

Q: How much mechanical work is required to mov feet to your heart, approximately 1.0m higher? A) 1 J B)…

A: Given:- 13 ) The mass of the blood m = 1.0 kg [ Given ] The height h = 1.0 m [ Given ] Find:-…

Q: A 1.9-kg rock is released from rest at the surface of a pond 1.8 mdeep. As the rock falls, a…

A: (a) Write the formula for the work done. Therefore, work done by the non-conservative force (water…

Q: Calculate the work done (in J) on a 1550 kg elevator car by its cable to lift it 37.5 m at a…

A: We have to be careful since we have to take the friction into consideration. Given: Mass of the…

Q: What is the total work WE done on the box by the appled force in this case? Express your answer in…

A: The force due to friction is given by Ff = μN, where μ = coefficient of friction, N = normal force.…

Q: In the given question/s as follows, consider a 20-foot chain that weighs 3 pounds per foot hanging…

A: Given: The weight is w=3 pounds/foot. The initial length is L=20 ft. The final length is L'=10 ft.…

Q: An object is mov ed from pont P(O,0> 0) to point Q (4,7,5) by exerting a force in the direción ŷ = Ì…

A: Write a given value of this question. P=(0,0,0)Q=(4,7,5)V→=F→F→=i^+4j^+8k^

Q: Consider a 55kg box being pushed with a 200N horizontal force acros The box accelerates at 2m/sec.…

A: Givenm=55 kgF=200 Nd=10 ma=2 m/s2

Q: From 2m/s, a 3 kg object is accelerated to 5 m/s on the positive x-axis. a. Determine the work; and…

A: Work done is defines as the dot product of force and the displacement of the body on which the force…

Q: A 44.0-kg projectile is fired at an angle of 30.0° above the horizontal with an initial speed of 144…

Q: How much work done in k J( kilo joule) can a 3 hp (horsepower) motor do in 1 hour? (Write the full…

A: Power is the amount of force per unit velocity Power=force×velocity P=Force×distancetimeP×time=work…

Q: Under what conditions is the work done i) maximum and ii) minimum?

A: Given:- Under the condition for the work done i. maximum ii. minimum is following…

Q: A boy pulls a 15-lb sled 50 ft along a horizontal surface at a constant speed. What work does he do…

A: Given data: Mass of sled is, m=15 lb=15×0.45=6.75 kg. Distance travelled by sled is, s=50…

Q: A physicist has been studying the effects of an unknown force. The work required to move an object…

Q: “ E = K + U constant is a special case of the work energy theorem.” Discuss this statement.

A: According to work energy theorem, work done by an object is equal to the change in kinetic energy of…

Q: 1. Given the illustration on the right, compute the work donc by the following: a. Tension b.…

Q: Suppose a worker lifts a box with constant speed, v. Calculate the total work done on the box while…

A: Given: The constant speed of the box is v.

Q: A force of F= (263 N) -(125 NS acts on an objeut, causing a displacement of P = (3.15m) î + (2.81 m)…

Q: tia 10 kg m² Vigt is the required average power? g at 50 rad/s. It must be brought to stop in 10 s.…

A: Work done on a body is equal to the increase in the energy of the body, for work transfers energy to…

Q: A 100 kg block is pulled at a constant speed of 4.0 m/s across a horizontal floor by an applied…

Q: If a constant force F is applied to an object, and the resulting movement of the objectis…

A: The work is done by an object when a force acts on it over a distance. The mathematical form of work…

Q: Let a bag of mass 'm' is being raised to a height 'h' from the floor of your classroom. What will be…

Q: A 150 kg block is pulled at a constant speed of 3.5 m/s across a horizontal floor by an applied…

A: given mass m = 150 kg speed of block v =3.5 m/s force acting F = 106N angle between v and F = 390 we…

Q: The formula W=Fdcos0 describes, done by a constant force. QUESTION 9 The SI unit of work is

Q: Given data: Force = 20.08 N Distance 10.05 m Calculate work done ?

A: Given The force is F = 20•08 N The distance is d = 10•05 m

Q: We know that the work (W) done by a force vector F applied to an object over a displacement ?x is…

A: Given Garph between between force - position We have to calculate the work done by force for the…

Q: Using dot product, calculate for the work done by gravity on a 5 kg box that is lifted 0.85 m above…

A: Let upward is positive y axis. Given Mass m = 5 kg displacement d = 0.85 m

Q: work done by abady, by the force of #N through a die termore of 14 move Find the work-done makes to

A: Given data : Force = F Distance = d…

Q: A mass m = 5 kg slides along the track shown. If u = 4 m/s at point A, 2, how much work must and v=…

Q: What is The SI unit of work?

Q: On a horizontal surface with µk = 0.70, a 5kg object is dragged with 350N force directed due East.…

Q: The figure shows three forces applied to a trunk that moves leftward by 3.08 mover a frictionless…

Q: An object of mass m and initial velocity vi is sliding along a frictionless plane. It then goes up…

A: Initial energy = 12mv2 final kinetic energy =12mv42 final potential energy =mgh = mgdsinθ

Q: A force of 25N is required to stretch a spring to .6 meters from its natural lenght of .4 meter.…

A: Given: the force applied F = 25 N stretch in spring x = 0.6 - 0.4 = 0.2 m

Topic Video

Question

1. Given the ill»stration on the right, compute the work done by the
following:
a. Tension (.
b. Frictional force
650 ft
1.0 kN

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

An archer pulls her bowstring back 0.400 m by exerting a force that increases uniformly from zero to 230 N. (a) What is the equivalent spring constant of the bow? (b) How much work does the archer do on the string in drawing the bow?
Give an example of a situation in which there is a force and a displacement, but the force does no work. Explain why it does no work.
A sled stalls from rest at the top of a snow-covered incline that makes a 22 angle with the horizontal. After sliding 75 m down the slope, its speed is 14 m/s. Use the work-energy theorem to calculate the coefficient of kinetic friction between the runners of the sled and the snowy surface.
A sledge loaded with bricks has a total mass of 18.0 kg and it pulled at constant speed by a rope inclined at 20.0 above the horizontal. The sledge moves a distance of 20.0 m on a horizontal surface. The confident of kinetic friction between the sledge and surface it 0.500. (a) What is the tension in the rope? (b) How much work is done by the rope on the sledge? (c) What is the mechanical energy lost due to friction?
Describe the energy transfers and transformations for a javelin, stating from the point at which an athlete picks up the javelin and ending when the javelin is stuck into the ground after being thrown.
Describe a situation in 4iich a force is exerted for a long time but does no work. Explain.
A sled plus passenger with total mass 50 kg is pulled 20 m across the snow (K=0.20) at constant velocity by a force directed 25 above the horizontal. Calculate (a) the work of the applied force, (b) the work of friction, and (c) the total work.
Suppose that the sled plus passenger of the preceding problem is pushed 20 m across the snow at constant velocity by a force directed 30 below the horizontal. Calculate (a) the work of the applied force, (b) the work of fiction, and (c) the total work.
Give an example of something we think of as work in everyday circumstances that is not work in the scientific sense. Is energy transferred or changed in form in your example? If so, explain how this is accomplished without doing work.
A 5.0-kg box has an acceleration of 2.0m/s2 when it is pulled by a horizontal force across a surface with K=0.50 . Find the work done over a distance of 10 cm by (a) the horizontal force, (b) the frictional force, and (c) the net force. (d) What is the change in kinetic energy of the box?
An electric scooter has a battery capable of supplying 120 Wh of energy. If friction forces and other losses account for 60.0% of the energy usage, what altitude change can a rider achieve when driving in hilly ter-rain if the rider and scooter have a combined weight of 890 N?
Engineers desire to model the magnitude of the elastic force of a bungee cord using the equation F(x)=a[x+9m9m( 9m x+9m)2] , where x is the stretch of the cord along its length and a is a constant. If it takes 22.0 kJ of work to stretch the cord by 16.7 m, determine the value of the constant a .