Answered: H.w 3: / carbon dioxide (CO:) has mass…

H.w 3: / carbon dioxide (CO:) has mass (4.2kg) pressure (12 bar) and temperature (92 °C).Calculate the volume of If (R 0.189 kJ/kg. K)?

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter5: Analysis Of Convection Heat Transfer

Section: Chapter Questions

Problem 5.5P: Evaluate the dimensionless groups hcD/k,UD/, and cp/k for water, n-butyl alcohol, mercury, hydrogen,...

See similar textbooks

Related questions

Q: Air bubble from the bottom of water well at 15°C rises slowly to the water surface above where…

Q: When we in the United States say a car’s tire is fi lled “to32 lb,” we mean that its internal…

Q: Determine the altitude of the atmosphere above sea level in meters if the atmosphere has an absolute…

Q: What is the value of pressure P3, cm-Hg in, if h,=23 %3D cm, h,=15 cm and P,=1 Atm? The liquid in…

Q: 2.143 The tank of water in Fig. P2.143 is full and open to the atmosphere (Patm = 15 psi = 2160 psf)…

A: Pe = 15 lbf/in2

Q: certain gasoline weighs 7 kN/ cu. M, what are the values of its der ecific volume and specific…

Q: 50. Find the volume of a tank (T = 42 C°, the rate change of density = 3.7 kg-m3-s“, p = 713 kPa),…

Q: A certain gas at temperature equivalent to 24 degrees Celsius at 7 cu.m and 180 kPa is compressed to…

Q: In a fluid rotated as a solid about a vertical axis with angular velocity ω, the pressure rise p in…

A: Given Data→Angular velocity=ωPressure rise=PPressure rise depends upon speed ω, radius r, and fluid…

Q: A 25 m high vertical column of a fluid of density 1800 kg/m³ exists in a place where g= 9.6 m/s².…

A: P= ρghρ=density h =Verical height of fluid columnP = 1800×9.6×25P =432 kPaThe pressure in a fluid is…

Q: m P2 = 500 rmixture is 800 kg/m*3, find the respective amounts of liquids used. Also find the weight…

Q: 1) Find the rate of bubble volume increasing when the radius is 4cm if its surface area is…

A: Given Data Radius of bubble is : r=4 cm Increasing of surface area is : dsdt=4 cm2/sec Now we know…

Q: A 25 m high vertical column of a fluid of density 1800 kg/m³ exists in a place where g = 9.6 m/s2…

Q: A Russian submarine crashs, loses control and runs aground at the bottom of the sea. The pressure,at…

Q: Example: If the temperature gradient is 2°C per 100 Km and if the specific heat capacity of the air…

A: Speed of air=10 km/h In one hr it covers=10 km In 12 hrs it covers= 120 km Temp. gradient in 100…

Q: P1.26 When we in the United States say a car's tire is filled "to 32 lb," we mean that its internal…

A: Given, Internal gauge pressure = Pg = 32 lbfin2 = 32 lbfin2 × (12 in)2(1 ft)2 = 4608 lbfft2 Volume =…

Q: Find the surface tension in N/m in a soap bubble of 30 mm diameter when the inside pressure is 1.962…

A: given data - pressure difference inside and outside the soap bubble = ∆P= 1.962 Pa dia of the bubble…

Q: ma P2 = 500 rnixture is 800 kg/m*3, find the respective amounts of liquids used. Also find the…

Q: 37. For a tank (T = 41 C°, volume = 0.051 m³, the rate change of density = 2.6 kg-m-s"), through a…

A: Giventemperature T=41oCvolume of tank V=0.051m3rate change of density ρ˙=2.6kg/m3sarea of hole…

Q: A weather balloon is filled with dintomic Hydrogen(H,) Given : Volume [V]= 4.19m3 density [P] =1,25…

Q: 3 The flow (in cm³ /s ) of blood from an artery into a small capillary can be modeled by

A: F(x,y,z)=cπx24y-zx=diameter of capillaryy=pressure in the arteryz=pressure in…

Q: A spherical shaped balloon of 10 mm diameter contains H2 at 27oC and 1.2 bar. Find the mass of H2 in…

A: Given, Diameter of balloon,d=10mmPressure, P=1.2barTemperature,T=27°C Real gas…

Q: Find MLT form for [P(pressure)/ρ(density)]

Q: In the figure, mass m covers a circular opening of radius, R. The liquid has density p (a) Find…

Q: 2. At a particular temperature, the surface tension of water is 0.073 N/m. Under ideal conditions,…

A: Answer: The theoretical height of the capillary rise is 0.297655 m.

Q: In Fig.the tank contains water and immiscibleoil at 20 ° C. What is h in cm if the density of the…

A: Given, The temperature of the water and immiscible oil, T= 20 °C the density of oil, ρo=898 kg/m3…

Q: 5. A piece of experimental apparatus, see Fig. below, is located where g = 9.5 m/s² and the…

A: ρ=Density of mercury=13600 kg/m3∆h=Height difference=200 mm=0.2 mg=9.5 m/s2

Q: A certain gas at temperature equivalent to 24 degrees Celsius at 10 cu.m and 160 kPa is compressed…

A: Find the resulting pressure .

Q: Methane is stored in a tank at a pressure of 291,890 Pa and a temperature of 279 Kelvin. The ambient…

Q: A hemispherical container, 32 inches in diameter, is filled with a liquid at 20°C and weighed. The…

Q: , find height

A: Given; Pressure of gas bulb A is , 50 cm of HGAtmospheric pressure =46 cm of HG

Q: In Fig. both fluids are at 20 ° C. If surface tensioneffects are negligible, what is the density of…

A: In the given column water and oil is used to measure the pressure. To calculate the density of oil,…

Q: The system in Fig. is at 20 ° C. Compute the pressureat point A in lbf/ft 2 absolute.

A: Given: The atmospheric temperature is Pa=14.7 lbf/in2. The specific gravity of the oil is SG=0.85…

Q: 7 m3 of oil weight 46800N. Find its mass density

A: Given data : Weight=W Volume =V To find : Mass density

Q: If the pressure in the air space above an oil (s=0.75) surface in a closed tank is 115kPa absolute,…

A: Specific gravity of oil, s=0.75Pressure above the oil, P=115 kPa=115*103 PaFind: Pressure h=2 m…

Q: B) a stream of oil in steady flow from pipe so that the diameter of the stream is 0.98cm. The stream…

A: Given, Diameter of the stream , d= 0.98 cm. Volume of the container , V =150 cm3. Time to fill the…

Q: Nitrogen at 200 psig is used to fill tank of 120 in². The filling process is very slow and the…

Q: An air bubble from the bottom of the water well, temperature is 15°C rises slowly to the water…

Q: Suppose, which is possible, that there is a half-miledeep lake of pure ethanol on the surface of…

Q: 1. A RESERVOIR OF CARBON TETHRACHLORIDE (CC14) HAS A MASS OF 500 kg. AND A VOLUME OF 0.315m3. FIND…

A: Given data Mass of Carbon Tetrachloride in reservoir= 500 kgVolume of reservoir = 0.315 m3We have to…

Q: Air tank filled with air (air gas constant 287 J/kg.K, density of 1.2 kg/m), the air temperature is…

A: Solution:

Q: A tank volume 9 contains gas at conditions ( ρ 0 , p 0 , T 0 ). Attime t = 0 it is punctured by a…

A: For control volume ddt(mtank)+m.exit=0ddt(ρv)=-m.exit=-(ρCA)

Q: Find surface tension in a soap bubble of 40 mm diameter when the inside pressure is 2.202 N/m2 above…

A: Given: Diameter of the bubble (d)=0.04mPressure inside the bubble (P)=2.202N/m2

Q: Suppose that we could increase the atmospheric pressure on the surface of Mars to 0.2 bar, by…

A: atmospheric pressure, commonly known as barometric pressure, is the force exerted by an atmospheric…

Q: A milkshake has fairly similar density to that of water (Ps 1200 kg/m³) but is far more viscous (j =…

A: Given data Density of milkshake = ρmilkshake = 1200 kg/m3Viscosity of milkshake = μ = 1 kg/msStraw…

Q: 2.10 A pressure of 4 X 10° N/m² is applied to mass of water that initially filled a 3200 cm³ volume.…

A: Bulk modulus(K) of fluid is equal to the change of pressure required for decreasing unit volume of…

Q: Steam undergoes constant volume process: T1=150 Degrees celcius, X=90%, until P2 =0.30 MPa.…

Q: 101.3 kpa expands constant temperature from 0.l m' to 10 ft', what is the final pressure in bar

A: GIVEN: 101.3 kpa expands constant temperature from 0.l m' to 10 ft', what is the final pressure in…

Question

H.w 3: / carbon dioxide (CO:) has mass (4.2kg) pressure (12 bar) and
temperature (92 °C).Calculate the volume of If (R
0.189 kJ/kg. K)?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In Fig.the tank contains water and immiscibleoil at 20 ° C. What is h in cm if the density of the oil is898 kg/m 3 ?
The system in Fig. is open to 1 atm on the rightside. ( a ) If L = 120 cm, what is the air pressure in containerA ? ( b ) Conversely, if p A = 135 kPa, what is thelength L ?
A storage tank, 26 ft in diameter and 36 ft high, is fi lledwith SAE 30W oil at 20 ° C. ( a ) What is the gage pressure,in lbf/in 2 , at the bottom of the tank? ( b ) How does your resultin ( a ) change if the tank diameter is reduced to 15 ft?( c ) Repeat ( a ) if leakage has caused a layer of 5 ft of waterto rest at the bottom of the (full) tank.
A hemispherical container, 26 inches in diameter, is filledwith a liquid at 20 ° C and weighed. The liquid weight isfound to be 1617 ounces. ( a ) What is the density of thefluid, in kg/m 3 ? ( b ) What fluid might this be? Assume standardgravity, g = 9.807 m/s 2 .
When we in the United States say a car’s tire is fi lled “to32 lb,” we mean that its internal pressure is 32 lbf/in 2 abovethe ambient atmosphere. If the tire is at sea level, has avolume of 3.0 ft 3 , and is at 75 ° F, estimate the total weightof air, in lbf, inside the tire.
Early mountaineers boiled water to estimate their altitude.If they reach the top and fi nd that water boils at 84 ° C,approximately how high is the mountain?
A large open tank is open to sea-level atmosphere and fi lledwith liquid, at 20 ° C, to a depth of 50 ft. The absolute pressureat the bottom of the tank is approximately 221.5 kPa.From Table , what might this liquid be?
Q2: The function relates the different variables in a capillary rise of a liquid is given by: h = f (d, g, ?, ?, ∅) where; h= capillary rise, d= tube diameter, ? = mass density, ? = surface tension; ∅ = contact angle Find a non-dimensionless expression relates h with the other given variables by using Buckingham theorem
A Russian submarine crashs, loses control and runs aground at the bottom of the sea. The pressure,at atm, to which the submarine gets subject ed when it ran aground at a depth of 100 meters is?(For seawater take that density is worth 1000 kg/m³)
Give me right solution. Determine the altitude of the atmosphere above sea level in meters if the atmosphere has an absolute pressure of 23 kPa, abs. and the atmospheric pressure at sea level is 101.325 kPa, absolute and temperature of 15 ⁰C. The gas constant of air is 286.9 joule per kilogram per degree kelvin. Assume the condition isisothermal.
In a fluid rotated as a solid about a vertical axis with angular velocity ω, the pressure rise p in a radial direction depends upon speed ω, radius r, and fluid density ρ. Obtain the form of equation for p=?
Suppose, which is possible, that there is a half-miledeep lake of pure ethanol on the surface of Mars. Estimatethe absolute pressure, in Pa, at the bottom of thisspeculative lake.