Humid air condensation

Q: 1) Determine the bottom product composition, as well as the molar flowrates of the distillate and…

A:

Q: H.W.4 try to find the equation below For a mixture of constant a: W 1 Inn F α- 1 In- == - (Xu…

A: Batch distillation is the method of separating components based on their relative volatilities. In…

Q: (min) C₁ (mol/dm³) 0 2 5 1.6 9 1.35 15 1.1 22 30 40 0.87 0.70 0.53 60 0.35

A:

Q: How to plot Txy diagram for p-xylene and benzene mixture at the pressure of 95 kpa

A:

Q: ХА Рт — Р В Po A PO в

A: given that there is an equation given in therms of total pressure and partial pressure ..we have to…

Q: 4. A certain reaction is first order in A. The specific rate constant is 3 x 10-³/s. a. Calculate…

A: a) given = K = 3*10-3 /s to find = half-life For first-order reaction t1/2 = 0.6933*10-3 s-1 = 231 s…

Q: 3.For a given T and P (binary system), V = 150x₂ + 75X₂ + 1.5X₁X₂ in cm³/mol. Solve for as a…

A: The molar volume of binary system is given

Q: The following reactions are taking place in an adiabatic CSTR. A1= A2= A3= 1s^-1 EA1/R=250K;…

A: A complex reaction (series-parallel) is carried out in a CSTR.

Q: Consider a continuous, steady-state process in which the following reactions take place: C6H12+…

A: Given reactions are- C6H12+6H2O→6CO+12H2C6H12+H2→C6H14 Input feed are- C6H12 (F1)=250 moles H2O…

Q: 1. In an unseeded BOD test, a 300-mL BOD bottle contains 30 mL wastewater sample. The initial DO is…

A: BOD3 = [DOinital - DO3 days]*dilution factorBOD3 = [9.0 mg/L - 3.2 mg/L]*30030BOD3 = 58 mg/L b) L =…

Q: What are typical ratios of nanomaterials to polymers in polymer in polymer nanocomposites?

A: To explain what the typical ratios of nanomaterials to polymers in polymer nanocomposites are

Q: 1) Distillation of a binary mixture is carried out in a packed column. The more volatile component…

A: Temperature = 80 0C Pressure = 1 bar Binary diffusion coefficient in vapor = 5*10–6 m2/s Binary…

Q: Estimate the fugacity of n-pentane at its normal-boiling-point temperature (36°C) and 200 bar. Take…

A: Temperature = 36 0C or 309.15 K Pressure = 200 bar

Q: Nanoparticles were added in a liquid to prompt the medication release, and it was observed that 5 mg…

A: Given that- Madication released= 5 mg Volume of PBS=1 liter Amount= 60% of total drug Equivalent…

Q: Choose the correct option: 18. For mixtures with substances with close boiling points, a…

A: A plain distillation is also known as simple distillation which is used to seperate the compoennets…

Q: Calculate how many CFSTR reactors are required to achieve a final effluent value that is only 2x…

A: Effluent concentration in single PFR = 0.1 C0 Final effluent concentration in CFSTR s connected in…

Q: Consider the reaction: 2H₂S(g) + 302 (g) → 2H₂O(l) + 2SO2(g) Using standard absolute entropies at…

A: Given the following reaction:   2H2S + 3O2 →2H2O + 2SO2we have to find the entropy change of the…

Q: A labeled flowchart of a continuous steady-state two-unit process is shown below. Each stream…

A: Given process flow digram has two unit process. Draw the flow diagram of first unit process as…

Q: The following data shows the liquid-vapor phase boundary of methane. T(K) 100 190 108 110 112 114…

A: Write the Clausuis Clapeyron equation as follows: lnP = -∆HvapR1T + C   ......1 Here, P is the vapor…

Q: In the ethyl benzene plant, one of the unit operations that is distillation column (T-302) is mainly…

A: First of all, the cost of the distillation tower in 2001 is calculated using the equation: Cost of…

Q: 2. Assuming a feed of x = 0.45 at 10 bar at the bubble point, we want to achieve an x= 0.70 and Xw =…

A: A mixture of cyclohexane and butanol is separated into distillate and bottom products.

Q: A boiler is used to heat steam at a brewery to be used in various applications, such as heating…

A: Given that :n=67 %P=20 barT=20 CQ=155 m3/h

Q: For the following reaction, 12.0 grams of magnesium nitride are allowed to react with 16.2 grams of…

A: Mass of the magnesium nitride = 12 g Mass of the water = 16.2 g

Q: 2) Atmospheric air (79% N₂ and 21% O2 on a molar basis) is to be distilled at 1 atm to produce 98%…

A: Atmospheric air is to be distilled in a fractionating distillation column.

Q: Logarithm of the relaxation modulus versus temperature for crystalline isostatic (curve A), lightly…

A: Relaxation modulus versus temperature graph of a polymer is given.

Q: space-time and space-velocity

A:

Q: For step 3, are you sure that there are two undesired reactions? Should the rate for U goes to A be…

A: -r1A=k1CA. CB-r2D= k2CD-r3A=k3.CA. CB-r2A=k4CA

Q: Estimate the volumetric flow rate

A: Given data: Composition of n-octane in the mixture = 40 wt % Composition of n-decane of the mixture…

Q: 5. In Semi-Batch Reactor, derive the working equation for both compressible and incompressible…

A: To understand the working equation for both compressible and incompressible fluids in a semi-batch…

Q: Why do you use this equation instead of Head loss=f*L/D*V^(2)/2

A: Given that You have doubt in head loss formula

Q: Find the pressure of saturated vapour as a function of temperature p(T) if at a temperature To its…

A: Note: We are authorized to answer one question at a time, since you have not mentioned which subpart…

Q: chemical factory wants to design an ethylene rectifying column to separate petroleum gases. Process…

A: The thickness parameters are used and standard thickness is choosen from standard table. The…

Q: EMO D130 EISO ARD140 V145 V196 PISO dyna DA 40 PS

A: A feedback control system consists of five basic components: (1) input, (2) process being…

Q: 4) A mixture containing equal molar amounts of methanol and water is fed into a vessel which is at a…

A: T,x-y diagram represents the distribution of components in liquid and vapor phase between boiling…

Q: Consider the ethylene(1)/propylene(2) system as a gas at t= 150°C, P= 30 bar, and y₁ = 0.35.…

A: System of ethylene (1) and propylene (2). Temperature, t = 150°C = 423 K Pressure, P = 30 bar Gas…

Q: Assume the benzene (species 1) from problem 1 is part of an equimolar vapor mixture with n-hexane…

A: Fugacity is the measure of the chemical potential of a component, in other word fugacity is the…

Q: As is good practice for apprenticing scientists, we plan to check the repeatability of experiments…

A: Given that- Volume of water= constant ( during experiment) Mass of object= 22.4 kg Number of fall,…

Q: the total heat loss per metre length of the reactor,

A:

Q: Question 8 Use the AHºf information provided to calculate AH°rxn for the following: 2CIF3 (g) +…

A: Given that :2CIF3+2NH3→N2+6HF +Cl2

Q: Problem 2. Water is flowing through a circular pipe of radius R=2.5cm. The velocity profile of the…

A: Given, The velocity profile, v = v01-rR1/7 Where, v0 = 3 m/s The radius of circular pipe, R = 2.5 cm…

Q: batch of green lumber is dried by passing air at 50 degree C dry-bulb and 20 degree C wetbulb over…

A: Given    The lumber decreases in mass at the rate of m =  2.6 kg/h. Dry bulb temperature TD = 50…

Q: Nitrogen gas enters a 0.450 m diameter pipe at 30.0 °C, 2.60 atm (absolute), and 6.30 m/s. The pipe…

A:

Q: According to the ideal gas law, a 0.9584 mol sample of argon gas in a 1.764 L container at 273.1 K…

A: Given: n = 0.9584 mol V = 1.764 L, Pideal = 12.18 atm, For Argon, a = 1.345 L2.atm/mol2 and b =…

Q: How did you assume the coefficient of discharge Cd? Did you get it from a table?    Thx

A: Orifice meter is a flow measuring device.

Q: (2.32) A feed stream to a chemical reactor consists of 0.2 kg/s of ammonia vapor at 300 K. Prior to…

A:

Q: The homogeneous liquid phase reaction A >2R carried out at constant volume and temperature in a…

A: we have constant volume system  as reaction in liquid phase. For first order reaction in batch…

Q: 2) A binary solution of ethanol and water is in equilibrium with its vapour in a process vessel at a…

A: The bubble temperature and resulting vapor composition is to be calculated.

Q: Milk (p = 1032 kg/m³, μ = 2 x 10-³ Pa s) flowing in a smooth stainless-steel pipe is 0.112 m in…

A:

Q: (2) Water is flowing at a rate of 0.03154 m/s through a horizontal nozzle shown in the figure below…

A: Given that Q=0.03154 m3/sd1=0.0635 m d2=0.0286 m ρ=1000 kgm3

Q: Consider the reaction: Ca(OH)2 (aq) + 2HCl(aq) CaCl2 (s) + 2H₂O(1) Using standard absolute entropies…

A: △S°sys =2× S° (H2O) +S°(CaCl2) -S°(Ca(OH)2 )-2×S°(HCl)