Answered: How much bleaching powder is needed to…

How much bleaching powder is needed to chlorinate 5000l of water whose chlorine demand is 2 mg/l, assuming that the bleaching powder has 25% available chlorine?

Materials Science And Engineering Properties

1st Edition

ISBN:9781111988609

Author:Charles Gilmore

Publisher:Charles Gilmore

Chapter5: Phase Transformations And Phase Diagrams

Section: Chapter Questions

Problem 5.19P

See similar textbooks

Related questions

Q: A hydrometer is used to measure the specific gravity of liquids (See Video V2.8). For a certain…

Q: The effective stress strength parameters of soil are c'= 10 kPa and p = 30°, then shear strength on…

A: Given data- Effective stress parameters-C'=10 kPaϕ=30ototal normal stress σ=300 kPapore water…

Q: Three structural member(AB,BC, and CA) of equal lengths L, areas A, and elastic moduli E,…

Q: A 25-mm diameter shaft with density 7,870 kg/m³ is pulled through a cylindrical bore a shown. Oil…

A: Given :

Q: For the beam shown in figure below, draw the shearing force and bending moment diagrams showing the…

A: Given data AC=CD=DB=BE=2m Draw shear force diagram and identify location of zero shear force…

Q: Consider the smooth uniform bar shown in (Figure 1), which has a mass of 27 kg. Neglect the…

A: Given :

Q: Current Attempt in Progress A sound wave is observed to travel through a liquid with a speed of 1700…

Q: Select the correct letter of the answer. A distance was measured on an 8% slope and found to be…

A: The given data is shown below: Slope=8%Rise=2528.75

Q: A W1 L 3 B 13. 3 C mi L 333 W2 D (a) A 12m long beam ABCD is loaded as shown above and rests on…

A: P=500N L=12m To find load intensities w1 and w2

Q: 2-118. Determine the angle between cables AB and AC. X FY 1m 0.75 m B 1 m 3 m Probs. 2-117/118 COC…

A: Given data:- Below figure is given in question,

Q: A hydrometer is used to measure the specific gravity of liquids (See Video V2.8). For a certain…

Q: Calculate the vertical reaction at B. Let P = 10 kips and W = 4 kips/ft. Assume support at B as…

Q: Explain the Iowa Borehole Shear Test ?

A: Borehole:- A well is generally excavated by hand and has a relatively large diameter, whereas a…

Q: Using the Double Integration Method. for the given cross-section of the beam below, find the ff.…

A: Given:- E=100GPa Hollow rectangle outer size=250*150 Inner size=50*50 To find:- a. Rotation in…

Q: Define the Correlations of Soil Types ?

A: The material that covers the earth's surface, known as soil, is created as a result of rock…

Q: please

A: PVCELV=PVIELV-g1L2PVCelv=14.87+0.08×1602PVCelv=21.27m

Q: A single-acting reciprocating pump discharges 0.018 m³ of water per second when running at 60 rpm.…

Q: definition of a datum in seismic reflection Choose one: a. a level equal to the mean-sea level b.…

A: Datum:- When preparing material or measuring a target's dimensions, a datum is a baseline, a line,…

Q: Question- A water treatment plant is to treat water at the rate of 6000 m³/day. If there are two…

A: Given- Discharge Q=6000 m3/dayTwo sedimentation tanks-dimensions=27×5×3.8⇒L=27 mB=5 mH=3.8 mTotal…

Q: Define why Standard Penetration Test is performed ?

A: Penetration:- Once it comes to fire-stopping, penetration is a hole made in a wall or floor assembly…

Q: 5 in y 1.00 in 2.00 in 1.00 in 5.00 in determine the polar moment of inertia of the section

A: Solution: Section Area xi Axi yi Ayi 1 1 x 5 = 5 0.5 2.5 52=2.5 12.5 2 4 x 1 = 4 1+42=3 12…

Q: A simple curve having a radius of 200m have tangents with bearing N10° E and N70° E, respectively.…

A: The given data is shown below: Radius=200 mBearings N10°E and N70°EPC distance=1+400

Q: A certain object weighs 438 N at the earth's surface. Determine (a) the mass of the object (in…

A: Note that the mass of the body is the measure of quantity of matter in a body and is a constant. It…

Q: A discharge of 150 liters per second is to be measured by a V-notch of vertex angle 60°. What would…

A: Given- Discharge Q=150 l/s=0.15 m3/sVertex angle θ=60odH=1 mmCd=0.62Head over the vertex and error…

Q: r item #3. What is the moment due to the reaction force at point A? 24.0 KN-m 36.0 KN-m 30.0 KN-m…

A: Given:- P=20kN span=5m To find:- 1.For item #3. What is the moment due to the reaction force at…

Q: Problem 8 A permeability pumping test was carried out through a confined aquifer. The aquiclude…

Q: What is Pedometer?

A: A pedometer, often known as a step-counter, is a device that counts each step a person takes by…

Q: below shows a single sided overhang beam subjected to various types of loading a mine the reactions…

Q: 7-29. Determine (approximately) the force in members GF, GK, and JK of the portal frame. Also find…

A: Given :

Q: Problem 2.139 Figure 1 of 1 300 mm -30 30 300 mm 7 300 mm Part A Determine the magnitude of the…

A: Given :

Q: The inclined pipe shown in the figure is used to carry oil (p = 900 kg/m³, μ = 9x10-3 Pa.s) The pipe…

A: Solution: Given: ρ=900 kg/m3 μ=9×10-3Pas D = 20 cm =0.2 m L = 300 m V = 3 m/s

Q: Small droplets of carbon tetrachloride at 68 °F are formed with a spray nozzle. If the average…

A: Given - Diameter of the Droplet = 240 um Temprature = 68 °F Find = Pressure difference between the…

Q: write and describe the steps and stages of designing a rail of the raiway track

A: Railway track:- The construction of a railway or railway comprised of the rails, screws, guard…

Q: What do you think are the applications of statics of rigid bodies in the photos presented below?…

A: Statics can be defined as a study which is carried out on the structures which are in the…

Q: The waste water of a certain large colony contains 10-5.6 mmol/l of OH ions at 25 °C. The pH of this…

A: Given- concentration of OH- ions=10-5.6 mmol/lIt is needed to find the pH of the sample.

Q: Fig.(4) 250 N Roller Th PT -1.5 m-1.5 m- 15m + 15m-+-15m² 1.5 m- 1.5 m- 2 m

A: This question is from solid mechanics here we are given with a triangular pin jointed frame with…

Q: (b) An aluminium plate (100 mm width x 300 mm height x 4 mm thick) with a centre-crack is subjected…

A: Given values: Aluminium plate size: 100 mm * 300 mm * 4 mm Service load = 40 KN Fracture toughness…

Q: A tyre with 230 kPa air pressure distributes a load over an area with circular contact radius of 200…

Q: A 150mm x 25mm wooden beam is reinforced with two 10mm thick steel plates on the top and bottom…

Q: 2. Fine the stress in all the members and the reactions at A of the steel frame as shown in the…

Q: FAC = -26 lb Express this component as a Cartesian vector.

A: Given :

Q: Given the coordinates of the land defined by fence posts 1-2-3-4-5-6-1 are shown in the following…

Q: The free speed of a passenger car on a 4 lane road is 90 km/hr, while that of a truck is 45 km/hr.…

A: Given- free speed of car Vf,car=90 km/hrfree speed of car Vf,truck=45 km/hraverage length=5 maverage…

Q: The rectangular bar has a width of w= 2.75 in. and a thickness of t = 2.00 in. The normal stress on…

A: Given : W = 2/75 in. t = 2.00 in Normal stress on plane AB of the rectangular block is 6ksi

Q: If the alum dose required to coagulate is 10 ppm, find out the amount of alum (in quintals) needed…

Q: Part A Determine the tension in the cable AB in order to support the 300-kg crate in the equilibrium…

A: Given : TO Find : FAC , FAB ,FAD?

Q: 2 in 4 in 130 lbf 13 in -in dia. 1-in thick 1 15 in The figure shows a rectangular member O B, made…

A: Given diagram:-

Q: Determine the maximum deflection of the 66-mm-diameter A-36 steel shaft. Express your answer to…

Q: express each common fraction as a decimal fraction. 1⁄3

A: Given:- The common fraction = 13 To determine:- Express the given common fraction as a decimal…

Q: A 4m high vertical wall supports a saturated cohesive soil p =0 with horizontal surface. The top…

A: Answer To find the Total active pressure on the wall based on the given data we have Pa =…

Concept explainers

Sediment transport

Sediment transport or Soil transport is the movement of solid particles, usually due to the combination of gravitational forces acting on the sediment, and the movement of the liquid at which the sediment enters. Soil erosion occurs in natural systems where the particles are sandstones (sand, rocks), mud, or clay; the liquid is air, water, or ice; and the gravitational force that works to move particles to the landing surface. Sediment transportation or soil migration due to the movement of liquids occurs in rivers, lakes, lakes, oceans, and other bodies of water as a result of currents and waves. Transportation is also caused by glaciers as they flow, and to places on earth under the influence of wind. Soil erosion due to gravity alone is possible in most sloping areas, including hills, scarves, cliffs, and the continental shelf — the continental boundary of the slope.

Question

How much bleaching powder is needed
to chlorinate 5000l of water whose
chlorine demand is 2 mg/l, assuming
that the bleaching powder has 25%
available chlorine?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

In ratio of 3:2 between alcohol and water is to be mix in order to produce a 1000 ml ethyl alcohol. How much is the alcohol? And how much is the water?
What will happen to the pH and alkalinity of the water as alum is added? Justify your answer.
What are the main sources of Nitrogen oxides (NOx)?
Hydr. Cycle.
DC Brick has fixed cost of production of $2,562,500 per year and a unit production cost of $0.75. Marvel Brick has a fixed cost of production of $1,000,000 a unit production cost of $2.00. At what number of units produced will the two companies have equal annual production costs?
1. Give other substances that can be used as coagulating agent in water purification besides aluminum sulfate and ferric chloride 2. What is the purpose of stirring after the addition of alum in water sample in water purification experiment?
A 1,200 gpm WTP is being designed for treating iron and manganese. The influent manganese concentration is 80 mg/L and the iron concentration is 90 mg/L. How much oxygen (mg/L DO) from aeration is needed for design? Assuming that aeration only removes 85% of Fe and Mn, how much potassium permanganate is needed (mg/L)? Design standards require 30 days of chemicals onsite. Assuming that the chemicals onside are dry, how many lbs of potassium permanganate are required? If the treatment plant is to operate two filter cells at a time, what is the required SA of each cell, assuming SOR of 2.5 gpm/sqft?
Mixtures of Non- Reacting Fluids A 100-L container contains 50 L of water and 100 g of soluble chemical at the start. At a rate of 3 L/min, a pre-mixed solution containing 2 grams of the soluble chemical per liter is pumped in. The output of well-stirred mixes is 1 L/min. What is the chemical content in water as it is filled, in grams per liter?
Short out this problem
need a good unplagiarized answer. Question: The slow cooling process can effectively stabilize the components of clinkers produced in the burning kiln.
Propose a combination of treatment processes which you think can achieve the best removal of biochemical oxygen demand (BOD), chemical oxygen demand (COD), and suspended solid from POME. Justify your answer.
Derive the CO2emission factor for the coal.