(h) A second-order system is defined by the equation 1.1 in sinusoidal steady state, where s corresponds to the complex frequency, jw. s2 + 8s + 36 = 0 (Equation 1.1) What is the damped natural frequency of oscillation of the system, @d, expressed in radians per second?

Q: An electric circuit, consisting of a capacitor, resistor, and an electromotive force can be modeled…

A:

Q: The current I through a semiconductor diode is relative to the voltage V across the diode via the…

A: Given: The current I through a semiconductor diode is relative to the voltage V across the diode via…

Q: a) What should be the K value for the following closed system to be at critical damped? G(s) R(s)…

A: In the question a closed-loop system is given. we have to find when the system is critically damped,…

Q: 5000 1000 0 160 nF 100 mH R = 500 N, R2 = 1000 N, L = 100 mH,C = 160 nF, i,(t) = 4 cos 5000t mA %3D…

A:

Q: In the circuit of the figure, working in transient conditions, the switch is initially closed and…

A: Note: As per our company guidelines we are supposed to answer ?️only the first 3️⃣ sub-parts. Kindly…

Q: Amplitude 0.6 3.6 2.8 Unit Step Response M 0.5 G(S) 1.5 Time (sec.) Damped Natural Freq (rad/sec)…

A:

Q: An inductance of 1 H, a resistance of 8 Ω and capacitance of 0.04 F are connected in series with a…

A:

Q: Problem 3: A series RC circuit has R= 25 ohms and C= 10 mF. The circuit is powered by v(1) = 10 cos…

A: (A) Calculate the initial voltage on the capacitor. VC0=Q0CC=100×10-3 C10×10-3 F=10 V

Q: A.i A change in current produces change in the electromagnetic field, which induces a voltage across…

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: An electrical circuit consisting of an inductor, L, and a capacitor, C, in series is shown in Figure…

A:

Q: 5. a. Find the mathematical expressions for the transient behavior of the voltage vc and the current…

A:

Q: Calculate the range of values K will take so that the steady-state error ess ξ ≥ 1/2√6 Calculate…

A:

Q: Consider the circuit shown in Fig. Let E = 36.0 V, R0 = 50.0 Ω, R = 150 Ω, and L = 4.00 H. (a)…

A: NOTE: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question…

Q: Suppose a capacitive touch screen that uses the mutual-capacitance design, as shown, is touched at…

A: Given mutual capacitance at a point (x , y) without a touch is C’mxy Mutual capacitance with touch…

Q: Q: For the system shown below, find K, and K2 if the maximum overshoot is 1.4% and the peak time is…

A:

Q: A 2-DOF spring-mass damper system as shown in the figure below is subjected to a harmonic excitation…

A:

Q: 8.3.8 For the RLC circuit shown in the image below, if R1 = 2 S2 and R2 = 9 52, C = 0.31 F, and the…

A: For the given circuit calculation of steady state value of capacitor voltage VC∞. Given: R1=2 ΩR2=9…

Q: SIC interpet By optaining the time the FOllowing Constant în REJ diFFerential equations L= coiL…

A: Consider the first-order equation of electric circuit,

Q: Consider an inductor whose inductance varies as L(x) 0.25H/cm-z, where is the variable length of the…

A:

Q: A system is represented by the equation z(t) = v(t)f(t) + B where v(t) is the input, z(t) the…

A: The input-output equation of the system is yn=∑k=-∞0xn-k. Memory: The system output is depending on…

Q: Submersibles with clear plastic hulls have the potential to revolutionize underwater leisure. One…

A: Steady state error due to disturbance, Tds=1s So, YsTds=1s1+k+k2k1s

Q: In an electric Circuit , total energy Cin Joules) dissipated elements between t, =0 by by E ,and tz=…

A: Given, Vt=15-5e-100t VI(t)=25e-100t mAt1=0 st2=20 msE=∫t1t2It×Vt dt

Q: In the figure, C= 0.4 µF, E = 20 V, R1 = 10 k2, and R2 = 15 k2. Initially, the switch S is closed a…

A: At steady state capacitor acts as open circuited , now using voltage division rule calculate voltage…

Q: Consider the circuit given below, where V = 120 V, R = 2.4 kΩ, and L = 60 mH. What is the time…

A: The time constant of the series RL circuit is the ratio of inductance to equivalent Thevenin…

Q: When a capacitor C (in F) and an inductor L (in H) are placed in series, the magnitude of the…

A: Given  L=0.1 HC=2 mFf=10 Hzdfdt=2 Hz/s The rate at which the magnitude of circuit impedance change…

Q: The circuit shown in Fig below has a step input voltage v(t)-10., a resistance R1 of 3.1 Q. an…

A:

Q: The voltage applied to the circuit shown  at t=0 is20 cos(800t+25∘) V. The circuit resistance is 80…

A:

Q: DIFFERENTIAL LENGTH, AREA, AND VOLUME Problem solving. Show your solutions and box your final…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: 8) The differential equation governing the charge stored in the capacitor q1 is: V(t) = 100041 + 2¢1…

A: We will write KVL equation for input loop . Then we replace current by charge .

Q: 1 Damped oscillations, and Faraday: An RLC series cirenit is powered br a sinusoidal voltage source…

A: Impedance of the circuit, Z=R+jXL-XC

Q: Q2. A Gaussian pulse of unit area g(t) is given by 1 g(t) -²/2 V2n (a) Sketch the function g(t). (b)…

A: Gaussian function- Gaussian function is non-causal, bounded and even function. g(t)=12πe-t2/2 where…

Q: A) Reduce the block diagram. B) G1(s)= 2/s, G2(s)= 1/4s+2, G3(s)=4, H(s)=0.5 according to the…

A:

Q: The sinusoidal voltage source in the circuit shown in Fig. 1 is generating the voltage vg = 20 sin…

A:

Q: Situation: An SUV is parked along the side of a roadway, while a van is traveling adjacent to the…

A: For SUV -The initial velocity is zero.The acceleration is a and total time taken is T.For van - The…

Q: Consider the given circuit. The switch has been closed for a very long time before opening at t=0s.…

A: To solve above question, one should understand the behavior of Inductor and capacitor in DC circuit.…

Q: “A system can never be operated higher than its steady state stability limit but it can operate…

A: In a Power System, steady state stability limit is defined as the maximum power that can be…

Q: In Fig. Q1.1 the switch is closed for a very long time such nhat the circuit has reached steady…

A:

Q: The differential equation governing the charge q (t) on the capacitor in an RC circuit is 1 E(t),…

A: Given: A RC circuit which is described by the following differential equation

Q: An electric circuit, consisting of a capacitor, resistor, and an electromotive force can be modeled…

A:

Q: In Figure, suppose the switch has been closed for a time interval sufficiently long (steady state)…

A:

Q: Consider the system in the Figure where kis a constant and G(2) is as follows z- 1 G(z) (z – 3)(4z –…

A: The solution is given below

Q: Identify the differential equation for the voltage v() in the circuit shown in the given figure for…

A:

Q: Q2- for the system shown in fig (2),when m= 10kg , c=20 N/m/s , k= 40 N/m, d'y F=m dy +ky • Find…

A: Solution (1) m=10kg C=20N s/mk = 40N/mF = m.d2ydt2+C.dydt+ky applying laplace transformation…

Q: 3. Given i () 1.5K L (1) 100 mh 0.01 μ f with input (changing from –5 to +5 at t=0) in (1) - 5 a.…

A:

Q: 4.b 1- Draw the SFG diagram 2- When 8u(t) is applied as input, enter the steady-state value of the…

A: According to the question,  (1) We need to draw the SFG for the given block diagram as shown below…

Q: A system with disturbance is shown below. D(s) R(s) C(s) G|(8) G2(8) H(s) Derive the expression for…

A:

Q: R1 ic 20 kM 20 + + E12 V C 0.05 µF vc R2 3 10 kN

A: Given,Vc(0-)=0VFor capacitor voltage cannot changeinstantaneously so,Vc(0+)=Vc(0-)=0VFor first order…

Q: Switch U1 is closed at t=0 Initial voltage C1=3V C2=0V 1. Derive governing equation for t>0 2.…

A: "According to the company's policy we will provide solution of only first three sub-parts of a given…

Q: An RC drcult with components C=5mF, R1 =2M2, R = 1M and V = 100V is set as shown in the figure. The…

A: RC circuit C=5mF R1 =2K ohm R2 = 1K ohm V=100V Initial capacitor uncharged Vc (0+) =0V Switch turn…

Q: Q.decide if the given statement is true or false,and give a brief justification for your answer.If…

A: Given- Voltage,  E(t)= E0 cosωt  Frequency, ω = 1 /√LC To find- Steady-state current of maximum…

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.