How much energy is stored in a capacitor of capacitance C = 2.89 µF connected in series to a resistor of resistance R = 1.39 MN and a battery of emf § =3.55 V in a time t = 2.12T where t is the time constant of the circuit? Express your answer in µJ but do %3D not write the unit. Round off your answer to 2 decimal places.

How much energy is stored in a capacitor of capacitance C = 2.89 µF connected in series to a resistor of resistance R = 1.39 MN and a battery of emf § =3.55 V in a time t = 2.12T where t is the time constant of the circuit? Express your answer in µJ but do %3D not write the unit. Round off your answer to 2 decimal places.

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter29: Direct Current (dc) Circuits

Section: Chapter Questions

Problem 19PQ

See similar textbooks

Similar questions

Power P0 = I0 V0 is delivered to a resistor of resistance R0. If the resistance is doubled (Rnew = 2R0) while the voltage is adjusted such that the current is constant, what are the ratios (a) Pnew/P0 and (b) Vnew/V0? If, instead, the resistance is held constant while Pnew = 2P0, what are the ratios (c) Vnew/V0, and (d) Inew/I0?
A 12-volt battery of internal resistance r of 0.05 ohm is to be recharged by a 50-volt dcsource at the rate of 8 amperes.a. What resistance R is to be connected in series with the circuit? ANSWER:_________b. What is the terminal voltage of the battery? ANSWER:_________c. How much energy in joules is dissipated in the resistor in one hour ?ANSWER:_________
From the given circuit, find I, the power dissipated by the resistor, and the power supplied by each source. Assume V1 = 11 V, V2 = 14 V, and V3 = -6 V.
How long does it take the charge to reach 63% of its final value if a 10 microfarad capacitor is connected to a 50V battery through a circuit whose resistance is 1000 ohms?
Given the following circuit, find theequivalent resistance and the voltageacross R2. Let V = 16 V, R1 = 4 Ω, R2 =2 Ω, R3 = 6 Ω, R4 = 3 Ω, and R5 = 5 Ω .
If a capacitor, C=30.4 μF is suddenly connected to a circuit with the total resistance of R =10.22 Ὼ in the circuit with a battery of any capacity, how much time (in microseconds) will elapse for the voltage on the capacitor to be 60 % that of the battery?
When the switch S is open, the voltmeter V of the battery reads 3.05 V. When the switch is closed, the voltmeter reading drops to 2.88 V, and the ammeter A reads 1.57 A. Find the (a) emf, (b) internal resistance r of the battery, and (c) circuit resistance R. Assume that the two meters are ideal, so they don’t affect the circuit.
How do you find the value of a resistance R1, in a circuit when the equivalent resistance is 40 ohms, given that: R2 = 12 ohm in series with R3 = 40 ohms whom combined are in parallel with R4 = 20 ohms, all in parallel to R1. And to find the current in each resistor, do I just apply the equation, I = V/R, given that the circuit runs on an 28 volt batt.
The figure above shows a circuit containing an electromotive force (a battery), a capacitor with a capacitance of C farads (F), and a resistor with a resistance of R ohms (Omega). The voltage drop across the capacitor is Q/C, where Q is the charge (in coulombs), so in this case Kirchhoff's Law gives RI + (Q/C) = E(t) since the current is I = (dQ/dt), we have R(dQ/dt) + (1/C)Q= E(t) Suppose the resistance is 30 ohms, the capacitance is 0.1 Farads, a battery gives a constant voltage of 40 volts, and the initial charge is Q(0)=0C.Find the charge and the current at time t. Q(t)=? I(t)=?
In the circuit below, the capacitor starts out uncharged. The resistance is R = 118 Ω, capacitance is C = 0.0647 F, and the battery emf is 16.7 V. What is the charge (Q) on the capacitor at a time of t = 3.72 seconds after the switch is closed?
The compressor on an air conditioner draws89.1 A when it starts up. The start-up time isabout 0.243 s.How much charge passes a cross-sectionalarea of the circuit in this time?Answer in units of C.
If the battery in the circuit below is 7.16V, resistor R1=331.15ΩΩ, and resistor R2=51.49ΩΩ, what is the magnitude of the current flowing through the circuit? Please give your answer in units of milli-Amps (mA).