Why Subtrate of N channel MOSFET is connected to ground ?
Q: In a hybrid computer, the digital signals generated by a computer are sent via a modem, which…
A: Modem is a device used to convert the incoming digital signals to outgoing analog signals. ADC…
Q: Derive current divider rule formula
A: The solution can be achieved as follows.
Q: which device can be used in a chopper circuit? a-all of the mentioned b-GTO c-MOSFET d-BJT
A: In chopper we need a power electronic switch which has unidirection current flow and unipolar…
Q: How many transmission channels are required for full duplex?
A: Full duplex mode requires two independent channels. One channel is for receiving the data and the…
Q: 4. What happen to a call in fixed channel strategy, if all the channels in a cell are occupied?
A: In a fixed channel strategy, each cell is allocated a predetermined number of voice channels.
Q: For 3G cellular data networks, what function does the RNC (Radio Network Controller) play?
A: RNC represents Radio Network Controller. The function RNC plays in this architecture is to control…
Q: Please describes the superheterodyne receiver in terms of the type and sequence of components…
A: The process of mixing two signals having different frequencies to produce a new frequency is called…
Q: can i series my led chip even though i don't put any fuse. Is it safe?
A: Most of circuit does not contain fuse for LED Chip Reason behind not putting fuse for LED Chip is…
Q: 2. What is type of Ring counter Explain them? 3. what is Decade Counter Explain it?
A: to explain the type of ring counter to explain decade counter
Q: Calculate the value of ID b) Determine VDS c) What effect has the insulated channel from the gate in…
A: Given, RD = 300ΩRS = 1900ΩVDD = 10V Used Formulae, VD = VDD2ID = VDRDVDS = VDD - ID(RD + RS) where,…
Q: How to wire 220volt ac at a breaker box?
A: To wire 220 V ac at a breaker box, the following steps needs to be followed: Turn off the main…
Q: What are the steps required in order to solder the RFID for the arduino? and what are the benefits…
A:
Q: Define and explain the fiber channel structure *
A: A fiber channel (FC) is a computer networking technology that is used to transfer data between one…
Q: Draw the neat labeled diagram of a 10Base5 ethernet cable?
A: The diagram of 10Base5 ethernet cable is as shown below
Q: what is the effect. low cost operation amplifier in optical fiber system ?
A: The optical amplifier is a gadget which gets some information signal and produces a yield signal…
Q: What are the three most important effects due to multipath in mobile radio channel? Explain each…
A: We have given the problem What are the three most important effects due to multipath in mobile radio…
Q: bipolar junction transistor is often applied to three terminal devices. why ?
A: Given: Why the BJT is applied to devices with three terminals?
Q: Question 4: what is the effect low cost operation amplifier in optical fiber system ?
A: Optical fibres are most commonly employed to convey light between the fibre's two ends, and they're…
Q: Explain how a RCD (Residual Circuit Device) works, also explain using a diagram.
A: According to the question we have to Explain how a RCD (Residual Circuit Device) works, also…
Q: Refer to the block diagram of an optical fiber communications system.
A:
Q: What frequencies found in RTK radios require licensure?
A: As per the code of federal regulations, it holds the complete rules of FCC. The federal regulations…
Q: Differentiate MCB and RCD and Explains its purpose in an installation?
A: MCB is an electrical switch designed for automatically working to protect the electrical circuit…
Q: What do you mean by cutoff voltage for JFET?
A: The JFET is the abbreviation for junction field effect transistor. There are two types of JFET…
Q: How to identify the miswire in a UTP cable using a cable tester, write the steps in your own words?
A:
Q: To avoid using a pin grid array, which AMD socket makes use of a land grid array?
A:
Q: i) List at least FIVE balance of system BOS components and state the main role of each. ii) What…
A: All components of a photovoltaic system other than the solar panels are included in the balance of…
Q: What are the different turn on methods of SCR?
A:
Q: NMD90 conductor size, and the minimum and maximum rating of circuit breaker that can be used for the…
A: Please find your answer below in step 2
Q: Describe how digital signals are transmitted over a telephone line or TV cable
A: Digital signals can be transmitted over the transmission line using either serial or parallel…
Q: 5.Differentiate the advantage and disadvantages of Conduits RSC,EMT,IMC, & PVC with each other
A:
Q: Function of RF mixer is
A: The correct option along with the explanation is provided in the following section.
Q: 3.It is possible to use the CRD for measuring the current?
A: The measurement devices are used to measure electrical quantities. The true value and the measured…
Q: How to test ( good, bad ,leak) of certain SCR and TRIAC using VOM?
A: A SCRis known as silicon controlled thyristor it has four layer which is shown in below figure scr…
Q: Duplex receptacles connected to a 20-amp, small appliance branch circuit in kitchens and dining…
A: The objective is to complete the statement. Duplex receptacles connected to a 20-amp, small…
Q: What is forward baising in the SCR?
A: In the forward biasing the majority carrier of the P-type will behave as the minority carriers of…
Q: constellation diagram for 9600 bps modem
A: Given that, Rb=9600 bps
Q: What is a borrowing strategy in fixed channel assignments? a) Borrowing channels from neighbouring…
A: In the borrowing process, the cell is allowed to borrow channels from a neighboring cell when all…
Q: Which modulation technique is used by GSM?
A: The solution is provided in the following section.
Q: What is the working explanartion for full-smd 16-led board?
A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…
Q: MOSFET
A: Given- Vt=1 Voltskn'=20μA/V2L=4μmW=100μmλ=0VD=+5Volts RS= 4 kΩ
Q: Which AMD socket uses a land grid array instead of a pin grid array to avoid needing a pin grid…
A: The power system has to transmit power from the generation side to the load side. For this purpose,…
Q: Q.1/ An optical fiber has a core-index of 1.480 and a cladding index of 1.478. What should be the…
A: Normalized frequency V<=2.405 is the value at which the lowest order Bessel function J=0.
Q: There is a technological divide between wireless access points and bridges.
A: Solution The technology divide is a term that refers to the gap between demographics and regions…
Step by step
Solved in 2 steps
- 6.a. What type of cable installation is typically used in industrial facilities?A. Aerial onlyB. Buried onlyC. Buried and aerialD. Industrial facilities don't use cable installations.6.b. Which type of fiber is used in a standard FDDI network?A. OM3 or OM4 at 850 nmB. OM1 at 1,550 nmC. OM2 at 1,310 nmD. OM1 at 1,310 nmConsider the voltage divider configuration circuit shown in figure 7, determine the levels of ICQ and VCEQ using the exact and approximate analysis techniques. then copare solutions obtained for exact and approximate analysis in part I and reflect on the result?QUICK QUESTION: for this particular circuit, what formula should I use for Rin(emitter)?
- Trying to solve this MOSFET question but not sure how.i) List at least FIVE balance of system BOS components and state the main role of each. ii) What are the relevant voltage and current ratings of each of the BOS equipment identified in (i)?What are the advantages of using CDMA for a cellular network?