Hn plane surveying (a) the curvature of the earth is taken into consideration (b) the curvature of the earth is not taken into consideration (c) the surveying extend over small areas (d) the surveys extend over large areas

Hn plane surveying (a) the curvature of the earth is taken into consideration (b) the curvature of the earth is not taken into consideration (c) the surveying extend over small areas (d) the surveys extend over large areas

Traffic and Highway Engineering

5th Edition

ISBN:9781305156241

Author:Garber, Nicholas J.

Publisher:Garber, Nicholas J.

Chapter14: Highway Surveys And Location

Section: Chapter Questions

Problem 7P

See similar textbooks

Related questions

Q: A backsight is taken on a benchmark of elevation 500 m, rod reading of 1.75 meters, vertical angle…

A: Given:- Elevation of the benchmark = 500 m Rod reading of the benchmark = 1.75 meters Vertical…

Q: SITUATION. Given the following corrected data of a close traverse: Course Distance Departure…

Q: Traverse adjustment applicable on the condition that angular accuracy is higher than linear accuracy…

A: Given- Traverse adjustment applicable on the condition that angular accuracy is higher than linear…

Q: The elevation of points O and a is 267ft, that of point is B and C is 52 4ft and that of D is 820ft…

A: The scale is defined as the ratio of the distance on the map to the distance on the ground. Scale…

Q: a) a closed traverse survey involved measurements of angels (using theodolite) and distances between…

A: To Determine Closing errors in angular measurements and in northing and easting (of the sides) and…

Q: Data of a closed traverse are as follows: Compute the distance of line (5-1) a. 206.92 m b. 374.97 m…

A: Let distance 3-4 be x and distance 5-1 be y

Q: Differentiate between the following: (i) (ii) (iii) Plane Surveying and Geodetic Surveying Obstacle…

Q: An upright aerial photograph is taken using a camera focal length of 150.7 mm, where there are 2…

Q: Q4/ Assume that a vertical photograph was taken at a flying height of 5000 m above sea level using a…

Q: SITUATION. A close traverse has a following data: Departure -500 m Course Distance Latitude А-В…

A: Given data in question Departures Latitudes Lengths To find out Error of enclosure

Q: A survey is performed on a closed traverse as shown in the figure below. The course of the traverse…

Q: HW-1-: The coordinates of traverse stations of a closed traverse ABCDE are given in Table below,…

A: solution consider the given coordinates and use cross coordinate method to find the area of the…

Q: Differentiate between the following terms/ scenarios used in engineering surveying. Retro-reflector…

A: Retro-reflector :- EDM devices have remote and a retroreflector.optical retro-reflector To reflect…

Q: What are the advantages and disadvantages of Electromagnetics surveying compared to resistivity…

A: Adavantages: 1. EM surveying is faster compared to Resistivity surveying. 2. EM surveying can be…

Q: What three surveying elements are needed in machine control?

A: The three surveying elements are needed in machine control are a} DTM Digital Terrain Models (DTM)…

Q: 3. Type of surveying in which the mean surface of the earth is considered as a plane and the…

A: Ans:- Plane Surveying

Q: Q2: a) A vertical aerial photograph was taken with (152.4 mm) focal length camera from flying height…

Q: What can be measured using total station.

A: The total station can be defined as it is an electronic instrument that is used in surveying and…

Q: A backsight is taken on a benchmark of elevation 500 m, rod reading of 1.75 meters, vertical angle…

A: To calculate the elevation in Levelling process we use the formula HI=RL+BSwhere,HI=height of…

Q: m, and 27.7 mm, respectively. What is the approximately area of this parcel in acres? 3. On a…

A: data given focal length of column f =88.9 mmflying height H = 3910 ft = 1191.768 m elevation of land…

Q: a) A closed traverse survey involved measurements of angels and distances between (5) stations A, B,…

Q: * Plus Sight is called also as I.S. O B.S. O F.S. O * F.S. is also called Station point O…

Q: SITUATION. Given the following corrected data of a close traverse: Course Latitude Departure -480 m…

A: Are of Traverse can be given by Double parallel distance method (DPD) Double meridian distance…

Q: Question: It is any deviation of the magnetic needle of a compass from its normal pointing towards

A: Magnetic declination- * Magnetic declination is the deviation of magnetic needle of compass towards…

Q: FUNDAMENTALS OF SURVEYING Triangulation stations A,B, C and D has the following observation angles.…

A: Given- Angle Values ACB 50° BAD 20° BCD 30° ABC 50° CAD 60°

Q: Problem 3 X is a point having an elevation of 756.32 m above the datum. Point Y and Z are of unknown…

Q: A survey party proceeded to do their stadia survey work as follows: the transit was set up at a…

A: c=0.30 m S1=2.001 mS2=0.600 m

Q: How to enclose a close traverse? -What is traversing in surveying and what is the importance of…

A: It has been asked in the question that how to enclose a close traverse and What is traversing in…

Q: Images a, b, and c of ground points A, B, and C appear on a vertical photograph taken from a flying…

A: It is required to find the ground length of sides AB, BC & AC. then area under triangle ABC…

Q: An inaccessible cliff was sighted from point A. The angle of elevation was observed to be 18.45°.…

Q: A man standing on a beach can just see the top of the lighthouse 25kms away. If his eye height level…

Q: A survey party proceeded to do their stadia survey work as follows: the fransit was set up at a…

A: a) Computation of stadia intervak factor (K) Given : C=0.30 m We know that, D=KS+C From A to B…

Q: 4. Type of surveying in which the shape of the earth taken into account is a) Topographic Surveying…

A: Surveying is classified in many categories based on the purpose of classification- Types of…

Q: An elevation must be established on a benchmark on an island that is 520.02 ft from the nearest…

A: Given The elevation between island and lake's shore Let shore be at point A and island be at…

Q: topic: Surveying Identification: 1. An arbitrary chosen fixed line of reference which is taken for…

A: Answer (i) Arbitrary Meridian or Assumed Meridian Answer (ii) Mistake Explanation is given in next…

Q: Q3) Suppose that highest terrain h1 average terrain havg' and lowest terrain h2 are 610, 460, and…

Q: Plane surveying is that type of surveying in which the earth is considered to be a flat surface.…

A: In plane survey curvature of the earth is not considered.Plane survey is done for area less than 250…

Q: An elevation must be established on a benchmark on an island that is 2536.98 ft from the nearest…

Q: a) a closed traverse survey involved measurements of angels (using theodolite) and distances between…

A: To Determine Correct the closing errors in angular measurements and in northing and easting (of the…

Q: A closed traverse has the following data: Line Departure (m) Latitude (m) AB 64.86 16.04 BC 84.51…

A: The latitude of a line is its projection on north-south meridian and is equal to the length of the…

Q: C) A 20-mile strip of terrain is to be photographed for highway mapping. The aerial camera to be…

A: Given values: Length of terrain, L = 20 mile =105600 ft Focal length of camera, f= 12 in Photograph…

Q: Relative precision of traverse is A absolute value of the difference between total distance and…

A: Relative precision of traverse is Option (D) ratio of linear error of closure to the perimeter of…

Q: Which statements about the Global Positioning System (GPS) are true (multiple choice questions) A.…

A: The Global Positioning System is one which provides the time, position and velocity of the object…

Q: A transit is set up at point - P with an elevation of 95 m. HI = 1.35 m, f/i = 100 m, f + c = 0.30…

Q: The distance measured along a vertical line from a vertical datum to a point or object. f.The rod…

A: Solution:

Q: An elevation must be established on a benchmark on an island that is 2536.98 ft from the nearest…

Q: List at least five (5) advantages and five (5) disadvantages of using the Trapezoidal Rule in…

A: ADVANTAGES the main advantage of the Trapezoid rule is its rather easy conceptualization and…

Q: What is the type of survey in which the curvature of the earth is disregarded? a. Geodetic survey b.…

Concept explainers

Asphalt Binders and Mixtures

Asphalt binders are subsidiary products procured during the refining process of petroleum while manufacturing gasoline, diesel, and similar petroleum products. Asphalt binders are obtained from the residue that remains after the distillation of petroleum, this residue is further subjected to steam distillation and oxidation to remove the traces of gas oil present in the residue. Certain additives or modifiers are also added to asphalt binders to alter them to suit different applications.

Question

I need the answer as soon as possible

Hn plane surveying
(a) the curvature of the earth is taken into
consideration
(b) the curvature of the earth is not taken into
consideration
(c) the surveying extend over small areas
(d) the surveys extend over large areas

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Kindly answer this, this is in the surveying subject. Thankyou in advance have a nice day! (your explantion) -How to enclose a close traverse? -What is traversing in surveying and what is the importance of this subject in agricultural and biosystem engineering
Defination of surveying? What are objectives of surveying
C) A 20-mile strip of terrain is to be photographed for highway mapping. The aerial camera to be used has a lens of focal length 12 in and takes 9×9 inches photographs. The ground elevation varies from a low of 800.00 ft to a high of 1050.00 ft above mean sea level. The plane has to make one flight line and the average width of the photographic coverage is to be 1650.00 ft. What will be the average scale of the photographs? What flying height, above mean sea level, should be used for this flight? If it is specified that the overlap (end lap) between photos be 60% and that 2 extra exposures be added at each end of the flight line, find how many photographs will be required.
When conducting traverse surveys, what are the two laws that are often used to correct the misclosure of the vertical and horizontal distances? (Check) 2 (multiple choice questions) □ A. Theodolite law, suitable for distance and angle accuracy B. Compass rule, suitable for distance measurement accuracy far worse than angle measurement accuracy C. Compass law, suitable for distance and angle accuracy □ D. Theodolite law, suitable for distance measurement accuracy far worse than angle measurement accuracy
List at least five (5) advantages and five (5) disadvantages of using the DPD method in computing the area of a given closed traverse.
What is the definition of Surveying and Plane Surveying? What is the main assumption of Plane Surveying and when not to consider this assumption?
vertical aerial photo is exposed at 3910 ft above mean sea level using a camera having an 88.9 mm focal length. A triangular parcel of land that lies at elevation 850 ft above sea level appears on the photo, and its sides measure 39.5 mm, 28.9 mm, and 27.7 mm, respectively. What is the approximately area of this parcel in acres? 3. On a vertical photograph, image a and b of ground points A and B have photographic coordinates X = -12.68 mm, Ya = 70.24 mm, Xo = 89.07 mm, and yo = 92.41 mm. The horizontal distance between A and B is 1317 m, and the elevation of A and B are 382 m and 431 m above datum, respectively. Calculate the flying height above datum if the camera had a 152.5 mm focal length?
When conducting a traverse survey, what are the precautions for selecting a traverse point? (Check) 3 (multiple choice questions) □ A. The side length of the wire should be uniform □ B. Adjacent wire points should see each other □ C. The location of the wire point should be convenient for the survey area Back D. Choose a wide field of view □E. Can use the unchangeable objects to work the guide point
This subject is surveying lecture about errors and mistakes. Please show complete solutions of no. 4 & 5.
please solve this perfectly and urgently . subject : surveying . No. 04: (a) Discuss the importance of photographic surveying with the help of examples. [CLO-
a) Plot the closed traverse based on the observed data. b) Compute the area using DMD method. c) Compute the area using DPD method.
The best surveying technique to be applied to construct a road through a thick forest choose one of the following remote senseing photogrammetry ground surveys all of the given choices