he tire on a unicycle h a diameterof 24 inches and rotates at a rate of 187 revolutions per minute. Find the linear sped in miles per hour.

Q: A businessman enters a revolving door on the right, pushing 576N of force directed perpendicular to…

A: Force applied by businessman: F1 = 576 N Perpendicular Distance of force by businessman from hub: d1…

Q: A torque of 720 Nm is applied to flywheel that has a radius of 32.1 cm .what is the applied force?

A: The torque is given by  torque = force x perpendicular distance

Q: net Torque? what Airection is the wheel moving what shtis 4ON 60 N

A: Torque is a measure of the force that can cause an object to rotate about an axis. τ→=r→×F→τ=|r| |F|…

Q: When a wrench is rotated the magnitude of the torque is 26N.m A 95-Force is applied 35 Cm from the…

A: The free-body diagram of the wrench is shown below. Here, F is the applied force and θ is the…

Q: rt B culate only the force that exert the torque menti Submit Request Answer

A: Apply formula of magnetic force on conductor

Q: What does pearson book say about clockwise and counter-clockwise torque? which direction gives a…

A: Clockwise  torque is  considered  as positive torque and anticlockwise torque   is considered as…

Q: A measure of the effectiveness of the force in producing rotation about an axis

A: Torque gives the measurement of the effectiveness of the force in producing rotation about an…

Q: A 1.6 kg mass and a 6 kg mass are connected by a massless string over a pulley that is in the shape…

A:

Q: A wheel 25cm in radius turning at 120 rpm increases its speed to 660 rpm in 9s. Find tangential…

A: Given: Radius = 25 cm= 0.25m Initial angular velocity: Final angular velocity: Angular…

Q: phonograph curntable rotating at 33 rpm is turned off and coasts to a stop after completing 3.0 rev.…

A:

Q: A force of magnitude 89 N is applied to a door. The lever arm is given at 0.859 m. Find the torque.

A:

Q: A cylinder 0.60 m in diameter and weighing 400N starts from rest and rolls freely down a 30° incline…

A:

Q: A solid cylinder with mass of 25 kg and a diameter of 1.5-m rotates about an axis along its center.…

A:

Q: A tire is spinning with an angular velocity of 190.005 rpm.  Suddenly, brakes are applied and the…

A: Given data The initial angular velocity of the tire is Ni=190.005 rpm The time taken to stop is t =…

Q: hy Are Wheels Circular?

A: The wheels of cars or automobiles are made circular for the purpose of reducing the frictional…

Q: The pulley is a solid disk with mass 3 kg. The hanging weight m, is 4 kg. The pivot is frictionless…

A:

Q: Two buckets of mass m¡ = 21.1 kg and m2 = 13.1 kg attached to the ends of a massless rope which…

A: Given:- m1 = 21.1 kg  m2 = 13.1 kg  The mass of pully mp = 9.13 kg  The radius of the pully rp =…

Q: The product of the applied torque and the length determines the relative angle of twist between the…

A:

Q: The bolts on a car wheel require tigthening to a torque of 90 N x m. If a 30 cm long wrench is used,…

A:

Q: net Torque? what disection is the wheel moring? what Is 4ON 60 N

A: Torque = Force x r where r= radius of wheel= 0.5m

Q: a belt has diameter of 12 cm rotating at 80 revolutions per minute. find the linear speed in cm per…

A: Given data *The diameter of the belt is d = 12 cm *The belt is rotating at a speed is s = 80…

Q: You are holding a 20 kg dumbbell straight out at arm's length. Assuming your arm is 0.80 m long,…

A: Given data The mass of the dumbbell is m=20 kg The length of the arm is L=0.80 m   The torque…

Q: cylinder consisting of an outer radius ha force F1 = 3N. A second string is 5m, what is the net…

A: The correct option is (d).

Q: ber of complete turns made by and multiplying it by the circumference of the wheel. If the odometer…

A: Odometer reads total distance travelled by vehicles

Q: A force of 618.8 N is applied at the end of a wrench of length 145.2 cm. Find the torque produced in…

A: The torque can be expressed as τ=r×F

Q: The total mass of a vehicle is 1.4 Mg. The front and rear axles have a total mass of 72 kg and each…

A:

Q: prove it, In 1 second propeller take 63.333π rad turn which is equivalent to 114000. So, it takes…

A:

Q: A light rope wrapped around a disk-shaped pulley is pulled tangentially with a force of 0.51 N.Find…

A:

Q: A worker applies a torque to a nut with a wrench 0.500 mlong. Because of the cramped space, she must…

A:

Q: A pull

A: Assuming linear velocity of both the pulley's are same. linear velocity v=rω also v=r'ω'

Q: A disk with a mass of 29 kg and a radius of 31 cm is mounted on a frictionless horizontal axle. A…

A: Given,

Q: An electric motor rotating a workshop grinding wheel at a rate of 151rev/min is switched off. Assume…

A:

Q: A force of 45.0 Newtons is applied at a right angle to a lever which is 1.50 meters long. Determine…

A:

Q: A force of 290 N acts tangentially on the rim of a wheel whose radius is 25 cm.  Find the torque…

A: Tangential force applied F = 290 N radius of rim     r = 25cm= 0.25 m

Q: Determine the distance X the 84.0 N force F 2 should be applied in order to balance force F 1 of…

A: The given data are: F2=84 NF1=24 Nx1=75 cm Here, x1 denotes the distance of the force F1 from the…

Q: A coke can is suspended by a string from the tab so that it spins with a vertical axis. A 14 N…

A:

Q: A wheel 25 cm in radius turning at 120 rpm increases its frequency to 660 in 8 s . Find the constant…

A: Given: The radius of the wheel is 25 cm. The initial angular velocity of the wheel is 120 rpm. The…

Q: Why Are Wheels Of An Automobile Made Circular?

A: The wheels of cars or automobiles are made circular for the purpose of reducing the frictional…

Q: A child is riding their bicycle. The rear wheel is spinning at an angular velocity of 247.554 rpm…

A: Answer              9

Q: A force of 35N in the x direction, and 49 N in the y direction is applied at a point displaced 0.43…

A:

Centripetal Force

A particle, body, object or certain mass while travelling in a rotational path or semicircular path, experiences an inertia force. If that inertia force pulls the towards the inward of the imaginary circle in the rotation, it is termed as centripetal force.