How long does it take to transmit one PCM frame with 16 bytes, no synchronization and a clock rate of 46 MHz

Q: Describe short stroking and its impact on SSD per-gigabyte cost.

A: To be determine: Describe short stroking and its impact on SSD per-gigabyte cost

Q: 4. To burn a CD-R, the laser must pulse on and off at a high speed. When running at 10x speed in…

A: Answer

Q: Q1)N voice channel multiplex on a PCM/QAM system with quantization level =16. The band width of each…

A: Given :-  The number of levels =16 bandwidth (B) = 3 KHz.  The Baud rate =300 ksymbol/sec.   Concept…

Q: Describe how RS-232 and RS-422 differ.

A: DIFFERENCE BETWEEEN RS-232 AND RS-422 - RS-232 - RSS-232 is a very common type of communication…

Q: In a PCM code, how many bits are required to represent 8 voltage levels of a modulating signal?

A: In a PCM code, how many bits are required to represent 8 voltage levels of a modulating signal?

Q: SAS sends data to SCSI drives through parallel lines. Is this a true or a false statement?

A: SCSI Drives: SCSI hard drives make use of a small computer system interface, which is a standard for…

Q: i. 18) In SPI Protocol each clock cycle results in: transfer of one bit from master to slave. ii.…

A: Dear Student, SPI uses a master-slave design with a single master and is a full duplex protocol. The…

Q: A small DRAM has address pins A0-A4 and also CAS and RAS. How many address locations are in the…

A: Explanation:  The memory storage cells, which are intended and be as minimal as possible, are indeed…

Q: 4. What is the sampling rate for PCM if the frequency ranges from 1000HZ to 4000HZ?

A: The human voice normally contains frequencies from 0 to 4000Hz.

Q: What phrase is used to refer to the sum of the rotational delay and seek time?

A: Ans: The phrase that is used to refer to the sum of the rotational delay and seek time is called the…

Q: Following the two-level decoder for DRAM, for a 64M x 1 DRAM, what would the the bit-width of he…

A: In 64Mx1 DRAM,  The total number of address location is 64M.

Q: Five sources, each with a bit rate of 1000 kbps are to be combined using synchronous TDM. Each…

A: Java is a programming language. It contains extensive libraries (package). It can be used to create…

Q: Q4: An analog voltage waveform's information is to be sent with ±0.1 percent accuracy through a PCM…

A: ANSWER:-

Q: In time division switches if each memory access takes 100 ns and one frame period is 125 us, then…

A: Introduction :Given,Time Division switches.memory access time = 100 nsone frame period = 125 us ( 1…

Q: What is the capacity of a DRAM that has twelve address lines

A: Given DRAM  have 12 address lines. The address lines are time multiplexed at the beginning of a…

Q: Explain how the PCI-Express differs from PCI and PCI-X.

A: Peripheral components interconnect (PCI) is a computer bus that is used to connect the hardware…

Q: voice messages work in the 700 high frequency of 10 kHz and low frequency of 2 kHz and 10 video…

A: Ans

Q: How much quicker does an SSD perform than a magnetic disc?

A: Intro SSD: The full form of SSD is Solid-State Drive. It is nothing but a huge storage device…

Q: Assume the system clock is 12 MHz. What is the baud rate if UARTO_IBRD_R equals 2 and UARTO_FBRD_R…

A: Below is the answer to above question. I hope this will meet your requirement..

Q: A processor is fetching instructions at the rate of 1 MIPS. A DMA module is used to transfer…

A: Answer :

Q: The number of bits per sample in a PCM system has SNqR=45 dB is None of them O 7 8 The 64 QAM…

A: Solution  1. the given SNqR.45 dB (SNqR)dB=6.02nb+1076 6.02nb+1.76=45 nb=45-1.76\6.02 nb=7.18 nb= 8…

Q: If the sampling rate for a PCM signal is 200,000 samples per sec, what is the sampling interval? 5…

A: I have given an answer in step 2.

Q: SAS us

A: To find that the statement “SAS transfers data to SCSI disks via parallel cables” is true or false.…

Q: how many address lines are on the 8088?

A: The address line usually refers to the physical connection between the CPU and memory. Specify which…

Q: What are the various serial port modes? How are their baud rates set up?

A: Introduction: The serial port has three distinct modes. Baud rate: This is the rate at which data is…

Q: What are the different modes of the serial port? How their baud rates are configured?

A: There are three different modes of the serial port.   Baud rate: It is the rate of the information…

Q: What is the data rate for the IEEE-1394 bus standard in the S100 mode? What is the data rate in the…

A: Note: There are multiple questions are given in one question. According to the rule, you will get…

Q: Find the time delay for the delay subroutine shown below if the system has an AVR with a clock…

A: As Given, We have to find time delay for the given delay subroutine with a clock frequency of 9 MHz.…

Q: What is the function of the PIC controller 8259A?

A: In either the 8085 or 8086 microprocessor, the 8259A PIC controller is utilized. It is used to…

Q: Burst time Process P1 2 P2 18 P3 12 P4 P5

A: Average waiting time using round robin algorithm

Q: Q9/ In a PCM system, the highest frequency component is 10 KHz. The signal is sampled at 40% above…

A: the correct answer is:-

Q: A multiplexer combines four 100-Kbps channels using a time slot of 2 bits. What is the bit rate?

A: Introduction :Given , 4 channels Bandwidth = 100 Kbps Time slot = 2 bits we have to calculate bit…

Q: How is latency measured, and in what unit?

A: Latency is the measure of how many seconds a network will take to transfer a data from one device to…

Q: DMA transfers 8 bits in 1 CPU cycle at regular intervals. For a 2 Mhz processor, if CPU uses 0.6%…

A: According to the given question, the answer solved below is correct and with explanation.  It is…

Q: How many address pins are required for a 4G x 4 DRAM chip not counting RAS and CAS?

A: Answer of the given question: Every memory gadget has no less than one control pin.  For ROMs, a…

Q: An electrical interconnection simultaneously is known as a Parallel interface. that allows 8 or more…

A: An electrical interconnection that allows 8 or more bits of data to be sent simultaneously is known…

Q: the following protocol used to Synchronous serial interface Select one or more: a. interface…

A: Synchronous Serial Interface (SSI) Protocol used for  Answer: c. secure digital card

Q: Parallel wires are used by SAS to interact with SCSI disks. Is this correct or incorrect?

A: Introduction: Data may be sent between computers and peripheral devices using Small Computer System…

Q: Consider a CDMA system with 4-bit chipping sequences.

A: CDMA is the code-division multiple access that is a channel access method used by the various radio…

Q: Assume the SMCLK clock is 8 MHz. What is the baud rate if the UCAxBRW equals to 833 s?

A: About bound:how many times a single changes per second. Solution below:

Q: (True/False): DRAM can only be erased using ultraviolet light.

A: DRAM Dynamic Random Access Memory (DRAM) is a type of random access semiconductor memory. It stores…

Q: 1.000 volts is input into a microcontroller ADC which uses a reference of 3.3 volts. What is the ADC…

A: your question is about calculating the ADC output where input volts = 1.000 volts reference of 3.3…

Q: If binary data are transferred on a USB at the rate of 480 million bits per second (480 Mbps), how…

A: Given: If binary data are transferred on a USB at the rate of 480 million bits per second(480 Mbps),…

Q: What is the term used to describe the total of rotational delay and seek time?

A: A disc is split into several circular tracks, each of which is named. Seek Time is defined as the…

Q: A large chip has 1000 paths that are all nearly critical. Each path has a nominal dela of 400 ps and…

A: It is defined as a bit like an electric street-map with small electronic components in place of the…

Q: 9600 bps. How much time will the processor be slowed down due to DMA activity?

A: The answer is

Q: A system can produce frequencies [1000 5000] Hz. Assume we need to convert the signal into digital…

A: Answer: THE SYSTEM PRODUCES [1000-5000]HZ .ACCORDING TO NYQUIST THEOREM TO CONVERT THE SIGNAL INTO…

Q: In general, the more devices attached to the bus, the greater the bus length and hence the greater…

A: Propagation Delay is defined as the ratio of length and propagation speed

Transmission media

A communication channel that transmits data from a source to a recipient is referred to as "transmission media." Electromagnetic impulses are used to transmit data. Transmission media's primary purpose is to transmit data in the form of bits via a local area network (LAN). In data transport, it is the physical link that connects the transmitter and receiver. Transmission medium is part of layer 1 or physical layer of the ISO/OSI (Open System Interconnection) model.