Answered: Homework F 52KN ) The slope of the…

Name: HomeworkF 52 kN) The slope of the 5.2-kN force F is specified as show
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: HomeworkF 52 kN) The slope of the 5.2-kN force F is specified as shownin the figure. Express F as a vector in terms of theunit vectors i and j.Ans. F -4.8i2j kN600 N

Engineering

Mechanical Engineering

Homework F 52KN ) The slope of the 5.2-kN force F is specified as shown in the figure. Express F as a vector in terms of the unit vectors i and j. Ans. F 4.8i-2j kN G00 N

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter6: Beams And Cables

Section: Chapter Questions

Problem 6.75P: The end of a water hose weighing 0.5 lb/ft is pulled with a 40-lb force that is inclined at 14 to...

See similar textbooks

Similar questions

Determine the magnitude of the moment (Nm) of the force P = 259 N about the line DF. Round off only on the final answer expressed in 3 decimal places.
Hi pls help me The resultant of the two forces F = 917 N and P = 1512 N is a vertical force directed upward. If the angle between F and P is 60°, as shown in the figure, find the magnitude of the resultant force (N). Round off only on the final answer expressed in 3 Decimal places.
Find the magnitude of the resultant of the concurrent forces if θ = 13.42° , β = 26.42°, F = 135.16, Q = 194.56, and P = 101.76. Round off only on the final answer expressed in 3 decimals
Determine the shear force 6.16 ft to the right of point A for the beam shown belowif P = 914 lb, W = 366 lb/ft, T = 4052 lb ft, a = 3.06 ft and b =5.21 ft. Round of the final answer (in lb) to four decimal places.
Determine the location of the resultant force acting on the shaft shown from left. options are as follows: a) 4.5m b) 4m c) 3.5m d) 2m
It is desired to remove the spike from the timber by appying force along its horizontal axis. An obstruction "A" prevents direct acess, so that two forces, one 400LB and the other "P" are applied by cables as shown. Here we want to investigate the effects of the distance between the spike adn the obstruction on the two forces so replace 8" by "d" in the figure. Determine the magnitude of "P" necessary to insure a resultant "T" directed along the spike. Please show all work and FBD thank you!
Determine the resultant internal loadings acting on the cross-section at B ofthe pipe shown in Fig. 1–7a. End A is subjected to a vertical force of 50 N, ahorizontal force of 30 N, and a couple of moments of 70 N # m. Neglect thepipe’s mass.
Q13. As shown in the image below, the member is subjected to the applied loads: a free couple moment M=320lb*ft, concentrated force F1=380lb, and concentrated force F2=220lb. The dimension a=5.5ft. Determine the magnitude of the resulatant moment (in lb*ft) caused by these applied loads about point A. Answer must inculde 1 place after the decimal point.
Draw the shear force and moment diagram between AB, assuming the earth pressure to the foundation AB as uniformly distributed.
The beam supports a vertical shear of V = 7 kip. Determine the resultant force in segment AB of the beam.
The end of a water hose weighing 0.5 lb/ft is pulled with a 40-lb force that is inclined at 14 to the horizontal. Determine the length s of the hose that is lifted off the ground and the corresponding horizontal distance L.
A beam of length L = 22 in supports a load which varies from w = 20 lb per ft at the right end to zero at the left end. Determine the position (in meters) of the resultant load measured from the left.