he temperature of 3 kg of liquid CCI, were increased from 0°C to 20°C at a constant pressSure of 1 bar. Determine AV, W, Q, AH', and AUt. The following are the properties of CCI, at 1 bar and 0°C (assumed to be constant with temp) B = 1.2 x 10-3K, kg p = 1590 m3 Cp = 0.84 9: K

Q: : Iraqi Drilling Company is considering drilling five oil wells. The probability of success for each...

A: Given: n = 5 oil wells Probability p = 20% or 0.2 The cost of each well is $200000 Each successful w...

Q: 4+3i Divide, 2-i O1+;i 01+ 2i 11 O " + 2i O 2 + 2i

A: A mathematical Expression  and need to simply it  

Q: Q: An open cylindrical vessel of (20 cm) diameter and (100 cm) long contains water up to a height of...

A: Given diameter of open cylindrical vessel of =20 cm length of open cylindrical vessel of =100 cm hei...

Q: Consider the PV diagram as shown above when a thermodynamic system changes its state from state a to...

A: given that for the path acb heat flows into the system (Q1)=120 J work done by the system (W1)=-50 J...

Q: It was found that, Van Laar model fits the behavior of the system at temperature and pressure of 65 ...

A: Given data: Temperature = 65 0C Pressure = 101.325 kPa

Q: Which of the following dimensionless numbers is not involved in the determination of convective mass...

A: By the Buckingham method of grouping the variables, the number of dimensionless groups π isequal to ...

Q: D. Argon (ideal gas) is contained in a piston-cylinder arrangement at a temperature of 120 °C and a ...

A:

Q: Q2/ A 1 m3 rigid tank has propane at 100 kPa, 300 K and connected by a valve to another tank of 0.5 ...

A:

Q: Hypothetical example – You have received a new molecule where someone tried to develop a liquid form...

A:

Q: gas is confined in a piston-cylinder device and has an initial volume of liter. It is heated and exp...

A: This question is based on Thermodynamics. Data given :  Initial Volume, V1= 1 litre= 1*10^-3 m3 [ 1 ...

Q: The cafe buzzed with activity. The cafe was cozy. It buzzed noisily.

A: The cafe buzzed with activity- Correct

Q: Using a centrifugal pump, process fluid is pumped from the bottom of one distillation column to anot...

A:

Q: The pressure at the top of a tank of jet fuel is 180KN/m². The depth of liquid in the tank is 6.4 m....

A: Given data: Pressure at the top of tank = 180 kN/m2 Depth of liquid in tank = 6.4 m Density of liqui...

Q: 12 kg of air per minute is delivered by a centrifugal air compressor It enters the compressor at a v...

A:

Q: High density polyethylene in general is ___ a. high surface area exposed than LDPE b. fluid than L...

A: High density polyethylene in general is an given options  

Q: provide diagram

A: The moles are calculated from given pressure temperature and volume . The molecular weight of mixtur...

Q: 3. A gasoline can be represented by the formula C,H16. a) Write the theoretical combustion equation ...

A:

Q: An uncontrolled furnace is emitting foul gas with NO2 portion of 1.8%. Knowing that the NO2 emission...

A: Given Foul gas have NO2=1.8% At STP(0 °C and 100 kPa) emission criteria of NO2=400mg/m3  Find Mini...

Q: When you convert a certain value of ° C to ° F, you have found out it is just simply numerically the...

A: When we convert into Degree to Fahrenheit then we have to multiply the temperature in degrees Celsiu...

Q: (a) In the recent years, the extractive heterogeneous-azeotropic distillation (EHAD) method gave gre...

A: Given: The mixture of acetone (1) and chloroform (2) forms an azeotrope at T = 65oC  or 338.15 K and...

Q: Aluminum Al (Tm=660 °C) and Germanium Ge (Tm-938 °C) were fully dissolved in each other in the liqui...

A:

Q: Determine the conjugate of the product of, (3 – 2i) (4 + 3i) O 18 – i - O 12 – i O 18 + i O 12 + i

A:

Q: Which of the following is not considered an equilibrium stage in tray tower separation processe A) r...

A: Given and Find- some options and statement regarding which is not considered as an equilibrium Stage

Q: Laboratory works were carried out to measure the composition of vapor and liquid of chloroform (1) a...

A: we have to measure Henrys constant and to be plot the graph.

Q: The cost of petroleum extraction for different depths were measurement by a chemical engineer as in ...

A:

Q: It is desired to cool 100 ton./h (tons/hour) of a mixture of hydrocarbons from 90 ºC to 60 ºC in a h...

A:

Q: 11. Parallel reactions in CSTR The following reactions take place in a CSTR: A > 3/2 B ; A –2 > 1/2 ...

A: Given: B is the desired product, and the rate of reaction for the given parallel reactions would be ...

Q: 2. The temperature of 3 kg of liquid CCI, were increased from 0°C to 20°C at a constant pressure of ...

A: Since you have asked multiple question, we will solve the first question for you. If you want any sp...

Q: Starting with Sulfur powder as raw material, give a flowsheet for production of sulfuric acid deploy...

A: Sulfuric acid is strongest acid among all the acids. It is dibasic in nature. It is oxidizing and de...

Q: Calculate the pH of the solution that results when 20.0 mL of 0.1590M benzoic acid (K.(CH;COOH) = 6....

A: Given: 20 ml of 0.1590 M of benzoic acid ka=6.28*10-5 mixed with 40 ml of 0.0795 M NaOH  

Q: a) Describe octane number b) Butanes is one of the low boiling products present in crude oils and p...

A: Answer a) The octane number (ON) is describe as knock resistance of gasoline. The Octane number is i...

Q: Determine the concentration of a 187 L solution that contains 0.33 moles of NaCN. - report answer ou...

A: Given Volume of solution=187L Moles of NaCN=0.33 Find Concentration of NaCN

Q: below

A:

Q: As an astronomer, you are in charge of an ancient collection of highly-valuable iron-type meteorites...

A:

Q: 1. Lighter feedstock will have... API gravity than the lighter feedstock. 2. Heavier feedstocks cont...

A: 1. Lighter feed stock will have higher API gravity than the lighter feedstock.  2. Heavier feed stoc...

Q: In a turbine, there is 150 m of steam entering at the top from its outlet. It enters at 5MPa, 450°C ...

A: Given data: Properties of steam at the inlet of turbine are, P1 = 5 MPa T1 = 450 0C h1 = 4000 kJ/kg ...

Q: A four pitched blades turbine is used to continuously stir a food mixture A which having a viscosity...

A: (A) It is given as baffled tank. reynold number is given as 110000. since it is for a baffled tank.t...

Q: Given all the conditions in the problem and given a flowrate of 0.11 cubic meter per second, what is...

A:

Q: X. According to Callister, the interrelationship between processing, structure, properties, and perf...

A: Material science engineering are sub categorized into material science and materials engineering. Ma...

Q: For kerosene the preferred feedstock is .... Feedstock having higher paraffin will yield gasoline of...

A: 3. For kerosene the preferred feed stock is lower aromatic. 4. Feed stock having higher paraffins wi...

Q: Calculate the density (in g/L) of argon, Ar. at 13.7 C and 639 torr Report your answer to THREE sign...

A: Argon T=13.7℃ P=639 torr Find Density,ρ of Argon

Q: An aqueous solution contains 0.239 M ascorbic acid (H2C6H606) and 0.103 M nitric acid. Calculate the...

A:

Q: Consider the process of metabolic oxidation of glucose(C6H12O6). The products of complete oxidation ...

A: Given Metabolic oxidation of glucose(C6H12O6) produces CO2 and H2O P=1atm T=25℃ Glucose feed rate=1...

Q: t-296, the blue spheres Wt-297, and the green spheres Wt-298. ng that the sample is statistically re...

A:

Q: Q2. Why the following statements are wrong? Give the correct answer. 1. Smoke Point and flashpoint o...

A: Given data  Smoke point and flashpoint of the kerosene oil are equal.  

Q: Consider the following chemical reaction between component A and B: A(l) + 2B(g) → C(g)+ 3D(l) ….....

A: The given reaction is an exothermic reaction Exothermic reaction is one in which heat is evolved. He...

Q: Example 4.3:We wish to strip SO2 from water using air at 20°C. The inlet air is pure. The outlet wat...

A: Given: Operation is at 855 mmHg Ls/Gs=0.9(Ls/Gs)max HOL is 2.76 ft Henry's law constant is 22500 mm...

Q: 'A. Calculate the pressure of steam at a temperature of 500°C and a density of 24 kg/m³ using (a) th...

A: Given: T = 500oC = 773 K Density = 24 kg/m3, Molar mass of steam (water) = 18 kg/kmol R = 8.314 J/mo...

Q: k - E = In k, + T In R - E 1 k In== Ink, + T R T

A: given lnkT=lnk0+-ER1T Slope- -ER

Q: A pipe flowing light oil has a manometer attached as shown in Figure 1. What is the absolute pressur...

A: Given:  The density of water is given as 997 kg/m3 and that of oil is 910 kg/m3. Pressure at both en...