How is the size of the overload heaters selected forma a particular instalación?

Q: Six 1/0 aluminum conductors are to be run in a conduit. Each conductor has type THWN insulation's,…

A:

Q: Considering the termination temperature ratings of the equipment used in residential wiring, discuss…

A: In residential wiring the selection of conductor ampacity is always determined based on the 60°C…

Q: 45. A switch or circuit breaker can be used as both the controller and disconnecting means if it a.…

A: a switch or circuit breaker can be used as both the controller and disconnecting means if: a) opens…

Q: On the Datex-Ohmeda Aestiva/5 what are the steps when replacing the 4thand 5thgas cylinder supply…

A: 1. Bleed all gas pressure from the machine.   2. Ensure that all cylinder and pipeline gauges read…

Q: 1. What is mean by sequencly connection. 2. What is the benefit of using the, connectors (C], C2} in…

A:

Q: What should be the contactor value for the arm with a step power of 50 kVAr in a compensation panel?

A: Reactive power is a parameter to measure the voltage. The voltage fluctuation has to be avoided as…

Q: 21) what is core and cladding?

A: Optical fibre is basically made up of three components namely, core, cladding and buffer. Difference…

Q: Ich of the TOllowing is hot a uirement of a good cribution system?

A: It is being given that which of the following is not a requirement of a good distribution system.

Q: Three resistors of 50 Ω, 100 Ω and 200 Ω are connected in delta across the three phases of a…

A: The following is the circuit analysis for the given data:   Ia=Iab-Ica    =100∠0∘-(200∠120∘)…

Q: Discuss different types of Air blast circuit breakers. Explain with the help of neat and clean…

A: The air blast circuit breaker, according to the type of flow of blast of air is of three types. 1.…

Q: Three separate neutral conductors are installed to reduce the possibility of a conductor overheating…

A: Three separate neutral conductors are installed to reduce the possibility of a conductor overheating…

Q: When installing raceways underground in rigid nonmetallic conduit and other approved raceways, there…

A: To find the cover distance in installing underground raceways in rigid non-metallic conduit.

Q: What is the Settling time in the circuit below?

A: Since above circuit is a series RC circuit, so the settling time for this circuit should be equal to…

Q: Refer to Figure 8-30 to answer the following questions. 5-7  5)Assume that a line voltage of 2400…

A: To find the  Turns Ratio N Primary current Secondary current

Q: What happens if the primemover of an alternator is removed after connecting to the infinity busbar?…

A: What happens if the prime mover of an alternator is removed after connecting to the infinity bus…

Q: what would be the minimum size feeder conductor THHW 75 degrees for four 30- amp motor generator arc…

A: To find minimum size feeder conductor THHW 75 degrees motor generator arc welders = 4 numbers  , 30…

Q: You are working as an electrician installing fluorescent lights. You notice that the lights were…

A: If a 50 Hz rated fluorescent light is supplied by a 60 Hz supply than

Q: A distributor arranged to form a closed loop

A: A distributor arranged to form a closed loop and fed at one or more points is ring distributor ,…

Q: What provides motor running overcurrent protection for the dryer

A: The dryer's motor has an integral thermal overload safety in compliance with NEC 422.11(G) which…

Q: What is the nodal voltage?

A: Given: To answer what is nodal voltage?

Q: Grounding methods in Power systems

A:

Q: What is the resistance of a copper bus-bar,as used in the power distribution panel of a high-rise…

A: To solve above problem, one should know about resistance calculation of a material. The resistance…

Q: The diagram below shows a 3-phase overload relay. How many sets of normally closed contacts does it…

A: The 3-phase overload relay diagram is shown below:

Q: Three 1/0 AWG conductors are installed in the flex between the 400-A switch (F225 A), and the motor.…

A: As per National electricity code (NEC), the wire size of equipment grounding is based on size of…

Q: Describe and Explain what occurs in each of these circuits when the pushbutton switch is actuated…

A: The SCR is a unidirectional device that allows the current to flow in one direction and opposes it…

Q: When you see a fan unbalance frequency on the motor in an overhung fan system, one of the problems…

A: Electrical machines can be either generator or motors. They can be either Ac machines or DC…

Q: . What's the primary instrument for locating a break in a cable during emergency maintenance? A. OSA…

A: In this question we need to choose a correct option

Q: What is the function of wave tap in substation ?

A: Using a wave trap, the high-frequency carrier signals are stopped from entering the substation side.…

Q: impedance coil takes 10 A and absorbs 250 W when connected across a 220 V, 60 Hz source. What power…

A: First we will find out resistance and inductor Value then we will find out power by finding current…

Q: Q.3. Give two reasons for overloading and two reasons for short circuit and two precautions to…

A: Two reasons for Overloading: When, the live and neutral wires come in direct contact with each…

Q: stator protection scheme

A: Stator winding of Generator and motor experience different types of fault such as external short…

Q: hree-phase gas pressure cable (Draw, Identify and Mark all the parts)

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: Why is contactor coil molded into epoxy resin

A: Magnetic contactor - Magnetic contactor operates when the contactor coil is energized that means…

Q: 14 Which type of Insulator is used in Substations to support connections for High Voltage…

A: Which type of insulator is used in substations to support connections for High voltage switchgears,…

Q: You are working as an electrician installing fluorescent lights. You notice that the lights were…

A: It is given that, The ballasts are rated for operation on a 50 Hz line. They are operated at 60 Hz.…

Q: Mark all the parts of gas pressure cable in pictures

A: Gas pressure cable : it an coaxial or simple cable which filled with inert gas like nitrogen at…

Q: A reversing motor starter will have how many large three-phase line-connected contacts? A. 8 B. 9…

A:

Q: The voltage of an alternator rises from 460 volts at full load to 535 volts at no load. Calculate…

A:

Q: A load connected between the terminals started drawing 3A current and terminal voltage dropped to…

A: It is given that: ILo=3 ATerminal voltage dropped to 95 % of it's no-load value.

Q: 6.) . The NTD fuse rating for a 230 V, 3Ø, 50 hp synchronous motor with an 80 % power factor using…

A:

Q: C1 (ii). Three lIdentical capacitors are connected in star to 415 Volts, F = 50 Hz, 3 phase supply.…

A: Given:-IL=12AVL=415voltF=50Hz

Q: if the transformers is supplied with 500 volts to the primary coil with a 200 turns; and 15,000…

A: In this question,   We need to determine the the voltage on the secondary ?

Q: A polarity test is performed upon 1150/115-volt transformer. If the input voltage is 120 V,…

A:

Q: QV Answer the following questions for the 3-ph induction motor connection below, A/ What is the…

A:

Q: A snap switch with integral nonmetallic enclosure complying with NEC 300.15(E) is required to be…

A: A snap switch with integral nonmetallic enclosure complying with NEC 300.15(E) is required to be…

Q: wiring/ connection diagram of fire alarm system by adruino. and dicuss it

A: Consider the fire alarm system diagram with arduino leonardo is shown in Figure in next step

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.