Answered: Given the tolerance on β for the…

Given the tolerance on β for the thermistor, what is the absolute value of the accuracy of the reading in °C that you will get on the thermistor at 30°C?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter9: Current And Resistance

Section: Chapter Questions

Problem 46P: An electronic device designed to operate at any temperature in the range from 10.0C to 55.0C...

See similar textbooks

Related questions

Q: In the calibration step of a thermochemistry experiment, a current of 124 mA, from a 24.0 V source…

A: When any material is provided with energy it leads to an increase in the temperature of the body.…

Q: What current is used by the 220 V AC electric heater which heats 2 kg of water (c = 4200 J/(kg K))…

Q: A metallic rod is heated by current carrying wire. The wire provides a constant power(P) to the…

Q: Assuming that β remained constant, what would be the resistance of the thermistor in the experiment…

Q: In the circuit shown, R,=R2=R, and ɛ2 =4. The rate of %3D heat dissipated by the whole circuit is…

Q: A spruce tree is 20 m tall with a trunk diameter of 0.4 m. Its needles have a measured water…

A: The given information is:Water potential of needles is -2.5 MPa.Water potential of roots is -1.2…

Q: A 17-V storage battery delivers current at the rate of 55 A. In a 26-min period, the heat lost from…

Q: 13-V storage battery delivers current at the rate of 59 A. In a 25 min period, the heat lost from…

Q: If you know that the work function of tungsten is(4.5ev), find: a- Emitter constant (b) for…

Q: A more general definition of the temperature coefficient of resistivity is α = 1ρ|dρdT|where ρ is…

Q: Which of the following assertions is NOT correcr? A The state of purity of a metal conductor…

Q: If 4.00 ✕ 10−3 kg of gold is deposited on the negative electrode of an electrolytic cell in a period…

A: Given - Mass of gold deposited , m = 4.00 x 10-3 kg = 4.00 g time taken for deposition of gold , t…

Q: Part A through C please The capacity of a storage battery, such as those used in automobile…

Q: An iron wire has a cross-sectional area of 3.60 x 10-6 m². Carry out steps (a) through (e) to…

Q: Residential building codes typically require the useof 12 - gauge copper wire (diameter 0.205 cm)…

A: Given data:Radius of the copper wire, R = 0.205 / 2 = 0.1025 cm = 0.001025 mArea, A = R2 = 3.14 x…

Q: (a) The resistance, R, of a series of aqueous NaCl solutions was measured in a cell with cell…

Q: In estimating pressure drops across the arterioles, assuming a specific number of arterioles with…

Q: Resistivity (A-m) 2.65 x 10 Material Aluminum Соpper Gold Iron | 1.68 x 10 244 x 10 9.71 x 10…

Q: Copper wire has a resistivity ρ = 1.7 × 10-8 Ω⋅m when at 20°C and it has a temperature coefficient α…

Q: How much time is needed for a surgical cauterizer to raise the temperature of 1.00 g of tissue from…

Q: A motorcyclist is making an electric vest that, when connected to the motorcycle's 12 V battery,…

A: Voltage, V = 12 V Diameter, d = 0.24 mm = 0.24×10-3 m Radius, r = d/2 = 0.12×10-3 m Current, I =…

Q: ssm In the conduction equation Q = (kA AT):/L, the combination of terms kA/L is called the…

A: 7. The thermal conductivity of Styrofoam is 0.01 J/s·m·°C and air is 0.0256 J/s·m·°C. The higher…

Q: Calculate the energy cost of an electroplating process running at 0.65 V and 48.9 A for 3149 s…

A: Given: The potential difference is V=0.65 volt The current is I=48.9 A The duration of the…

Q: If 3.25 × 10−3 kg of gold is deposited on the negative electrode of an electrolytic cell in a period…

Q: A Nichrome heater dissipates 526 W when the applied potential difference is 110 V and the wire…

A: Given: The power loss due to the nichrome heater at 800 oC is 526 W. The potential difference is 110…

Q: A 84 W freezer has an EER of 12.7. How much heat is exhausted to the room in 2.5 hours? |(include…

A: EER = 12.7 P = 84 W t = 2.5 hours t = 2.5 * 60 * 60 t = 9000 seconds

Q: When a metal rod is heated, not only its resistance but also its length and cross-sectional area…

A: The linear expansion,

Q: Copper wire has a resistivity ρ = 1.7 × 10-8 Ω⋅m when at 20°C and it has a temperature coefficient α…

A: we have ρ(T) =ρ0(1+α∆T)=ρ0(1+αT-20) (a) Also since the temperature on rod varies linearly, the…

Q: A type S thermocouple uses a 0 degree C reference junction. What voltage (in mV) will be generated…

A: Given : S type thermocouple Reference temperature is 0oC. Junction temperature is 1272oC.

Q: H.W. 1.1: it is required to maintain a loading of 5 kW in a heating unit. At an initial temperature…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Copper wire has a resistivity ρ = 1.7 × 10-8 Ω⋅m when at 20°C and it has a temperature coefficient α…

Q: If 3.50 ✕ 10−3 kg of gold is deposited on the negative electrode of an electrolytic cell in a period…

Q: For the water heater in the previous question, how muc does it cost to run t month? Assume a month…

A: GivenPower, P=4500 WTime, t=2 hrs/dayV=220 VCost of electricity=$0.21 /kW-hr

Q: The approximate number of Fridges in Italy is 90 thousand. If each is on standby for about 2 hours…

A: Number of fridges = 90 thousand standby hours each day = 2 hours Power consumed by fridge while on…

Q: A typical daily shower uses 25 litres of water at 42 degrees celsius. If the incoming mains water is…

Q: A 20-V storage battery delivers current at the rate of 53 A. In a 28-min period, the heat lost from…

Q: When temperature increases the mean free time in a conductor Select one: O a. Oscillates O b.…

A: Introduction: The mean free time of a conductor is the time between two successive collisions of an…

Q: 1. A resistor R and another resistor 2R are connected in series across a battery. If heat is…

Q: Resistance R of a graphite resistor depends on its temperature acco- rding to the equation R= R,…

A: Given : Temperature dependence of Graphite resistor, R = Ro{1-α(θ-θo)} Rate of heat transfer, H =…

Q: A thermocouple, with a spherical junction diameter of 0.5 mm, is used for measuring the temperature…

Question

100%

Given the tolerance on β for the thermistor, what is the absolute value of the accuracy of the reading in °C that you will get on the thermistor at 30°C? (Type in a three-decimal number) Given the tolerance on β = 3977 (+ or - 0.75% at 25°C for a 5000 ohm resister )

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1 given data

Step 2

Step 3

Step 4

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 7 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The resistance RT of a platinum varies with temperature T (0C), as measured on the constant-volume gas thermometer according to the equation RT = R0(1+AT+BT2). Where A=3.8 × 10-3 0C-1 and B= -5.6×10-7 0C-2. Calculate the temperature that would be indicated on a platinum thermometer, when the gas scale reads 2000C.
Assuming that β remained constant, what would be the resistance of the thermistor in the experiment as the temperature approached absolute zero?
When a metal rod is heated, not only its resistance but also its length and cross-sectional area change.The relation R = rL/A suggests that all three factors should be taken into account in measuring r at various temperatures. If the temperature changes by 1.0 C°, what percentage changes in (a) L, (b) A, and (c) R occur for a copper conductor? (d) What conclusion do you draw? The coefficient of linear expansion is 1.70 * 10-5 K-1.
A more general definition of the temperature coefficient of resistivity is α =1ρ|dρdT|where ρ is the resistivity at temperature T. (a) Assuming α is constant, show that ρ = ρ0eα(T−T0) where ρ0 is the resistivity at temperature T0. (b) Using the series expansion ex ≈ 1 + x for x << 1, show that the resistivity is given approximately by the expression ρ = ρ0[1 + α(T − T0)] for α(T − T0) ≪ 1
If you know that the work function of tungsten is(4.5ev) , find: a- Emitter constant (b) for tungsten. b- The value of the constant A at a temperature of (27270 °C ) if you know that the density of the current passing through is (J=15 A/m?).
A temperature-stable resistor is made by connecting a resistor made of silicon in series with one made of iron. If the required total resistance is 1000 ohm in a wide temperature range around 20C, what should be the resistance of the (a) silicon resistor and (b) iron resistor?
Calculate the specific conductivity of the conductor in Mega(Ωm)-1 since the current passing through a conductor with a cross-section (1.00nm x 1.00µm), length of 10.00mm, is 1.00mA and the voltage value falling on it is 1.00V.
An electronic device designed to operate at any temperature in the range from 10.0C to 55.0C contains pure carbon resistors. By what factor does their resistance increase over this range?
An immersion-type heating coil with a resistance of 13 ohms is connected to a 120 V outlet and immersed in a 250 mL cup of water initially at 10 degree Celsius. Assume that there is no heat loss and neglect the heater's heat capacity. How long does it take to bring the water to the boiling point?
A 3 ohm heater takes 6 amperes while submerged in 1200 grams of water contained in a vessel with a water equivalent to 200 grams. What is the efficiency of the system if the time required for the temperature to change by 70 degrees Celsius is 3.95 hours?
Consider a resistor of resistivity 1.59x10^-8 ohms•m. If an electric field of 19 V/m is applied across the resistor and the electron volume concentration in the conductor is 4.7x10^28 per cubic meter, determine the drift velocity, in mm/s, of the free electron constituting the current.
A 20-V storage battery delivers current at the rate of 53 A. In a 28-min period, the heat lost from the battery is 103.07 kJ. What is the change in internal energy in kJ of the battery for the discharging period? answer must be in 3 decimal places