Gyuri performed an analysis of Simvastatin tablets. The following are the data she obtained: 39.5 mg, 41.2 mg, 40.7 mg, 38.9 mg, 42.1 mg, 41.7 mg, 38.7 mg Suppose the mg of Simvastatin stated in label is 40 mg, is there a significant difference between her results and the label claim?

Gyuri performed an analysis of Simvastatin tablets. The following are the data she obtained: 39.5 mg, 41.2 mg, 40.7 mg, 38.9 mg, 42.1 mg, 41.7 mg, 38.7 mg Suppose the mg of Simvastatin stated in label is 40 mg, is there a significant difference between her results and the label claim?

Chemistry: Principles and Reactions

8th Edition

ISBN:9781305079373

Author:William L. Masterton, Cecile N. Hurley

Publisher:William L. Masterton, Cecile N. Hurley

Chapter1: Matter And Measurements

Section: Chapter Questions

Problem 41QAP

See similar textbooks

Related questions

Q: Draw Lewis structures for tye following molecules. a.) Atom "X" has 4 valence electrons and Atom "Y"...

A: (a) X has 4 valence electrons Y has 6 valence electrons We have to draw lewis dot structure for XY2...

Q: Calculate strain energy for the conformer pictured below, using strain energy increments from the ta...

A: The molecule given is,

Q: Sample Problem X. Percentage mass weight by volume and sample preparation Calculate the % w/v of 623...

Q: Refer to the periodic table and write the predicted electron configuration for each of the following...

A: Given ions.Cd2+ and P3–

Q: What are in the distillate collected from the distillation?

A: (1) A receiver

Q: For each compound below, identify if ionic, polar covalent or nonpolar covalent and write the Lewis ...

A: A covalent bond will be polar if there's a electronegativity difference arises between two bonded at...

Q: [References] Indicate whether the pair of structures shown represent stereoisomers, constitutional i...

Q: A benzene sample with a mass of 47.7 g is removed from a freezer at an initial temperature of -10.2"...

A: Given that : Mass of benzene sample (m) = 47.7 g Initial temperature = -10.20C Final temperature to ...

Q: between liquid cyclohexane (C6H12) and oxygen gas. Another product of this combination is water as s...

Q: Solution 5% v/v of methanol with water means that. O 5 ml methanol in 100 ml water. O 5 ml methanol ...

A: Given, Solution 5% v/v methanoI with water.

Q: Solution 5% v/v of methanol with water means that. O 5 ml methanol in 100 ml water. O 5 ml methanol ...

A: That means 5% v/v of methanol with water implies that 5ml methanol in 100 ml water. And thus sol...

Q: of nodal planes p

Q: 8.00 mL of 5.00 x 10-3 M Fe(NO3)3 (5.00 times 10 to the minus 3rd power M F e (NO3)3) is added to 9....

A: Given that : Volume of Fe(NO3)3 = 8.00 mL Concentration of KSCN = 5.00 x 10-3 M Volume of KSCN = 8.0...

Q: The molar heat of solution of a substance is found to be +21.38 kJ/mol. The addition of 0.100 mol of...

A: Please find the below attachment.

Q: ) Balance the following equations and state whether they are redox or non-redox reactions. For the r...

A: Redox reaction is the reaction in which oxidation that is loss of electrons as well as reduction tha...

Q: Direction: Identify the given substances if it is polar or nonpolar, and which type of intermolecula...

A: 1.H-F is a polar molecule and have dipole dipole forces 2. CH3-CH2-CH3 is a non polar molecule and...

Q: The indicator of Moher regent is. KMN04. О Ксго4.

A: Mohr's method: Mohr's method is a direct method of titration. In this method potassium chromate (KCr...

Q: ASSESSMENT Write the Lewis dot structure of the following ionic compounds. 1. MgBr2 2. AgCI 4. KaN 5...

A: Lewis dot structure of the following compunds given below,

Q: Write the IUPAC name for the compound below. Be sure to use correct punctuation. CHy-CH-CHy-CH, CH3-...

A: i) The longest carbon chain in the given compound contains nine carbon atoms. Therefore, the root ...

Q: Br HBr ROOR 7.

A: This is an addition reaction in presence of peroxide. This reaction proceeds through free radical me...

Q: scandium(III) zinc (II) hydrogen carbonate cyanide lead (II) nitrate is mixed with a solution of sod...

A: A balanced chemical equation occurs when the number of the atoms involved in the reactants side is e...

Q: .Alkalinity understand that is Measure of acidity. O Measure of basicity. O Measure of nationalize. ...

A: pH less than 7 means solution is acidic. pH greater than 7 means solution is basic. pH is equal to 7...

Q: You would like to create a 50ml bottle of Eau de toilette at a concentration of 8%. You would like t...

Q: The. osmotic pressure of a solution that contains 19.67 mg of an unknown protein dissolved in 12.2 m...

A: Number of mole is calculated by dividing given mass with molecular mass.

Q: Why is molality and not molarity used to express concentration in the equations for freezing point d...

A: Given : We have to tell why molality is used in equations of freezing point depression and boiling p...

Q: Given 100.0 grams of a sample that has a half life of 7.02 days, determine the time in days for ther...

Q: 2. Twenty-five mL of 0.100 M lactic acid (K, = 1.4 x 104) is titrated with 0.097 M KOH. %3D a) What ...

A: Volume of lactic acid = 25ml Concentration of lactic acid = 0.1M Concentration of KOH = 0.097M We ar...

Q: The atomic weight of Ga is 69.72 amu. There are only two naturally occurring isotopes of gallium: 69...

A: Given atomic weight of Ga is 69.72 amu

Q: Calculate the boiling point of a solution containing 25.0g of urea, (H2N)2CO(s), dissolved in 1.50kg...

A: Given, Mass of urea = 25.0 g Mass of nitrobenzene = 1.50 Kg The boiling point elevation constant (Kb...

Q: Alcohols can act either as weak acid or as weak base, just as water can. Show the reaction of methan...

A: Alcohols can act either as weak acid or as weak base, just as water can.

Q: Water at 40 ºC, flows over a 10 millimeters thick aluminum plate. The plate is electrically heated f...

A: GivenThickness of aluminium Plate = t = 10 mmt = 10 × 10-3 mTemperature of water = Tw = 40°CTemperat...

Q: Calculate n initial for the wavelength 656.3nm the n final is 4 also calculate the energy emitted by...

A: energy is emitted by a photon when its comes from excited state to lower state or ground state

Q: F.

A: Axial and equatorial are types of bonds found in the 'chair' conformation of cyclohexane. The chair ...

Q: e) OH OH 1. 2.

Q: This is the spectral data for 4-cyclohexene-cis-1,2-dicarboxylic acid - Can you tell whether you hav...

A: Given 13C-NMR peak are δ 25.9, 39.2, 125.2, 174.9 There are total 4 peak given.

Q: DIRECTION: Refer to the following phase diagram of a certain substance to answer the following quest...

Q: State whether the reaction below gave a single product or more than one product in quantities equimo...

Q: A plot of pressure-volume isotherms for an ideal gas at two different temperatures is shown below. C...

A: For cyclic process, Delta ( state function ) = 0 Because state function depends upon only it's ini...

Q: Pure aluminum (Al) metal reacts with hydrochloric acid (HCl) to produce aluminum chloride (AlCl3) an...

A: Given. 2 Al + 6 HCl → 2 AlCl3 + 3 H2

Q: Compound A 1.5 1.0 0.5 0 40 80 120160 200 T ('C) A. Identify: f. Sublimation curve a. Gasd b. Critic...

A: We are given a phase diagram and asked to spot different phases on it. We are also asked to find the...

Q: 5. ? 6. 1) Excess NaNH2/NH3 2) ВНз, THF 3) H2О2, NaOH

A: Given,

Q: Suppose a student places a beaker on his balance and does not tare it. Then, he adds three substance...

A: The data given is, Before After distilled water 57.160 g 70.990 g sodium acetate 70.990 ...

Q: What mass of sodium acetate must be added to 435 mL of water to give a solution with pOH = 4.65? Kb ...

Q: u know ou looking fo ance do you

A: As per rule, allowed to answer first question and pot the remaining in the next submission.

Q: C: Determination of K, for a Weak Acid Volume Used(Liters) Moles 0.1 M HC,H,O, 0.0269 (L) HC,H,O, [N...

Q: What volume of solution is required to create a 0.15 M solution that contains 0.750 moles? O 0.60 L ...

Q: Cesium has higher melting temperature than Sodium. True or False?

A: Given : We have to tell whether the statement is true or not.

Q: Problem 6: A solutions contains 7.500x10-7 g of lead (Pb) and 100.0 g of H,Oq). How many ppm of Pb a...

A: PPM is calculated by dividing the mass of the solute by the mass of the solution, then multiplying b...

Q: identifying letters A-D below each structure. A table of pka values for various organic and inorgani...

A: Given : We have to write which of the following is weaker acid and its conjugate acid .

Q: What mole fraction of solvent will be present in an aqueous solution that is 0.858 m in sucrose?

A: Given, Concentration of aqueous solution is 0.858 m

Question

Gyuri performed an analysis of Simvastatin tablets. The following are the data she obtained:

39.5 mg, 41.2 mg, 40.7 mg, 38.9 mg, 42.1 mg, 41.7 mg, 38.7 mg

Suppose the mg of Simvastatin stated in label is 40 mg, is there a significant difference between her results and the label claim?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Azythromycin is usually administered intravenously over a concentratoin rance of 1.0-2.0 mg/mL over a period of one hour. Consider a hypothetical situation whereby a dose of 500 mg of azithromycin is administered at 2.0 mg/mL of azythromycin in saline. How many mg of medicine would have been administered every 15 minutes? (Answer should be a whole number)
A chemist working in a hospital clinical laboratory obtained the following values for uric acid in blood serum: 4.63, 4.58, 4.82, 4.31, 4.67 and 4.60 mg%. What value should be reported as the mean? Value of QT at 90 % confidence level is 0.56.
what is the cost of 8 oz of cannabis oil if 1ml value $30?
SK weighs 23 kg and mom reports that he consumed 2 tubes of toothpaste that were each 130 g with 0.14% fluoride. What is the total fluoride dose, in mg/kg?
A ciprofloxacin otic solution contains 0.5 mg of ciprofloxacin in a 0.25-mL singledose package. Based on 20 drops/mL, (a) how many drops would be administered and (b) how many micrograms of ciprofloxacin would be in each drop?
A physician has ordered 0.50 mg of atropine, intramuscularly. If atropine were available as 0.10 mg/mL of solution, how many milliliters would you need to give?Express the volume in milliliters to two significant figures.
A physician ordered 20 mg of MEPER GAN and 0.3 mg of atropine sulfate to be administered preoperatively to a patient MEPERGAN is available in a syringe con taining 25 mg/ml, and atropine sulfate is in an ampul containing 0 4 mg per 0 5 mL How many milliliters of each should be used in filling the medication order?
Compare the pair sample number 1 and 4 in terms of their use.
Convert the amount of spiperone in each sample to the concentration in the 1 ml total volume of assay tube. I have calculated amount of 3H spiperone in pmol in each dilution in second picture. To converted concentration in 1 ml total volume of each assay tube do I need to consider dilution factor？
Given that three trials revealed the # of drops in 1.0 mL with a fine tip pipette were 19 drops, 23 drops & 21 drops. Using the average value of drops/mL, how many milliliters would be contained in 9 drops reported to 2 significant figures?
4. A fat sample with combination of acids contain standard hydrochloric acid for blank and sample with 8mL and 5mL respectively. The normality of the standard hydrochloric acid is 0.93N and the weight of the sample is 3 grams. Calculate the saponification value.
For the following results: 1.87 g/mL, 1.96 g/mL, 1.88 g/mL, 1.85 g/mL. If the actual value for the density of the sugar solution is 1.80 g/mL, what is the percent error?