Answered: many conductors will be necessary if an…

many conductors will be necessary if an address bus has to address eight devices? What if each of those devices has to be able to communicate with the I/O control device as

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter6: System Integration And Performance

Section: Chapter Questions

Problem 15VE

See similar textbooks

Related questions

Q: We pointed out that I/O buses do not need separate addresslines. Construct a timing diagram similar…

A: Answer is given below .

Q: Examination of the timing diagram of the 8237A indicates that once a block transfer begins, it takes…

A: 8237A is which refers to the direct memory access controllers which is the part of the MCS 85 of the…

Q: H6. Explain how bus encoding is used to minimize off-chip dynamic power dissipation. How does the…

A: Here's the solution:

Q: What addresses in the output portion of the datapath are mapped to the DSR and DDR respectively?…

A: Solution is:

Q: If we have one master interrupt controller connected with 2 slave interrupt controllers, then the…

A: According to our guidelines, I can provide you answer for the 1 Question at-a-time. I Provide you…

Q: planning a very wide 1024 lane bus in a system that will transfer 1024 bits in parallel to get…

A: Lets see the solution.

Q: 3. To extend the connectivity of the processor bus we use ______ . a. PCI bus b. SCSI bus c.…

A: To extend the connectivity of the processor bus we use ______

Q: Following the two-level decoder for DRAM, for a 64M x 1 DRAM, what would the the bit-width of he…

A: In 64Mx1 DRAM, The total number of address location is 64M.

Q: The byte addresses assigned to the internal SRAM are _______ to _______ in ATmega328. (Hint: To…

A: 1) ATmega328 is an Advanced Virtual RISC (AVR) microcontroller. It supports 8-bit data processing.…

Q: Why is the address bus only going in one direction?

A: To be determine: Reason for address bus only going in one direction

Q: How many conductors will be necessary if an address bus must be able to address eight devices? What…

A: With the help of conductors, the address bus must be able to address the devices. The address bus…

Q: QUESTION 2 A DMA controller transfer 32-bit words from an input device to memory in one clock cycle…

A: ANSWER:-

Q: If an address bus for a given computer has 20 lines,what is the maximum amount of memory it can…

A: GIVEN: If an address bus for a given computer has 20 lines, what is the maximum amount of memory it…

Q: If an address bus needs to able to address eight devices, how many conductors will be required? What…

A: 1. Three conductors will be needed. Consider three conductors as three bits. with three bits eight…

Q: What is the capacity of a DRAM that has twelve address lines

A: Given DRAM have 12 address lines. The address lines are time multiplexed at the beginning of a…

Q: Can DMA acts as processor? What kind of information required by DMA to act as bus master, list it…

A: DMA controller acts as an interface between the bus and the device's input-output. Even though it…

Q: What is the maximum address that can be accessed by a 16 bit address bus? a. 32 O b. 2^15 O c. 2^16…

A: The suitable option is (c) 216.

Q: lease Answer all of the following questions for MSP-432 processor with detailed calculations. Thank…

A: Introduction Please Answer all of the following questions for MSP-432 processor with detailed…

Q: The address decoder ensures that only one IC is active at a time to avoid a bus conflict caused by…

A: Given that: The address decoder ensures that only one IC is active at a time to avoid a bus conflict…

Q: As a technique of transferring data between computer peripherals A wire routeing system is necessary…

A: Justification: A computer network is a telecommunications network that allows computers to exchange…

Q: A common bus system which is capable of transferring 4 bits at time with number of registers are 4…

A: Circuit Diagram:

Q: How many conductors will be required to address eight devices through an address bus? What if each…

A: How many conductors will be required to address eight devices through an address bus? What if each…

Q: QUESTION 1 A 4K×4 DRAM uses the following pins for addressing: O 6 address pins (AO-A5) and RAS and…

A: As per our guideline we must answer only first 3 questions for the MCQ's. Below are the answers with…

Q: Design bus structure of a 32 bit system having 12 I/O devices using separate data, control and…

A: Below i have designed:

Q: 5) When using PIC32MZ EBI without an external address decoder (and note that anything that performs…

A: The Externаl Bus Interfасe (EBI) mоdule рrоvides а соnvenient, high-sрeed wаy tо…

Q: A common bus in a computer connects 16 source registers (each register is 32 bits) and one memory…

A: Given: What is the minimum number of multiplexers required? _____ What is the minimum number of…

Q: If an address bus needs to be able to address eight devices, how many conductors are required? What…

A: Address bas is part of system bus and an element of CPU which sends the address to the RAM for…

Q: Maximum propagation delay on this bus is 4 ns. The bus master takes 1.5 ns to place an address on…

A: Question :-

Q: Draw a timing diagram showing the signals required for the master to send the byte 0x2B and the…

A: Timing diagram is given below We have to send 0x2B for master We have to send 0x47 for slave…

Q: Briefly explain how the three 8-bit port registers control the I/O on the three 8-bit ports B, C,…

A: In 8-bit port register are total four ports: Port A Port B Port C port D Port B: Port B is…

Q: he maximum hex value that can be sent out from the CPU at a time on a 24 -bit bus is _________H.…

A: Hexa number system : The Hexa number system is a base-16 model of representation of the decimal…

Q: Question 4 Why must the single-cycle datapath have separate instruction and data memories? The…

A: answer is

Q: The FSM of the arbiter defined in section 8.8, and reproduced in Figure 2, can cause the third…

A: Answer:

Q: What is the method of arbitration of the PCI bus? Modify the following diagram arbitration, when…

A: In order to attenuate the latency of access, PCI's arbitration mechanism relies on access instead of…

Q: A generic DMA controller consists of the following components:1. Address generator2. Address bus…

A: Purpose of Address generator: The address generator is used to generate the source as well as the…

Q: arbitration type of control pins are needed in a microprocessor to regulate traffic on the bus, in…

A: Required: Bus arbitration type of control pins are needed in a microprocessor to regulate traffic…

Q: When multiple sources send data to the bus it results in ___. a. data collision b. bus…

A: Let us see the answer below.

Q: 45. Consider the GPIB interface between a talker and a listener as shown in Figure 13-86(a). From…

A: Given:

Q: . Answer the following questions for MSP-432 processor with detailed calculations. (a) How many…

A: According to the Bartleby guideline we are suppose to answer only first 3 sub part of the question…

Q: A common bus system which is capable of transferring 4 bits at time with number of registers are 4…

A: ANSWER : A common bus system that is capable of transferring 4 bits at a time with a number of…

Q: are used to over come the difference in data transfer speeds of various devices. a. Speed enhancing…

A: Required: ______ are used to over come the difference in data transfer speeds of various…

Q: If two devices A and B contesting for the BUS have ID’s 5 and 6 respectively, which device gets the…

A: The Answer :

Q: Assume a data bus is 16 bits wide. The data and address lines are multiplexed. If the bus runs at a…

A: Solution:-

Q: a) In order to communicate between devices inside a computer. A wire routing scheme is needed such…

A: Explanation: A Computer-motherboard is made up of a number of elements that are all linked together…

Q: Identify the addressing modes used for the source and destination operands, and then compute the…

A: The different ways in which a source operand is denoted in an instruction is known as addressing…

Q: Can DMA acts as processor? What kind of information required by DMA to act as bus master, list it…

A: DMA: DMA stands for direct memory access, and the hardware that is used to direct this memory…

Q: For the following figure, answer the questions below: 1. What is the size of address bus? 2. What is…

A: Here we have given the answers for the mentioned questions. You can find the solution in step 2.

Q: Why do we require so many addressing modes?

A: Address mode: An addressing mode is an operand that refers to the specification of instruction and…

Concept explainers

Embedded Software Development

Using specific programming languages (like C and C++) to write code for a specific hardware device in which it runs is called embedded software development. It makes the device smart by performing actions based on user's input which improves the user experience. They are designed to perform function-specific tasks rather than doing multiple tasks like computers. The embedded system is incredibly intuitive. An embedded software system could be a system developed and organized on any device, apart from an old-fashioned computer. It is the brain of a specific device; however, it is a solely useless tool and simple to elucidate what software system is embedded.

Question

How many conductors will be necessary if an address bus has to address eight devices? What if each of those devices has to be able to communicate with the I/O control device as well?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

How many conductors are necessary for an address bus to have if it has to be able to address eight different devices? What happens if every single one of those components also has to be able to communicate with the I/O control device?
If an address bus needs to be able to address eight devices, how many conductors are required? What if each of those components needs to be able to talk to the I/O control device as well?
If an address bus has to be able to address eight different devices, how many conductors will it need to have? What happens if each of those devices also has to be able to connect with the device that controls the inputs and outputs?
If an address bus has to be able to address eight devices, how many conductors will it require? What if it's necessary for all of those gadgets to talk to the one in charge of I/O?
How many conductors will be required to address eight devices through an address bus? What if each of those devices has to connect with the I/O control device as well?
How many drivers will an address bus need if it needs to be able to talk to eight different devices? What happens if each of these devices also needs to be able to connect to the device that handles the inputs and outputs?
What is the data rate if a peripheral bus operates at 12 gigatransfers per second and if there are 64 bits per transfer?
If an address bus needs to able to address eight devices, how many conductors will be required? What if each of those devices also needs to able to talk back to the I/O control device? Of programmed I/O, interrupt-driven I/O, DMA, or Channel I/O which is most suitable for processing the I/O of a: Mouse Game controller CD Thumb drive or memory stick Explain your answers.
For a 16T x 4 DRAM chip, how many internal address lines are necessary?
What benefits do a serial bus have over a parallel bus for transferring data between locations? What drawbacks exist when using a serial bus rather than a parallel bus?
What are some of the disadvantages that come along with using the bus topology?
What advantages do a serial bus for moving data between locations have over a parallel bus? What disadvantages result from choosing a serial bus over a parallel bus?