HEAR AND MOMENT ite the shear and moment equations for the beam shown. Draw the shear and moment diagrams under e load diagram in your answer sheet, specifying values at all change of loading positions and at all mints of zero shear. mplify all equations. Please provide the FBD DIAGRAMS in your hand-written solution. INCOMPLETE/NO OLUTION means NO CREDIT. F2 kN F1 kN/m F3 kN/m BI C D 1 m 3 m 1 m 2 m 3 m E.

Q: Design a rectangular beam for a 5 m simple span to support a uniform dead load of 20 kN/m and live l...

A:

Q: The triangular channel (n = 0.013) shown in the figure is to carry water at a flow rate of 38.5 m3/s...

A: Calculate critical depth,flow velocity and slope

Q: A propped cantilever beam ABC carries a concentrated point load of 10 kN and a 2 kNm moment at point...

A: Given data, For propped cantilever beam ABC carries concentrated point load of 10kN and a 2 KNm mome...

Q: A laced column with two channels placed back to back carry an axial factored load of 1400 kN. The wh...

A:

Q: A concrete pile of size 50 cm x 50 cm is to be provided in a clay stratum whose unconfined compressi...

A:

Q: If a certain liquid weighs 6.80 kN/m³. Compute the following: 1) Mass density in kg/m³ . 2) Specif...

A:

Q: A rectangular simply supported prestressed concrete beam of span L is subjected to a prestressing fo...

A:

Q: Determine maximum principal stress

A: Given data : Normal stress in Y direction σY=10 ksiNormal stress in X direction σX=-25 ksiShear stre...

Q: The double pulley shown weighs 15 kg and has a centroidal radius of gyration of 160 mm. Cylinder A a...

A:

Q: If the sensitivity of an irrigation module is 0.5, then what percent variation in outlet discharge w...

A:

Q: Data measured during tests of a centrifugal pump at 2750 rpm are Parameter Inlet, Section O Outlet, ...

A:

Q: A distance is expressed as 1908.23 U.S. survey feet. What is the length in(a) international feet? (b...

A: Given: The distance is 1908.23 U.S. survey feet.

Q: The pump in the figure draws water from a reservoir. At point A on the suction pipe an open manomete...

A:

Q: Consider the given plane truss supported at A and B as shown below. 20 kN 5 kN E 2m 2 m 2 m H 2m F 2...

A: Given data, To find  (i) The sum of vertical reactions at A and B (ii) The force in member GI

Q: The recessed rectangular gate is located at an angle of 45 to the water surface. The gate is 5 m wid...

A:

Q: Which of the following is best modified in order to increase open channel flow capacity? a) Surface ...

A: (D) hydraulic radius is the correct answer  

Q: A strip of uniform width is to be cut off both sides and both ends of a sheet of paper that is 9 inc...

A: Given data: Size of the paper 9 in x 14 in Area=70 in2   Let strip width be "x" 

Q: 1. Formulate the Shear and moment equation of the fsimply supported beam loaded by a concentrated do...

A: Simply supported beam   a+b=L Carries point load at a distance a from support A

Q: A 2000-lb wheel load is to be supported by aggregate over soil that can withstand a pressure of 1000...

A:

Q: A concrete pile of size 50 cm x 50 cm is to be provided in a clay stratum vhose unconfined compressi...

A: Size = o.4mx0.4m load = 450  UCS unconfined compressive strength = 110kpa Hence c = 110/2 = 55  Adhe...

Q: Ex 1)if the length of a sprinkler pipe is 360m, C-120,S-12m.L-18m, GDI- 100mm, I-11mm/hr,slope of th...

A: Given Data: length of a sprinkler pipe = 360 m                                        C = 120       ...

Q: Prob. A falling head permeability test was performed on a sample of silty sand. The time required fo...

A: Given that, For a falling head permeability test, Area of stand pipe, a = 1.25 cm² Height of sample,...

Q: The triangular channel (n = 0.013) shown in the figure is to carry water at a flow rate of 38.5 m3/s...

A:

Q: PROBLEM 5: A 5° curve intersects a property line CD at point O. The back tangent intersects the prop...

A:

Q: A thin-walled circular tube and a solid circularbar of the same material (see figure) are subjectedt...

A: Given:- The torsion is applied to the circular tube and a solid circular bar The material of both ci...

Q: Compute for Rc 1.5 kips/ft A B C 8 ft 12 ft- 20 kips

A: Given -  To find - The reaction at C (Rc).  

Q: ALL SOLUTIONS

A:

Q: A soil sample has a void ratio of 0.5; its porosity will be

A: Given Data: Void ratio (e) : 0.5 To determine: Porosity (n)

Q: Q1/ A soil flooded with an (8cm) water depth at 12 p.m., at 2 p.m., the water depth on the soil beca...

A: The given data is: Total water depth=8 cm (at 12 pm) Total water depth=5 cm (at 2 pm) Total water de...

Q: For the given beam below, take P = 30 kN, W= 4 kN/m, and L= 3.5 m to solve the followings: L/2 B 3L/...

A: Answer We know that the total number of possible joint displacement which can take place due to the ...

Q: Construct the shear and moment equations of the loaded beam as shown and draw the shear and moment d...

A:

Q: An elevation must be established on a benchmark on an island that is 520.02 ft from the nearest benc...

A:

Q: The vertical stress increment (Ao) due to a point load acting on the surface of linearly elastic med...

A:

Q: 6. Draw completely the shear and moment diagrams. 40 kN 20 kN/m 10 kN/m 4m 6m 3m 3m 4m 10m -Hinge Hi...

A:

Q: 15 kN 2m 20 kN/m B D 1.5I 1.51 3m 3m 5m 4m I A

A:

Q: What will be minimum number of bolts required in each row for a suitable bolted bracket connection o...

A: Given data,

Q: Determine the force in the member AC for the given truss is 4 m 2.5 m 2.5 m G 2.5 m F 2.5 m 10 kN A.

A:

Q: 2) Three cables are connected at A, where the forces Pand Q are applied as shown. Knowing that Q-0, ...

A:

Q: a.) Compute the bearing of line 4-1. b.) Compute the distance of line 4-1. c.) Compute the DMD of th...

A: Latitude L=l cosθDeparture D=l sinθ Let l4-1 be the distance of line 4-1.  x and y be the latitude a...

Q: The estimated common excavation for the driveway is 420 cubic meters and there are also 32 footings ...

A:

Q: How many tons of coarse aggregate will be required to fill a trench 5 ft deep, 3 ft wide, and 300 ft...

A: Dimention of trench: Length= 300 ft  Width = 3 ft  Depth = 5ft Therefore, Volume= l * b * d  V= 300 ...

Q: Consider a system shown below: 5 m C D 1m 4 kN/m B 2 m With respect to above system, SFDS and BMDS o...

A:

Q: 50 mm 20 mr 75 kN

A:

Q: A prestressed concrete rectangular beam has a width = 400 mm and a depth 900 mm. It is simply suppor...

A: Given,Width=400mmDepth=900mmPrestressing force=2000 kNEccentricity =240mm(At mid span)Eccentricity =...

Q: Find redundant Re. All bar areas are the same. 160 k A 50 k D C 20 ft 20 ft 20 ft

A:

Q: 6) What are the real and imaginary parts of (1+i)exp(-it/4)/v/2? 7) What are the real and imaginary ...

A: Given  (1+i)e(-iπ/4)/√2  (1+3i)e(-iπ/4)/(6+8i)  

Q: The cross-section of a pretensioned prestressed concrete beam is shown in figure. The reinforcement ...

A:

Q: ) For adry soil, y dry = 16 KN/ m², Ws 22% %3D ind Ysat , Gs =3e ) If S=50%, e = o.82 Determine GS a...

A: Given data- Ydry = 16kn/m³ Water content (w) = 22% = 0.22 Gs = 3e Ydry = Yw(Gs)/(1+e) Ydry = 9.81kn/...

Q: a) Determine the polar moment of inertia (in in^4) of the steel shaft. b) Determine the required tor...

A: Given, d = 1.85 in  L = 4.25 ft or 51 in  P = 75 HP τa = 7500 psi  ϕ = 2.1 degree 

Q: 3. A treatment facility is currently receiving 4 MGD of flow with a contaminant concentration of 14 ...

A: