How to identify the miswire in a UTP cable using a cable tester, write the steps in your own words?
Q: Why Subtrate of N channel MOSFET is connected to ground ?
A: MOSFET(Metal Oxide Semiconductor field effect Transistor) is three terminal electronic device.…
Q: hat does the term dBi mean? How is it computed?
A: dBi stands for Decibels referenced to Isotropic gain or Isotropic antenna power gain Decibels…
Q: How many transmission channels are required for full duplex?
A: Full duplex mode requires two independent channels. One channel is for receiving the data and the…
Q: if an eight-level encoding scheme is used in a 30-kHz bandwidth system, what is the channel capacity…
A: The solution is given below
Q: What is a multipath channel? why is a multipath channel frequency selective?
A: Multipath channel Multipath channel (MPC) authorizes to code single transmission group for…
Q: 4. What happen to a call in fixed channel strategy, if all the channels in a cell are occupied?
A: In a fixed channel strategy, each cell is allocated a predetermined number of voice channels.
Q: layman's term, explain super heterodyne receiver.
A: The explanation is as follows.
Q: For 3G cellular data networks, what function does the RNC (Radio Network Controller) play?
A: RNC represents Radio Network Controller. The function RNC plays in this architecture is to control…
Q: 1. In BST Wnicn Terminal is the jargest region?.
A:
Q: - Design a 3x8 decoder by using 2x4 decoder? - Design a 4x16 decoder by using 3x8 decoder?
A: To construct 3x8 decoder two 2x4 decoder and a not gate is used. And for 4x16 decoder two 3x8…
Q: Explain block schematic of TDM?
A: Time division multiplexing is a technique by which multiple data signals can be transmitted over a…
Q: Draw the neat labeled diagram of a 10Base5 ethernet cable?
A: The diagram of 10Base5 ethernet cable is as shown below
Q: For the source coding Explain the difference between variable length and fixed length source coding?
A:
Q: Q5: Design a 4x16 decoder using 1x2 decoder?
A:
Q: Determine the Emmision Classification 2. Single sideband full carrier single analog channel…
A: Given: Single sideband full carrier single analog channel telephony. To find: Determine the Emission…
Q: 2. What is the reason of inventing Excess-3 Codes?
A: in this question, we have to give the reason for inventing excess-3 code
Q: -Q.1 B) Construct a 5-to-32-line decoder with four 3-to-8-line decoders with enable and a 2- to-…
A: Note: Since you have posted multiple independent questions in the same request, we will solve the…
Q: Explain the things that need to be met to get reliability in connectivity and interoperability!
A: There are billions of devices which is connected through internet of things. These devices are…
Q: Refer to the block diagram of an optical fiber communications system.
A:
Q: What is the mixer in a superheterodyne receiver?
A: Superheterodyne receiver It is used in radio broadcast reception and two-way radio communication…
Q: Construct 2 to 4 line decoder using NOR gates with enable and truth table ?
A: 2 to 4-line decoder The A and B are 2 binary inputs decoded into 4 outputs is known as 2 to 4-line…
Q: Give one advantage and one potential disadvantage of using licensed spectrum in wireless…
A: to give one advantage and one potential disadvantage of licensed spectrum in wireless communications
Q: Q#4: a. What is meant by interpolation? b. Explain the voice to digital and digital to voice…
A: a) Interpolation- The literal meaning of interpolation is to inject something of different nature…
Q: To avoid using a pin grid array, which AMD socket makes use of a land grid array?
A:
Q: 2.) Do radio transmissions occur in the VLF and LF ranges? Explain.
A: Radio transmission: Radio transmission means transmitting the radio signals at a radio frequency in…
Q: Describe how digital signals are transmitted over a telephone line or TV cable
A: Digital signals can be transmitted over the transmission line using either serial or parallel…
Q: Discuss Telecommunication Engineering, explaining all its key components and how telephone call is…
A: The communication systems enable fast transfer of information all over the world. Some modes of…
Q: Choose the correct Answer: The difference in the propagation delay between the fastest and slowest…
A: delay skew is the difference between the propagation delay on the fastest and slowest pairs in a…
Q: Draw a circuit diagram of a 2 bit NOR decoder. Show and explain which line will be activated if he…
A:
Q: What is a GOOSE message? For what purposes is it used and how is the message delivered? What are its…
A: GOOSE is stands for Generic Object Oriented Substation Event which provides the main possibilities…
Q: a. What is communications system's main equipment? Write and explain with short sentences.
A: Explanation: “Since you have asked multiple questions, we will solve the first question for you. If…
Q: For GSM 900, mention the uplink and downlink frequency bands
A: In the following section, the uplink and the downlink frequency bands for GSM 900 is provided.
Q: (b) In a particular implementation of ADSL2+, 400 downstream subchannels are being used to achieve a…
A:
Q: What is the biggest disadvantage of the ASK scheme?
A:
Q: How many 3-line-to-8-line decoders are required for a 1-of-32 decoder? 2 8.
A:
Q: Introduction about cables that related to voltage and application of thes
A: A power cable is an electrical cable that is made up of one or more electrical conductors that are…
Q: Choose the power electronics device, which is latching device?
A: A Latching device is a switch that stays on until the power that goes into is removed or disabled…
Q: A bank has its head office in the financial district in the middle of a city. It has six branches,…
A: The cost of all branches is calculated as: Cb=3×6×100ε=1800ε The cost of all modem is determined as:…
Q: Draw the block diagram of optical fiber communication system
A: The three elements of optical fibre communication are as follows- (1) Transmitter- it consists of…
Q: Which AMD socket uses a land grid array instead of a pin grid array to avoid needing a pin grid…
A: The power system has to transmit power from the generation side to the load side. For this purpose,…
Q: How to identify the short in a UTP cable using a cable tester, write the steps in your own words?
A: UTP cable stands for unshielded twisted pair cable
Q: For a communication link what are the different forms of modulation?
A: Given : Modulation is a method which is used in the communication system for the following…
Q: What are some of the potential complications associated with the use of communication equipment?
A: Communication Equipment- Equipment which refer to the communication process. Some equipment which…
Step by step
Solved in 2 steps with 2 images
- How to identify the short in a UTP cable using a cable tester, write the steps in your own words?6.a. What type of cable installation is typically used in industrial facilities?A. Aerial onlyB. Buried onlyC. Buried and aerialD. Industrial facilities don't use cable installations.6.b. Which type of fiber is used in a standard FDDI network?A. OM3 or OM4 at 850 nmB. OM1 at 1,550 nmC. OM2 at 1,310 nmD. OM1 at 1,310 nmList and critically explain at least five (05) security mechanisms that are important for wireless communications?
- What are some of the potential complications associated with the use of communication equipment?1) Draw 5*32 decoder by using only 2*4 and one 3* 8 decoder as enable with proper labelling ?Discuss Telecommunication Engineering, explaining all its key components and how telephone call is established from party A to party B. Outline every process involved
- Refer to the block diagram of an optical fiber communications system. Explain the basic operation and, specifically, the function of each block and/ or component within the system.] Explain with the aid of equations the following:(a) How to improve the noiseless channel capacity?communications systems question :-What is the meaning of the following abbreviations : PAM,PDM, PPM
- Explain the things that need to be met to get reliability in connectivity and interoperability!What are the advantages of using CDMA for a cellular network?Explain the concept of cable impedance matching and why it is crucial for high-speed data transmission. Provide examples of situations where impedance mismatches can lead to signal degradation.