Answered: heat | bartleby

Science

Physics

heat

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter14: Heat And Heat Transfer Methods

Section: Chapter Questions

Problem 52PE: During heavy exercise, the body pumps 2.00 L of blood per minute to the surface, where it is cooled...

See similar textbooks

Related questions

Q: I. Gravity decreases with increasing distance. II. Gravity causes the occurrence of ocean tides.…

Q: a diameter of 0.762 mm was immersed in kerosene at 20˚C. Kerosene with a glass surface Since the…

A: We know that we have given that the A glass tube with a diameter of 0.762 mm was immersed in…

Q: 10 A river is flowing at a speed of 1.5 m/s. Sam wants to row from point A on one bank to point B on…

A: We need to find the direction in which Sam should row in order to reach the point B directly…

Q: The second step is to add 10 grams to the correct mass so that the actual moving net force is…

A: The given sentence: The second step is to add 10 grams to the correct mass so that the actual moving…

Q: What is the force that does zero work on a closed path Concurrent force Contact force Conservative…

A: Introduction :- Here we need to check for which type of force work done around a closed path is…

Q: A light beam strikes a piece of glass with an incident angle of 45.00. The beam contains two colors:…

Q: In the figure below, what is the work done by the non-constant force from x = 0 m to x = 12 m? * F,…

Q: 7. A pendulum has a period of 1.098 second on Earth (g = 9.80m/s²). The length (m) of the pendulum…

A: Given data: A simple pendulum Period (T) = 1.098 s g = 9.80 m/s2 Required: Length (L)

Q: A barrel contains a 0.180 m layer of olive oil floating on water that is 0.40 m deep. If the…

A: Given: Height of oil layer = 0.18 meters Height of water layer = 0.4 meters Specific gravity of…

Q: A 12-turn coil 10 cm in diameter has its axis parallel to a magnetic field of 0.5 T which is…

Q: 5q 5q 5q 5q 24 5q 2q -2g 5q 39 3q 24 2q -3ą 4 3 1 2.

Q: the masses of the two carts were measured to be m1 = 1.016 kg, m2 = 0.505 kg Use these masses and…

A: Given information: The mass of the carts: m1 = 1.016 kgm2 = 0.505 kg Assumption:The velocity of the…

Q: Freaks yon. Consider two blocks, A and B, where ma < mg . They are pulled by a horizontal force with…

Q: From the picture below of a roller coaster, at which point is kinetic energy at its maximum? a.…

A: Given data: A roller coaster Four different points are given Required: The point at which the…

Q: Two very long lines of charge are parallel to each other. One with a linear charge density -A, and…

A: Given that:- Two parallel infinitely long line charge is given.

Q: Using the slope for each spring, what would be the force required 1. to stretch the spring 0.10 m?…

Q: A point charge is located at the center of a spherical surface. The total fx through the sphere is…

Q: 12) The magnetic field at the center of a 1 cm diameter loop is 2.5 mT. a. What is the current in…

A: Given data as per question B = 2.5mT diameter = 1cm

Q: A comet has a period of 72.3 years and moves in an elliptical orbit in which its perihelion (closest…

Q: In the figure below, what is the weight of the object? That is, what is Fw? 40° cord 2 50 30 N cord…

Q: John’s mass is 86 kg, and Barbara's is 55 kg. He is standing on the x-axis at 9.0 m, while she is…

A: Given that:- Mass of John=86kg Mass of Barbara=55kg

Q: + of the potential ne figure. 9 V VE E 6 V d +

Q: a physics lab experiment, a 6.00kg box is pushed across a flat table by a horizontal force. a) If…

Q: gravitational potential energy at 20.0 m, (c) the total potential energy at 0m, and (f) the total…

A: Givenm=2.16 kgh=20 m

Q: A rectangular container of ethanol with density peth = 800kg/m3 floats in the a liquid of density pf…

Q: In a uniform electric field, compare the electric potential of the three locations and explain your…

A: Solution: Step1 - Here we will understand the concept that will be used to solve the question.…

Q: years ago, future Nobel laureate Sheldon Glashow predicted that if an antineutrino — the antimatter…

A: 1) The Glashow resonance describes the resonant formation of a $W^-$ boson during the interaction of…

Q: A hemisphere with a circular base contains a total charge of 232 pC; it has a radius of 3.29 cm. If…

A: Write the expression for the net flux and substitute the required values.

Q: Rounding a banked curve. What should be the banking angle of the road if the maximum velocity of the…

Q: In newton's ring experiment, "Central spot is dark in reflected system' and "Fringes get closer as…

A: Answer:- In newton's ring experiment Central spot is dark in reflected system and Fringes getcloser…

Q: Part A A resting muscle cell has a 70 mV potential difference across the 7-nm-thick cell membrane,…

Q: A lens of focal length +24.0 cm is at x 0, and a second lens of focal length -24.0 cm is located at…

A: Given that : Focal length of first lens = +24 cm Focal length of second lens = - 24 cm Distance…

Q: Part A A 42 g marble moving at 2.0 m/s strikes a 24 g marble at rest. Assume the collision is…

Q: 1. There are how many laws of motion? a. 5 b. 2 c. 3 d. 4 2. Which law of motion is also known as…

Q: 2) A positively-charged particle with 4e is separated at a distance of 6.11 pm from a…

Q: The position of a surveyor along the +x-axis is given in the attached equation below. In the…

A: x(t) = 7×t - 3×t2 t1 = 0 s t2 = 4 s

Q: mL cup of coffee is too hot to drink at 91C, so 100.0 mL of cold water at 6.5 C is added to cool it…

A: GivenVolume of coffee, Vc=450 mLTemperature of coffee, Tc=91°CVolume of cold water added, Vw=100…

Q: Part (b) Calculate the angular frequency, w, in radians per second. Part (c) Express the charge, Q,…

Q: A rickshaw puller pulls the rickshaw by applying a force of 160 N. If the rickaw moves with constant…

Q: Q14. Magnetic field inside a solenoid is . A. Strong at N pole and weak at S pole B. Strong at S…

A: The magnetic field within the solenoid is uniform and parallel to the axis of the solenoid.

Q: A 15.0 kg block of wood falls 3.0 m above the ground with a speed of 10 m/s from rest. How much…

A: Given data: Mass (m) = 15.0 kg Height (h) = 3.0 m Speed (v) = 10 m/s Required: Mechanical Energy…

Q: In Lab 8, Ohm's Law, a student measures the below values of voltage V and current I. First convert…

Q: Part A With -5.5 D corrective lenses, Juliana's distant vision is quite sharp. She has a pair of…

Q: Which of the following shows the CORRECT motion graphs for the following scenario? A car slows down…

Q: 12–158. An airplane is flying in a straight line with a velocity of 200 mi/h and an acceleration of…

Q: Hi there can you show me step by step on computing this problem? Thank you in advance

A: From the laws of electromagnetic induction, we know that induced emf linked to a loop depends on the…

Q: Determine which position the kinetic energy is zero. в Yo C -X-

Q: Convert 46.0° to radians, 14.0 rad to revolutions, and 73.0 rpm to rad/s. HINT (a) 46.0° to radians…

Q: A sled is tied to a tree on a frictionless, snow-covered hill, as shown in the second figure in the…

Q: How does the specific heat of water compare with that of various metals? Why ?

Question

A 158 cm long aluminum rod (thermal conductivity = 205 W/m-K) has a cross-section area of 1 cm². If one end is kept in a steam bath and the other end in an ice-water mixture, what is the quantity of heat (in Joules) conducted by the rod in 4 days? Input only the numerical value of the answer.

Video Video

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

During heavy exercise, the body pumps 2.00 L of blood per minute to the surface, where it is cooled by 2.00C. What is the rate of heat transfer from this forced convection alone, assuming blood has the same specific heat as water and its density is 1050kg/m3 ?
At 25.0 m below the surface of the sea, where the temperature is 5.00C, a diver exhales an air bubble having a volume of 1.00 cm3. If the surface temperature of the sea is 20.0C, what is the volume of the bubble just before it breaks the surface?
An engineer who is working on the heat transfer analysis of a house in English units needs the convection heat transfer coefficient on the outer surface of the house. But the only value he can find from his handbooks is 22 W/m2·K, which is in SI units. The engineer does not have a direct conversion factor between the two unit systems for the convection heat transfer coefficient. Using the conversion factors between W and Btu/h, m and ft, and °C and °F, express the given convection heat transfer coefficient in Btu/h·ft2·°F.
A window has dimensions of 1.6 m by 2.85 m and is made of glass 7.25 mm thick. On a winter day, the outside temperature is 24° C while the inside temperature is a comfortable at 19.5° C. (k of glass =0.195W/m.K) (1.5+1.5+2 = 5marks)Calculate the following:a) the area of the window in square metres Answer for part 1 .b) the temperature gradient (ΔT/Δx)in kelvin/metre Answer for part 2 .c) the rate of heat lost through the window by conduction in watts Answer for part 3 .
The tube in a heat exchanger has a 2-in inner diameter and a 3-in outer diameter. The thermal conductivity of the tube material is 0.5 Btu/h·ft·°F, while the inner surface heat transfer coefficient is 50 Btu/h·ft2·°F and the outer surface heat transfer coefficient is 10 Btu/h·ft2·°F. Determine the overall heat transfer coefficients based on the outer and inner surfaces.
Consider a 20 cm thick granite wall with a thermal conductivity of 2.79 W/m·K. The temperature of the left surface is held constant at 50°C, whereas the right face is exposed to a flow of 22°C air with a convection heat transfer coefficient of 15 W/m2·K. Neglecting heat transfer by radiation, find the right wall surface temperature and the heat flux through the wall.
A human body has a temperature of 30°C If its total surface area is 1.2 m2, what is the net rate of heat loss from the body by convection alone considering the surrounding temperature to be 24°C? Consider film coefficient to be h = 4.7 W/m2K.
A metal rod is 10 cm long and has a diameter of 2 cm one end is in contact with steam at 100 deg C while the other end contacts a block of ice at 0 deg C. The cylindrical surface of the rod is carefully insulated so heat flows only from one end to end. In a time of 20 minutes, 320 grams of ice melts. What is the thermal conductivity of the metal?
A 880 cm X 1680 cm house is built on a 15.6 cm thick concrete slab of thermal conductivity 0.62 W/m.K.. If the ground temperature of the slab is 7.6ºC while the interior of the house is 21ºC. Calculate the following: a) The temperature difference in kelvin Answer for part 1 . b) The temperature gradient (ΔT/Δx) in kelvin/metre Answer for part 2 . c) The heat loss rate through the concrete slab in kilowatt Answer for part 3 .
A rectangular window in a home has a length of 1.5 m and a height of 0.80 m. If the window allows heat to escape from the home at a rate of 2,000 watts, how thick must the window be if the inside temperature of the home is 220 C and the outside temperature is 3.00C? (Assume that the coefficient of thermal conduction of glass is 0.80 W/mK.) a. 7.1 mm b. 124 mm c. 9.1 mm d. 8.1 mm e. 11 mm
An aluminum bar has a cross-section that is 5.1 cm by 6.93 cm and is 1.91 m long. Aluminum has a thermal conductivity of 205 W/m K. If the aluminum bar is used to bridge between ice at 0 °C and boiling water at 100 °C, what is the rate of heat transfer (in W) along the bar?
A series of composite wall of a furnace consists of 20cm of firebrick, 15cm of a high temperature insulating material, 12cm of ordinary brick, and lastly, 8mm of asbestos cement board. The inside of the furnace wall is 100C. Determine the heat transfer through the wall per m². Firebrick k=1.4W/m-K High temperature insulation k = 0.22 W/m-K Ordinary brick k = 0.90 W/m-K Asbestos k = 0.39 W/m-K